Fermentation liquid production of food wastes as carbon source for denitrification: Laboratory and full-scale investigation

Insight into performance of nitrogen removal enhanced by adding lactic acid-rich food waste fermentation liquid as carbon source in municipal wastewater treatment

Lactic acid-rich fermentation liquid (LAFL) of food waste is found to act as a promising alternative carbon source for nitrogen removal in wastewater treatment. Here, LAFL was employed to investigate its impacts on nitrogen removal during raw municipal wastewater treatment with a comparison to sodium acetate (NaAc). Results indicated that nitrogen removals were comparable when incorporated with LAFL and NaAc (92.89 % v.s. 91.23 %). Unlike the utilization of NaAc, using LAFL could avoid suppressing the relative abundance of the nitrification genes and thus pose a negative risk to nitrogen removal during prolonged operation. The introduction of LAFL increased the stability and robustness of the functional microbial community and effectively reduced excess activated sludge (AS) generation by 109 % compared to NaAc addition, consequently enhancing nitrogen removal but diminishing the treatment cost. In general, LAFL exhibits prospective engineering application potentials and economic advantages in improving nitrogen removal by AS process.

Mitigation of N2O emissions via enhanced denitrification in a biological landfill leachate treatment using external carbon from fermented sludge

The effects of an external carbon source (C-source) on the mitigation of N₂O gas (N₂O_(g)) emissions from landfill leachate were investigated via enhanced denitrification using anaerobically fermented sewage sludge. Anaerobic fermentation of sewage sludge was conducted under thermophilic conditions with progressively increasing organic loading rates (OLR). Optimal conditions for fermentation were determined based on the efficiency of hydrolysis and the concentrations of sCOD and volatile fatty acids (VFAs) as follows: at an OLR of 40.48 ± 0.77 g COD/L·d with 1.5 days of solid retention time (SRT), 14.68 ± 0.59% of efficiency of hydrolysis, 14.42 ± 0.30 g sCOD/L and 7.85 ± 0.18 g COD/L of VFAs. Analysis of the microbial community in the anaerobic fermentation reactor revealed that degradation of sewage sludge might be potentially affected by proteolytic microorganisms producing VFAs from proteinaceous materials. Sludge-fermentate (SF) retrieved from the anaerobic fermentation reactor was used as the external C-source for denitrification testing. The specific nitrate removal rate (K_NR) of the SF-added condition was 7.54 mg NO₃^-N/g VSS·hr, which was 5.42 and 2.43 times higher than that of raw landfill leachate (LL) and a methanol-added condition, respectively. In the N₂O_(g) emission test, the liquid phase N₂O (N₂O-^N_(l)) of 20.15 mg N/L was emitted as N₂O_(g) of 19.64 ppmv under only LL-added condition. On the other hand, SF led to the specific N₂O_(l) reduction rate (K_N2O) of 6.70 mg N/g VSS hr, resulting in mitigation of 1.72 times the N₂O_(g) emission compared to under the only-LL-added condition. The present study revealed that N₂O_(g) emissions from biological landfill leachate treatment plants can be attenuated by simultaneous reduction of NO₃^-N and N₂O_(l) during enhanced denitrification via a stable supply of an external C-source retrieved from anaerobically fermented organic waste.

Conceptual system for sustainable and next-generation wastewater resource recovery facilities

Shifting the concept of municipal wastewater treatment to recover resources is one of the key factors contributing to a sustainable society. A novel concept based on research is proposed to recover four main bio-based products from municipal wastewater while reaching the necessary regulatory standards. The main resource recovery units of the proposed system include upflow anaerobic sludge blanket reactor for the recovery of biogas (as product 1) from mainstream municipal wastewater after primary sedimentation. Sewage sludge is co-fermented with external organic waste such as food waste for volatile fatty acids (VFAs) production as precursors for other bio-based production. A portion of the VFA mixture (product 2) is used as carbon sources in the denitrification step of the nitrification/denitrification process as an alternative for nitrogen removal. The other alternative for nitrogen removal is the partial nitrification/anammx process. The VFA mixture is separated with nanofiltration/reverse osmosis membrane technology into low-carbon VFAs and high-carbon VFAs. Polyhydroxyalkanoate (as product 3) is produced from the low-carbon VFAs. Using membrane contactor-based processes and ion-exchange techniques, high-carbon VFAs are recovered as one-type VFA (pure VFA) and in ester forms (product 4). The nutrient-rich fermented and dewatered biosolid is applied as a fertilizer. The proposed units are seen as individual resource recovery systems as well as a concept of an integrated system. A qualitative environmental assessment of the proposed resource recovery units confirms the positive environmental impacts of the proposed system.

Enhancement of denitrification efficiency using municipal and industrial waste fermentation liquids as external carbon sources

The addition of external carbon source for nitrogen removal from wastewater is an essential step in wastewater treatment. In this study, various external carbon sources from the fermentation of primary sludge (PS), thickened waste activated sludge (TWAS), food waste (FW), bakery processing & kitchen waste (BP + KW), fat, oil, & grease (FOG), and whey powder (WP) were successfully employed for wastewater denitrification. Methanol and acetate were also used as controls due to their common use as external carbon sources for wastewater denitrification. The denitrification performance and kinetics such as the specific denitrification rate (SDNR), denitrification potential (PDN), and the biomass yield were studied at a constant TVFA as COD/N ratio of 5 for all substrates. Complete denitrification was achieved with a NO₃^--N removal efficiency of 98-99%, and no NO₂^- accumulation was observed at the end of the experiments for all substrates. The results revealed that the liquid fermentation filtrates exhibited higher SDNRs than methanol and acetate. This indicates the high organic matter utilization efficiency and better denitrification ability of fermentation filtrates over conventional carbon sources. WP exhibited the highest SDNR of 17.6 mg NO_x - N/g VSS/h, which is approximately four times that of methanol (4.6 mg NO_x - N/g VSS/h). The other carbon sources had SDNRs two to three times higher than that of methanol. However, the fermentation filtrates exhibited higher biomass yields of 0.26-0.37 mg VSS/mg COD compared to methanol of 0.21 mg VSS/mg COD, which could lead to higher sludge handling costs. Moreover, methanol exhibited higher PDN of 0.25 g N/g COD compared to all the fermentation filtrates.

Inhibitory effect of oil and fat on denitrification using food waste fermentation liquid as carbon source

Food waste fermentation liquid (FWFL) can be used as carbon source to enhance nitrogen removal in wastewater treatment. However, the influence of lipid, a common component of food waste, on denitrification remains unclear. In this study, the effect of oil and fat on denitrification process and the underlying mechanisms were investigated using synthetic oil- and fat-bearing carbon source and verified with real FWFL. In the batch experiment, oil and fat had no obvious influence on denitrification, but in the semi-continuous experiment, the denitrification rate in the oil- and fat-added assays decreased to 44% and 38% of that in the control, respectively, after 45 batches. Oil and fat caused sludge floatation, and the floating sludge thickness increased with the continuous operation. Oil/fat-sludge aggregates were observed in the floating sludge and limited gas release. Microbial community analysis indicated that oil and fat did not affect denitrifying bacteria abundance. Limitation of mass transfer might be the main reason for the inhibition of oil and fat on denitrification. In the real FWFL experiment, the denitrification rate in the original and emulsified oil-bearing FWFL decreased to 24% and 56% of that in the demulsifying FWFL, respectively, after 45 batches. These findings indicate the necessity of removing lipids when FWFL is used as denitrification carbon source.