Nitrogen modulation under chemostat cultivation mode induces biomass and lipid production by Chlorella vulgaris and reduces antenna pigment accumulation

Potential of algal oil production from secondary treated sewage: a study using Chlorella vulgaris and synthetic wastewater

To assess the potential of using the secondary treated wastewater for the production of algal biofuel, batch experiments were carried out in photobioreactors using indigenous Chlorella vulgaris isolated from the natural freshwater body. Secondary treated wastewater with partial nitrification was simulated using various proportions of NO3-N and NH4-N while keeping the total nitrogen the same. Experiments with similar concentrations of nitrate without the NH4-N were used for comparison. In the presence of only NO3-N in the concentration range of 9-37 mg/L, the growth and fatty acid methyl ester (FAME) production was similar to the literature reports. When NH4-N was present along with NO3-N, the biomass growth was adversely affected, indicating an impact on the metabolic activity. For the same initial concentrations of nitrate in the culture, the maximum biomass concentration was reduced by 50-60% in the presence of NH4-N. The FAME profile changed significantly and a new FAME was identified, suggesting an impact on the lipid synthesis pathway. Comparison and analysis with the help of existing literature indicated that the adverse effect due to NH4-N was a function of pH. The growth, biomass yield, and FAME production were unaffected by a wide range of phosphorus concentrations. Maximum fatty acid methyl ester (FAME) suitable for biodiesel production (fatty acid carbon chain length C16 to C18) was 381.01 mg/L (224.58 mg/g of dry biomass), produced at NO3-N concentration of 18.5 mg/L and initial nitrogen loading per unit biomass of 0.37 g NO3-N/g of dry biomass.

Numerical simulation of vortex flow field generated in a novel nested-bottled photobioreactor to improve Arthrospira platensis growth

In this study, computational fluid dynamics were employed to examined clockwise and anticlockwise vortexes in the rising and down coming sections of novel nested-bottle photobioreactor. The radial velocity was increased by four times which significantly reduced dead zones compared to traditional PBR. The (NB-PBR) comprised of integrated bottles connected by curved tubes (d = 4 cm) that generated dominant vortices as the microalgae solution flows through each section (h = 10 cm). The (NB-PBR) was independent of the inner and outer sections which increased the mixing time and mass-transfer coefficient by 13.33 % and 42.9 %, respectively. Furthermore, the results indicated that the (NB-PBR) showed higher photosynthesis efficiency preventing self-shading and photo-inhibition, resulting in an increase in biomass yield and carbon dioxide fixation by 35 % and 35.9 %, respectively.

Integrating FTIR 2D correlation analyses, regular and omics analyses studies on the interaction and algal toxicity mechanisms between graphene oxide and cadmium

Graphene oxide (GO, a popular 2D graphene-based nanomaterial) has developed quickly and has received considerable attention for its applications in environmental protection and pollutant removal. However, significant knowledge gaps still exist about the interaction characteristic and joint toxicity mechanism of GO and cadmium (Cd) on aquatic organisms. In this study, GO showed a high adsorption capacity (120. 6 mg/g) and strong adsorption affinity (K_L = 0.85 L/mg) for Cd²⁺. Integrating multiple analytical methods (e.g., electron microscopy, Raman spectra, and 2D correlation spectroscopy) revealed that Cd²⁺ is uniformly adsorbed on the GO surface and edge mainly through cation-π interactions. The combined ecological effects of GO and Cd²⁺ on Chlorella vulgaris were observed. Cd²⁺ induced more severe growth inhibition, photosynthesis toxicity, ultrastructure damage and plasmolysis than GO. Interestingly, we found that GO nanosheets could augment the algal toxicity of Cd²⁺ (e.g., chlorophyll b, mitochondrial membrane damage, and uptake). Transcriptomics and metabolomics further explained the underlying mechanism. The results indicated that the regulation of PSI-, PSII-, and metal transport-related genes (e.g., ABCG37 and ZIP4) and the inhibition of metabolic pathways (e.g., amino acid, fatty acid, and carbohydrate metabolism) were responsible for the persistent phytotoxicity. The present work provides mechanistic insights into the roles of coexisting inorganic pollutants on the environmental fate and risk of GO in aquatic ecosystems.

A novel strategy to simultaneously enhance bioaccessible lipids and antioxidants in hetero/mixotrophic Chlorella vulgaris as functional ingredient

Microalgae are a promising source of polyunsaturated fatty acids as well as bioactive antioxidant compounds such as carotenoids, phenolics and tocopherols. However, the accumulation of these biomolecules is often promoted by conflicting growth conditions. In this study, a phased bioprocessing strategy was developed to simultaneously enhance the lipid and antioxidant amounts by tailoring nitrogen content in the cultivation medium and applying light stress. This approach increased the overall contents of total fatty acids, carotenoids, phenolics, and α-tocopherol in Chlorella vulgaris by 2.2-, 2.2-, 1.5-, and 2.1-fold, respectively. Additionally, the bioaccessibility of the lipids and bioactives from the obtained biomasses improved after pulsed electric field (5 μs, 20 kV cm^-1, 31.8 kJ kg^-1_sus) treatment (up to +12%) and high-pressure homogenization (100 MPa, 5-6 passes) (+41-76%). This work represents a step towards the generation of more efficient algae biorefineries, thus expanding the alternative resources available for essential nutrients.

