Removal of phenolic contaminants from water by in situ coated surfactant on Keggin-aluminum nanocluster and biodegradation

Tris-Copper Nanozyme as a Novel Laccase Mimic for the Detection and Degradation of Phenolic Compounds

Phenolic compounds are one of the main organic pollutants in the environment that can seriously affect ecosystems, even at very low concentrations. Due to the resistance of phenolic compounds to microorganisms, conventional biological treatment methods face challenges in effectively addressing this pollution problem. In this study, a novel laccase mimic (Tris-Cu nanozyme) is prepared using a simple and rapid synthesis strategy based on the coordination of copper ions and amino groups in Tris(hydroxymethyl)aminomethane (Tris). It is found that the Tris-Cu nanozyme exhibits good catalytic activity against a variety of phenolic compounds, the Km, Vmax and Kcat are determined to be 0.18 mM, 15.62 μM·min-1 and 1.57 × 107 min-1 using 2,4-dichlorophenol (2,4-DP) as the substrate, respectively. Then, based on the laccase-like activity of the Tris-Cu nanozyme, a novel colorimetric method for 2,4-DP (the limit of detection (LOD) = 2.4 μM, S/N = 3) detection in the range of 10-400 μM was established, and its accuracy was verified by analyzing tap and lake water samples. In addition, the Tris-Cu nanozyme shows excellent removal abilities for six phenolic compounds in experiments. The removal percentages for 2,4-DP, 2-chlorophenol (2-CP), phenol, resorcinol, 2,6-dimethoxyphenol (2,6-DOP), and bisphenol A (BPA) are 100%, 100%, 100%, 100%, 87%, and 81% at 1 h, respectively. In the simulated effluent, the Tris-Cu nanozyme maintains its efficient catalytic activity towards 2,4-DP, with a degradation percentage of 76.36% at 7 min and a reaction rate constant (k0) of 0.2304 min-1. Therefore, this metal-organic complex shows promise for applications in the monitoring and degrading of environmental pollutants.

An efficient differential sensing strategy for phenolic pollutants based on the nanozyme with polyphenol oxidase activity

To realize the efficient differential sensing of phenolic pollutants in sewage, a novel sensing strategy was successfully developed based on one nanozyme (GMP-Cu) with polyphenol oxidase activity. Phenolic pollutants can be oxidized by GMP-Cu, and the oxidation products reacts subsequently with 4-aminoantipyrine to produce a quinone-imine compound. The absorption spectra of final quinone-imine products resulted from different phenolic pollutants showed obvious differences, which were due to the interaction difference between GMP-Cu and phenolic pollutants, as well as the different molecular structures of the quinone-imine products from different phenolic pollutants. Based on the difference of absorption spectra, a novel differential sensing strategy was developed. The genetic algorithm was used to select the characteristic wavelengths at different enzymatic reaction times, HCA and PLS-DA algorithms were utilized for the discriminant sensing of seven representative phenolic pollutants, including hydroquinone, resorcinol, catechol, resorcinol, phenol, p-chlorophenol, and 2,4-dichlorophenol. Scientific wavelength selection algorithm and recognition algorithm resulted in the successful identification of phenolic pollutants in sewage with a discriminant accuracy of 100%, and differentiation of the phenolic pollutants regardless of their concentration. These results indicate that sensing strategy can be used as an effective tool for the efficient identification and differentiation of phenolic pollutants in sewage.

