Thermodynamic and kinetic studies on harmful algal blooms harvesting by novel etherified cationic straw flocculant

Fabrication of high performance poly(vinyl alcohol)/straw composite film used for package via melt casting and biaxial stretching

A high performance poly(vinyl alcohol)/straw (PVA/SP) composite film for package was fabricated in this study by using thermal processing technology of PVA established in our research group and biaxial stretching technology. The introduction of SP disrupted the original hydrogen bonds in modified PVA by forming new hydrogen bonds with the hydroxyl groups of each component in modified system, thus promoting the stable melt casting of PVA/SP composites and also endowing the obtained PVA/SP precursor sheets with good drawability. Upon biaxial stretching, SP reinforced the crystalline structure and orientation of PVA through their hydrogen bonds with PVA, improving the mechanical strength, crystallinity and thermal stability of PVA/SP films. The film with 3.0 × 3.0 stretching ratios demonstrated the exceptional tensile strength (62.2 MPa), tear strength (119.7 kN/m), low heat shrinkage (5.2 %), and oxygen permeability coefficient (1.38 × 10-16 cm3·cm/cm2·s·Pa), which surpassed most conventional plastic films used in food packaging field. This research not only pioneered an environmentally friendly packaging solution, but also offered a novel strategy for solid-state high-value, large-scale and economical utilization of waste crop straw, greatly avoiding the adverse effects of its burning on the environment.

Upcycling harmful algal blooms into short-chain organic matters assisted with cellulose-based flocculant

Upcycling harmful algal blooms (HABs) into short-chain organic matters (SCOMs) presents a significantly underexplored opportunity for addressing environmental concerns and achieving circular economy. But there are challenges of low HABs harvesting and SCOMs conversion efficiencies. To address these issues, a novel cellulose-based flocculant derived from abundant agricultural waste (wheat straw) was developed. This flocculant possesses high surface positive charge to aggregate negatively charged microalgae cells via charge neutralization mechanism, resulting in HABs harvesting efficiency of 97 %. Moreover, the flocculant can serve as a carbon to nitrogen (C/N) regulator to optimize the harvested slurry properties for downstream fermentation. Following hydrothermal pretreatment for one hour, the HABs-flocculant slurry was effectively converted into SCOMs with a total energy output of 64.3 kJ/L and energy conversion efficiency of 67 %, in which SCOMs was major contributor (92 %). This work may inspire eco-friendly and cost-effective approach for HABs disposal with extra benefits of SCOMs production.

Adsorption performance of Ni(II) by KOH-modified biochar derived from different microalgae species

Microalgae biochar is potential adsorbents to remove heavy metals from wastewater due to abundant functional groups, high porosity and wide sources, but performance is not fully developed since it depends on microalgae species attributing to distinct morphology and biomass compositions. Here, two microalgae species Chlorella Pyrenoidosa and Scenedesmus Obliquus were used for biochar preparation via KOH-modification, biochar properties and their influences on Ni(II) adsorption were investigated. Ni(II) adsorption performances responding to biochar properties and operating conditions were upgraded via progressive optimization and response surface methodology. Together, adsorption isotherms and kinetics were analyzed to obtain significant factors for Ni(II) removal. As results, 100 % of Ni(II) removal was achieved under 100 mg/L initial Ni(II) concentration as pH was higher than the biochar zero-charge point of 6.87 with low biochar dosage (0.5 g/L), which provides an efficient approach for heavy metal removal from wastewater with microalgae biochar.

Technologies for harvesting the microalgae for industrial applications: Current trends and perspectives

Microalgae are emerging as a promising source for augmenting the supply of essential products to meet global demands in an environmentally sustainable manner. Despite the potential benefits of microalgae in industry, the high energy consumption for harvesting remains a significant obstacle. This review offers a comprehensive overview of microalgae harvesting technologies and their industrial applications, with particular emphasis on the latest advances in flocculation techniques. These cutting-edge methods have been applied to biodiesel production, food and nutraceutical processing, and wastewater treatment. Large-scale harvesting is still severely impeded by the high cost despite progress has been made in laboratory studies. In the future, cost-effective microalgal harvesting will rely on efficient resource utilization, including the use of waste materials and the reuse of media and flocculants. Additionally, precise regulation of biological metabolism will be necessary to overcome algal species-related limitations through the development of extracellular polymeric substance-induced flocculation technology.

