Antimicrobial activities of polyethylene glycol and citric acid coated graphene oxide-NPs synthesized via Hummer’s method

Investigation of antibacterial and anticancer activities of copper, aluminum and nickel doped zinc sulfide nanoparticles

First time compared the different metals doped ZnS nanoparticles for antibacterial and liver cancer cell line. In this study, copper, aluminum and nickel doped ZnS NPs were synthesized via co-precipitation method. The XRD analysis was confirmed the presence of cubic crystal structure and crystallite size decreased from 6 to 3 nm with doping elements. While as SEM micro-grains were revealed slightly irregular and agglomerated morphology with the presence of dopant elements. The presence of different dopant elements such as Cu, Al and Ni in ZnS NPs was identified via EDX analysis. The FTIR results demonstrate various vibrational stretching and bending modes attached to the surface of ZnS nanomaterials. After that the well diffusion method was used to conduct in-vitro bioassays for evaluation of antibacterial and anticancer activities against E.coli and B.cereus, as well as HepG2 liver cancer cell line. Our findings unveil exceptional results with maximum inhibition zone of approximately 9 to 23 mm observed against E.coli and 12 to 27 mm against B.cereus, respectively. In addition, the significant reduction in cell viability was achieved against the HepG2 liver cancer cell line. These favorable results highlight the potential of Ni doped ZnS NPs for various biomedical applications. In future, the doped ZnS nanomaterials will be suitable for hyperthermia therapy and wound healing process.

Fabrication of Zinc Doped Titanium Dioxide Nanoparticles to Inhibit Escherichia coli Growth and Proliferation of Liver Cancer Cells (HepG2)

The current research is related to the synthesis of different concentrations (0, 3, and 7 wt %) Zn doped TiO2-NPs by using the coprecipitation method. The rutile, anatase crystal structure appeared on different diffracted peaks in TiO2-NPs, and the crystallite size (12 to 24 nm) was calculated by using XRD analysis. The spherical, irregular, porous grain-like surface morphology was observed by SEM analysis, and the identification of different functional modes such as hydroxyl, -C-O, -C-O-C, and Ti-O-Ti attached on the surface of the spectrum was examined via FTIR analysis. After that, the increased absorbance of TiO2-NPs by increasing the Zn concentration in TiO2-NPs was observed by UV-visible analysis. After that, the well diffusion method was performed to measure antibacterial activity, and the MTT assay was used to investigate anticancer activity against the HepG2 cell line. It was observed that the inhibition zone of S. aureus and E. coli increased by increasing the concentration of Zn-doped TiO2-NPs from 2 to 32 mm. The 7 wt % Zn-doped TiO2-NPs provided significant anticancer activity against the liver cancer cell line and antibacterial activity. In the future, Zn doped TiO2-NPs can be used for in vitro analysis against different microbial and animal models for the treatment of cancer.

Synergistic Effect of Polyethylene Glycol and Lactic Acid on Handling Properties and Antibacterial Efficacy of Premixed Calcium Silicate Cement

Calcium silicate (CaSi) bone cement with antibacterial and osteogenic properties has attracted significant interest. However, there is a need to develop a variety of new premixed bone cement to meet the clinical requirements of fast setting time, ease of handling, and efficient antibacterial properties. In this study, different volume ratios of polyethylene glycol (PEG) and lactic acid liquids were added to calcium silicate, and the effects of varying liquid-to-powder ratios (L/P) were examined. This study assessed the physicochemical properties, cytotoxicity, and antibacterial activity against S. aureus and E. coli of this premixed cement. The results from the experiments indicated that lactic acid significantly reduced the setting time of the CaSi-based cement and enhanced its mechanical strength. Furthermore, the appropriate concentration of lactic acid and matching L/P ratio improved its washout resistance. The cell viability of all premixed cement was found to be over 80%. The premixed cement containing PEG and lactic acid exhibited superior antibacterial properties compared to the CaSi control. Based on its setting time, washout resistance, and antibacterial activity, a premixed cement with a liquid phase of 80% PEG and 20% lactic acid at an L/P ratio of 0.4 appeared promising for use in dental and orthopedic practice.