Selective Separation Catalysis Membrane for Highly Efficient Water and Soil Decontamination via a Persulfate-Based Advanced Oxidation Process

The application of sulfate radical advanced oxidation for organic pollutant removal has been hindered by some shortages such as the recycling difficulty of a powered catalyst, the low utilization efficiency of oxidants, and the secondary pollution (including soil acidification) after reaction. Herein, we fabricate a selective separation catalysis membrane (SSCM) for a highly efficient and environment-friendly persulfate-based advanced oxidation process. The SSCM comprises a top polydimethylsiloxane layer which is selectively penetrable to hydrophobic organic pollutants, followed by a catalyst layer with a magnetic nitrogen-doped porous carbon material, targeting the advanced oxidation of the selected pollutants. Compared with the catalyst in powder form, such SSCM devices significantly reduced the dosage of peroxymonosulfate by more than 40% and the catalyst dosage by 97.8% to achieve 80% removal of phenol with the coexistence of 20 mg L^-1 humic acid (HA). The SSCM can extract target pollutants while rejecting HA more than 91.43% for 100 h. The pH value in the receiving solution demonstrated a significant reduction from 7.01 to 3.00. In comparison, the pH value in the feed solution varied from 6.05 to a steady 4.59. The results can be ascribed to the specific functionality for the catalyst anchored, natural organic matter isolation, and reaction compartmentation provided by SSCMs. The developed SSCM technology is beneficial for catalysts reused in remediation practices, saving oxidant dosage, and avoiding acidification of soil and water, thus having tremendous application potential.

The Application of Response Surface Methodology for 2,4,6-Trichlorophenol Removal from Aqueous Solution Using Synthesized Zn2+-Al3+-Tartrate Layered Double Hydroxides

Trichlorophenols are on the US environmental protection agency’s list of priority pollutants due to their serious damage to water safety. With the aim of adsorbing the 2,4,6-trichlorophenol (2,4,6-TCP), Zn2+-Al3+-tartrate layered double hydroxides (Zn2+-Al3+-C4H4O62−-LDHs) adsorbent was synthesized via homogeneous precipitation method. X-ray powder diffraction (XRD), Fourier infrared spectroscopy (FT-IR), scanning electron microscopy (SEM) and energy dispersive spectrometry (EDS) were used to characterize Zn2+-Al3+-C4H4O62−-LDHs. The concentration of 2,4,6-TCP was determined using gas chromatography–mass spectrometry (GC-MS). Zn2+-Al3+-C4H4O62−-LDHs exhibited a good adsorption performance of 2,4,6-trichlorophenol, since a bigger layer spacing of Zn2+-Al3+-C4H4O62−-LDHs was obtained than that in Zn2+-Al3+-CO32−-LDHs. Adsorption parameters of adsorption temperature, contact time, adsorbent dosage, and solution pH were investigated, the initial concentration of 2,4,6-TCP was 2.0 g/L. Response surface methodology (RSM) was employed to provide an investigative approach towards optimization of the adsorption process. The highest removal rate of 89.94% and the average removal rate of 88.74% were achieved under a temperature of 20.0 °C, a contact time of 2.5 h, an adsorbent dosage of 0.15 g, and a solution pH of 3. the capacity of the adsorbent is 599.6 mg/g. Meanwhile, the reusable properties of Zn2+-Al3+-C4H4O62−-LDHs were evaluated by the same adsorption system, and the removal rate of 2,4,6-TCP was 85.57% at the fifth regeneration. The obtained results confirmed that the Zn2+-Al3+-C4H4O62−-LDHs can be used as a potential introduction in practical applications for the removal of 2,4,6-TCP.

Nanobioremediation: A sustainable approach towards the degradation of sodium dodecyl sulfate in the environment and simulated conditions

Nanotechnology has gained huge importance in the field of environmental clean-up today. Due to their remarkable and unique properties, it has shown potential application for the remediation of several pesticides and textile dyes. Recently it has shown positive results for the remediation of sodium dodecyl sulfate (SDS). One of the highly exploited surfactants in detergent preparation is anionic surfactants. The SDS selected for the present study is an example of anionic linear alkyl sulfate. It is utilized extensively in industrial washing, which results in the high effluent level of this contaminant and ubiquitously toxic to the environment. The present review is based on the research depicting the adverse effects of SDS in general and possible strategies to minimizing its effects by bacterial degradation which are capable of exploiting the SDS as an only source of carbon. Moreover, it has also highlighted that how nanotechnology can play a role in the remediation of such recalcitrant pesticides.

