Biomethanation at 45 °C offers high process efficiency and supports hygienisation

Meso- and thermophilic posttreatment of press water coming from a thermophilic municipal solid waste digester

An efficient biogas production out of organic (waste) materials is important to contribute to a carbon-neutral future. In this study, thermophilic press water (PW) coming from an organic fraction of the municipal solid waste digester was further digested in a thermo- and mesophilic posttreatment approach using two semicontinuous 14 L digesters. The results showed that the PW can still have considerable high biogas potential-at least during the touristic high season in central Europe. The change in temperature led to an increase in volatile fatty acid concentrations and a decrease in biogas production in the mesophilic approach in the first days. However, the losses in biogas production at the beginning could be compensated thus there were no considerable differences in biogas production between thermo- and mesophilic posttreatment at the end of incubation. This can most probably be contributed to a change in the microbial community, and potentially problematic intermediates like valerate could be better degraded in the mesophilic reactor. Especially the abundance of representatives of the phylum Bacteroidota, like Fermentimonas spp., increased during mesophilic anaerobic digestion.

Digesters as heat storage: Effects of the digester temperature on the process stability, sludge liquor quality, and the dewaterability

Variation of the digester temperature during the year enables the operation of digesters as seasonal heat storage contributing to a holistic heat management at water resource recovery facilities. Full- and lab-scale process data were conducted to examine the effect of the digester temperature on process stability, sludge liquor quality, and dewaterability. Both full- and lab-scale digesters show a stable anaerobic degradation process with a hydraulic retention time of more than 20 days and organic load rates up to 2.2-kg COD/(m3 ·day) at temperatures between 33 and 53°C. The concentrations of soluble COD and ammonium-nitrogen in the sludge liquor digested at 53°C are 2.6 to 5.8 times and 1.3 times higher, respectively, than in the sludge liquor digested at 37°C. Dewatering tests show an enhancement of the dewaterability but a clear increase in the polymer demand at increased digester temperature. PRACTITIONER POINTS: Digesters can operate as seasonal heat storage within mesophilic and thermophilic temperatures Stable anaerobic degradation process for HRT above 20 days Maintenance of process stability as well as quantity and quality of biogas Increase of soluble COD in sludge liquor at higher temperatures Better dewaterability but higher demand for polymers with increasing temperature.

Decentralised system for demand-oriented collection of food waste - Assessment of biomethane potential, pathogen development and microbial community structure

Enormous amounts of food waste (FW) are produced worldwide, requiring efficient disposal strategies, both economically and ecologically. Anaerobic digestion to produce biomethane is among the most promising strategies, but requires proper solutions for storage and delivery of the waste material. Here, a decentralized system for demand-oriented FW storage and its practical usability was assessed. FW was stored under batch and fed-batch strategies at 5 °C, 20 °C and 30 °C for 28 days. The results showed that FW can be stored without cooling since bacterially produced lactic acid rapidly stabilized the material and inactivated pathogens. While FW storage worked well under all storage conditions and strategies, 16S analysis revealed a distinct microbiota, which was highly characteristic for each storage temperature. Moreover, FW storage had no negative impact on methane yield and stored FW contained readily degradable substances for demand-oriented biogas production.

Biodigestion System Made of Polyethylene and Polystyrene Insulator for Dog Farm (on the Example of the Republic of Chile)

Anaerobic digestion is a system that can have a high environmental impact through the use of different wastes to obtain biogas and its consequent use for the generation of renewable energy. The objective of this study was to implement a polyethylene biodigester, using polystyrene for thermal insulation in a dog kennel, using canine feces collected in the same place during a period of 5 months to obtain biogas and energy. The results indicated that biogas production started on day 30 and stopped during the winter period with low temperatures; therefore, from day 54 onwards, equine manure was added to continue producing biogas. Although biogas was obtained, the biodigester did not function optimally, due to the fact that the materials used in its construction did not provide efficient insulation from the low external temperatures; the low C/N ratio of the canine feces, which led to a reduction in the processing of the methanogenic bacteria; and the low amount of feces collected for use. In general, the use of a biodigester can provide a tool for the biological processing and management of organic waste, yielding a cumulative source of renewable energy and ensuring environmental safety.

Can quarantine plant-parasitic nematodes within wastes be managed by useful tools in a circular economy approach?

