Ferrate(VI) oxidation of pentachlorophenol in water and soil

Advanced technologies for the determination of quantitative structure-activity relationships and degradation efficiency of micropollutants and their removal in water - A review

The growing concentrations of micropollutants in aquatic ecosystems are a global water quality issue. Understanding micropollutants varied chemical composition and potency is essential to solving this complex issue. Micropollutants management requires identifying contaminants to reduce, optimal reduction targets, and the best wastewater recycling locations. Management requires appropriate technological measures. Pharmaceuticals, antibiotics, hormones, and other micropollutants can enter the aquatic environment from point and diffuse sources, with wastewater treatment plants (WWTPs) distributing them in urban areas. Micropollutants like pharmaceuticals and hormones may not be removed by conventional WWTPs. Micropollutants affect the EU, especially in densely populated areas where surface water is consumed. This review examines several technological options that can be integrated into existing treatment methods to address this issue. In this work, oxidation, activated carbon, and their combinations as potential solutions, considering their efficacy and cost were evaluated. This study illuminates micropollutants origin and physico-chemical properties, which affect distribution, persistence, and environmental impacts. Understanding these factors helps us develop targeted micropollutant mitigation strategies to protect water quality. This review can inform policy and decision-making to reduce micropollutant impacts on aquatic ecosystems and human health.

Insights into oxidation of pentachlorophenol (PCP) by low-dose ferrate(VI) catalyzed with α-Fe2O3 nanoparticles

In this study, the catalytic performance of α-Fe₂O₃ nanoparticles (nα-Fe₂O₃) in the low-dose ferrate (Fe(VI)) system was systematically studied through the degradation of pentachlorophenol (PCP). Based on the established quadratic functions between nα-Fe₂O₃ amount and observed pseudo first-order rate constant (k_obs), two linear correlation equations were offered to predict the optimum catalyst dosage and the maximum k_obs at an applied Fe(VI) amount. Moreover, characterization and cycling experiments showed that nα-Fe₂O₃ has good stability and recyclability. According to the results of reactive species identification and quenching experiment and galvanic oxidation process, the catalytic mechanism was proposed that Fe(III) on the surface of nα-Fe₂O₃ may react with Fe(VI) to enhance the generation of highly reactive Fe(IV)/Fe(V) species, which rapidly extracted a single electron from PCP molecule for its further reaction. Besides, two possible PCP degradation pathways, i.e., single oxygen transfer mediated hydroxylation and single electron transfer initiated polymerization were proposed. The formation of coupling products that are prone to precipition and separation was largely improved. This study proved that nα-Fe₂O₃ can effectively catalyze PCP removal at low-dose Fe(VI), which provides some support for the application of Fe(VI) oxidation technology in water treatment in the context of low-carbon emissions.

Indirect spectrophotometric determination of aqueous ferrate(VI) based on its reaction with iodide in acidic media

Ferrate(VI) (Fe(VI)) is utilized as an efficient and environmentally friendly water treatment agent that can be widely used for degradation of (in)organic pollutants in practical applications. However, only a few spectrophotometric methods for Fe(VI) determination were reported. In this study, a novel method for determining trace levels of aqueous Fe(VI) was developed based on the fact that Fe(VI) reacts with iodide at acidic pH to form iodine, which subsequently is treated with starch to yield the blue starch-iodine complex measured spectrophotometrically at 590 nm. The key measurement parameters, including acidic medium, starch dosages, temperature, time, and addition order were optimized to improve the sensitivity of detection. The increase in absorbance at 590 nm was linear with respect to Fe(VI) added (0.022-50 µM). Its sensitivity was determined as (4.61 ± 0.05) × 10⁴ M^-1 cm^-1, which was higher than that of existing spectrophotometric methods. The principle for Fe(VI) determination was studied by investigating stoichiometry, kinetics, and mechanism of Fe(VI) reaction with iodide. The molar stoichiometry of Fe(VI) with I₃^- species was determined to be 1:2. The reaction of Fe(VI) with iodide followed a second-order rate law with first order in each reactant and displayed apparent anti-Arrhenius kinetics, then its reaction pathway was proposed as well. Furthermore, the established method was successfully applied to measure Fe(VI) in various environmental water samples. The results show that the proposed approach is simple, convenient, highly reproducible and extremely sensitive, and is also expected to be of use for kinetic studies of Fe(VI) reaction with (in)organic compounds under acidic conditions.

