A method to detect superoxide radicals using Teflon membrane and superoxide dismutase

An aptamer cocktail-functionalized photocatalyst with enhanced antibacterial efficiency towards target bacteria

We developed TiO2 particles conjugated with an Escherichia coli surface-specific ssDNA aptamer cocktail (composed of three different aptamers isolated from E. coli) for targeted and enhanced disinfection of E. coli. We examined the target-specific and enhanced inactivation of this composite (TiO2-Apc), which were compared to those of TiO2 conjugated with a single aptamer (one of the three different aptamers, TiO2-Aps) and non-modified TiO2. We found that TiO2-Apc enhanced the inactivation of targeted E. coli under UV irradiation compared to both the non-modified TiO2 and TiO2-Aps. A higher number of TiO2-Apc than TiO2-Aps particles was observed on the surface of E. coli. The amount of TiO2-Apc required to inactivate ∼99.9% of E. coli (10(6) CFU/ml) was 10 times lower than that of non-modified TiO2. The close proximity of functionalized particles with E. coli resulting from the interaction between the target surface and the aptamer induced the efficient and fast transfer of reactive oxygen species to the cells. In a mixed culture of different bacteria (E. coli and Staphylococcus epidermidis), TiO2-Apc enhanced the inactivation of only E. coli. Taken together, these results support the use of aptamer cocktail-conjugated TiO2 for improvement of the target-specific inactivation of bacteria.

In vitro detection of superoxide anions released from cancer cells based on potassium-doped carbon nanotubes-ionic liquid composite gels

A newly developed electrochemical biosensor for the determination of superoxide anions (O(2)˙(-)) released from cancer cells using potassium-doped multi-walled carbon nanotubes (KMWNTs)-1-butyl-3-methylimidazolium hexafluorophosphate ([BMIM]PF(6)) ionic liquid composite gels is demonstrated. The KMWNTs-[BMIM]PF(6) can electrocatalyze oxygen reduction to generate a strong current signal in neutral solution. Compared with KMWNTs without [BMIM]PF(6) or MWNTs-[BMIM]PF(6) composites, the KMWNTs-[BMIM]PF(6) can enhance the oxygen reduction peak current by 6.2-fold and 2.8-fold, which greatly increases the detection sensitivity of oxygen. Then, O(2)˙(-) biosensors are fabricated by mixing superoxide dismutase (SOD) in the KMWNTs-[BMIM]PF(6) gels via monitoring oxygen produced by an enzymic reaction between SOD/O(2)˙(-) without the help of electron mediators. The resulting biosensors show a linear range from 0.04 to 38 μM with a high sensitivity of 98.2 μA mM(-1), and a lower detection limit of 0.024 μM. The common interferents such as hydrogen peroxide (H(2)O(2)), ascorbic acid (AA), uric acid (UA), and metabolites of neurotransmitters, do not interfere with the detection of O(2)˙(-). The proposed biosensor is tested to determine O(2)˙(-) in vitro and from liver cancer and leukemia cells and shows good application potential in biological electrochemistry.

Determination of the antioxidants' ability to scavenge free radicals using biosensors

Free radicals are highly reactive molecules generated during cellular metabolism. However, their overproduction results in oxidative stress, a deleterious process that can damage cell structures, including lipids and membranes, proteins and DNA. Antioxidants respond to this problem, scavenging free radicals. This chapter critically reviews the electrochemical biosensors developed for the evaluation of the antioxidant capacity of specific compounds. Due to the ability of these devices to perform simple, fast and reliable analysis, they are promising biotools for the assessment ofantioxidant properties.

Cytochrome C mutants for superoxide biosensors

The effect of introducing positive charges (lysines) in human cytochrome c (cyt c) on the redox properties and reaction rates of cyt c with superoxide radicals was studied. The mutated forms of this electron-transfer protein are used as sensorial recognition elements for the amperometric detection of the reactive oxygen radical. The proteins were prepared by site-directed mutagenesis focusing on amino acids near the heme edge. The 11 mutants of human cyt c expressed in the course of this research have been characterized by UV-vis spectroscopy, circular dichroism, and NMR spectroscopy to verify overall structure integrity as well as axial coordination of the heme iron. The mutants are investigated voltammetrically using promoter-modified gold electrodes with respect to redox activity and formal redox potential. The rate constants for the reaction with superoxide have been determined spectrophotometrically. Four mutants show a higher reaction rate with the radical as compared to the wild type. These mutants are used for the construction of superoxide sensors based on thiol-modified gold electrodes and covalently fixed proteins. We found that the E66K mutant-based electrode has a clearly higher sensitivity in comparison with the wild-type-based sensor while retaining the high selectivity and showing a good storage stability.