Kinetic modelling of microalgal growth and fucoxanthin synthesis in photobioreactor

This paper presented a mathematical model to describe the production of fucoxanthin by alga Thalassiosira weissflogi ND-8 in photobioreactor. Our interest was focused on characterizing the effects of nitrogen and phosphorus on the growth of microalgae and on the synthesis of fucoxanthin. The rate equations of microalgal growth, fucoxanthin synthesis and substrate consumptions were formulated. Kinetic parameters of the model and their sensitivities with respect to model output were estimated. The predicted results were compared with experimental data, which showed that this model closely agrees with actual experiment and is able to reflect the growth and metabolism characteristics of microalgae. Our results also indicated that nitrogen plays a major role in the synthesis of fucoxanthin, and the synthesis of fucoxanthin is partially linearly related to the consumption of nitrogen. Phosphorus is primarily consumed in the growth and metabolism of microalgal cells, while excessive phosphorus concentration has an inhibitory effect on the growth of microalgae.

Development of a single helical baffle to increase CO2 gas and microalgal solution mixing and Chlorella PY-ZU1 biomass yield

A single helical baffle (SHB), consisting of twisted turns, was developed to convert straight flow into spiral flow in a Chlorella PY-ZU1 open raceway pond (ORWP) bubbled with 15% CO₂. Microalgal solution flowing through the SHB alternative helical interspaces generated whirling flow both vertically and horizontally, which decreased mixing and increased mass transfer rates. The optimized SHB had a pitch length to total SHB length ratio of 0.13 and SHB diameter to ORWP single channel width ratio of 0.30, which decreased mixing times and increased mass transfer coefficients by 41.1% and 38.4% respectively. SHB moved Chlorella PY-ZU1 from the ORWP bottom to the top, increasing light exposure for photosynthesis. Cellular electron transfer rates and photochemical efficiency (φPSII) increased by 18%, chlorophyll a content increased by 16% and variable to maximum fluorescence ratio increased by 13%. The microalgal biomass of SHB ORWP was 23% higher than that of conventional ORWP.

Biphasic optimization approach for maximization of lipid production by the microalga Chlorella pyrenoidosa

The aim of the study was to identify the optimum cultivation conditions for the microalgal growth and lipid production of the oleaginous microalga Chlorella pyrenoidosa Chick (IPPAS C2). Moreover, an appropriate NO₃^- concentration in the cultivation medium for maximized lipid accumulation was determined. The experimental design involved a biphasic cultivation strategy with an initial biomass accumulating phase under optimized light (400 μmol/m² per s), temperature (25 °C), and elevated CO₂ concentration in the air mixture (3%), followed by a mid-elevated CO₂ concentration (0.5%) for lipid induction. The highest lipid yields of 172.47 ± 18.1 and 179.65 ± 25.4 mg/L per day were detected for NO₃^- concentrations of 100 and 150 mg/L. The optimization approach presented here led not only to the maximization of lipid yield but also to the development of a biphasic cultivation strategy easily applicable to the cultivation process without the necessity for algal cell harvesting between the first and second cultivation phases.

Two-stage cultivation strategy for the improvement of pigment productivity from high-density heterotrophic algal cultures

Herein, a two-stage cultivation process was devised to overcome low pigment content of algal biomass grown in heterotrophy. Post-treatment conditions (i.e., light intensity, temperature, pH and salinity) were initially tested for dense heterotrophically-grown Chlorella sp. HS2 cultures in a multi-channel photobioreactor (mcPBR), and the results clearly indicated the influence of each abiotic factor on algal pigment production. Subsequently, the optimal post-treatment conditions (i.e., 455 μmol m^-2 s^-1, 34.8℃, pH 8.23 and 0.7% (w/v) salinity), in which highest accumulation of algal pigments is expected, were identified using Response Surface Methodology (RSM). Compared to the control cultures grown in mixotrophy for the same duration of entire two-stage process, the results indicated a significantly higher pigment productivity (i.e., 167.5 mg L^-1 day^-1) in a 5-L fermenter following the post-treatment at optimal conditions. Collectively, these results suggest that the post-treatment of heterotrophic cultures can be successfully deployed to harness the nascent algae-based bioeconomy.