Degradation of mineral-immobilized pyrene by ferrate oxidation: Role of mineral type and intermediate oxidative iron species

Ferrate (Fe(VI)) salts like K₂FeO₄ are efficient green oxidants to remediate organic contaminants in water treatment. Minerals are efficient sorbents of contaminants and also excellent solid heterogeneous catalysts which might affect Fe(VI) remediation processes. By targeting the typical polycyclic aromatic hydrocarbon compound - pyrene, the application of Fe(VI) for oxidation of pyrene immobilized on three minerals, i.e., montmorillonite, kaolinite and goethite was studied for the first time. Pyrene immobilized on the three minerals was efficiently oxidized by Fe(VI), with 87%-99% of pyrene (10 μM) being degraded at pH 9.0 in the presence of a 50-fold molar excess Fe(VI). Different minerals favored different pH optima for pyrene degradation, with pH optima from neutral to alkaline following the order of montmorillonite (pH 7.0), kaolinite (pH 8.0), and goethite (pH 9.0). Although goethite revealed the highest catalytic activity on pyrene degradation by Fe(VI), the greater noneffective loss of the oxidative species by ready self-decay in the goethite system resulted in lower degradation efficiency compared to montmorillonite. Protonation and Lewis acid on montmorillonite and goethite assisted Fe(VI) oxidation of pyrene. The intermediate ferrate species (Fe(V)/Fe(IV)) were the dominant oxidative species accountable for pyrene oxidation, while the contribution of Fe(VI) species was negligible. Hydroxyl radical was involved in mineral-immobilized pyrene degradation and contributed to 11.5%-27.4% of the pyrene degradation in montmorillonite system, followed by kaolinite (10.8%-21.4%) and goethite (5.1%-12.2%) according to the hydroxyl radical quenching experiments. Cations abundant in the matrix and dissolved humic acid hampered pyrene degradation. Finally, two different degradation pathways both producing phthalic acid were identified. This study demonstrates efficient Fe(VI) oxidation of pyrene immobilized on minerals and contributes to the development of efficient environmentally friendly Fe(VI) based remediation techniques.

Oxidation of chloroquine drug by ferrate: Kinetics, reaction mechanism and antibacterial activity

Chloroquine (CLQ) is required to manufacture on a larger scale to combat COVID-19. The wastewater containing CLQ will be discharged into the natural water, which was resistant to environmental degradation. Herein, the degradation of CLQ by ferrate (Fe(VI)) was investigated, and the biodegradability of the oxidation products was examined to evaluate the potential application in natural water treatment. The reaction between CLQ and Fe(VI) was pH-dependent and followed second-order kinetics. The species-specific rate constant of protonated Fe(VI) species (HFeO₄ ^-) was higher than that of the FeO₄ ^2- species. Moreover, increasing the reaction temperature could increase the degradation rate of CLQ. Besides, HCO₃ ^- had positive effect on CLQ removal, while HA had negative effect on CLQ removal. But the experiments shows Fe(VI) could be used as an efficient technique to degrade co-existing CLQ in natural waters. During the oxidation, Fe(VI) attack could lead to aromatic ring dealkylation and chloride ion substitution to form seven intermediate products by liquid chromatography-time-of-flight-mass spectrometry (LC-TOF-MS) determination. Finally, a pure culture test showed that the oxidation of CLQ by Fe(VI) could slightly increase the antimicrobial effect towards Escherichia coli (E.coli) and reduce the toxicity risk of intermediates. These findings might provide helpful information for the environmental elimination of CLQ.

Bacterial consortium biotransformation of pentachlorophenol contaminated wastewater

The aims of this study were (i) to compare PCP removal (100 mg L^-1) by two bacterial consortia B₁ and B₂ in sterile wastewater (STWW) and liquid mineral medium (MSM), (ii) PCP effect in biofilm formation and antimicrobial susceptibility. PCP removal was measured by high-performance liquid chromatography (HPLC) during 168 h at 30 °C. Biofilm formation was assessed with two approaches: Congo Red Agar and Microtiter-plate. Antimicrobial susceptibility was determined by the agar disc diffusion technique. The results showed that the PCP removal for consortium B₁ and B₂ after 168 h was 70 and 97.5% in STWW; 62.2 and 85.5% in MSM, respectively. In addition, PCP addition showed an increase in biofilm development especially for B₂ consortium around 3.5 nm in 100 mg L^-1 PCP. PCP added in the Muller Hinton (MH) medium and Gentamicin disc showed a clear increase in diameter of cell lysis around 2 to 4.5 cm.