Photocatalytic synergistic biofilms enhance tetracycline degradation and conversion

Tetracyclines are refractory pollutants that cause persistent harm to the environment and human health. Therefore, it is urgently necessary to develop methods to promote the efficient degradation and conversion of tetracyclines in wastewater. This report proposes a photobiocatalytic synergistic system involving the coupling of GeO₂/Zn-doped phosphotungstic acid hydrate/TiO₂ (GeO₂/Zn-HPW/TiO₂)-loaded photocatalytic optical hollow fibers (POHFs) and an algal-bacterial biofilm. The GeO₂/Zn-HPW/TiO₂ photocatalyst exhibits a broad absorption edge extending to 1000 nm, as well as high-efficiency photoelectric conversion and electron transfer, which allow the GeO₂/Zn-HPW/TiO₂-coated POHFs to provide high light intensity to promote biofilm growth. The resulting high photocatalytic activity rapidly and stably reduces the toxicity and increases the biodegradability of tetracycline-containing wastewater. The biofilm enriched with Salinarimonas, Coelastrella sp., and Rhizobium, maintains its activity for the rapid photocatalytic degradation and biotransformation of intermediates to generate the O₂ required for photocatalysis. Overall, the synergistic photocatalytic biofilm system developed herein provides an effective and efficient approach for the rapid degradation and conversion of water containing high concentrations of tetracycline.

Enhanced energy recovery from landfill leachate by linking light and dark bio-reactions: Underlying synergistic effects of dual microalgal interaction

Bioconversion of nutrients and energy from landfill leachate (LL) to biohydrogen and volatile fatty acids (VFAs) using dark fermentation (DF) is a promising technique for developing a sustainable ecosystem. However, poor performance of DF caused by vulnerable fermentative bacteria vitality and strong LL toxicity significantly hinder its commercialization. Herein, an integrated technique linking microalgae photosynthesis and DF was proposed, in which mixed microalgae were applied to robustly reclaim nutrients and chemical oxygen demand (COD) from LL. Then, microalgae biomass was fermented into biohydrogen and VFAs using the DF process. Underlying synergistic mechanisms of the interaction of Scenedesmus obliquus and Chlorella vulgaris resulting from the functioning of extracellular polymeric substances (EPS) were discussed in detail. For better absorption of nutrients from LL, the mixed microalgae secreted obviously more EPS than pure microalgae, which played vital roles in the assimilation of cellular nutrients by forming more negative zeta potential and secreting more tyrosine-/tryptophan-family proteins in EPS. Besides, mixed microalgae produced more intracellular proteins and carbohydrates than the pure microalgae, thereby providing more feedstock for DF and achieving higher energy yield of 10.80 kJ/L than 6.64 kJ/L that was obtained when pure microalgae were used. Moreover, the energy conversion efficiency of 7.75% was higher for mixed microalgae than 4.77% that was obtained for pure microalgae. This work may inspire efficient disposal of LL and production of bioenergy, together with filling the knowledge gaps of synergistic mechanisms of dual microalgal interactions.

A tailored bifunctional carbon catalyst for efficient glycosidic bond fracture and selective hemicellulose fractionation

This study proposed a mild chlorination-sulfonation approach to synthesize magnetic carbon acid bearing with catalytic SO₃H and adsorption Cl bifunctional sites on polydopamine coating. The catalysts exerted good textural structure and surface chemical properties (i.e., porosity, high specific surface area of >70 m²/g, high catalytic activity with 0.86-1.1 mmol/g of SO₃H sites and 0.8%-1.9% of Cl sites, and abundant hydrophilic functional groups), rendering a maximum cellobiose adsorption efficiency of ∼40% within 6 h. Moreover, the catalysts had strong fracture characteristics on different α-/β-glycosidic bonds with 85.4%-93.9% of disaccharide conversion, while selectively fractionating hemicellulose from wheat straw with 64.3% of xylose yield and 93.4% of cellulose retention. Due to the stable interaction between parent polydopamine support with Fe core and functional groups, the catalysts efficiently recovered by simple magnetic separation had good reusability with minimal losses in catalytic activity.