Stabilizing lactate production through repeated batch fermentation of food waste and waste activated sludge

Bio-valorization of organic waste streams, such as food waste and waste activated sludge, to lactic acid (LA) has recently drawn much attention. It offers an opportunity for resource recovery, alleviates environmental issues and potentially turns a profit. In this study, both stable and high LA yield (0.72 ± 0.15 g/g total chemical oxygen demand) and productivity rate (0.53 g/L•h) were obtained through repeated batch fermentation. Moreover, stable solubilization and increase in the critical hydrolase activities were achieved. Depletions of ammonia and phosphorus were correlated with the LA production. The relative abundance of the key LA bacteria genera (i.e., Alkaliphilus, Dysgonomonas, Enterococcus and Bifidobacterium) stabilized in the repeated batch reactor at a higher level (44.5 ± 2.53%) in comparison with the batch reactor (26.2 ± 4.74%). This work show a practical way for the sustainable valorization of organic wastes to LA by applying the repeated batch mode during biological treatment.

Continuous 3-year outdoor operation of a flat-panel membrane photobioreactor to treat effluent from an anaerobic membrane bioreactor

A membrane photobioreactor (MPBR) plant was operated continuously for 3 years to evaluate the separate effects of different factors, including: biomass and hydraulic retention times (BRT, HRT), light path (Lp), nitrification rate (NOxR), nutrient loading rates (NLR, PLR) and others. The overall effect of all these parameters which influence MPBR performance had not previously been assessed. The multivariate projection approach chosen for this study provided a good description of the collected data and facilitated their visualisation and interpretation. Forty variables used to control and assess MPBR performance were evaluated during three years of continuous outdoor operation by means of principal component analysis (PCA) and partial least squares (PLS) analysis. The PCA identified the photobioreactor (PBR) light path as the factor with the largest influence on data variability. Other important factors were: nitrogen and phosphorus recovery rates (NRR, PRR), biomass productivity (BP), optical density of 680 nm (OD680), ammonium and phosphorus effluent concentration (NH₄, P), HRT, BRT, air flow rate (F_air) and nitrogen and phosphorus loading rates (NLR and PLR). The MPBR performance could be adequately estimated by a PLS model based on all the recorded variables, but this estimation worsened appreciably when only the controlled variables (Lp, F_air, HRT and BRT) were used as predictors, which underlines the importance of the non-controlled variables on MPBR performance. The microalgae cultivation process could thus only be partially controlled by the design and operating variables. A high nitrification rate was found to be inadvisable, since it showed an inverse correlation with NRR. In this respect, temperature and microalgae biomass concentration appeared to be the main factors to mitigate nitrifying bacteria activity.

Development of CRISPR/Cas9 system in Chlorella vulgaris FSP-E to enhance lipid accumulation

Microalgae biorefinery is an alternative, sustainable and promising trend to solve the problem of fossil oil depletion and carbon dioxide emission. However, considering the innate limitation of cell growth and oil content in microalgae, to accelerate metabolic balance by CRISPR/Cas9 system is attractive. At first, plasmid based from Agrobacterium tumefaciens and a fragment of mGFP was transformed into Chlorella sorokiniana and Chlorella vulgaris FSP-E by electroporation, respectively. Selected colonies were tested by spectrophotometer and inverted fluorescence microscopy (IFM), and an increase of fluorescent was observed by 67% compared with that in wild type, which proved the Agrobacterium-mediated plasmid is suitable for gene insertion in Chlorella species. Consequently, plasmid with similar structure as mentioned previously containing fragment of Cas9 with sgRNA designed on omega-3 fatty acid desaturase (fad3) gene was constructed and showed a higher accumulation of lipid content by 46% (w/w) in C. vulgaris FSP-E. This is first-time to use CRISPR/Cas9 based technology for gene manipulation in Chlorella.

Dynamic Interactions between Autophagosomes and Lipid Droplets in Chlamydomonas reinhardtii

Autophagy is a highly conserved catabolic process in eukaryotic cells by which waste cellular components are recycled to maintain growth in both favorable and stress conditions. Autophagy has been linked to lipid metabolism in microalgae; however, the mechanism underlying this interaction remains unclear. In this study, transgenic Chlamydomonas reinhardtii cells that stably express the red fluorescent protein (mCherry) tagged-ATG8 as an autophagy marker were established. By using this tool, we were able to follow the autophagy process in live microalgal cells under various conditions. Live-cell and transmission electron microscopy (TEM) imaging revealed physical contacts between lipid droplets and autophagic structures during the early stage of nitrogen starvation, while fusion of these two organelles was observed in prolonged nutritional deficiency, suggesting that an autophagy-related pathway might be involved in lipid droplet turnover in this alga. Our results thus shed light on the interplay between autophagy and lipid metabolism in C. reinhardtii, and this autophagy marker would be a valuable asset for further investigations on autophagic processes in microalgae.