Biochar with enhanced performance prepared based on "graphite-structure regulation" conjecture designed to effectively control water pollution

In this work, corn straw was used as raw material, Hummers method and activation were used to adjust the graphite structure in biochar, and preparing straw based biochar (H-BCS) with ultra-high specific surface area (3441.80 m2/g), highly total pore volume (1.9859 cm3/g), and further enhanced physicochemical properties. Compared with untreated straw biochar (BCS), the specific surface area and total pore volume of H-BCS were increased by 47.24 % and 55.85 %, respectively. H-BCS showed good removal ability in subsequent experiments by using chloramphenicol (CP), hexavalent chromium (Cr6+), and crystal violet (CV) as adsorption models. In addition, the adsorption capacities of H-BCS (CP: 1396.30 mg/g, Cr6+: 218.40 mg/g, and CV: 1246.24 mg/g) are not only higher than most adsorbents, even after undergoing 5 cycles of regeneration, its adsorption capacity remains above 80 %, indicating significant potential for practical applications. In addition, we also speculated and analyzed the conjecture about the "graphite-structure regulation" during the preparation process, and finally discussed the possible mechanism during the adsorption processes. We hope this work could provide a new strategy to solve the restriction of biochar performance by further exploring the regulation of graphite structure in carbon materials.

The role of reduced graphene oxide on mitigation of lead phytotoxicity in Triticum aestivum L.plants at morphological and physiological levels

Rapid global industrialization and an increase in population have enhanced the risk of heavy metals accumulation in plant bodies to disrupt the morphological, biochemical, and physiological processes of plants. To cope with this situation, reduced graphene oxide (rGO) NPs were used first time to mitigate abiotic stresses caused in plant. In this study, rGO NPs were synthesized and reduced with Tecoma stans plant leave extract through modified Hummer's methods. The well prepared rGO NPs were characterized by ultra-violet visible spectroscopy (UV-Vis), Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), Zeta potential, and scanning electron microscopy (SEM). However, pot experiment was conducted with four different concentrations (15, 30, 60, 120 mg/L) of rGO NPs and three different concentrations (300, 500,700 mg/L) of lead (Pb) stress were applied. To observe the mitigative effects of rGO NPs, 30 mg/L of rGO NPs and 700 mg/L of Pb were used in combination. Changes in morphological and biochemical characteristics of wheat plants were observed for both Pb stress and rGO NPs treatments. Pb was found to inhibit the morphological and biochemical characteristics of plants. rGO NPs alone as well as in combination with Pb was found to increase the chlorophyll content of wheat plants. Under Pb stress conditions and rGO NPs treatments, antioxidant enzyme activities like ascorbate peroxidases (APX), superoxide dismutase (SOD), peroxidase (POD) and catalase (CAT) were observed. Current findings revealed that greenly reduced graphene oxide NPs can effectively promote growth in wheat plants under Pb stress by elevating chlorophyll content of leaves, reducing the Pb uptake, and suppressing ROS produced due to Pb toxicity.

Photochemical-promoted ZVI reduction for highly efficient removal of 4-chlorophenol and Cr(VI): Catalytic activity, performance and electron transfer mechanisms

