DEM simulation of the mixing behavior in a spheronization process

Numerical Investigation of the Particle Dynamics in a Rotorgranulator Depending on the Properties of the Coating Liquid

In the pharmaceutical industry, the coating of particles is a widely used technique to obtain desired surface modifications of the final product, e.g., controlled release of the active agents. The production of round, coated particles is particularly important, which is why fluidized bed rotor granulators (FBRG) are often used for this process. In this work, Computational Fluid Dynamics (CFD) coupled with the Discrete Element Method (DEM) is used to investigate the wet particle dynamics, depending on the properties of the coating liquid in a FBRG. The DEM contact model was extended by liquid bridge model to account for capillary and viscous forces during wet contact of particles. The influence of the relative contact velocity on the maximum length of the liquid bridge is also considered in the model. Five different cases were compared, in which the particles were initially wetted, and the liquid loading as well as the surface tension and viscosity of the liquid were changed. The results show that increasing viscosity leads to a denser particle bed and a significant decrease in particle rotational velocities and particle motion in the poloidal plane of the FBRG. Reducing the liquid loading and surface tension results in increased particle movement.

Study of the capsule-filling dosator process via calibrated DEM simulations

Capsule filling is frequently accomplished via the dosator process. Controlling the main quality attributes, i.e., the fill weight and the fill weight variability, requires excellent process understanding. For the investigation of critical process parameters of low-dose capsule filling, DEM simulations were used. Two contact models (Hertz model and Luding model) were calibrated and validated to represent the lactose powder Lactohale 100. Both models gave good results, yet the Luding model resulted in better predictions. Since the dosator process is a volume-based approach, the dosator geometry is an important factor. We provide evidence that not only the volume, but also the proportions of the dosator affect the capsule fill weight. Slim nozzle chambers cause lower mass due to increased wall friction impact. The process is not volumetric, as a fill weight to volume correlation does not exist. Furthermore, the fill weight increases with higher powder beds and smaller gaps between the nozzle tip and the container bottom due to higher densification of the powder. Fill weight variations due to bed inhomogeneity were investigated by varying the bulk density of the initial powder bed.