High reusability and adsorption capacity of acid washed calcium alginate/chitosan composite hydrogel spheres in the removal of norfloxacin

Efficiency and mechanism of enhanced norfloxacin removal using amorphous TiO2-modified biochar

Inadequate treatment of antibiotic-contaminated wastewater, including compounds such as norfloxacin (NOR), poses a substantial treat to both ecological safety and human well-being. An innovative approach was devised to address NOR pollution using amorphous TiO2 modified biochar (A-TiO2/BC) prepared via sol-gel impregnation. The resultant had a commendably specific surface area of 131.8 m2/g-1, which was 1.91 times more than the original surface area of unmodified BC. A-TiO2/BC also exhibited abundant hydroxyl and oxygen-containing functional groups, thereby provided adequately active sites for NOR adsorption. R2 values obtained from NOR isotherm adsorption models descended in order of Freundlich < Temkin < Sips < Langmuir, which indicated that the NOR removal by A-TiO2/BC mainly complied with monolayer adsorption accompanied by heterogeneous surface adsorption. Under weakly acidic conditions, NOR adsorption benefits from the synergistic physicochemical interactions of A-TiO2 and BC. Notably, A-TiO2/BC demonstrated an impressive NOR adsorption capacity of up to 78.14 mg g-1, with a dosage of 20 mg L-1 at 25 °C under pH 6. Such A-TiO2 modified biochar thus presents a promising alternative for NOR removal.

Adsorptive removal of norfloxacin from aqueous solutions by Fe/Cu CNS-embedded alginate-carboxymethyl cellulose-chitosan beads

The pervasive application of pharmaceuticals in aquatic environments has acquired much focus owing to their nonbiodegradability and eco-toxicity, which might readily destroy the ecological balance. Developed chitosan-coated Fe-Cu CNS alginate-CMC beads (NBs) were utilized in this study to adsorb the quinolone antibiotic norfloxacin (NOR) from water for the first time. Under ideal conditions (CNOR: 20 mg L-1; sorbent conc.: 2000 mg L-1; sorbent dosage: 0.15 g; interaction time: 300 min; solution pH: 6.0), about 86% NOR removal was achieved through batch mode. The removal performance for NOR was examined concerning pH, ionic strength, and coexisting micropollutants. The greatest NOR removal was attained on NBs with the greatest Langmuir adsorption capacity of 355 mg g-1 due to numerous mechanisms such as sorbent pore filling, electrostatic attraction, π-π attraction and hydrogen bonding. Studies using environmentally significant algae, such as Scenedesmus sp., to analyze the residual toxicity of treated NOR solution revealed a significant reduction in their toxic effects. Current research has demonstrated that nanocomposite beads are an excellent wastewater treatment material with promising industrial applications due to their ease of synthesis, exceptional surface adsorption properties, stability, and environmentally friendly reaction.

Application of a novel polymer cross-linked with magnetite for efficient norfloxacin adsorption at a wide pH range

Nowadays, NOR-containing wastewater has placed huge pressure on global ecology. In this study, a chemically-modified chitosan-based polymer was cross-linked with magnetite to prepare a novel magnetic composite adsorbent named Fe3O4/CS-P(AM-SSS) for norfloxacin (NOR) removal. The preparation conditions were optimized by single factor experiments and response surface methodology. A series of characterization analyses were carried out on the morphology, structure, and properties of Fe3O4/CS-P(AM-SSS), verifying that Fe3O4/CS-P(AM-SSS) was successfully prepared. Batch adsorption experiments showed that NOR was efficiently removed by Fe3O4/CS-P(AM-SSS), with a broad pH applicability of 3-10, short adsorption equilibrium time of 60 min, maximum adsorption capacity of 268.79 mg/g, and high regeneration rate of 86% after eight adsorption-desorption cycles. Due to the three-dimensional network structure and abundant functional groups provided by modified chitosan polymer, the superior adsorption capability of Fe3O4/CS-P(AM-SSS) was achieved through electrostatic interaction, π-π stacking, hydrophobic interaction, and hydrogen bonding. Adsorption process was exothermic and well fitted by the pseudo-second-order kinetic model and the Langmuir isothermal model. The presence of cations had a slight inhibitory effect on NOR adsorption, while humic acid nearly had no effect. In model swine wastewater, 90.3% NOR was removed by Fe3O4/CS-P(AM-SSS). Therefore, with these superior characteristics, Fe3O4/CS-P(AM-SSS) was expected to be an ideal material for treating NOR-containing wastewater in the future.