Zero-valent iron (ZVI) reduction represents a promising methodology for water remediation, but its broad application is limited by two critical challenges (i.e., aggregation and passivation). Here, we report a hybrid strategy of photochemical-promoted ZVI reduction with high efficiency and reduction capacity for removing coexisting refractory pollutants in water. A composite material with Pd/Fe bimetallic nanoparticles supported onto semiconducting metal oxide (Pd/Fe@WO3-GO) was prepared and subsequently used as the model catalyst. By using the developed strategy with visible light as light source, this catalyst showed a remarkable catalytic performance for simultaneously eliminating 4-chlorophenol (4-CP) and Cr(VI), with dehalogenation rate as high as 0.43 min-1, outperforming the reported ZVI-based catalysts. A synergistic interaction of photocatalysis and ZVI reduction occurred in this strategy, where the interfacial electron transfer on particles surface were greatly strengthened with light irradiation. The activation was attributed to the dual functions of semiconducting material as support to disperse Pd/Fe nanoparticles and as (photoexcited) electron donor to directly trigger reduction reactions and/or indirectly inhibit the formation of oxides passivation layer. Both direct electron transfer and H*-mediated indirect electron transfer mechanisms were confirmed to participate in the reduction of pollutants, while the later was quantitatively demonstrated as the predominant reaction route. Importantly, this strategy showed a wide pH applicability, long-term durability and excellent catalytic performance in different real-water systems. This work provides new insights into ZVI reduction and advances its applications for the removal of combined organic and inorganic pollutants. The developed photochemical-promoted ZVI reduction strategy holds a great potential for practical applications.

Synthesis and characterization of a novel magnetic chitosan-nickel ferrite nanocomposite for antibacterial and antioxidant properties

A novel nanomagnet modified with nickel ferrite nanoparticles (NPs) coated with hybrid chitosan (Cs-NiFe2O4) was synthesized using the co-precipitation method. The resulting nanomagnets were characterized using various techniques. The size of the nanomagnetic particles was estimated to be about 40 nm based on the transmission electron microscopy (TEM) image and X-ray diffraction analysis (XRD) pattern (using the Debye-Scherrer equation). Scanning electron microscopy (SEM) images indicated that the surface of Cs-NiFe2O4 NPs is flatter and smoother than the uncoated NiFe2O4 NPs. According to value stream mapping (VSM) analysis, the magnetization value of Cs-NiFe2O4 NPs (17.34 emu/g) was significantly lower than NiFe2O4 NPs (40.67 emu/g). The Cs-NiFe2O4 NPs indicated higher antibacterial properties than NiFe2O4 NPs and Cs. The minimum inhibitory concentrations of Cs-NiFe2O4 NPs against S. aureus and E. coli were 128 and 256 mg/mL, respectively. Antioxidant activity (evaluated by 2,2-diphenyl-1-picrylhydrazyl (DPPH) scavenging test) for NiFe2O4 NPs and Cs-NiFe2O4 NPs at the concentration of 100 µg/mL were 35% and 42%, respectively. Consequently, the synthesized Cs-NiFe2O4 NPs can be proposed as a viable material for biomedical applications.

Polyethylene glycol and chitosan functionalized manganese oxide nanoparticles for antimicrobial and anticancer activities

Biocompatible polymer-functionalized magnetic nanoparticles could offer promising applications in biomedical sciences. We fabricated polymer functionalized tri-manganese tetra oxide (Mn₃O₄) nanoparticles with the co-precipitation method and an octahedral crystal structure having a crystallite size of 10-17 nm was identified via XRD analyses. The SEM graph depicted the non-uniform and smooth surface of PEG-functionalized Mn₃O₄ NPs as compared to Mn₃O₄ and chitosan-coated Mn₃O₄ NPs. Elemental composition in the prepared sample was examined by EDX analysis. Various modes such as MnO, MnOH, OH, symmetric, and anti-symmetric of CH₂ attached to the spectrum of Mn₃O₄ NPs were observed with FTIR analysis. The magnetization factor decreased and increase the coreacivity and retentivity of surface functionalized Mn₃O₄-NPs was calculated via VSM analysis. In-vitro bioassay, antibacterial activity was tested against Escherichiacoli, Bacillus cereus, and anti-fungal activities against two Fusarium strains indicated clear antimicrobial activities. The MTT assay to examine the anticancer activity against the MCF-7 cancer cell line was performed and the T₁ MRI contrast agent demonstrated that PEG-coated Mn₃O₄ NPs exhibited anti-cancer activities. We propose that surface-functionalized magnetic NPs used for the treatment of cancer by using a remote controlled process of hyperthermia therapy.