Silver-modified octahedral anatase particles as plasmonic photocatalyst

Insight into the LED-assisted deposition of platinum nanoparticles on the titania surface: understanding the effect of LEDs

This paper proposes a novel LED-assisted deposition of platinum nanoparticles on the titania surface. For the first time, this process was supported by a UV-LED solution. We used two light sources with different wavelengths (λmax = 365 and 395 nm), and power (P = 1, 5, and 10 W) because the photodeposition process based on LEDs has not been defined. The TiO2-Pt material was discovered to be nano-crystalline anatase particles with nano-platinum particles deposited on the surface of titanium dioxide. Furthermore, the luminescence intensity decreased when Pt was added to TiO2, indicating that charge carrier recombination was reduced. The spectra matching of the photocatalyst and LED reactor was performed for the first time in this work. We proposed a convenient LED reactor that focused light in the range of 350-450 nm, allowing us to effectively use photo-oxidative properties of TiO2-Pt materials in the process of removing 4-chlorophenol. In the presented work, the LED light source plays a dual role. They first induce the platinum photodeposition process, before becoming an important component of tailored photoreactors, which is an important innovative aspect of this research.

Enhanced Photocatalytic Activity of Hierarchical Bi2WO6 Microballs by Modification with Noble Metals

Visible-responsive photocatalysts for environmental purification and fuel generation are, currently, highly sought after. Among the possible candidates, Bi2WO6 (BWO) has been considered due to its efficient light harvesting, stability, and promising activities. Here, hierarchical BWO microballs have been prepared using a hydrothermal method, and additionally modified with deposits of noble metals (gold, silver, copper, palladium and platinum) by the photodeposition method. The structure, morphology, photoabsorption properties, and surface composition of bare and metal-modified BWO samples were investigated by XRD, SEM, DRS and XPS analyses. The photocatalytic activity was evaluated by the oxidative degradation of model dye (methyl orange (MO)) under UV/vis, and hydrogen generation under vis and/or UV irradiation. It was found that hierarchical morphology is detrimental for high photocatalytic activity in both tested systems, resulting in the improved degradation of MO (ca. 65% during 90 min of UV/vis irradiation), and hydrogen evolution (0.1 and 0.4 μmol h−1 under vis and UV/vis irradiation, respectively). Moreover, the type of noble metal and its properties influence the overall photocatalytic performance. It was found that, under UV/vis irradiation, only platinum accelerates hydrogen evolution, whereas under vis irradiation the activity follows the order: BWO < BWO/Cu < BWO/Ag < BWO/Pt < BWO/Pd < BWO/Au. It was concluded that zero-valent metal is recommended for high vis response, probably due to plasmonic photocatalysis, efficient light harvesting ability, and co-catalytic role.

Morphology-Governed Performance of Multi-Dimensional Photocatalysts for Hydrogen Generation

In the past few decades, extensive studies have been performed to utilize the solar energy for photocatalytic water splitting; however, up to the present, the overall efficiencies reported in the literature are still unsatisfactory for commercialization. The crucial element of this challenging concept is the proper selection and design of photocatalytic material to enable significant extension of practical application perspectives. One of the important features in describing photocatalysts, although underestimated, is particle morphology. Accordingly, this review presents the advances achieved in the design of photocatalysts that are dedicated to hydrogen generation, with an emphasis on the particle morphology and its potential correlation with the overall reaction performance. The novel concept of this work—with the content presented in a clear and logical way—is based on the division into five parts according to dimensional arrangement groups of 0D, 1D, 2D, 3D, and combined systems. In this regard, it has been shown that the consideration of the discussed aspects, focusing on different types of particle morphology and their correlation with the system’s efficiency, could be a promising route for accelerating the development of photocatalytic materials oriented for solar-driven hydrogen generation. Finally, concluding remarks (additionally including the problems connected with experiments) and potential future directions of particle morphology-based design of photocatalysts for hydrogen production systems have been presented.

