Structure and assembly of bacteriophage PRD1, and Escherichia coli virus with a membrane

A new approach to testing the efficacy of drinking water disinfectants

New disinfection procedures are being developed and proposed for use in drinking-water production. Authorising their use requires an effective test strategy that can simulate conditions in practice. For this purpose, we developed a test rig working in a flow-through mode similar to the disinfection procedures in waterworks, but under tightly defined conditions, including very short contact times. To quantify the influence of DOC, temperature and pH on the efficacy of two standard disinfectants, chlorine and chlorine dioxide, simulated use tests were systematically performed. This test rig enabled quantitative comparison of the reduction of four test organisms, two viruses and two bacteria, in response to disinfection. Chlorine was substantially more effective against Enterococcus faecium than chlorine dioxide whereas the latter was more effective against the bacteriophage MS2, especially at pH values of >7.5 at which chlorine efficacies already decline. Contrary to expectation, bacteria were not generally reduced more quickly than viruses. Overall, the results confirm a high efficacy of chlorine and chlorine dioxide, validating them as standard disinfectants for assessing the efficacy of new disinfectants. Furthermore, these data demonstrate that the test rig is an appropriate tool for testing new disinfectants as well as disinfection procedures.

Optimizing Bacteriophage Surface Densities for Bacterial Capture and Sensing in Quartz Crystal Microbalance with Dissipation Monitoring

Surface immobilized bacteriophages (phages) are increasingly used as biorecognition elements on bacterial biosensors (e.g., on acoustical, electrical, or optical platforms). The phage surface density is a critical factor determining a sensor's bacterial binding efficiencies; in fact, phage surface densities that are too low or too high can result in significantly reduced bacterial binding capacities. Identifying an optimum phage surface density is thus crucial when exploiting the bacteriophages' bacterial capture capabilities in biosensing applications. Herein, we investigated surface immobilization of the Pseudomonas aeruginosa specific E79 (tailed) phage and the Salmonella Typhimurium specific PRD1 (nontailed) phage and their subsequent bacterial capture abilities using quartz crystal microbalance with dissipation monitoring (QCM-D). The QCM-D was used in two experimental setups: (i) a conventional setup and (ii) a combined setup with ellipsometry. Both setups were exploited to link the phages' immobilization behaviors to their bacterium capture efficiency. While E79 displayed characteristic optima in both the mechanical (QCM-D) and the optical (ellipsometry) data that coincided with its specific bacterial capture optimum, no optima were observed during PRD1 immobilization. The characteristic optima suggests that the E79 phage undergoes a surface rearrangement event that changes the hydration state of the phage film, thereby impairing the E79 phage's ability to capture bacteria. However, the absence of such optima during deposition of the nontailed PRD1 phage suggests that other mechanisms may also lead to reduced bacterial capture by surface immobilized bacteriophages.

Lipid-containing viruses: bacteriophage PRD1 assembly

PRD1 is a tailless icosahedrally symmetric virus containing an internal lipid membrane beneath the protein capsid. Its linear dsDNA genome and covalently attached terminal proteins are delivered into the cell where replication occurs via a protein-primed mechanism. Extensive studies have been carried out to decipher the roles of the 37 viral proteins in PRD1 assembly, their association in virus particles and lately, especially the functioning of the unique packaging machinery that translocates the genome into the procapsid. These issues will be addressed in this chapter especially in the context of the structure of PRD1. We will also discuss the major challenges still to be addressed in PRD1 assembly.

Transport of coliphage PRD1 in a surface flow constructed wetland

A tracer study was conducted in a 3-ha surface flow constructed wetland to analyze transport performance of PRD1, an enteric virus model. The convection-dispersion equation (CDE), including a first-order reaction model, adequately simulated transport performance of PRD1 in the wetland under an average hydraulic loading rate of 82 mm/d. Convective velocity (v) and longitudinal dispersion coefficient (D) were estimated by modeling a conservative tracer (bromide) pulse through the wetland. Both PRD1 and bromide were simultaneously added to the entering secondary treated wastewater effluent. The mass of bromide and PRD1 recovered was 76 and 16%, respectively. The PRD1 decay rate was calculated to be 0.3/day. The findings of this study suggest that the CDE model and analytical moment equations represent a suitable option to characterize virus transport performance in surface flow constructed wetlands.

