Profiling microalgal cultures growing on municipal wastewater and fertilizer media in raceway photobioreactors

Acclimated green microalgae consortium to treat sewage in an alternative urban WWTP in a coastal area of Central Italy

This study exposed a microalgal consortium formed by Auxenochlorella protothecoides, Tetradesmus obliquus, and Chlamydomonas reinhardtii to six mixed wastewater media containing different proportions of primary (P) or secondary (S) effluents diluted in centrate (C). Algae could grow at centrate concentrations up to 50 %, showing no significant differences between effluents. After acclimation, microalgae cultivated in 50%P-50%C and 50%S-50%C grew at a rate similar to that of control cultures (0.59-0.66 d-1). These results suggest that the consortium acclimated to both sewage streams by modulating the proportion of the species and their metabolism. Acclimation also altered the photosynthetic activity of wastewater-grown samples compared to the control, probably due to partial photoinhibition, changes in consortium composition, and changes in metabolic activity. No major differences were observed between the two streams with respect to biochemical composition, biomass yield, or bioremediation capacity of the cultivated algae but algae grown in the secondary effluent showed qualitatively higher exopolysaccharides (EPS) production than algae grown in primary. Regarding wastewater remediation, microalgae grown in both WW media showed proficient nutrient removal efficiencies (close to 100 %); however, the final pH value (close to 11) would be controversial if the system were upscaled as it is over the legal limit and would cause phosphorus precipitation, so that CO2 addition would be required. The theoretical scale-up of the microalgae system could achieve water treatment costs of 0.109 €·m-3, which was significantly lower than the costs of typical activated sludge systems.

Exploring microbial growth dynamics in a pilot-scale microalgae raceway fed with urban wastewater: Insights into the effect of operational variables

Microalgae-based wastewater treatment is a promising technology efficient for nutrient recycling and biomass production. Studies continuously optimize processes to reduce costs and increase productivity. However, changes in the operational conditions affect not only biomass productivity but the dynamics of the overall microbial community. This study characterizes a microalgae culture from an 80 m2 pilot-scale raceway reactor fed with untreated urban wastewater. Operational conditions such as pH, dissolved oxygen control strategies (On-off, PI, Event-based, no control), and culture height were varied to assess microbial population changes. Results demonstrate that increased culture height significantly promotes higher microalgal and bacterial diversity. pH, dissolved oxygen and culture height highly affects nitrifying bacteria activity and nitrogen accumulation. Furthermore, the system exhibited high disinfection capability with average Logarithmic Reduction Values (LRV) of 3.36 for E. coli and 2.57 for Clostridium perfringens. Finally, the fungi species detected included Chytridiomycota and Ascomycota, while purple photosynthetic bacteria were also found in significant abundance within the medium.

Conventional activated sludge vs. photo-sequencing batch reactor for enhanced nitrogen removal in municipal wastewater: Microalgal-bacterial consortium and pathogenic load insights

Municipal wastewater treatment plants are mostly based on traditional activated sludge (AS) processes. These systems are characterised by major drawbacks: high energy consumption, large amount of excess sludge and high greenhouse gases emissions. Treatment through microalgal-bacterial consortia (MBC) is an alternative and promising solution thanks to lower energy consumption and emissions, biomass production and water sanitation. Here, microbial difference between a traditional anaerobic sludge (AS) and a consortium-based system (photo-sequencing batch reactor (PSBR)) with the same wastewater inlet were characterised through shotgun metagenomics. Stable nitrification was achieved in the PSBR ensuring ammonium removal > 95 % and significant total nitrogen removal thanks to larger flocs enhancing denitrification. The new system showed enhanced pathogen removal, a higher abundance of photosynthetic and denitrifying microorganisms with a reduced emissions potential identifying this novel PSBR as an effective alternative to AS.

Microbial community acclimatization enhances bioplastics biodegradation and biogas production under thermophilic anaerobic digestion

This paper reports the results of a novel study of microbial acclimatization for bioplastics anaerobic degradation and conversion into biogas. Three sequential anaerobic digestion (AD) runs were carried out to favour microbial acclimatization to two different bioplastics, starch-based (SBS) and polyactic-acid (PLA). AD of SBS and PLA bioplastics was favoured by the acclimatization of the inoculum to the substrate after each run of AD. SBS conversion into biogas increased by 52 % (from 94 to 143 NL kgVS-1) and it was correlated with the enhanced growth of starch degrading bacteria such as Hydrogenispora, Halocella and Haloplasma. PLA anaerobic degradation increased by 97 % (from 395 to 779 NLbiogas kgVS-1) and it was related to the acclimatization of known PLA-degraders such as Tepidimicrobium, Methanothermobacter and Tepidanaerobacter. Microbial acclimatization appears a suitable and low-cost strategy to enhance bioplastics circularity by promoting their anaerobic biodegradation and conversion into biogas.

A Low-Cost Fertilizer Medium Supplemented with Urea for the Lutein Production of Chlorella sp. and the Ability of the Lutein to Protect Cells against Blue Light Irradiation

This study aimed to investigate the use of organic fertilizers instead of modified f/2 medium for Chlorella sp. cultivation, and the extracted lutein of the microalga to protect mammal cells against blue-light irradiation. The biomass productivity and lutein content of Chlorella sp. cultured in 20 g/L fertilizer medium for 6 days were 1.04 g/L/d and 4.41 mg/g, respectively. These values are approximately 1.3- and 1.4-fold higher than those achieved with the modified f/2 medium, respectively. The cost of medium per gram of microalgal biomass reduced by about 97%. The microalgal lutein content was further increased to 6.03 mg/g in 20 g/L fertilizer medium when supplemented with 20 mM urea, and the cost of medium per gram lutein reduced by about 96%. When doses of ≥1 μM microalgal lutein were used to protect mammal NIH/3T3 cells, there was a significant reduction in the levels of reactive oxygen species (ROS) produced by the cells in the following blue-light irradiation treatments. The results show that microalgal lutein produced by fertilizers with urea supplements has the potential to develop anti-blue-light oxidation products and reduce the economic challenges of microalgal biomass applied to carbon biofixation and biofuel production.

Impact of photobioreactor design on microalgae-bacteria communities grown on wastewater: Differences between thin-layer cascade and thin-layer raceway ponds

Thin-layer (TL) photobioreactors (PBRs) are characterised by high productivity. However, their use is limited to lab/pilot-scale, and a deeper level of characterisation is needed to reach industrial scale and test the resistance of multiple microalgae. Here, the performance and composition of eight microalgal communities cultivated in the two main TLs design (thin-layer cascade (TLC) and thin-layer raceway pond (RW)) were investigated through Illumina sequencing. Chlorella vulgaris showed robustness in both designs and often acted as an "invasive" species. Inoculum and reactor type brought variability. Eukaryotic microalgae inocula led to a more robust and stable community (higher similarity), however, RWs were characterised by a higher variability and did not favour the eukaryotic microalgae. The only cyanobacterial inoculum, Nostoc piscinale, was maintained, however the community was variable between designs. The reactor design had an effect on the N cycle with the TLC and RW configurations, enhancing nitrification and denitrification respectively.