Electrical breakdown of protoplast membranes under different osmotic pressures

Changes of the solution pH due to exposure by high-voltage electric pulses

The change of the pH of a NaCl solution (139-149 mM NaCl) buffered with 5-15 mM sodium phosphates (pH 7.4) during electromanipulation was studied. It has been determined that an increase in the pH value of electroporation solution of a whole chamber volume, caused by the application of electric field pulses, commonly used in cell electromanipulation procedures, can exceed 1-2 pH units. Several materials for the cathode were tested. In all cases a stainless steel anode was utilized. The aluminum cathode gave a two-fold greater DeltapH in comparison with platinum, copper or stainless steel cathodes. In addition, a substantial release of aluminum (up to 1 mg/l) from the cathode was observed. It has also been found that the shift in pH depended on the medium conductivity: DeltapH of the solution, in which sucrose was substituted for NaCl, was about 5 times less. On the basis of the results obtained here, to avoid the plausible undesirable consequences of the cathodic electrolysis processes, in particular under the conditions of strong electric treatment, it could be recommended that chambers with aluminum electrodes not be utilized and one should use strongly buffered solutions of low conductivity and alternating current (sine or square wave) bipolar electric pulses.

Material property characteristics for lipid bilayers containing lysolipid

The apparent area expansion modulus and tensile strength of egg phosphatidylcholine (EPC) membranes are measured in the presence of monooleoylphosphatidylcholine (MOPC). The apparent area expansion modulus decreases from 171 mN m-1 for pure EPC membrane to 82 mN m-1 for a membrane containing 30 mol % MOPC. This significant decrease of the apparent area expansion modulus is attributed to the change of the membrane area due to the tension-dependent exchange of MOPC between the bathing solution and the membrane. Similar to the apparent area expansion modulus, the tensile strength of the membrane decreases with the increase of the molar concentration of MOPC in the membrane. The tensile strength of pure EPC membrane is 9.4 mN m-1 whereas that for a membrane containing 30 mol % MOPC is only 1.8 mN m-1, and for a membrane containing 50 mol % MOPC it is even smaller, on the order of 0.07 mN m-1. The decrease of the tensile strength is coupled with a decrease of the work for membrane breakdown, which changes from 4.3 x 10(-2) kT for pure EPC membrane to 2 x 10(-6) kT for a membrane with 50 mol % MOPC. Overall, these results show that the decrease of the apparent area expansion modulus in the presence of exchangeable molecules is a fundamental property for all membranes and depends on the area occupied by these molecules. The method presented here provides a unique tool for measuring the area occupied by an exchangeable molecule in the bilayer membrane.

Membrane electroporation--fast molecular exchange by electroosmosis

Human and rabbit erythrocyte ghosts loaded with FITC-dextran (mol. mass = 10 kDa) and NBD-glucosamine (mol. mass = 342 Da) in buffers of different ionic strength and composition were subjected to electric pulses (intensity 0.7 kV/mm and decay half-time 1 ms) at 7-10 degrees C and 20-24 degrees C. The transfer of the fluorescent dyes from the interior of the ghosts through the electropores was observed by low light level video microscopy. The pulses caused the fluorescence to appear outside the membranes as a transient cylindrical cloud directed toward the negative electrode during the first video frame (17 ms). It was similar in both rabbit and human erythrocyte ghosts and at both temperatures but differs for the two dyes, the fluorescence cylinder is long and tall for the FITC-dextran and relatively short and thick for the NBD-glucosamine. The molecular exchange was 2-3 orders of magnitude faster within the first 17 ms after the pulse than the diffusional exchange. It decreased with increasing ionic strength. Formulae for the transfer of molecules by electroosmotic flow through the pores are in agreement with these observations. They allow estimation of the total area of pores with radii larger than that of the fluorescent dye during the pulse. The major conclusion is that electroosmosis is the dominating mechanism of molecular exchange in electroporation of erythrocyte ghosts.