Morphology-Governed Performance of Plasmonic Photocatalysts

Plasmonic photocatalysts have been extensively studied for the past decade as a possible solution to energy crisis and environmental problems. Although various reports on plasmonic photocatalysts have been published, including synthesis methods, applications, and mechanism clarifications, the quantum yields of photochemical reactions are usually too low for commercialization. Accordingly, it has been proposed that preparation of plasmonic photocatalysts with efficient light harvesting and inhibition of charge carriers’ recombination might result in improvement of photocatalytic activity. Among various strategies, nano-architecture of plasmonic photocatalysts seems to be one of the best strategies, including the design of properties for both semiconductor and noble-metal-deposits, as well as the interactions between them. For example, faceted nanoparticles, nanotubes, aerogels, and super-nano structures of semiconductors have shown the improvement of photocatalytic activity and stability. Moreover, the selective deposition of noble metals on some parts of semiconductor nanostructures (e.g., specific facets, basal or lateral surfaces) results in an activity increase. Additionally, mono-, bi-, and ternary-metal-modifications have been proposed as the other ways of performance improvement. However, in some cases, the interactions between different noble metals might cause unwanted charge carriers’ recombination. Accordingly, this review discusses the recent strategies on the improvements of the photocatalytic performance of plasmonic photocatalysts.

Photonic Crystals for Plasmonic Photocatalysis

Noble metal (NM)-modified wide-bandgap semiconductors with activity under visible light (Vis) irradiation, due to localized surface plasmon resonance (LSPR), known as plasmonic photocatalysts, have been intensively studied over the last few years. Despite the novelty of the topic, a large number of reports have already been published, discussing the optimal properties, synthesis methods and mechanism clarification. It has been proposed that both efficient light harvesting and charge carriers’ migration are detrimental for high and stable activity under Vis irradiation. Accordingly, photonic crystals (PCs) with photonic bandgap (PBG) and slow photon effects seem to be highly attractive for efficient use of incident photons. Therefore, the study on PCs-based plasmonic photocatalysts has been conducted, mainly on titania inverse opal (IO) modified with nanoparticles (NPs) of NM. Although, the research is quite new and only several reports have been published, it might be concluded that the matching between LSPR and PBG (especially at red edge) by tuning of NMNPs size and IO-void diameter, respectively, is the most crucial for the photocatalytic activity.

Size-Controlled Synthesis of Pt Particles on TiO2 Surface: Physicochemical Characteristic and Photocatalytic Activity

Different TiO2 photocatalysts, i.e., commercial samples (ST-01 and P25 with minority of rutile phase), nanotubes, well-crystallized faceted particles of decahedral shape and mesoporous spheres, were used as supports for deposition of Pt nanoparticles (NPs). Size-controlled Pt NPs embedded in TiO2 were successfully prepared by microemulsion and wet-impregnation methods. Obtained photocatalysts were characterized using XRD, TEM, X-ray photoelectron spectroscopy (XPS), Brunauer–Emmett–Teller (BET) specific surface area, DR/UV-vis and action spectrum analysis. The effect of deposition method, amount of Pt precursor and TiO2 properties on size, distribution, and chemical states of deposited Pt NPs were investigated. Finally, the correlations between the physicochemical properties and photocatalytic activities in oxidation and reduction reactions under UV and Vis light of different Pt-TiO2 photocatalysts were discussed. It was found that, regardless of preparation method, the photoactivity mainly depended on platinum and TiO2 morphology. In view of this, we claim that the tight control of NPs’ morphology allows us to design highly active materials with enhanced photocatalytic performance. Action spectrum analysis for the most active Pt-modified TiO2 sample showed that visible light-induced phenol oxidation is initiated by excitation of platinum surface plasmon, and photocatalytic activity analysis revealed that photoactivity depended strongly on morphology of the obtained Pt-modified TiO2 photocatalysts.

