Emulsification liquid phase microextraction followed by on-line phase separation coupled to high performance liquid chromatography

Arsenic speciation by using emerging sample preparation techniques: a review

Arsenic is a hazardous element that causes environmental pollution. Due to its toxicological effects, it is crucial to quantify and minimize the hazardous impact on the ecology. Despite the significant advances in analytical techniques, sample preparation is still crucial for determining target analytes in complex matrices. Several factors affect the direct analysis, such as trace-level analysis, advanced regulatory requirements, complexity of sample matrices, and incompatible with analytical instrumentation. Along with the development in the sample preparation process, microextraction methods play an essential role in the sample preparation process. Microextraction techniques (METs) are the newest green approach that replaces traditional sample preparation and preconcentration methods. METs have minimized the limitation of conventional sample preparation methods while keeping all their benefits. METs improve extraction efficacy, are fast, automated, use less amount of solvents, and are suitable for the environment. Microextraction techniques with less solvent consumption, such as solid phase microextraction (SPME) solvent-free methods, and liquid phase microextraction (LPME), are widely used in modern analytical procedures. SPME development focuses on synthesizing new sorbents and applying online sample preparation, whereas LPME research investigates the utilization of new solvents.

Strategies to improve the challenges of classic dispersive liquid-liquid microextraction for determination of the parabens in personal care products-One step closer to green analytical chemistry

Gas flow-assisted dispersive liquid-phase microextraction based on deep eutectic solvent was used to determine parabens in personal care products such as mouthwash, lidocaine gel, aloe vera gel, and skin tonic. A homemade extraction device was innovated, in which by passing the stream of gas bubbles through the deep eutectic solvent a thin layer of the extraction phase is coated on the surface of the bubbles. The extraction is finally achieved when the bubbles are going up through the sample. The single-factor experiments and response surface methodology were applied to optimize the independent variables. The linear range of the method was 0.5 to 1000 µg L^-1, the coefficient of determination for the goal analytes was higher than 0.9989, the instrumental limit of detections were in the range 0.2-0.3 μg L^-1, and the instrumental limit of quantifications were in the range 0.5-1.1 μg L^-1, the relative standard deviations were <5.2% for repeatability and <11.2% for intermediate precision, and the enrichment factors were 66 to 87 obtained under the optimized conditions. A spiking approach by means of standard material was used to estimate accuracy. The relative recoveries were in the range 95.8-105.2%. By using mentioned strategies, the organic waste and energy consumption reduced, toxic reagents replaced with safer ones, and operator safety enhanced. Accordingly, these benefits have been simultaneously attained and, the proposed method was one step closer to automation and sustainable analytical chemistry.

Persistence of the parabens in soil and their potential toxicity to earthworms

Due to their antimicrobial activity, parabens are commonly used as preservatives in a variety of consumer goods including cosmetics, pharmaceuticals, and personal care products. During the production, usage and disposal of these products, parabens are released into the environment. In this study, the persistence of three widely used parabens; methyl-, propyl-, and butyl paraben in soil and their toxic effects on the soil invertebrate, Eisenia fetida was investigated. The results of this study indicate that selected parabens do not negatively affect the survival, growth, and reproduction of Eisenia fetida up to 1000 mg Kg^-1 concentration. Further, these parabens (0-1000 mg Kg^-1) exhibited a low persistence in soil with more than 90 % disappearing within three days. In contrast, only 16-54 % degradation of parabens occurred in frozen soil suggesting a microbial role in parabens degradation. This study demonstrates that methyl-, propyl-, and butyl parabens degrade rapidly in the terrestrial environment and therefore, are unlikely to pose a threat to species such as Eisenia fetida. To our knowledge, this is the first report on the toxicity of parabens to earthworms.

Cetyl-alcohol-reinforced hollow fiber solid/liquid-phase microextraction and HPLC-DAD analysis of ezetimibe and simvastatin in human plasma and urine

A new cetyl-alcohol-reinforced hollow fiber solid/liquid-phase microextraction (CA-HF-SLPME) followed by high-performance liquid chromatography-diode array detection (HPLC-DAD) method was developed for simultaneous determination of ezetimibe and simvastatin in human plasma and urine samples. To prepare the CA-HF-SLPME device, the cetyl-alcohol was immobilized into the pores of a 2.5 cm hollow fiber micro-tube and the lumen of the micro-tube was filled with 1-octanol with the two ends sealed. Afterwards, the prepared device was introduced into 10 mL of the sample solution containing the analytes with agitation. Under optimized conditions, calibration curves plotted in spiked plasma and urine samples were linear in the ranges of 0.363-25/0.49-25 μg L^-1 for ezetimibe/simvastatin and 0.193-25/0.312-25 μg L^-1 for ezetimibe/simvastatin in plasma and urine samples, respectively. The limit of detection was 0.109/0.174 μg L^-1 for ezetimibe/simvastatin in plasma and 0.058/0.093 μg L^-1 for ezetimibe/simvastatin in urine. As a potential application, the proposed method was applied to determine the concentration of selected analytes in patient plasma and urine samples after medication and satisfactory results were achieved. In comparison with reference methods, the CA-HF-SLPME-HPLC-DAD method demonstrates considerable potential in the biopharmaceutical analysis of selected drugs.