Superoxide radical sensing using a cytochrome c3 immobilized conducting polymer electrode

A biosensor based on cytochrome c3 (cyt c3) has been introduced to detect and quantify superoxide radical (O2*-). Cyt c3, isolated from the sulfate-reducing bacterium (Desulfovibrio vulgaris Miyazaki F. strain), and its mutant were immobilized onto a conducting polymer coated electrodes by the covalent bonding with carbodiimide chemistry. The immobilization of cyt c3 was investigated with quartz crystal microbalance, electrochemical impedance spectroscopy, and cyclic voltammetric studies. The CVs recorded for cyt c3 and a mutant modified-electrodes showed a quasi-reversible behavior having the formal potential of about -471 and -476 mV (versus Ag/AgCl), respectively, in a 0.1M phosphate buffer solution (pH 7.0). The modified electrodes showed the surface controlled process and the electron transfer rate constants (ks) were evaluated to be 0.47 and 0.51 s(-1) for cyt c3 and mutant modified electrodes, respectively. A potential application of the cyt c3 modified electrode was evaluated by monitoring the bioelectrocatalytic response towards the O2*-. The hydrodynamic range of 0.2-2.7 micromole L(-1) and the detection limit of 0.05 micromole L(-1) were obtained.

Biosensors for determination of total antioxidant capacity of phytotherapeutic integrators: comparison with other spectrophotometric, fluorimetric and voltammetric methods

Enzymatic electrodes based on superoxide dismutase (SOD) biosensors, working both in aqueous and non-aqueous solutions, recently developed by the present authors, were used to experimentally evaluate the antioxidant capacity of several phytotherapeutic diet integrators. The precision of this method of analysis was found to be reasonable (R. S. D. < or = 10%). The results were also compared with those obtained using a traditional spectrophotometric method as well as a spectrofluorimetric method described in literature. Lastly, the comparison was extended to another method based on cyclic voltammetry currently being trialled by the present authors.

Third-generation superoxide anion sensor based on superoxide dismutase directly immobilized by sol–gel thin film on gold electrode

A third-generation biosensor for superoxide anion (O(2)*-) was developed based on superoxide dismutase (SOD) immobilized by thin silica-PVA sol-gel film on gold electrode surface. A rapid and direct electron transfer of SOD in the thin sol-gel film at the gold electrode was realized without any mediators or promoters. The characterization of the SOD electrodes showed a quasi-reversible electrochemical redox behavior with a formal potential of 80 + 5 mV (versus SCE) in 50 mmol l(-1) phosphate buffer solution (PBS), pH 7.0. The heterogeneous electron transfer rate constant was evaluated to be about 2.1s(-1). The anodic and cathodic transfer coefficients are 0.6 and 0.4, respectively. Based on biomolecular recognition for specific reactivity of SOD toward O(2)*- the SOD electrode was applied to a sensitive and selective measurement of O(2)*- with the low operation potential (-0.15 V versus SCE) in phosphate buffer solution, pH 7.0. The amperometric response was proportional to O(2)*- concentration in the range of 0.2-1.6 micromol l(-1) and the detection limit was 0.1 micromol l(-1) at a signal-to-noise ration of 3. The preparation of SOD electrode is easy and simple. The uniform porous structure of the silica-PVA sol-gel matrix results in a fast response rate of immobilized SOD and is very efficient for stabilizing the enzyme activity.

New biosensor for superoxide radical used to evidence molecules of biomedical and pharmaceutical interest having radical scavenging properties

A superoxide dismutase biosensor was used to determine the antioxidant properties of scavenger molecules and the antiradical activity of healthy and diseased human kidney tissues; this biosensor is based on the use of the enzyme superoxide dismutase (SOD), which is physically entrapped in a kappa-carrageenan gel membrane, and of a transducer consisting of an amperometric hydrogen peroxide electrode. Several compounds with scavenging properties were tested, including some commercial drugs.