Effect of ion source pressure on ion formation of carbamates in particle-beam chemical-ionisation mass spectrometry

Multiresidue determination of thermolabile insecticides in cereal products by gas chromatography-mass spectrometry: Evaluation with on-column injection and conventional hot splitless injection

This communication presents a study on the simultaneous determination of thermolabile N-methylcarbamate and organophosphorus insecticides in cereal products by gas chromatography-mass spectrometry. The thermal stability of the multiple insecticides was evaluated with conventional hot splitless injection and on-column injection. The results obtained by GC-MS with these two injection techniques were compared in terms of the recovery, the limit of detection, the limit of qualification, and the reproducibility. With on-column injection, the pesticide recoveries in cereal samples were better than 82%, with relative standard deviations lower than 5.4%. The limits of qualification for most insecticides were in the range of 0.009-0.08 mg/kg, i. e. lower than the maximum residue limits established for insecticides in cereal products by the European Union. The long-term stability using on-column injection for analysis of insecticides in real samples was evaluated and normal chromatographic performance could be obtained within 50 analyses. The results revealed that it was possible for application of on-column injection in the analysis of thermolabile multiple insecticides in food sample after comprehensive sample clean-up, despite the highly contaminated nature of the column system.

Gas chromatographic–tandem mass spectrometric method for the quantitation of carbofuran, carbaryl and their main metabolites in applicators’ urine

A new gas chromatographic-tandem mass spectrometric method has been developed and validated for the determination of two N-methylcarbamates, carbofuran and carbaryl and their metabolites in applicators' urine specimens. Mild conditions were used for sample preparation based on enzymic hydrolysis and solid-phase extraction using Oasis HLB sorbent cartridges. Amides, phenols and ketones were first converted to volatile derivatives of trifluoroacetic acid anhydride (TFAA) and afterwards were quantitated using tandem mass spectrometry. Linear calibration equations (1-200 ng mL(-1) urine) were obtained from fortified urine samples for all eight compounds, carbaryl, 1-naphthol, 2-naphthol, and carbofuran, 3-hydroxycarbofuran, 7-phenol, carbofuran-3-keto, 3- hydroxycarbofuranphenol. For all compounds, the limit of detection was lower than 0.1 ng mL(-1). Precision for all compounds, at the concentrations of 1, 10 and 100 ng mL(-1) (n = 5) in-fortified urine samples ranged from 0.7% to 18%. Accuracy was calculated at two concentrations 8 and 80 ng mL(-1) (n = 5) and ranged from -8.4% to 8.2%. Relative recoveries at concentrations of 1, 10 and 100 ng mL(-1), ranged from 71% to 116%. The method was successfully applied to five male applicators and 10 non-applicators (including both smokers and non-smokers).

Determination of traces of pesticides in water by solid-phase extraction and liquid chromatography-ionspray mass spectrometry

A multi-residue analytical method for six pesticides (atrazine, hydroxyatrazine, carbofuran, promecarb, linuron and monolinuron) in drinking water has been developed. The method combines liquid chromatography and mass spectrometry using an ionspray interface. The linearity domain, as well as the limits of detection and quantification, were determined for each compound. Although satisfactory performance could be achieved, present drinking water regulations (0.1 microgram l-1 for single pesticide) requires a pre-concentration step. This was performed using solid-phase extraction with octadecyl-bonded silica cartridges. The analytical procedure was tested on water samples spiked at the 0.04 and 0.08 microgram l-1 levels, and allowed the determination of the investigated pesticides (except hydroxyatrazine) at these trace concentrations.