Acid–base properties of silica-based ion-exchanger having covalently bonded aminodi(methylphosphonic) acid

Optimal Synthesis of Novel Phosphonic Acid Modified Diatomite Adsorbents for Effective Removal of Uranium(VI) Ions from Aqueous Solutions

The authors synthesized a series of functionalized diatomite-based materials and assessed their U(VI) removal performance. Phosphor-derivative-modified diatomite adsorbents were synthesized by the three-route procedures: polymerisation (DIT-Vin-PAin), covalent (DIT-Vin-PAcov), and non-covalent (DIT-PA) immobilization of the functional groups. The effects of the diatomite modification have been studied using powder XRD, solid state NMR, FTIR spectroscopy, electronic microscopy, EDX, acid-base titrations, etc. The maximum adsorption capacities of DIT-Vin-PAcov, DIT-PA, and DIT-Vin-PAin samples were 294.3 mg/g, 253.8 mg/g, and 315.9 mg/g, respectively, at pH0 = 9.0. The adsorption amount of U(VI) ions using the prepared DIT-Vin-PAin was 95.63%, which is higher compared with that of the natural diatomite at the same concentration. The adsorption studies demonstrated that the phosphonic and hydroxyl groups on the surface of the diatomite played pivotal roles in the U(VI) adsorption. The U(VI) ions as a "hard" Lewis acid could easily form bonds with the "hard" donor P-containing ligands, so that the as-prepared DIT-Vin-PAin sample had excellent adsorption properties. The monolayer adsorption of the analyte on the surface of the raw diatomite and DIT-PA was observed. It was found from the thermodynamic parameters that the uptake of the U(VI) ions by the obtained adsorbents was a spontaneous process with an endothermic effect. Findings of the present work highlight the potential for using modified diatomite as effective and reusable adsorbents for the extraction of U(VI) in the waste, river, and tap waters with satisfactory results.

In situ Functionalized Mesoporous Silicas for Sustainable Remediation Strategies in Removal of Inorganic Pollutants from Contaminated Environmental Water

Low-cost mesoporous silicas of the SBA-15 family were prepared, aimed for removal of a broad spectrum of both cationic and anionic forms of hazardous metal pollutants (Cr(III, VI), Mn(II, VII), Pb(II), Cd(II), and Cu(II)) from environmental water. Series of mono- and bifunctional materials with immobilized ethylenediaminetriacetic acid (EDTA), primary amine (NH₂), and quaternary ammonium (QAS) groups were prepared in a cost-efficient one-step synthesis using two silica sources, low-cost sodium metasilicate (Na₂SiO₃ 9H₂O) and the conventional source-tetraethylorthosilicate (TEOS). The functionalized SBA-15 samples obtained from both silica sources were highly ordered, as evidenced by TEM and SAXS data. All obtained materials were mesoporous with high surface area values of up to 745 m²/g, pore volumes from 0.99 to 1.44 cm³/g, and narrow pore distributions near 7 nm. The adsorption affinity of the EDTA-functionalized samples followed the common order Pb(II)> Cd(II)> Cu(II)> Cr(III)> Mn(II), which could be explained based on the Pearson theory. The highest adsorption capacities were observed for samples functionalized by EDTA groups using TEOS for synthesis (TEOS/EDTA): 195.6 mg/g for Pb(II), 111.2 mg/g for Cd(II), 58.7 mg/g for Cu(II), 57.7 mg/g for Cr(III), and 49.4 mg/g for Mn(II). Moreover, organic matter (humic acid up to 10 mg/L) and inorganic (Na(I), K(I), Mg(II), Ca(II), etc) macrocomponents present in environmental water had almost negligible effect on the removal of these cations. The NaSi/EDTA/NH₂ sample revealed a better selectivity compared to the NaSi_/NH₂ sample towards such species as Cr(III), Mn(II), Cd(II), and Cu(II). The chromate-ions uptake at pH 7.5 by the TEOS/QAS sample turned practically unaffected by the presence of doubly charged anions (CO₃ ^2-, SO₄ ^2-). The content of functional groups on the surface of MS decreased only slightly (∼1-5%) after several regeneration cycles. The complete desorption of all heavy metal ions can be achieved using 1 mol/L EDTA solution. Reusability tests demonstrated the complete stability of the adsorbent for at least five to six consecutive adsorption/desorption cycles with no decrease in its adsorption characteristics compared to those obtained by 0.05 mol/L HNO₃ treatments. The synthesized mesoporous materials were evaluated for removal of the heavy metal ions from drinking and different natural water samples, proving their potential as sustainable, effective, and cost-efficient adsorbents.

EBT anchored SiO2 3-D microarray: a simultaneous entrapper of two different metal centers at high and low oxidation states using its highest occupied and lowest unoccupied molecular orbital, respectively

Simultaneous binding of two different metal centers, Zr(iv) and Tl(i) at the HOMO and LUMO, respectively, of the extractor (FSG-EBT).

Quantitative physicochemical analysis of equilibria on chemically modified silica surfaces

Quantitative physicochemical analysis (QPCA) enables the determination of the stoichiometric compositions and physicochemical parameters of species in equilibrium systems proceeding from the composition-property dependencies. The paper discusses modifications to the routine QPCA procedures required to characterize properties of reagents fixed on surfaces of silica-organic hybrid materials. The cooperative effects and the energetic heterogeneity of fixed reagents are especially important in this context. It follows that the main peculiarities of silica surfaces chemically modified by aliphatic amines are (a) the pronounced energetic heterogeneity of reagents caused by the non-random surface topography, (b) the decrease of the bacisity of amines induced by their interactions with residual surface silanols, and (c) the expressed sensibility of reactions in the near-surface layer to the state of its hydration. The interaction of grafted organic bases with metal ions results in the preferred formation of bis metal-ligand coordination compounds. Stability constants of complexes are decreased as a consequence of fixation and depend on not only donor but also acceptor ability of a solvent. Also, the denticity of polydentate ligands may decrease as a result of grafting. The changes of protolytic and complexing properties in the case of grafting of weak acids and phosphorus-containing complexons are due to their interactions with other surface groups and the influence of hydration effects in the near-surface layer.