In-Syringe Micro Solid-Phase Extraction Method for the Separation and Preconcentration of Parabens in Environmental Water Samples

In this study, a simple, rapid and effective in-syringe micro-solid phase extraction (MSPE) method was developed for the separation and preconcetration of parabens (methyl, ethyl, propyl and butyl paraben) in environmental water samples. The parabens were determined and quantified using high performance liquid chromatography and a photo diode array detector (HPLC-PDA). Chitosan-coated activated carbon (CAC) was used as the sorbent in the in-syringe MSPE device. A response surface methodology based on central composite design was used for the optimization of factors (eluent solvent type, eluent volume, number of elution cycles, sample volume, sample pH) affecting the extraction efficiency of the preconcentration procedure. The adsorbent used displayed excellent absorption performance and the adsorption capacity ranged from 227–256 mg g⁻¹. Under the optimal conditions the dynamic linear ranges for the parabens were between 0.04 and 380 µg L⁻¹. The limits of detection and quantification ranged from 6–15 ng L⁻¹ and 20–50 ng L⁻¹, respectively. The intraday (repeatability) and interday (reproducibility) precisions expressed as relative standard deviations (%RSD) were below 5%. Furthermore, the in-syringe MSPE/HPLC procedure was validated using spiked wastewater and tap water samples and the recoveries ranged between from 96.7 to 107%. In conclusion, CAC based in-syringe MSPE method demonstrated great potential for preconcentration of parabens in complex environmental water.

Extraction and determination of sulfonylurea herbicides in water and soil samples by using ultrasound-assisted surfactant-enhanced emulsification microextraction and analysis by high-performance liquid chromatography

An ultrasound-assisted surfactant-enhanced emulsification microextraction (UASEME) with low-density extraction solvents was developed for the extraction of sulfonylurea herbicides from water and soil samples prior to high-performance liquid chromatography coupled with ultraviolet detection (HPLC-UV). In this technique, a surfactant was used as emulsifier which could enhance the dispersion of water-immiscible extraction solvent into aqueous phase and was favorable for the mass-transfer of the analytes from aqueous phase to organic phase. The target analytes were extracted into an extraction phase (Aliquat-336 in 1-octanol) and dispersed in an aqueous solution. After extraction and phase separation, the organic solvent on top of the solution was withdrawn into a syringe and 20 µL of it was injected into a HPLC instrument for analysis. Influential factors in extraction were investigated and optimized. Under optimum experimental conditions, calibration curve was linear in the concentration range from 1 to 100 µg/L, with coefficients of estimation (R(2) values) varying from 0.9928 to 0.9952, and satisfactory repeatabilities (4.7<RSDs%<6.1) were attained. High preconcentration factors were achieved ranging from 103 to 153. Applicability of the method to the extraction of sulfonylurea herbicides from different types of complicated matrices, such as water and soil samples, was studied. The obtained results indicated that the proposed method is efficient, fast and inexpensive for extraction and determination of sulfonylurea herbicides in environmental aqueous and soil samples.

A sensitive emulsification liquid phase microextraction coupled with on-line phase separation followed by HPLC for trace determination of sulfonamides in water samples

For the first time, ion-pair based emulsification liquid phase microextraction coupled with a novel approach for phase separation followed by high performace liquid chromatgraphy (HPLC) was utilized for trace determination of sulfonamides in water samples. After the formation of ion-pair complex with a cationic surfactant, sulfonamides were extracted into the drops of dispersed organic extracting solvent. Then, the cloudy solution was passed through an in-line filter located in a suitable holder and was separated based on emulsion filtration. By changing the HPLC valve position, the filter was laid in the mobile phase path, and the extraction phase was eluted by the mobile phase and introduced into the separation column for analysis. The effects of important parameters, such as type of extraction solvent, type of ion-pair agent and its concentration, pH of sample solution, ionic strength, and volume of extraction phase, on the extraction efficiency, were investigated and optimized. Under optimal conditions, the linear range, limits of detection, and precision (relative standard deviations) were 0.3-100, 0.1-0.3 μg L(-1), and 4.7-5.8%, respectively. Preconcentration factors (PFs) for the compounds studied were obtained in the range of 268-664. These PFs correspond to extraction recoveries in the range of 41-97%. The sample throughput of the method was 3 samples per hour, regarding 20 min analysis time for a single procedure. Finally, the method was successfully applied to determine the selected sulfonamides in some water samples.