Seen as an integral part of sustainable development, circular economy represents a model of production and consumption notably based on the limitation of both resource wastage and environmental impact. Laboratories and commercial companies working on plant pathogens, in particular quarantine species, must effectively disinfect their waste to avoid disseminating these organisms. The methods used for waste disinfection can however incur high energy costs or pose environmental and human health hazards. Here, we tested the effectiveness of five disinfection methods - chlorination, heat treatment, composting, mesophilic methanation and waste stabilization ponds - on plant-parasitic nematodes belonging to the genera Globodera and Meloidogyne. For the widely used chlorination and heat treatment methods, we showed that they can be very effective in inactivating nematodes at relatively low chlorine doses and temperatures (60 °C-3 min and 50 °C-30 min), respectively. For the three other disinfection methods tested, initially designed for waste recycling, we obtained different levels of efficiency. Composting and mesophilic methanation (based on cattle or pig slurry) both led to the complete elimination of nematodes, even for short treatment durations. However, waste stabilization ponds showed contrasting results, ranging from virtually no effect to high levels of inactivation of nematodes. Our study demonstrates that it is possible to use more environmentally friendly disinfection methods to control plant-parasitic nematodes. In particular, this finding paves the way towards the treatment of infected plant materials using composting or methanation, providing that disinfection is still reached under other (real-life) treatment conditions, especially with other kinds of waste. Both composting and methanation recycle and thus valorize infected waste; they are viable alternatives to landfilling or incineration, thereby demonstrating the usefulness of a circular economy approach.

Substrate-to-inoculum ratio drives solid-state anaerobic digestion of unamended grape marc and cheese whey

Inoculation dose is a key operational parameter for the solid-state anaerobic digestion (SS-AD) of lignocellulosic biomass, maximum methane recovery, and stable digester performance. The novelty of this study was the co-digestion of unamended full-strength grape marc and cheese whey for peak methane extraction at variable inoculation levels. An acclimatised digestate from a preceding anaerobic treatment was used as a downstream inoculum. The impact of inoculum size (wet weight) was evaluated at 0/10, 5/5, 7/3 and 9/1 substrate-to-inoculum (S/I) ratios, corresponding to an initial concentration of 20-30% total solids (TS) in digesters over 58 days at 45°C. The optimal 7/3 S/I produced the highest cumulative methane yield, 6.45 L CH4 kg-1 VS, coinciding with the lowest initial salinity at 11%; the highest volumetric methane productivity rate of 0.289±0.044 L CH4 LWork-1 d-1; the highest average COD/N ratio of 9.88; the highest final pH of 9.13, and a maximum 15.07% elemental carbon removal; for a lag time of 9.4 days. This study identified an optimal inoculation dose and opens up an avenue for the direct co-digestion of grape marc and cheese whey without requirements for substrate pretreatment, thus improving the overall bioenergy profile of the winery and dairy joint resource recovery operations.

Biological conversion of carbon monoxide and hydrogen by anaerobic culture: Prospect of anaerobic digestion and thermochemical processes combination

Waste biomass is considered a promising renewable energy feedstock that can be converted by anaerobic digestion. However, anaerobic digestion application can be challenging due to the structural complexity of several waste biomass kinds. Therefore, coupling anaerobic digestion with thermochemical processes can offset the limitations and convert the hardly biodegradable waste biomass, including digestate residue, into value-added products: syngas and pyrogas (gaseous mixtures consisting mainly of H₂, CO, CO₂), bio-oil, and biochar for further valorisation. In this review, the utilisation boundaries and benefits of the aforementioned products by anaerobic culture are discussed. First, thermochemical process parameters for an enhanced yield of desired products are summarised. Particularly, the microbiology of CO and H₂ mixture biomethanation and fermentation in anaerobic digestion is presented. Finally, the state-of-the-art biological conversion of syngas and pyrogas to CH₄ mediated by anaerobic culture is adequately described. Extensive research shows the successful selective biological conversion of CO and H₂ to CH₄, acetic acid, and alcohols. The main bottleneck is the gas-liquid mass transfer which can be enhanced appropriately by bioreactors' configurations. A few research groups focus on bio-oil and biochar addition into anaerobic digesters. However, according to the literature review, there has been no research for utilising all value-added products at once in anaerobic digestion published so far. Although synergic effects of such can be expected. In summary, the combination of anaerobic digestion and thermochemical processes is a promising alternative for wide-scale waste biomass utilisation in practice.