Efficient adsorption of chloroquine phosphate by a novel sodium alginate/tannic acid double-network hydrogel in a wide pH range

In this work, a novel double-network composite hydrogel (SA/TA), composed of sodium alginate (SA) and tannic acid (TA), was designed and fabricated by a successive cross-linking method using Ti(IV) and Ca(II) as crosslinkers. SA/TA exhibited reinforced mechanical strength and anti-swelling properties because of the double-network structure. SA/TA was used as an adsorbent for removal of a popular antiviral drug, chloroquine phosphate (CQ), in water. The adsorption performance of SA/TA was systematically investigated, to study various effects including those of TA mass content, solution pH, adsorption time, and initial CQ concentration. Adsorption was also examined in presence of inorganic and organic coexisting substances commonly found in wastewater, and under different actual water samples. Batch experimental results indicated that SA/TA could maintain higher and more stable CQ uptakes within a wide solution pH range from 3.0 to 10.0, compared to its precursor, SA hydrogel, owing to the addition of TA-Ti(IV) coordination network. The maximum experimental CQ uptake exhibited by the 1:1 (by wt) SA/TA (SA/TA2) was as high as 0.699 mmol/g at the initial pH of 9.0. A high concentration of coexisting NaCl evidently reduced the CQ uptakes of SA/TA2 due to the electrostatic shielding effect, moreover, divalent cations including Ca(II) and Mg(II) also inhibited the adsorption of CQ due to competitive adsorption. However, humic acid had little effect on this adsorption. Considering the apparent adsorption performance, the aforementioned effects of various factors and the spectroscopic characterizations, multi-interactions are suggested for adsorption including chelation, electrostatic interactions, π-π electron donor-acceptor interaction and hydrogen bonding. SA/TA showed a slight loss in adsorption capacity toward CQ and sustained physicochemical structural stability, even after six adsorption-desorption cycles. In addition to CQ, SA/TA could be efficiently used for adsorption of two other antivirus drugs, namely, hydroxychloroquine sulfate and oseltamivir phosphate. This work provides an effective strategy for the design and fabrication of novel adsorbents that can effectively adsorb antiviral drugs over a wide pH range.

ZnO-Ti3C2TX composites supported on polyacrylic acid/chitosan hydrogels as high-efficiency and recyclable photocatalysts for norfloxacin degradation

Photocatalysts immobilized on hydrogels is a win-win mode, which not only improves photocatalysis but also successfully prevents catalyst loss, making it easy to separate and reuse during catalytic process. Here, ZnO-Ti3C2TX photocatalysts are loaded into the chitosan/polyacrylic acid hydrogel networks, realizing the efficiently photocatalytic degradation of norfloxacin. The chitosan-based composite hydrogel features rich functional groups and a dense pore structure, which is beneficial to antibiotic enrichment and photocatalytic degradation. The effects of different catalyst ratios, dosage, initial concentrations and pH on the degradation efficiency are investigated. The norfloxacin degradation rate constant is 0.012 min-1 and its degradation efficiency reaches up to 90 % after 240 min. Importantly, the photocatalytic composite hydrogel still retains 85 % degradation efficiency after 6 cycles. Moreover, e- plays a significant role in the degradation process. This work converts the traditional powder photocatalysts into bulk photocatalysts (photocatalytic hydrogels) to accomplish efficient degradation and rapid recycling for contaminant removal.

Environmental remediation of the norfloxacin in water by adsorption: Advances, current status and prospects

Antibiotics are considered as the new generation water pollutants as these disturb endocrine systems if water contaminated with antibiotics is consumed. Among many antibiotics norfloxacin is present in various natural water bodies globally. This antibiotic is considered an emerging pollutant due to its low degradation in aquatic animals. Besides, it has many side effects on human vital organs. Therefore, the present article discusses the recent advances in the removal of norfloxacin by adsorption. This article describes the presence of norfloxacin in natural water, consumption, toxicity, various adsorbents for norfloxacin removal, optimization factors for norfloxacin removal, kinetics, thermodynamics, modeling, adsorption mechanism and regeneration of the adsorbents. Adsorption takes place in a monolayer following the Langmuir model. The Pseudo-second order model represents the kinetic data. The adsorption capacity ranged from 0.924 to 1282 mg g-1. In this sense, the parameters such as the NFX concentration added to the adsorbent textural properties exerted a great influence. Besides, the fixed bed-based removal at a large scale is also included. In addition to this, the simulation studies were also discussed to describe the adsorption mechanism. Finally, the research challenges and future perspectives have also been highlighted. This article will be highly useful for academicians, researchers, industry persons, and government authorities for designing future advanced experiments.

Chitosan Hydrogels for Water Purification Applications

Chitosan-based hydrogels have gained significant attention for their potential applications in water treatment and purification due to their remarkable properties such as bioavailability, biocompatibility, biodegradability, environmental friendliness, high pollutants adsorption capacity, and water adsorption capacity. This article comprehensively reviews recent advances in chitosan-based hydrogel materials for water purification applications. The synthesis methods, structural properties, and water purification performance of chitosan-based hydrogels are critically analyzed. The incorporation of various nanomaterials into chitosan-based hydrogels, such as nanoparticles, graphene, and metal-organic frameworks, has been explored to enhance their performance. The mechanisms of water purification, including adsorption, filtration, and antimicrobial activity, are also discussed in detail. The potential of chitosan-based hydrogels for the removal of pollutants, such as heavy metals, organic contaminants, and microorganisms, from water sources is highlighted. Moreover, the challenges and future perspectives of chitosan-based hydrogels in water treatment and water purification applications are also illustrated. Overall, this article provides valuable insights into the current state of the art regarding chitosan-based hydrogels for water purification applications and highlights their potential for addressing global water pollution challenges.