High performance liquid chromatography–tandem mass spectrometry for the analysis of 10 pesticides in water: A comparison between membrane-assisted solvent extraction and solid phase extraction

Molecularly imprinted polypyrrole nanotubes based electrochemical sensor for glyphosate detection

An electrochemical sensor based on molecularly imprinted polypyrrole nanotubes (MIPNs) has been developed for the detection of glyphosate (Gly) with high sensitivity and specificity. Herein, the MIPNs are prepared by imprinting Gly sites on the surface of polypyrrole (PPy) nanotubes. The synthesized MIPNs have high electrical conductivity and exhibit rapid adsorption rate, enhanced affinity and specificity to Gly. An electrochemical sensor for Gly detection is fabricated by assembling MIPNs-modified screen-printed electrodes with a 3D-printed electrode holder, which is highly portable and suitable for real-time detection. The results demonstrate that the MIPNs-based electrochemical sensor for Gly exhibits a wide detection range of 2.5-350 ng/mL with a limit of detection (LOD) of 1.94 ng/mL. Besides, the Gly sensor possessed good stability, reproducibility, and excellent selectivity against other interferents. The practicability of the sensor is verified by detecting Gly in orange juice and rice beverages, indicating that the sensor is suitable for monitoring pesticides in actual food and environmental samples.

Optimising factors affecting solid phase extraction performances of molecular imprinted polymer as recent sample preparation technique

Molecular imprinted solid-phase extraction is the technique that uses molecular imprinted polymer as the sorbent in solid phase extraction. Molecular imprinted solid-phase extraction is effective and efficient for the extraction process and cleaning as compared with solid phase extraction (SPE) without molecular imprinted polymer. The complexity of variables in molecular imprinted solid-phase extraction arise as problems in the analysis, therefore it is necessary to optimize the extraction conditions of molecular imprinted solid-phase extraction. To achieve the sorption equilibrium and achieve the shortest time, certain parameters such as contact time, ion strength of sample, pH of sample, amount of sorbent, sample flow rate, addition of salt and buffer solution, washing solvent, elution solvent, and loading solvent need to be optimized. The selection of suitable properties and quantities of each factor greatly affect the formation of appropriate interactions between the sorbent and analytes. Percentage recovery is also influenced by formation of the appropriate bonds, sample flow rates, extraction time, salt addition, and sorbent mass. Therefore, in the future, molecular imprinted solid-phase extraction optimization has to consider and adjust various factors reviewed in this paper to form appropriate interactions between the absorbent and target molecules which have an impact on the optimal results.

Biocide emissions from building materials during wet weather: identification of substances, mechanism of release and transfer to the aquatic environment

Biocides are added to or applied on building materials to prevent microorganisms from growing on their surface or to treat them. They are leached into building runoff and contribute to diffuse contamination of receiving waters. This review aimed at summarizing the current state of knowledge concerning the impact of biocides from buildings on the aquatic environment. The objectives were (i) to assess the key parameters influencing the leaching of biocides and to quantify their emission from buildings, (ii) to determine the different pathways from urban sources into receiving waters and (iii) to assess the associated environmental risk. Based on consumption data and leaching studies, a list of substances to monitor in receiving water was established. Literature review of their concentrations in the urban water cycle showed evidences of contamination and risk for aquatic life, which should put them into consideration for inclusion to European or international monitoring programs. However, some biocide concentration data in urban and receiving waters is still missing to fully assess their environmental risk, especially for isothiazolinones, iodopropynyl carbamate, zinc pyrithione and quaternary ammonium compounds, and little is known about their transformation products. Although some models supported by actual data were developed to extrapolate emissions on larger scales (watershed or city scales), they are not sufficient to prioritize the pathways of biocides from urban sources into receiving waters during both dry and wet weathers. Our review highlights the need to reduce emissions and limit their transfer into rivers and reports several solutions to address these issues.

An environmentally friendly method for the determination of triazine herbicides in estuarine seawater samples by dispersive liquid-liquid microextraction

A fast, simple, sensitive and green chemistry method using dispersive liquid-liquid microextraction (DLLME) for the simultaneous determination of seven triazine herbicides (ametryn, atrazine, cyanazine, propazine, simazine, simetryn and terbuthylazine) in estuarine seawater samples has been developed. DLLME was carried out using a small volume of seawater (25 mL) and 300 μL of 1-octanol. Herbicide concentrations were determined by liquid chromatography-diode array detection, and results were confirmed by liquid chromatography-electrospray ionisation tandem spectrometry analysis. The analytical features of the proposed method were satisfactory with repeatability < ±5% and intermediate precision < ±10%, and recoveries ranged from 81-102% for all compounds. All the triazines exhibited linear matrix calibration curves with coefficients of determination >0.999 for all the analytes except for simazine (0.9975). Limits of quantification ranged between 0.19 and 1.12 μg L(-1). The method was applied to the analysis of seawater samples from ten points susceptible to contamination by triazines from estuary of A Coruña (Galicia, NW of Spain). The levels of the seven triazines were below the LODs in the analysed samples. Use of proposed method will allow for monitoring of triazines at levels below the regulatory limits set by the European Directive 2008/105/EC of 2 and 4 μg L(-1) for atrazine and simazine, respectively.

