Amidolytic, procoagulant, and activation-suppressing proteins produced by contact activation of blood factor XII in buffer solution

FXII contact activation products have an inhibitory effect on αFXIIa

It is accepted that the contact activation complex of the intrinsic pathway of blood coagulation cascade produces active enzymes that lead to plasma coagulation following biomaterial contact. In this study, FXII was activated through contact with hydrophilic glass beads and hydrophobic octadecyltrichlorosilane-modified glass beads from neat buffer solutions. These FXII contact activation products generated from material interaction were found to suppress the procoagulant activity of exogenous αFXIIa, and this inhibition was dependent on surface wettability and the concentration of exogenous αFXIIa. Higher relative inhibition rates were generally observed at low concentrations of αFXIIa (1-2 μg/mL) while both hydrophobic and hydrophilic materials showed similar inhibition levels (~39%) at high concentrations of αFXIIa (20 μg/mL). The presence of prekallikrein in the activation system increased the amount of FXIIa produced during FXII contact activation, and also suppressed the apparent levels of inhibitors on hydrophilic surfaces, while having no effect on apparent levels of inhibitors on hydrophobic surface. The combination of FXII contact activation products and activator surfaces was found to dramatically increase inhibition of αFXIIa activity compared to the activation products alone, regardless of activator surface wettability and the presence of prekallikrein. This finding of inhibitors in the suite of proteins generated by contact activation provides additional knowledge into the complex series of interactions that occur when plasma comes into contact with material surfaces.

Preparation and blood compatibility of polyethersulfone dialysis membrane modified by apixaban as coagulation factor Xa inhibitor

Blood purification therapy is widely used in the treatment of critically ill patients. However, most dialysis membranes are prone to thrombosis. Activated coagulation factor X (FXa) functions at the intersection of intrinsic, extrinsic, and common coagulation pathways and plays a central role in thrombogenesis. To date, few dialysis membranes that directly inhibit FXa have been reported. We modified a polyethersulfone(PES) membrane using apixaban as an FXa inhibitor and investigated the performance of this membrane (AMPES). The contact angle of the modified membrane was reduced. PWF and retention rates of BSA were increased, demonstrating good hydrophilicity and dialysis performance. Albumin adsorption was reduced from 141.8 ± 15.5 to 114.1 ± 6.9 μg cm^-2. Reduced protein adsorption, especially targeted anti-FXa effect, inhibited the activation of intrinsic, extrinsic, and common coagulation pathways, as evidenced by significant prolongations of activated partial thromboplastin time, prothrombin time, and thrombin time by 145.04, 46.84 and 11.46 s, respectively. Furthermore, we determined the FXa concentration of each group, and found that the modified membrane had better anticoagulant performance through the inhibition of FXa. Favorable antiplatelet activity was also demonstrated. Thromboelastogram was used to comprehensively evaluate the anticoagulant and antithrombotic activities of the modified membrane. The R value was increased by 43.1 min, while the reduction in α angle was 42.5°. The coagulation comprehensive index reduction was 34.3. In addition, C3a and C5a were decreased by 15.3 % and 30.4 %, respectively. Furthermore, in vitro cytotoxicity and erythrocyte stability testing as well as in vivo murine experiments demonstrated the biosafety of the modified membrane. These results indicate that the AMPES dialysis membrane has an excellent potential for clinical applications.

Effects of diameters and crystals of titanium dioxide nanotube arrays on blood compatibility and endothelial cell behaviors

Titanium dioxide nanotube arrays (TNTAs) have attracted extensive attention in the fields of biomaterials and biomedicine due to their unique tubular structure and good biocompatibility. In this paper, TNTAs with different nanotube diameters and lengths were in situ prepared on the titanium surface by the anodic oxidation, and their crystal structures were further changed by annealing treatment. The effects of TNTAs with different diameters and crystals on the blood compatibility and endothelial cell behaviors were investigated. The results showed that TNTAs with the diameter of 30∼90 nm can be obtained by controlling the anodization voltage, and annealing treatment did not obviously change the diameters and lengths of the nanotube arrays. However, annealing treatment can transform the amorphous TNTAs into the anatase structure. The diameter and crystal structure of the nanotube arrays played a key role in the surface wettability and protein adsorption. The nanotube array with larger diameter displayed better surface hydrophilicity as compared to the pristine titanium, and annealing treatment further enhanced the hydrophilicity. As compared to the pristine titanium, the nanotube array structure had the characteristic of selective protein adsorption, and the nanotube array can promote the bovine serum albumin (BSA) adsorption and prevent the fibrinogen (FIB) adsorption, however, the increase of nanotube diameter could reduce BSA adsorption and increase FIB adsorption. Besides, the nanotube array with anatase structure can promote BSA adsorption while reduce FIB adsorption. Therefore, the TNTAs with smaller diameter and anatase crystal had good blood compatibility and cell compatibility, they can not only reduce platelet adhesion and hemolysis rate but also increase endothelial cell adhesion and proliferation. In conclusion, the nanotube arrays of the present study can be used to improve the cell compatibility and blood compatibility of the titanium implants.