Influence of Semiconductor Morphology on Photocatalytic Activity of Plasmonic Photocatalysts: Titanate Nanowires and Octahedral Anatase Nanoparticles

Octahedral anatase particles (OAP) with eight exposed and thermodynamically most stable (101) facets were prepared by an ultrasonication-hydrothermal (US-HT) reaction from potassium titanate nanowires (TNW). The precursor (TNW) and the product (OAP) of US-HT reaction were modified with nanoparticles of noble metals (Au, Ag or Pt) by photodeposition. Samples were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), diffuse reflectance spectroscopy (DRS), scanning transmission electron microscopy (STEM) and time-resolved microwave conductivity (TRMC). The photocatalytic activity was investigated in three reaction systems, i.e., anaerobic dehydrogenation of methanol and oxidative decomposition of acetic acid under UV/vis irradiation, and oxidation of 2-propanol under vis irradiation. It was found that hydrogen liberation correlated with work function of metals, and thus the most active were platinum-modified samples. Photocatalytic activities of bare and modified OAP samples were much higher than those of TNW samples, probably due to anatase presence, higher crystallinity and electron mobility in faceted NPs. Interestingly, noble metals showed different influence on the activity depending on the semiconductor support, i.e., gold-modified TNW and platinum-modified OAP exhibited the highest activity for acetic acid decomposition, whereas silver- and gold-modified samples were the most active under vis irradiation, respectively. It is proposed that the form of noble metal (metallic vs. oxidized) as well as the morphology (well-organized vs. uncontrolled) have a critical effect on the overall photocatalytic performance. TRMC analysis confirmed that fast electron transfer to noble metal is a key factor for UV activity. It is proposed that the efficiency of plasmonic photocatalysis (under vis irradiation) depends on the oxidation form of metal (zero-valent preferable), photoabsorption properties (broad localized surface plasmon resonance (LSPR)), kind of metal (silver) and counteraction of “hot” electrons back transfer to noble metal NPs (by controlled morphology and high crystallinity).

Morphology, Photocatalytic and Antimicrobial Properties of TiO2 Modified with Mono- and Bimetallic Copper, Platinum and Silver Nanoparticles

Noble metal nanoparticles (NMNPs) enhanced TiO₂ response and extended its activity under visible light. Photocatalytic activity of TiO₂ modified with noble metal nanoparticles strongly depends on the physicochemical properties of NMNPs. Among others, the differences in the size of NMNPs seems to be one of the most important factors. In this view, the effect of the metal’s nanoparticles size, type and amount on TiO₂ photocatalytic and biocidal activity was investigated. TiO₂ modified with mono- and bimetallic nanoparticles of Pt, Cu and Ag were prepared using chemical and thermal reduction methods. Obtained nanocomposites were characterized using transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD) and diffuse-reflectance spectroscopy (DR/UV-Vis) techniques. The photocatalytic activity was examined in 2-propanol oxidation and hydrogen generation processes. The mechanism of modified TiO₂ excitation was evaluated in action spectrum measurements during phenol oxidation. A possibility of using less energy-consuming light sources as a set of light-emitting diodes (LEDs) selected based on action spectrum results was examined. It was found that the differences in NMNPs size were the result of the reduction method. Moreover, coupling with a second metal strongly affected and differentiated the photocatalytic and biocidal activity of the obtained TiO₂-based photocatalysts.

Photocatalytic and Antimicrobial Properties of Ag2O/TiO2 Heterojunction

Ag2O/TiO2 heterojunctions were prepared by a simple method, i.e., the grinding of argentous oxide with six different titania photocatalysts. The physicochemical properties of the obtained photocatalysts were characterized by diffuse-reflectance spectroscopy (DRS), X-ray powder diffraction (XRD) and scanning transmission electron microscopy (STEM) with an energy dispersive X-ray spectroscopy (EDS). The photocatalytic activity was investigated for the oxidative decomposition of acetic acid and methanol dehydrogenation under UV/vis irradiation and for the oxidative decomposition of phenol and 2-propanol under vis irradiation. Antimicrobial properties were tested for bacteria (Escherichia coli) and fungi (Candida albicans and Penicillium chrysogenum) under UV and vis irradiation and in the dark. Enhanced activity was observed under UV/vis (with synergism for fine anatase-containing samples) and vis irradiation for almost all samples. This suggests a hindered recombination of charge carriers by p-n heterojunction or Z-scheme mechanisms under UV irradiation and photo-excited electron transfer from Ag2O to TiO2 under vis irradiation. Improved antimicrobial properties were achieved, especially under vis irradiation, probably due to electrostatic attractions between the negative surface of microorganisms and the positively charged Ag2O.