Enzymatic synthesis optimization of a cosmetic ester catalyzed by a homemade biocatalyst prepared via physical adsorption of lipase on amino-functionalized rice husk silica

Investigation on solvent-free esterification of oleic acid by hemp tea waste-immobilized Candida rugosa lipase

This study aimed at Candida rugosa lipase immobilization on a low-cost and readily available support. Among agro-industrial crops, hemp tea waste was chosen as the carrier because it provides higher immobilization performance than hemp flower and leaf wastes. Support characterization by ATR-FTIR, SEM and elemental analysis and the optimization of the adsorption immobilization process were performed. The lipase adsorption immobilization was obtained by soaking the support with hexane under mild agitation for 2 h and a successively incubating the enzyme for 1 h at room temperature without removing the solvent. The esterification of oleic acid with n-decanol was tested in a solvent-free system by studying some parameters that influence the reaction, such as the substrates molar ratio, the lipase activity/oleic acid ratio, reaction temperature and the presence/absence of molecular sieves. The biocatalyst showed the ability to bring the esterification reaction to equilibrium under 60 min and good reusability (maintaining 60 % of its original activity after three successive esterification reactions) but low conversion (21 %) at the optimized conditions (40 °C, 1:2 substrates molar ratio, 0.56 lipase/oleic acid ratio, without sieves). Comparing the results with those obtained by free lipase form at the same activity (1 U) and experimental conditions, slightly higher conversion (%) appeared for the free lipase. All this highlighted that probably the source of lipase for its carbohydrate-binding pocket and lid structure affected the esterification of oleic acid but certainly, the immobilization didn't induce any lipase conformational change also allowing the reuse of the catalytic material.

Improved Synthesis of Deoxyadenosine Triphosphate by Saccharomyces cerevisiae Using an Efficient ATP Regeneration System: Optimization of Response Surface Analysis

Deoxyadenosine triphosphate (dATP) is an important biochemical molecule. In this paper, the synthesis of dATP from deoxyadenosine monophosphate (dAMP), catalyzed by Saccharomyces cerevisiae, was studied. By adding chemical effectors, an efficient ATP regeneration and coupling system was constructed to achieve efficient synthesis of dATP. Factorial and response surface designs were used to optimize process conditions. Optimal reaction conditions were as follows: dAMP 1.40 g/L, glucose 40.97 g/L, MgCl₂·6H₂O 4.00 g/L, KCl 2.00 g/L, NaH₂PO₄ 31.20 g/L, yeast 300.00 g/L, ammonium chloride 0.67 g/L, acetaldehyde 11.64 mL/L, pH 7.0, temperature 29.6 °C. Under these conditions, the substrate conversion was 93.80% and the concentration of dATP in the reaction system was 2.10 g/L, which was 63.10% higher than before optimization, and the concentration of product was 4 times higher than before optimization. The effects of glucose, acetaldehyde, and temperature on the accumulation of dATP were analyzed.

Renewable, sustainable, and natural lignocellulosic carriers for lipase immobilization: A review

It is well-known that enzymes are molecules particularly susceptible to pH and temperature variations. Immobilization techniques may overcome this weakness besides improving the reusability of the biocatalysts. Given the strong push toward a circular economy, the use of natural lignocellulosic wastes as supports for enzyme immobilization has been increasingly attractive in recent years. This fact is mainly due to their high availability, low costs, and the possibility of reducing the environmental impact that can occur when they are improperly stored. In addition, they have physical and chemical characteristics suitable for enzyme immobilization (large surface area, high rigidity, porosity, reactive functional groups, etc.). This review aims to guide readers and provide them with the tools necessary to select the most suitable methodology for lipase immobilization on lignocellulosic wastes. The importance and the characteristics of an increasingly interesting enzyme, such as lipase, and the advantages and disadvantages of the different immobilization methods will be discussed. The various kinds of lignocellulosic wastes and the processing required to make them suitable as carriers will be also reported.

The Recent Advances in the Utility of Microbial Lipases: A Review

Lipases are versatile biocatalysts and are used in different bioconversion reactions. Microbial lipases are currently attracting a great amount of attention due to the rapid advancement of enzyme technology and its practical application in a variety of industrial processes. The current review provides updated information on the different sources of microbial lipases, such as fungi, bacteria, and yeast, their classical and modern purification techniques, including precipitation and chromatographic separation, the immunopurification technique, the reversed micellar system, aqueous two-phase system (ATPS), aqueous two-phase flotation (ATPF), and the use of microbial lipases in different industries, e.g., the food, textile, leather, cosmetics, paper, and detergent industries. Furthermore, the article provides a critical analysis of lipase-producing microbes, distinguished from the previously published reviews, and illustrates the use of lipases in biosensors, biodiesel production, and tea processing, and their role in bioremediation and racemization.

