Sorption and migration of organophosphate flame retardants between sources and settled dust

Bis(2-ethylhexyl) phthalate transfer from polyvinyl chloride sheet to several kinds of particles

Bis(2-ethylhexyl) phthalate (DEHP) transfer from a polyvinyl chloride (PVC) sheet to 9 kinds of particles, namely, polyethylene particles (1-10, 45-53, 90-106 μm), soda lime glass particles (1-38, 45-53, 90-106 μm), black forest soil, carbon black, and cotton linter, for the particle weights of 0.3, 1, 3, and 12 mg/cm2, were determined for 1, 3, 7, and 14 days using a passive flux sampler (PFS), as well as standard dust. Transfer amounts to small polyethylene particles (1-10 μm), black forest soil, and carbon black were large (8.5, 16, and 48 μg/mg-particle, respectively, for 0.3 mg/cm2 for 14 days) and were similar to standard house dust (35 μg/mg-particle). On the other hand, transfer amount to large polyethylene particles (0.056-0.12 μg/mg-particle), soda lime glass (0.18-0.31 μg/mg-particle), and cotton linter (0.42-0.78 μg/mg-particle) were much lower. The DEHP transfer amount to the particles was proportional to the surface area of the particles, but not associated with the organic content. The DEHP transfer amount per surface area to small polyethylene particles was larger than that of other particles, suggesting the contribution of absorption into the polyethylene particle. However, for the larger polyethylene particles with different manufacturing process that may have different crystallinity, the contribution of absorption was small. The amount of DEHP transferred to soda lime glass did not differ from 1 to 14 days, suggesting that an adsorption equilibrium was reached after 1 day. The estimated value of particle/gas partition coefficients of DEHP, Kpg, of small polyethylene, black forest soil and carbon black were much higher (3.6, 7.1, and 18 m3/mg, respectively) than those of large polyethylene and soda lime glass particles (0.028-0.11 m3/mg).

Effects of TCPP and TCEP exposure on human corneal epithelial cells: Oxidate damage, cell cycle arrest, and pyroptosis

Tris(2-chloroisopropyl) phosphate (TCPP) and Tris(2-chloroethyl) phosphate (TCEP) are the widely used organophosphorus flame retardants indoors and easily accessible to the eyes as the common adhesive components of dust and particle matter, however, hardly any evidence has demonstrated their corneal toxicity. In this study, the adverse effects of TCPP, TCEP, and TCPP + TCEP exposure on human corneal epithelial cells (HCECs) were investigated. The cell viability and morphology, intracellular reactive oxygen species (ROS), cell cycle, and the expressions of cell cycle and pyroptosis-related genes were assessed to explain the underlying mechanisms. Compared to individual exposure, co-exposure to TCPP₂₀+TCEP₂₀ showed higher cytotoxicity with a sharp decrease of >30% in viability and more serious oxidative damage by increasing ROS production to 110.92% compared to the control group. Furthermore, the cell cycle arrested at the S phase (36.20%) was observed after combined treatment, evidenced by the upregulation of cyclin D1, CDK2, CDK4, CDK6, p21, and p27. Interestingly, pyroptosis-related genes GSDMD, Caspase-1, NLRP3, IL-1β, IL-18, NLRP1, and NLRC4 expressions were promoted with cell swelling and glowing morphology. Oxidative stress and cell cycle arrest probably acted as a key role in TCPP₂₀+TCEP₂₀-induced cytotoxicity and pyroptosis in HCECs. Our results suggested that TCPP₂₀+TCEP₂₀ co-exposure induced severer corneal damage, further illustrating its significance in estimating indoor health hazards to humans.

Exposure to flame retardants in European children - Results from the HBM4EU aligned studies

Many legacy and emerging flame retardants (FRs) have adverse human and environmental health effects. This study reports legacy and emerging FRs in children from nine European countries from the HBM4EU aligned studies. Studies from Belgium, Czech Republic, Germany, Denmark, France, Greece, Slovenia, Slovakia, and Norway conducted between 2014 and 2021 provided data on FRs in blood and urine from 2136 children. All samples were collected and analyzed in alignment with the HBM4EU protocols. Ten halogenated FRs were quantified in blood, and four organophosphate flame retardants (OPFR) metabolites quantified in urine. Hexabromocyclododecane (HBCDD) and decabromodiphenyl ethane (DBDPE) were infrequently detected (<16% of samples). BDE-47 was quantified in blood from Greece, France, and Norway, with France (0.36 ng/g lipid) having the highest concentrations. BDE-153 and -209 were detected in <40% of samples. Dechlorane Plus (DP) was quantified in blood from four countries, with notably high median concentrations of 16 ng/g lipid in Slovenian children. OPFR metabolites had a higher detection frequency than other halogenated FRs. Diphenyl phosphate (DPHP) was quantified in 99% of samples across 8 countries at levels ∼5 times higher than other OPFR metabolites (highest median in Slovenia of 2.43 ng/g lipid). FR concentrations were associated with lifestyle factors such as cleaning frequency, employment status of the father of the household, and renovation status of the house, among others. The concentrations of BDE-47 in children from this study were similar to or lower than FRs found in adult matrices in previous studies, suggesting lower recent exposure and effectiveness of PBDE restrictions.