Column experiments to study nonlinear removal of bacteriophages by passage through saturated dune sand

In a recent field study on dune recharge, bacteriophages MS2 and PRD1 were found to be removed 3 log10 over the first 2.4 m and only 5 log10 over the next 27 m. To understand the causes of this nonlinear removal, column experiments were carried out under conditions similar to the field: same recharge water, temperature (5 +/- 3 degrees C) and pore water velocity (1.5 m day(-1)). Soil samples were taken along a streamline between the recharge canal and the first monitoring well. Bacteriophage phiX174 was included for comparison. The high initial removal in the field was found not to be due to heterogeneity of phage suspensions but to soil heterogeneity. Phage removal rates correlated strongly positively with soil organic carbon content, and relatively strongly positively with silt content and the presence of ferric oxyhydroxides. Soil organic carbon content, silt content and the presence of ferric oxyhydroxides were found to decrease exponentially with travel distance. Removal rates of phiX174 were found to be 3-10 times higher than those of MS2 and PRD1 due to the lower electrostatic repulsion that the less negatively charged phiX174 experiences. It is suggested that the high initial removal in the field is due to the presence of favorable sites for attachment formed by ferric oxyhydroxides that decrease exponentially with travel distance. Similar removal rates may be found at both laboratory and field scale. However, due to local variations at field scale detailed knowledge on soil heterogeneity may be needed to enable a reliable prediction of removal.

Two-site kinetic modeling of bacteriophages transport through columns of saturated dune sand

Breakthrough curves, on a semi-log scale, from tests in porous media with block-input of viruses, bacteria, protozoa and colloidal particles often exhibit a typical skewness: a rather slowly rising limb and a smooth transition of a declining limb to a very long tail. One-site kinetic models fail to fit the rising and declining limbs together with the tail satisfactorily. Inclusion of an equilibrium adsorption site does not seem to improve simulation results. This was encountered in the simulation of breakthrough curves from a recent field study on the removal of bacteriophages MS2 and PRD1 by passage through dune sand. In the present study, results of laboratory experiments for the study of this issue are presented. Breakthrough curves of salt and bacteriophages MS2, PRDI, and phiX174 in 1 D column experiments have been measured. One- and two-site kinetic models have been applied to fit and predict breakthrough curves from column experiments. The two-site model fitted all breakthrough curves very satisfactorily, accounting for the skewness of the rising limb as well as for the smooth transition of the declining limb to the tail of the breakthrough curve. The one-site model does not follow the curvature of the breakthrough tail, leading to an overestimation of the inactivation rate coefficient for attached viruses. Interaction with kinetic site 1 is characterized by relatively fast attachment and slow detachment, whereas attachment to and detachment from kinetic site 2 is fast. Inactivation of viruses and interaction with kinetic site 2 provide only a minor contribution to removal. Virus removal is mainly determined by the attachment to site 1. Bacteriophage phiX174 attached more than MS2 and PRD1, which can be explained by the greater electrostatic repulsion that MS2 and PRD1 experience compared to the less negatively charged phiX174.

Gene XV of bacteriophage PRD1 encodes a lytic enzyme with muramidase activity

Bacteriophage PRD1 is a lipid-containing virus that infects a variety of Gram-negative bacteria, including Escherichia coli. The phage lyses its host by virtue of a virally-encoded lytic enzyme, the synthesis of which has been assigned to gene XV on the basis of complementation analysis and experiments with mutant phages. We report here the cloning of gene XV into an expression plasmid and the purification of its product, protein P15, to near homogeneity. The purified protein P15, identified by N-terminal sequence analysis, showed a strong lytic activity against chloroform-treated Gram-negative cells. No activity against Gram-positive bacterial species could be detected. The pH optimum of the enzyme was between 7.0-8.0. Protein P15 was readily inactivated at temperatures above 4 degrees C, as well as by increasing the ionic strength of the buffers. The analysis of cell wall digests indicated that P15 is a glycosidase that cleaves the beta (1-4) linkage between N-acetylmuramic acid and N-acetylglucosamine, thus displaying muramidase activity.