Optimized Conditions for Preparing a Heterogeneous Biocatalyst via Cross-Linked Enzyme Aggregates (CLEAs) of β-Glucosidase from Aspergillus niger

This study mainly aims to find the optimal conditions for immobilizing a non-commercial β-glucosidase from Aspergillus niger via cross-linked enzyme aggregates (CLEAs) by investigating the effect of cross-linking agent (glutaraldehyde) concentration and soy protein isolate/enzyme ratio (or spacer/enzyme ratio) on the catalytic performance of β-glucosidase through the central composite rotatable design (CCRD). The influence of certain parameters such as pH and temperature on the hydrolytic activity of the resulting heterogeneous biocatalyst was assessed and compared with those of a soluble enzyme. The catalytic performance of both the soluble and immobilized enzyme was assessed by hydrolyzing ρ-nitrophenyl-β-D-glucopyranoside (ρ-NPG) at pH 4.5 and 50 °C. It was found that there was a maximum recovered activity of around 33% (corresponding to hydrolytic activity of 0.48 U/mL) in a spacer/enzyme ratio of 4.69 (mg/mg) using 25.5 mM glutaraldehyde. The optimal temperature and pH conditions for the soluble enzyme were 60 °C and 4.5, respectively, while those for CLEAs of β-glucosidase were between 50 and 65 °C and pH 3.5 and 4.0. These results reveal that the immobilized enzyme is more stable in a wider pH and temperature range than its soluble form. Furthermore, an improvement was observed in thermal stability after immobilization. After 150 days at 4 °C, the heterogeneous biocatalyst retained 80% of its original activity, while the soluble enzyme retained only 10%. The heterogeneous biocatalyst preparation was also characterized by TG/DTG and FT-IR analyses that confirmed the introduction of carbon chains via cross-linking. Therefore, the immobilized biocatalyst prepared in this study has improved enzyme stabilization, and it is an interesting approach to preparing heterogeneous biocatalysts for industrial applications.

Application of a constrained mixture design for lipase production by Penicillium roqueforti ATCC 10110 under solid-state fermentation and using agro-industrial wastes as substrate

Solid state fermentation (SSF) simulates the natural conditions fungal growth, where the amount of water in the reaction medium must be restricted, thus limiting the use of liquid substrate. An analytical strategy to deal with this limitation is the design of blending with constraints. Thus, the objective of the work was to optimize two constrained waste mixtures for the production of lipase by Penicillium roqueforti ATCC 10110 under SSF, using different substrates that combine solid and liquid waste. For this, the best fermentation time was determined through a fermentative profile, afterwards a restricted-mix design with lower and upper limits of the components of mixture I (cocoa residue, solid palm oil residue and liquid palm oil residue) and II (cocoa residue, mango residue and palm oil residue liquid palm) was applied. By means of Pareto and contour graphs, the maximum production points of lipase in mixtures I (6.67 ± 0.34 U g^-1) and II (6.87 ± 0.35 U g^-1) were obtained. The restricted mixture design proved to be a promising tool in the production of lipase by P. roqueforti ATCC 10110 under SSF since the use of restrictions is useful when intending to combine solid and liquid residues in fermentation processes.

Candida rugosa lipase immobilized on hydrophobic support Accurel MP 1000 in the synthesis of emollient esters

OBJECTIVES

To immobilize Candida rugosa lipase in Accurel MP 1000 (CRL-AMP) by physical adsorption in organic medium and apply in the synthesis of wax esters dodecanoyl octadecanoate 1 and hexadecanoyl octadecanoate 2 in a heptane medium, as well as evaluating the stability and recyclability of CRL-AMP in six reaction cycles.

RESULTS

The specific activity (A_sp) for CRL-AMP was 200 ± 20 U mg^-1. Its catalytic activity was 1300 ± 100 U g^-1. CRL-AMP was used in the synthesis of esters in heptane medium with a 1:1 acid:alcohol molar ratio at 45 °C and 200 rpm. In synthesis 1, conversion was 62.5 ± 3.9% in 30 min at 10% m v^-1 and 56.9 ± 2.8% in 54 min at 5% m v^-1; while in synthesis 2, conversion was 79.0 ± 3.9% in 24 min at 10% m v^-1, and 46.0 ± 2.4% in 54 min at 5% m v^-1. Reuse tests after six consecutive cycles of reaction showed that the biocatalyst retained approximately 50% of its original activity for both reaction systems.

