Antibiotic Adsorption by Acid Enhanced Dialium guineense Seed Waste

Utilizing olive leaves biomass as an efficient adsorbent for ciprofloxacin removal: characterization, isotherm, kinetic, and thermodynamic analysis

Olive leaves were utilized to produce activated biomass for the removal of ciprofloxacin (CIP) from water. The raw biomass (ROLB) was activated with sodium hydroxide, phosphoric acid, and Dead Sea water to create co-precipitated adsorbent (COLB) with improved adsorption performance. The characteristics of the ROLB and COLB were examined using SEM images, BET surface area analyzer, and ATR-FTIR spectroscopy. COLB has a BET surface area of 7.763 m2/g, markedly higher than ROLB's 2.8 m2/g, indicating a substantial increase in adsorption sites. Through investigations on operational parameters, the optimal adsorption efficiency was achieved by COLB is 77.9% within 60 min, obtained at pH 6, and CIP concentration of 2 mg/mL. Isotherm studies indicated that both Langmuir and Freundlich models fit the adsorption data well for CIP onto ROLB and COLB, with R2 values exceeding 0.95, suggesting effective monolayer and heterogeneous surface adsorption. The Langmuir model revealed maximum adsorption capacities of 636 mg/g for ROLB and 1243 mg/g for COLB, highlighting COLB's superior adsorption capability attributed to its enhanced surface characteristics post-modification. Kinetic data fitting the pseudo-second-order model with R2 of 0.99 for ROLB and 1 for COLB, along with a higher calculated qe for COLB, suggest its modified surface provides more effective binding sites for CIP, enhancing adsorption capacity. Thermodynamic analysis revealed that the adsorption process is spontaneous (∆Go < 0), and exothermic (∆Ho < 0), and exhibits a decrease in randomness (∆So < 0) as the process progresses. The ΔH° value of 10.6 kJ/mol for ROLB signifies physisorption, whereas 35.97 kJ/mol for COLB implies that CIP adsorption on COLB occurs through a mixed physicochemical process.

Thermodynamics, kinetics and isothermal studies of chromium (VI) biosorption onto Detarium senegalense stem bark extract coated shale and the regeneration potentials

A low-cost adsorbent (Detarium senegalense stem bark extract coated shale (DSMS)) comprising pristine shale (PSH) coated with D. senegalense stem bark extract was prepared and utilized for the adsorption of Cr(VI). The DSMS and PSH were characterized by the SEM, XRD, FTIR, EDX, TGA, and BET. The batch adsorption experiment results showed that DSMS exhibited an excellent ability to adsorb chromium with a maximum removal occurring at pH 2, dosage of 0.05 g and 180 min contact time. The adsorption process was best described by the pseudo-second-order for DSMS and Elovich model for PSH which depicts chemisorption as the major mechanism responsible for the uptake of Cr(VI) onto the adsorbents. Langmuir model provided the best fit to the isotherm analysis on both materials. The maximum adsorption capacity of DSMS and PSH were 64.98 mg g^-1 and 29.97 mg g^-1 respectively. The thermodynamics revealed that the adsorption of Cr(VI) was feasible, endothermic and entropy driven. Furthermore, after five cycles of reuse, both DSMS and PSH demonstrated effective regeneration and reusability for Cr(VI) uptake. The structural properties, reusability, and high adsorption capabilities of DSMS indicate that they could be used as low-cost adsorbents in large-scale Cr(VI) wastewater treatment. Novelty statement Plant extracts are packed with a variety of polyphenolic compounds, such as aldehydes, alcohols, carboxylics, ethers, ketones, and phenols which contains several functionalities useful in the adsorption of toxic metals. Despite this, research on the use of plant extracts in the modification of adsorbent materials for enhanced adsorption is rare. This study reports for the first time the use of Detarium senegalense stem bark extract coated shale adsorbent for the efficient uptake of Cr(VI) ion.

One-pot synthesis of zinc oxide nanoparticles via chemical precipitation for bromophenol blue adsorption and the antifungal activity against filamentous fungi