In vitro replication of bacteriophage PRD1 DNA. Characterization of the protein-primed initiation site

Bacteriophage PRD1 replicates its DNA by means of a protein-primed replication mechanism. Using single-stranded oligonucleotide templates carrying the sequence corresponding to the 25 first bases of the 3' end of PRD1 DNA, and Mg2+ as the activating metal ion of the phage DNA polymerase, we show that the fourth base from the 3' end of the template directs, by base complementarity, the dNMP to be linked to the phage terminal protein (TP) in the initiation reaction. This result suggests that phage PRD1 maintains its 3' end DNA sequences via a sliding-back mechanism. The single-stranded DNA templates could not be replicated by the PRD1 DNA polymerase, much in contrast to the natural TP-DNA. Nevertheless, the analysis of the transition products obtained with TP-DNA and origin-containing oligonucleotides suggests that sliding-back occurs stepwise, the fourth base being the directing position during the entire process.

Binding of an Escherichia coli double-stranded DNA virus PRD1 to a receptor coded by an IncP-type plasmid

IncP plasmid RP1 Tra regions are needed to assemble the receptor for lipid-containing double-stranded DNA bacteriophage PRD1 on the cell surface. Using radioactively labeled phage and electron microscopic techniques, we showed that the surfaces of Salmonella typhimurium(RP1) and Escherichia coli(RP1) cells contained approximately 50 and 20 PRD1 binding sites, respectively. Expression of the receptor was growth phase dependent and was highest at late logarithmic or early stationary phase. The PRD1-resistant RP1 transposon mutants isolated were all Tra-, and the transposons were located in both the Tra1 and Tra2 regions.

Overproduction, purification, and characterization of DNA-binding protein P19 of bacteriophage PRD1

The early protein, P19, of bacteriophage PRD1 was purified after overexpression of the cloned gene, XIX, in Escherichia coli DH5 alpha cells. The purified protein binds as multimers to single-stranded DNA (ssDNA), and with a lower affinity to double-stranded DNA (dsDNA), without sequence-specificity. Two distinct P19-ssDNA complexes were discovered in gel- mobility-shift assays at different protein:DNA ratios. P19 was capable of fully protecting ssDNA against nuclease P1. Electron microscopy of protein P19-ssDNA complexes showed DNA molecules which were extensively coated with protein and whose contour length was clearly reduced by P19 binding. The results suggest that P19 binds to ssDNA with moderate cooperativity and are consistent with the DNA being wrapped around the P19 multimers.

In vitro replication of bacteriophage PRD1 DNA. Metal activation of protein-primed initiation and DNA elongation

Bacteriophage PRD1 replicates its DNA by means of a protein-primed replication mechanism. Compared to Mg2+, the use of Mn2+ as the metal activator of the phage DNA polymerase results in a great stimulation of the initiation reaction. The molecular basis of the observed stimulatory effect is an increase in the velocity of the reaction. The phage DNA polymerase is also able to catalyze the formation of the initiation complex in the absence of DNA template. Although the presence of Mn2+ does not affect either the polymerization activity or the processivity of the DNA polymerase, this metal is unable to activate the overall replication of the phage genome. This can be explained by a deleterious effect of Mn2+ on the 3'-5'-exonucleolytic and/or the strand-displacement activity, the latter being an intrinsic function of the viral DNA polymerase required for protein-primed DNA replication.

Genome organization of membrane-containing bacteriophage PRD1

We have determined the nucleotide sequence of the late region (11 kbp) of the lipid-containing bacteriophage PRD1. Gene localization was carried out by complementing nonsense phage mutants with genomic clones containing specific reading frames. The localization was confirmed by sequencing the N-termini of isolated gene products as well as sequencing the N-termini of tryptic fragments of the phage membrane-associated proteins. This, with the previously obtained sequence of the early regions, allowed us to organize most of the phage genes in the phage genome.

High-frequency transfer of linear DNA containing 5'-covalently linked terminal proteins: electroporation of bacteriophage PRD1 genome into Escherichia coli

Using electroporation with the phage PRD1 genome, we set up a high-frequency DNA transfer system for a linear dsDNA molecule with 5'-covalently linked terminal proteins. The transfer was saturated when more than 100 ng of PRD1 genome was used. Electroporation efficiency was about four orders of magnitude higher than that obtained with transfection. Removal of the terminal protein abolished plaque formation, which could not be rescued by supplying the terminal protein or phage DNA polymerase or both in trans.