Inadvertently Generated PCBs in Consumer Products: Concentrations, Fate and Transport, and Preliminary Exposure Assessment

Although commercial polychlorinated biphenyl (PCB) production was banned in 1979 under the Toxics Substance Control Act, inadvertent generation of PCBs through a variety of chemical production processes continues to contaminate products and waste streams. In this research, a total of 39 consumer products purchased from local and online retailer stores were analyzed for 209 PCB congeners. Inadvertent PCBs (iPCBs) were detected from seven products, and PCB-11 was the only congener detected in most of the samples, with a maximum concentration exceeding 800 ng/g. Emission of PCB-11 to air was studied from one craft foam sheet product using dynamic microchambers at 40 °C for about 120 days. PCB-11 migration from the product to house dust was also investigated. The IAQX program was then employed to estimate the emissions of PCB-11 from 10 craft foam sheets to indoor air in a 30 m3 room at 0.5 h-1 air change rate for 30 days. The predicted maximum PCB-11 concentration in the room air (156.8 ng/m3) and the measured concentration in dust (20 ng/g) were applied for the preliminary exposure assessment. The generated data from multipathway investigation in this work should be informative for further risk assessment and management for iPCBs.

Comprehensive analysis of triphenyl phosphate: An environmental explanation of colorectal cancer progression

Organophosphate flame retardants (OPFRs) are alternatives to brominated flame retardants (BFRs) and have recently gained wide acceptance in various materials. For the treatment and prevention of diseases, it is also important to clarify the relationship between OPFRs and tumors, despite the fact that OPFRs are less toxic than BFRs. This research used the TCGA and CTD databases for transcriptome profiling and identifying OPFRs-related genes. GO and KEGG analyses suggested that OPFRs may be closely related to colorectal cancer (CRC), and genes correlated with OPFRs were significantly and differently expressed between tumor and normal group. Further, OPFRs-related genes were associated with a good prognosis in CRC patients. The deeper research demonstrated that one of the OPFRs-triphenyl phosphate could significantly increased the viability and proliferation of CRC cell lines compared with the control group. In addition, Our research also found that melatonin at 50 μM could significantly impact CRC cell proliferation and migration ability induced by TPP.

Investigation on the Direct Transfer of SVOCs from Source to Settled Dust: Analytical Model and Key Parameter Determination

Settled dust is an important medium for semivolatile organic compound (SVOC) transport indoors. Understanding the mechanism of interaction between SVOCs and settled dust can greatly improve the exposure assessment. This study develops an analytical model to elucidate the mechanism of direct contact between SVOC sources and settled dust. The model incorporates the adsorption of SVOCs onto indoor surfaces, which was ignored in previous numerical models. Based on this model, a hybrid optimization method is applied to determine the key parameters of SVOC transport, i.e., the diffusion coefficient in the dust, the dust-air partition coefficient, and the chamber surface-air partition coefficient. Experiments of direct contact between SVOC source materials containing organophosphorus flame retardants (OPFRs) and settled dust were conducted in chambers. The key parameters were determined by performing curve fitting using data collected from the OPFR chamber tests and from the literature on phthalates. The reliability and robustness of the model and measurement method are demonstrated by the high fitting accuracy and sensitivity analysis. The obtained key parameters are more accurate than those from correlations in prior studies. Further analysis indicates that dust-air partition coefficient plays an important role and the adsorption effect on surfaces cannot be neglected for SVOC transport.

Predicting the emissions of VOCs/SVOCs in source and sink materials: Development of analytical model and determination of the key parameters

The emissions of volatile organic compounds (VOCs) and semi-volatile organic compounds (SVOCs) from indoor materials pose an adverse effect on people's health. In this study, a new analytical model was developed to simulate the emission behaviors for both VOCs and SVOCs under ventilated conditions. Based on this model, we further introduced a hybrid optimization method to accurately determine the key parameters in the model: the initial emittable concentration, the diffusion coefficient, the material/air partition coefficient, and the chamber surface/air partition coefficient (for SVOCs). Experiments for VOC emissions from solid wood furniture were performed to determine the key parameters. We also evaluated the hybrid optimization method with the data of flame retardant emissions from polyisocyanurate rigid foam and VOC emissions from a panel furniture in the literature. The correlation coefficients are high during the fitting process (R² = 0.92-0.99), demonstrating effectiveness of this method. In addition, we observed that chemical properties could transfer from SVOC-type to VOC-type with the increase of temperature. The transition temperatures from SVOC-type to VOC-type for the emissions of tris(2-chloroethyl) phosphate (TCEP) and tris(1-chloro-2-propyl) phosphate (TCIPP) were determined to be about 45 ℃ and 35 ℃, respectively. The present study provides a unified modelling and methodology analysis for both VOCs and SVOCs, which should be very useful for source/sink characterization and control.