CONCLUSIONS

CRL-AMP showed a high potential in the production of wax esters, since it started from low enzymatic load and high specific activities and conversions were obtained, in addition to allowing an increase in stability and recyclability of the prepared biocatalyst.

Current Status and Future Perspectives of Supports and Protocols for Enzyme Immobilization

The market for industrial enzymes has witnessed constant growth, which is currently around 7% a year, projected to reach $10.5 billion in 2024. Lipases are hydrolase enzymes naturally responsible for triglyceride hydrolysis. They are the most expansively used industrial biocatalysts, with wide application in a broad range of industries. However, these biocatalytic processes are usually limited by the low stability of the enzyme, the half-life time, and the processes required to solve these problems are complex and lack application feasibility at the industrial scale. Emerging technologies create new materials for enzyme carriers and sophisticate the well-known immobilization principles to produce more robust, eco-friendlier, and cheaper biocatalysts. Therefore, this review discusses the trending studies and industrial applications of the materials and protocols for lipase immobilization, analyzing their advantages and disadvantages. Finally, it summarizes the current challenges and potential alternatives for lipases at the industrial level.

Immobilization of Candida rugosa lipase on magnetic chitosan beads and application in flavor esters synthesis

In this work, magnetic chitosan (MCH) beads were synthesized by phase-inversion method, and grafted with polydopamine (PDA) and then used for direct immobilization of Candida rugosa lipase by Schiff base reaction. The amount of immobilized enzyme and the retained activity were found to be 47.3 mg/g and 72.8%, respectively, at pH 7.0, and at 25 °C. The apparent Km (9.7 mmol/L), and Vmax (384 U/mg) values of the immobilized lipase were significantly changed compared to the free lipase. The MCH@PDA-lipase was better thermal and storage stability at different temperatures than those of the free lipase. In hexane medium, the esterification reaction results showed that the maximum conversions of isoamylalcohol and isopentyl alcohol to isoamyl acetate and isopentyl acetate using the MCH@PDA-lipase were found to be 98.4 ± 1.3% and 73.7 ± 0.7%, respectively. These results showed that the MCH@PDA-lipase can be used as an operative immobilized enzyme system for many biotechnological applications.

Sustainable Enzymatic Synthesis of a Solketal Ester—Process Optimization and Evaluation of Its Antimicrobial Activity

The present study aims the enzymatic synthesis of solketal palmitate by esterification between solketal and palmitic acid using heptane as solvent. Lipases from Thermomyces lanuginosus (TLL), Candida rugosa type VII (CRL), and Pseudomonas fluorescens (PFL) were immobilized via interfacial activation on rice husk silica functionalized with triethoxy(octyl)silane (Octyl–SiO2) and used as biocatalysts. A loading of 20–22 mg of lipase/g of support was immobilized independently of the studied enzyme. TLL–Octyl–SiO2 was the most active biocatalyst in oil hydrolysis (656.0 ± 23.9 U/g) and ester synthesis (productivity of 6.8 mmol/min.gbiocat), and it has been chosen for further ester synthesis optimization. The effect of some important parameters such as biocatalyst concentration, reaction temperature and acid:alcohol molar ratio on the reaction has been evaluated using a central composite rotatable design at fixed mechanical stirring (240 rpm) and reaction time (15 min). Subsequently, the effect of reactants concentration and molecular sieve concentration has also been examined. Under optimal conditions (56 °C, acid:alcohol molar ratio of 1:3 with a palmitic acid concentration of 1 M, and 20% wt. of TLL–Octyl–SiO2 per volume of reaction mixture), 83% acid conversion was obtained after 150 min of reaction. The biocatalyst retained 87% of its initial activity after seven successive reaction batches. The product was identified by nuclear magnetic resonance analysis. Antimicrobial activity studies showed that the synthesized ester demonstrated antifungal activity against Candida albicans and Candida parapsilosis, with minimum inhibitory concentration (MIC) between 200 and 400 µg/mL, and bacteriostatic/fungistatic action—minimum microbicial concentration (MMC) > 400 µg/mL.