Advances in micro interfacial phenomena of adsorptive micellar flocculation: Principles and application for water treatment

Among various aqua remediation technologies, separation aims at cleaning pollutants by isolating them despite their destruction; solutes can also be recovered after the process. Adsorptive micellar flocculation (AMF) has been known as an important surfactant-based technique to separate poorly water-soluble hazardous pollutants from aqua media as an efficient and energy-intensive replacement for other surfactant-based techniques, as such AMF should be known. AMF is based on the partitioning of solutes gradient from bulk solution into the nanosized smart anionic surfactant micelle followed by flocculation. However, unlike coagulation/flocculation or adsorption, AMF is not viable for the production of drinking water in water utilities due to the loss of surfactant monomers. Unfortunately, it can be used as a reservoir or for the recycling/recovery of organic pollutants (intermediates) (ions, organics/bioactive, dyes, etc.), even at high concentrations. The performance of AMF depends on various parameters, and this review briefly summarizes the existing researches on different pollutants removal by AMF and material recovery/recycling. This includes operating condition factors (surfactants, flocculants, surfactant-flocculant or surfactant-pollutant concentration ratio, and water conditions chemistry). Because varieties of micro interfacial phenomena other than physical interactions occur in a versatile micellar environment in the AMF process, emphases are given to adsorptive oxidation, micellar catalysis, selectivity. Furthermore, for the first time, this review gives an overview of understanding the state-of-the-art multifunctional nano amphiphile-based AMF that behaves mimetic to aquatic organisms in the process of pollutant removal. The efficiency of AMF, including recycling concentrated solution without noticeable deterioration, as an auxiliary resource/income for the next cycle, signifies economic viability, versatility, and manifold applications in aqua remediation. Significance, ways to achieve enhanced process efficiency, as well as challenges and future opportunities in wastewater treatment, are also highlighted.

Water Purification of Classical and Emerging Organic Pollutants: An Extensive Review

The main techniques used for organic pollutant removal from water are adsorption, reductive and oxidative processes, phytoremediation, bioremediation, separation by membranes and liquid–liquid extraction. In this review, strengths and weaknesses of the different purification techniques are discussed, with particular attention to the newest results published in the scientific literature. This study highlighted that adsorption is the most frequently used method for water purification, since it can balance high organic pollutants removal efficiency, it has the possibility to treat a large quantity of water in semi-continuous way and has acceptable costs.

Comparison of an integrated short-cut biological nitrogen removal process with magnetic coagulation treating swine wastewater and food waste digestate

An integration of two processes, magnetic coagulation (MC) and short-cut biological nitrogen removal (SBNR), coupled with a sequencing batch membrane bioreactor (SMBR) controlled by an automatic real-time control strategy (RTC), was developed to treat different characteristics of high strength wastewater. The treatment efficiency and microbial community-diversity of the proposed method was evaluated and investigated using swine wastewater and food waste (FW) digestate. The MC showed high removal of TSS (89.1 ± 1.5%, 92.21 ± 1.8%), turbidity (90.58 ± 2.1%, 95.1 ± 2.1%), TP (88.5 ± 1.9%, 92.1 ± 1.5%), phosphate (87.76 ± 1.6%, 91.22 ± 1.5%), and SMBR achieved stable and excellent removal of COD (96.05 ± 0.2%, 97.39 ± 0.2%), TN (97.30 ± 0.3%, 97.44 ± 0.3%) andNH₄⁺-N (99.07 ± 0.2%, 98.54 ± 0.2%) for swine wastewater and FW digestate, respectively. The effluent COD andNH₄⁺-N concentrations were found to meet their discharge standards. The microbial community comparison showed similar diversity and richness, and genus Diaphorobacter and Thaurea were dominant in denitritation, and Nitrosomonas was dominant in nitritation treating both swine wastewater and FW digestate.