Fabrication of sucrose biosensor based on single mode planar optical waveguide using co-immobilized plant invertase and GOD

Investigation for terminal reflection optical fiber SPR glucose sensor and glucose sensitive membrane with immobilized GODs

Glucose sensitive membrane (GSM) consists of glucose oxidases (GODs) and matrix material (for example, polyacrylamide gel). In this paper, we have investigated the optical property and adsorption isotherms of a GSM based on a terminal reflection optical fiber SPR sensor. Firstly, we reported the fabrication of one kind of GSM which was made of immobilized GODs on SiO₂ nanoparticles and PAM gel. Then, we investigated the effects of GSM thickness, GOD content, solution pH and ambient temperature on the reflected spectrum of sensor, and the optimum parameters of the sensor, such as, GSM thickness of 12 times pulling, 4 mg/mL of GOD content in GSM, 7.0 of solution pH and 40 °C of measuring temperature were obtained. Thirdly, we measured the wavelength shifts of the optimized SPR sensor in the solutions with different glucose concentrations. As the glucose concentration increases from 0 to 80 mg/dL, the resonance wavelength decreases approximately linearly and the corresponding sensitivity is about 0.14 nm/(mg/dL). Finally, we investigated the RI of the GSM, the concentration of glucose into GSM and the adsorption isotherm of GSM by the combination of SPR experiment data, theoretical simulation and Gladstone-Dale mixing rule. As the glucose concentration is in the region of [0, 80] mg/dL, the adsorption of GSM for glucose can be explained by the Freundlich isotherm model. As the glucose concentration is in the region of [120, 500] mg/dL, the Langmuir isotherm model is more suitable to describe the adsorption process of GSM for glucose.

3D hydrogel scaffold doped with 2D graphene materials for biosensors and bioelectronics

Hydrogels consisting of three-dimensional (3D) polymeric networks have found a wide range of applications in biotechnology due to their large water capacity, high biocompatibility, and facile functional versatility. The hydrogels with stimulus-responsive swelling properties have been particularly instrumental to realizing signal transduction in biosensors and bioelectronics. Graphenes are two-dimensional (2D) nanomaterials with unprecedented physical, optical, and electronic properties and have also found many applications in biosensors and bioelectronics. These two classes of materials present complementary strengths and limitations which, when effectively coupled, can result in significant synergism in their electrical, mechanical, and biocompatible properties. This report reviews recent advances made with hydrogel and graphene materials for the development of high-performance bioelectronics devices. The report focuses on the interesting intersection of these materials wherein 2D graphenes are hybridized with 3D hydrogels to develop the next generation biosensors and bioelectronics.

Invertase-nanogold clusters decorated plant membranes for fluorescence-based sucrose sensor

In the present study, invertase-mediated nanogold clusters were synthesized on onion membranes, and their application for sucrose biosensor fabrication was investigated. Transmission electron microscopy revealed free nanoparticles of various sizes (diameter ~5 to 50 nm) along with clusters of nanogold (~95 to 200 nm) on the surface of inner epidermal membranes of onions (Allium cepa L.). Most of the polydispersed nanoparticles were spherical, although some were square shaped, triangular, hexagonal or rod-shaped. Ultraviolet-visible spectrophotometric observations showed the characteristic peak for nanoparticles decorated invertase-onion membrane at approximately 301 nm. When excited at 320 nm in the presence of sucrose, the membranes exhibited a photoemission peak at 348 nm. The fluorescence lifetime of this nanogold modified onion membrane was 6.20 ns, compared to 2.47 ns for invertase-onion membrane without nanogold. Therefore, a sucrose detection scheme comprised of an invertase/nanogold decorated onion membrane was successfully developed. This fluorescent nanogold-embedded onion membrane drop-test sensor exhibited wide acidic to neutral working pH range (4.0-7.0) with a response time 30 seconds (<1 min). The fabricated quenching-based probe had a low detection limit (2x10(-9) M) with a linear dynamic range of 2.25x10(-9) to 4.25x10(-8) M for sensing sucrose. A microplate designed with an enzyme-nanomaterial-based sensor platform exhibited a high compliance, with acceptable percentage error for the detection of sucrose in green tea samples in comparison to a traditional method. With some further, modifications, this fabricated enzyme-nanogold onion membrane sensor probe could be used to estimate glucose concentrations for a variety of analytical samples. Graphical abstract Synthesis and characterization of invertase assisted nanogold clusters on onion membranes and their application for fluorescence-based sucrose sensor.

Agarose–guar gum assisted synthesis of processable polyaniline composite: morphology and electro-responsive characteristics

An electroactive, electroconducting, processable polyaniline composite is developed via agarose–guar gum assisted polymerization.

Thin hydrogel films for optical biosensor applications

Hydrogel materials consisting of water-swollen polymer networks exhibit a large number of specific properties highly attractive for a variety of optical biosensor applications. This properties profile embraces the aqueous swelling medium as the basis of biocompatibility, non-fouling behavior, and being not cell toxic, while providing high optical quality and transparency. The present review focuses on some of the most interesting aspects of surface-attached hydrogel films as active binding matrices in optical biosensors based on surface plasmon resonance and optical waveguide mode spectroscopy. In particular, the chemical nature, specific properties, and applications of such hydrogel surface architectures for highly sensitive affinity biosensors based on evanescent wave optics are discussed. The specific class of responsive hydrogel systems, which can change their physical state in response to externally applied stimuli, have found large interest as sophisticated materials that provide a complex behavior to hydrogel-based sensing devices.

Biosensors as analytical tools in food fermentation industry

The food industries need rapid and affordable methods to assure the quality ofproducts and process control. Biosensors, combining a biological recognition element and a sensitive transducer, are versatile analytical tools that offer advantages as classical analytical methods due to their inherent specificity, selectivity and simplicity. This paper reviews the recent trends in the development and applications of biosensors used in food fermentation industry, focusing on amperometric enzymatic and microbial sensors.

Waveguide-based biosensors for pathogen detection

Optical phenomena such as fluorescence, phosphorescence, polarization, interference and non-linearity have been extensively used for biosensing applications. Optical waveguides (both planar and fiber-optic) are comprised of a material with high permittivity/high refractive index surrounded on all sides by materials with lower refractive indices, such as a substrate and the media to be sensed. This arrangement allows coupled light to propagate through the high refractive index waveguide by total internal reflection and generates an electromagnetic wave-the evanescent field-whose amplitude decreases exponentially as the distance from the surface increases. Excitation of fluorophores within the evanescent wave allows for sensitive detection while minimizing background fluorescence from complex, "dirty" biological samples. In this review, we will describe the basic principles, advantages and disadvantages of planar optical waveguide-based biodetection technologies. This discussion will include already commercialized technologies (e.g., Corning's EPIC(®) Ô, SRU Biosystems' BIND(™), Zeptosense(®), etc.) and new technologies that are under research and development. We will also review differing assay approaches for the detection of various biomolecules, as well as the thin-film coatings that are often required for waveguide functionalization and effective detection. Finally, we will discuss reverse-symmetry waveguides, resonant waveguide grating sensors and metal-clad leaky waveguides as alternative signal transducers in optical biosensing.