Digested Sludge Quality in Mesophilic, Thermophilic and Temperature-Phased Anaerobic Digestion Systems

Anaerobic digestion (AD) technology is commonly used to treat sewage sludge from activated sludge systems, meanwhile alleviating the energy demand (and costs) for wastewater treatment. Most often, anaerobic digestion is run in single-stage systems under mesophilic conditions, as this temperature regime is considered to be more stable than the thermophilic one. However, it is known that thermophilic conditions are advantageous over mesophilic ones in terms of methane production and digestate hygienisation, while it is unclear which one is better concerning the digestate dewaterability. Temperature-phased anaerobic digestion (TPAD) is a double-stage AD process that combines the above-mentioned temperature regimes, by operating a thermophilic digester followed by a mesophilic one. The aim of this study is to compare the digestate quality of single-stage mesophilic and thermophilic AD and TPAD systems, in terms of the dewaterability, pathogenic safety and lower calorific value (LCV) and, based on the comparison, consider digested sludge final disposal alternatives. The research is conducted in lab-scale reactors treating waste-activated sludge. The dewaterability is tested by two methods, namely, centrifugation and mechanical pressing. The experimental results show that the TPAD system is the most beneficial in terms of organic matter degradation efficiency (32.4% against 27.2 for TAD and 26.0 for MAD), producing a digestate with a high dewaterability (8.1–9.8% worse than for TAD and 6.2–12.0% better than for MAD) and pathogenic safety (coliforms and Escherichia coli were not detected, and Clostridium perfringens were counted up to 4.8–4.9 × 103, when for TAD it was only 1.4–2.5 × 103, and for MAD it was 1.3–1.8 × 104), with the lowest LCV (19.2% against 15.4% and 15.8% under thermophilic and mesophilic conditions, respectively). Regarding the final disposal, the digested sludge after TAD can be applied directly in agriculture; after TPAD, it can be used as a fertilizer only in the case where the fermenter HRT assures the pathogenic safety. The MAD digestate is the best for being used as a fuel preserving a higher portion of organic matter, not transforming into biogas during AD.

CoMA - an intuitive and user-friendly pipeline for amplicon-sequencing data analysis

In recent years, there has been a veritable boost in next-generation sequencing (NGS) of gene amplicons in biological and medical studies. Huge amounts of data are produced and need to be analyzed adequately. Various online and offline analysis tools are available; however, most of them require extensive expertise in computer science or bioinformatics, and often a Linux-based operating system. Here, we introduce "CoMA-Comparative Microbiome Analysis" as a free and intuitive analysis pipeline for amplicon-sequencing data, compatible with any common operating system. Moreover, the tool offers various useful services including data pre-processing, quality checking, clustering to operational taxonomic units (OTUs), taxonomic assignment, data post-processing, data visualization, and statistical appraisal. The workflow results in highly esthetic and publication-ready graphics, as well as output files in standardized formats (e.g. tab-delimited OTU-table, BIOM, NEWICK tree) that can be used for more sophisticated analyses. The CoMA output was validated by a benchmark test, using three mock communities with different sample characteristics (primer set, amplicon length, diversity). The performance was compared with that of Mothur, QIIME and QIIME2-DADA2, popular packages for NGS data analysis. Furthermore, the functionality of CoMA is demonstrated on a practical example, investigating microbial communities from three different soils (grassland, forest, swamp). All tools performed well in the benchmark test and were able to reveal the majority of all genera in the mock communities. Also for the soil samples, the results of CoMA were congruent to those of the other pipelines, in particular when looking at the key microbial players.

Lessons Learned from an Experimental Campaign on Promoting Energy Content of Renewable Biogas by Injecting H2 during Anaerobic Digestion

Direct injection of H2 to an anaerobic reactor enables biological fixation of CO2 into CH4 (biomethanation) and consequently boosts methane content in the produced biogas. However, there has been only a small amount of literature reporting results on this technique in a continuous reactor framework to date. To fill this gap, the present study devoted an experimental work to direct H2 addition to a fed-batch semi-continuous reactor, where the injected H2 concentration increased gradually (~3–30 mmol), spanning a moderate operational period of about 70 days. As the results revealed, the reactor continued anaerobic operation for each level of H2 dosing and produced an average methane content in the biogas ranging between 65% and 72%. The exhibited biogas upgrading trend appeared to be under-developed, and thereby suggests the need for further research.