In this research, zinc oxide nanoparticles (ZnONPs) were prepared via a facile one-pot chemical precipitation approach and applied in the adsorption of bromophenol blue (BRB) and as antifungal agents against the filamentous fungi and plant pathogens; Alternaria alternata CGJM3078, Alternaria alternata CGJM3006 and Fusarium verticilliodes CGJM3823. The ZnONPs were characterized by the UV-Vis, FTIR, XRD, TGA, BET, SEM, TEM, and EDX techniques, which showed efficient synthesis. The characteristics ZnO UV-Vis absorption band was observed at 375 nm, while the XRD showed an average ZnONPs crystalline size of 47.2 nm. The SEM and TEM images showed an irregular shaped and aggregated porous structure of 65.3 nm average-sized ZnONPs. The TGA showed 22.9% weight loss at 800 °C indicating the high thermal stability of ZnONPs, while BET analysis revealed a surface area, pore volume and pore diameter of 9.259 m2/g, 0.03745 cm3/g and 9.87 nm respectively. The Freundlich, pseudo-second-order, and intra-particle diffusion models showed R2 > 0.9494 and SSE < 0.7412, thus, exhibited the best fit to the isotherm and kinetics models. Thermodynamics revealed feasible, endothermic, random, and spontaneous adsorption of BRB onto the synthesized ZnONPs. The antifungal assay conducted depicts strong antifungal activities against all three tested fungi. Noticeably, ZnONPs (0.002-5 mg/mL) showed maximum activities with the largest zone of inhibition against A. alternata CGJM 3006 from 25.09 to 36.28 mm. This was followed by the strain F. verticilliodes CGJM 3823 (range from 23.77 to 34.77 mm) > A. alternata CGJM3078 (range from 22.73 to 30.63 mm) in comparison to Bleach 5% (positive control). Additionally a model was proposed based on the possible underlying mechanisms for the antifungal effect. This research demonstrated the potent use of ZnONPs for the adsorption of BRB and as effective antifungal agents.

Biosorption and regeneration potentials of magnetite nanoparticle loaded Solanum tuberosum peel for celestine blue dye

This research evaluated the adsorption of celestine blue (CB) onto a novel Solanum tuberosum waste-magnetite nanocomposite (Mt@STB), prepared by an ecofriendly impregnation of magnetite (Mt) nanoparticles onto Solanum tuberosum waste (STB). The adsorbents characterization revealed that Mt@STB had a surface area (18.92 m²/g), pHpzc (7.55), porous morphology as well as suitable functional groups for efficient sequestration of CB onto the composite. The SEM, XRD, and EDX showed successful incorporation of 31.21 nm average size Mt nanoparticles on Mt@STB. Faster kinetics of CB sequestration from the wastewater was obtained for Mt@STB (100 min) compared to STB (140 min). Among four isotherm models, the Langmuir exhibited the best fit with R² > 0.9971 and sum square errors (SSE) < 0.0151. The pristine STB and Mt@STB composite showed maximum monolayer CEB uptake of 7.61 and 9.02 mg/g, as well as optimum removal of 73.8 and 84.7%, respectively. The pseudo-second-order model was more suitable in the kinetic description, while thermodynamics revealed a physical, spontaneous, and endothermic CB uptake. Besides, the efficacy of the composite for CB was confirmed from efficient regeneration over three adsorption/desorption cycles, which specified the viability of Mt@STB as a sustainable material for the decontamination of CB polluted water. NOVELTY STATEMENT The adsorption of dyes from wastewaters has been widely studied due to the harmful effects on the ecosystem. However, research on the removal of celestine blue (CB) dye is rare despite its wide use in the nuclear and textile industries. Until date, there is no report on the adsorption of CB on biomaterial via biosorption. Therefore, the biosorption behavior of CB is presently unknown. Hence, this study reports the biosorption of CB onto a biosorbent (Solanum tuberosum peel [STB]) in an attempt to understand its biosorption behavior. Besides, the impregnation of magnetite (Mt) nanoparticles has been reported to enhance the uptake of most adsorbents for dye. To the best of our knowledge, such magnetic nanoparticle impregnation of STB has not been reported. We, therefore, synthesized a novel biowaste-magnetite composite (Mt@STB) and evaluated its potentials for the uptake as well as its reuse for CB biosorption.

Synthesis, characterization, and regeneration of an inorganic-organic nanocomposite (ZnO@biomass) and its application in the capture of cationic dye

Despite the efficiency of ZnO nanoparticle (NPs) composite adsorbents in the adsorption of various pollutants, there is presently no report on the combo of ZnONPs with biomass for adsorption. Besides, there is a dearth of information on the biosorption of celestine blue (CEB), a dye used in the nuclear and textile industry. In this study, biogenic-chemically mediated synthesis of a composite (ZnO@ACP) was prepared by the impregnation of ZnONPs onto Ananas comosus waste (ACP) for the adsorption of CEB. The SEM, EDX, FTIR, XRD, BET, and TGA characterizations showed the successful presence of ZnONPs on the biomass to form a nanocomposite. The uptake of CEB was enhanced by the incorporation of ZnONPs on ACP. A faster CEB adsorption onto ZnO@ACP (120 min) compared to ACP (160 min) was observed. The Langmuir (R² > 0.9898) and pseudo-second-order (R² > 0.9518) models were most appropriate in the description of the adsorption process. The impregnation of ZnONPs onto the biomass enhanced the spontaneity of the process and displayed endothermic characteristics. High CEB desorption of 81.3% from the dye loaded ZnO@ACP as well as efficient reusability showed the efficacy of the prepared nanocomposite for CEB adsorption.