On the Origins of Some Spectroscopic Properties of "Purple Iron" (the Tetraoxoferrate(VI) Ion) and Its Pourbaix Safe-Space

In this work, the authors attempt to interpret the visible, infrared and Raman spectra of ferrate(VI) by means of theoretical physical-inorganic chemistry and historical highlights in this field of interest. In addition, the sacrificial decomposition of ferrate(VI) during water treatment will also be discussed together with a brief mention of how Rayleigh scattering caused by the decomposition of Fe^VIO₄²⁻ may render absorbance readings erroneous. This work is not a compendium of all the instrumental methods of analysis which have been deployed to identify ferrate(VI) or to study its plethora of reactions, but mention will be made of the relevant techniques (e.g., Mössbauer Spectroscopy amongst others) which support and advance this overall discourse at appropriate junctures, without undue elaboration on the foundational physics of these techniques.

Surfactant efficiency on pentachlorophenol-contaminated wastewater enhanced by Pseudomonas putida AJ 785569

This study aims to evaluate the effect of three surfactants on the removal of PCP (800 mg L^-1) from Secondary Treated Wastewater (STWW) by Pseudomonas putida AJ 785569. The effect of surfactants [sodium lauryl sulfate (SDS) as anionic, Tween 80 (TW80) as non-anionic and cetyltrimethylammonium bromide (CTAB) as cationic] is tested about the three following aspects: (1) bacterial growth, (2) bacterial biofilm formation or development and (3) PCP rate removal. The results showed that strain P. putida AJ 785569 could adsorb around 30 mg L^-1 and remove 600 mg L^-1 of PCP within 168 h of incubation. The SDS developed the growth of bacteria and the removal of PCP. This PCP removal in mineral salt medium (MSM) is around 760 mg L^-1 (95% degradation) higher than the ones registered with CTAB and TW80 with a value 506.75 (63% degradation) and 364.1 mg L^-1 (45% degradation), respectively. The obtained results of chloride concentration showed an important relation with PCP removal during incubation with an important value. Monitoring the development of bacterial biofilm, in MSM medium added with PCP (100 mg L^-1) by strain P. putida AJ 785569, showed a significant increase in the optical density value from 0.9 to 4 at λ = 595 nm, a modification of strain P. putida AJ 785569's morphotype, density and color colonies.

Enhancement of Pentachlorophenol Removal in a Historically Contaminated Soil by Adding Ascorbic Acid to H2O2/Magnetite System

Development of new tools to improve the efficiency of iron minerals in promoting Fenton oxidation for environmental remediation is a highly promising field. Here, we examine for the first time the role of ascorbic acid (AA) in improving the magnetite (Fe3O4)-mediated Fenton oxidation to remove pentachlorophenol (PCP) in a historically contaminated soil. Experiments were performed in batch and flow-through conditions. In batch slurry experiments, the combination of Fe3O4/AA/H2O2 removed up to 95% of PCP as compared to the 43% removal by Fe3O4/H2O2. Dissolved Fe(II) measurements and Mössbauer spectroscopy highlight the role of AA in increasing the Fe(II) generation. Therefore, its presence enabled the Fe3O4 to maintain its structural Fe(II) content even after the oxidation reaction. Despite kinetic limitations in water-saturated columns, use of Fe3O4/AA/H2O2 removed about 70% of PCP contrary to the 20% PCP removal with Fe3O4/H2O2. This oxidation performance was affected by an injection flow rate or column residence time of AA and H2O2 in columns. Thus, the presence of AA significantly improved the ability of magnetite in promoting the Fenton reaction. Owing to the crucial role of AA in the Fe(II)/Fe(III) redox cycling, a mixed-valent character of magnetite makes it a potential catalyst for Fenton oxidation of organic pollutants.

A bibliometric study of the Fenton oxidation for soil and water remediation

Fenton based treatments have received tremendous attention in the recent decades as viable strategies for soil and water remediation. There exist different processes associated to the Fenton oxidation. Efficiency, reaction chemistry, and environmental consequences of these processes vary according to the iron (Fe) activation techniques such as soluble Fe(II) (homogeneous Fenton process), soluble Fe(II) and chelating agent (modified-Fenton), Fe minerals or solids (heterogeneous Fenton), iron and UV light (photo-Fenton) and electro-Fenton oxidation. Despite immense amount of research articles and reviews related to the Fenton oxidation, no bibliometric study of this topic has been published to our knowledge. Bibliometric studies provide a useful means to track research output and scholarly trends in a field. Here, we conducted a bibliometric study of the publications on this theme (>4000 documents) published during the past three decades available from the Science Citation Index Expanded (SCI-EXPANDED) database of the Web of Science Core Collection (Clarivate Analytics). Based on the bibliometric analysis of 4349 documents, various essential research indicators were described such as the type and language of publications, the most prominent authors in this theme, the most impactful articles, research categories, journals, institutions, and the countries, that have made the greatest contribution to this theme along with potential research hotspots. This bibliometric study allowed visualization of the current landscape and future trends in this field to facilitate the future collaborative research and exchange of knowledge.