Design, synthesis, and biomedical applications of synthetic sulphated polysaccharides

This review summarizes the synthetic methods to sulphated polysaccharides, describes their compositional and structural diversity in regards to activity, and showcases their biomedical applications.

Surface dependent contact activation of factor XII and blood plasma coagulation induced by mixed thiol surfaces

Studies of the activation of FXII in both platelet poor plasma and in neat buffer solutions were undertaken for a series of mixed thiol self-assembled monolayers spanning a broad range of water wettability. A wide spectrum of carboxyl/methyl-, hydroxyl/methyl-, and amine/methyl-thiol modified surfaces were prepared, characterized, and then utilized as the procoagulant materials in a series of FXII activation studies. X-ray photoelectron spectroscopy was utilized to verify the sample surface's thiol composition and contact angles measured to determine the sample surface's wettability. These samples were then used in in vitro coagulation assays using a 50% mixture of recalcified plasma in phosphate buffered saline. Alternatively, the samples were placed into purified FXII solutions for 30 min to assess FXII activation in neat buffer solution. Plasma coagulation studies supported a strong role for anionic surfaces in contact activation, in line with the traditional models of coagulation, while the activation results in neat buffer solution demonstrated that FXIIa production is related to surface wettability with minimum levels of enzyme activation observed at midrange wettabilities, and no statistically distinguishable differences in FXII activation seen between highly wettable and highly nonwettable surfaces. Results demonstrated that the composition of the solution and the surface properties of the material all contribute to the observation of contact activation, and the activation of FXII is not specific to anionic surfaces as has been long believed.

Effect of construction of TiO2 nanotubes on platelet behaviors: Structure-property relationships

Blood compatibility of TiO₂ nanotubes (TNTs) has been assessed in rabbit platelet-rich plasma (PRP), which combines activation of both blood plasma coagulation and platelets. We find that (i) amorphous TiO₂ nanotubes (TNTs) with relatively larger outer diameters led to reduced platelet adhesion/activation, (ii) TNTs with relatively smaller outer diameters in a predominately rutile phase also inhibited platelet adhesion and activation, and (iii) a pervasive fibrin network formed on larger outer diameter TNTs in a predominately anatase phase. Thus, this study suggests that combined effect of crystalline phase and surface chemistry controls blood-contact behavior of TNTs. A more comprehensive mechanism is proposed for understanding hemocompatibility of TiO₂ which might prove helpful as a guide to prospective design of TiO₂-based biomaterials.

STATEMENT OF SIGNIFICANCE

To realize optimal design and construction of biomaterials with desired properties for blood contact materials, a comprehensive understanding of structure-property relationships is required. In the existing literature, TiO₂ nanotube has been reported to be a good candidate for biomedical applications. However, it is noticeable that the blood compatibility of TiO₂ nanotubes (TNTs) remains obscure or even inconsistent in the previously published works. The inconsistency could derive from different research protocols, material properties or blood sources. Thus, a thorough investigation of the effect of surface properties on blood compatibility is crucial to the development of titanium based materials. In this paper, we explored the effect of surface properties on the response of platelet-rich plasma, especially surface morphology, chemistry, wettability and crystalline phase. The results indicated that crystalline phase was a dominant factor in platelet behaviors. Reduced adhesion and activation of platelets were observed on amorphous and rutile dominated TNTs, whereas anatase dominated TNTs activated the formation of fibrin network. We further proposed a hypothetical mechanism for better understanding of how surface properties affect the response of platelet-rich plasma. Therefore, this study expands the fundamental understanding of the structure-property relationships of titanium based materials.

A comparison of blood factor XII autoactivation in buffer, protein cocktail, serum, and plasma solutions

Activation of blood plasma coagulation in vitro by contact with material surfaces is demonstrably dependent on plasma-volume-to-activator-surface-area ratio. The only plausible explanation consistent with current understanding of coagulation-cascade biochemistry is that procoagulant stimulus arising from the activation complex of the intrinsic pathway is dependent on activator surface area. And yet, it is herein shown that activation of the blood zymogen factor XII (Hageman factor, FXII) dissolved in buffer, protein cocktail, heat-denatured serum, and FXI deficient plasma does not exhibit activator surface-area dependence. Instead, a highly-variable burst of procoagulant-enzyme yield is measured that exhibits no measurable kinetics, sensitivity to mixing, or solution-temperature dependence. Thus, FXII activation in both buffer and protein-containing solutions does not exhibit characteristics of a biochemical reaction but rather appears to be a "mechanochemical" reaction induced by FXII molecule interactions with hydrophilic activator particles that do not formally adsorb blood proteins from solution. Results of this study strongly suggest that activator surface-area dependence observed in contact activation of plasma coagulation does not solely arise at the FXII activation step of the intrinsic pathway.