Square-Wave Voltammetric Determination of Nanomolar Levels of Linuron in Environmental Water Samples Using a Glassy Carbon Electrode Modified with Platinum Nanoparticles within a Dihexadecyl Phosphate Film

A new sensitive method for linuron determination using a glassy carbon electrode modified with platinum nanoparticles within a dihexadecyl phosphate film (PtNPs-DHP/GCE) and square-wave voltammetry was proposed. The PtNPs-DHP/GCE was characterised by scanning electron microscopy and the diameter of the Pt nanoparticles was between 13 and 34 nm. The electrochemical behaviour of linuron was studied using cyclic voltammetry and an irreversible anodic peak was obtained at a potential of 1.2 V in 0.1 mol L–1 phosphate buffer (pH 3.0) solution. The analytical curve, obtained by square-wave voltammetry after accumulation, was linear in the linuron concentration range from 1.0 to 74.0 nmol L–1, with a detection limit of 0.61 nmol L–1. This sensitive analytical method was successfully applied for linuron determination in environmental water samples with results that showed good agreement with those obtained using a comparative HPLC method.

Matrix effect during the membrane-assisted solvent extraction coupled to liquid chromatography tandem mass spectrometry for the determination of a variety of endocrine disrupting compounds in wastewater

Membrane-assisted solvent extraction (MASE) coupled to liquid chromatography-triple quadrupole mass spectrometry (LC-MS/MS) was studied for the determination of a variety of emerging and priority compounds in wastewater. Among the target analytes studied certain hormones (estrone (E1), 17β-estradiol (E2), androsterone (ADT), 17α-ethynyl estradiol (EE2), diethylstilbestrol (DES), equilin (EQ), testosterone (TT), mestranol (MeEE2), 19-norethisterone (NT), progesterone (PG) and equilenin (EQN)), alkylphenols (APs) (4-tert-octylphenol (4tOP), nonylphenol technical mixture (NPs) and 4n-octylphenol (4nOP)) and BPA were included. The work was primarily focused in the LC-MS/MS detection step, both in terms of variable optimization and with respect to the matrix effect study. Both, electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) were assessed both in the negative and positive mode, including the optimization of MS/MS operating conditions. The best results were obtained, in most of the cases, for ESI using 0.05% ammonium hydroxide as buffer solution in the mobile phase, composed with methanol and water. Under optimum detection conditions, matrix effect during the detection step was thoroughly studied. Dilution, correction with deuterated analogues and clean-up of the extracts were evaluated for matrix effect correction. Clean-up with Florisil together with correction with deuterated analogues provided the most satisfactory results, with apparent recoveries in the 57-136% range and method detection limits in the low ngL(-1) level for most of the analytes. For further validation of the method, two separated extraction procedures, the above mentioned MASE, and conventional solid phase extraction (SPE) were compared during the analysis of real samples and comparable results were successfully obtained for E1, E2, EE2, DES, NT, TT, EQ, PG, BPA, ADT, 4nOP, 4tOP, NPs and EQN.

Part I: temporal and spatial distribution of multiclass pesticide residues in lake waters of Northern Greece: application of an optimized SPE-UPLC-MS/MS pretreatment and analytical method

The present work describes the application of an analytical procedure, utilizing ultra performance liquid chromatography (UPLC) coupled with mass spectrometry instrumentation, for the determination of 253 multiclass pesticides, classified in six different groups. Solid phase extraction was applied for the isolation and pre-concentration of target compounds in water samples. Surface waters of the lakes located in Northern Greece (Volvi, Doirani, and Kerkini), were collected in two time periods (fall/winter 2010 and spring/summer 2011) and analyzed, applying the developed analytical methods. Spatial distribution of detected pesticides was visualized using interpolation methods and geographical information systems (GIS). Pesticides with maximum concentrations were amitrole, propoxur, simazine, chlorpyrifos, carbendazim, triazophos, disulfoton-sulfone, pyridaben, sebuthylazine, terbuthylazine, atrazine, atrazine-desethyl, bensulfuron-methyl, metobromuron, metribuzin, rotenone, pyriproxyfen, and rimsulfuron. In Lake Kerkini, mainly carbamates and triazines were determined at elevated concentrations, near the coastal point of the NW side of the lake. Seasonal variations were strong among the applied pesticide classes and determined concentrations, indicating the contribution of pesticide application patterns and rainfall. Lake Doirani exhibited organophosphate pesticides at higher concentrations mainly at coastal points, while triazines emerged as the main pollutant during spring sampling. Lake Volvi exhibited the highest pesticide concentrations, mostly triazines and ureas at the central part of the lake. The occurrence of extreme values and nonconstant seasonal variations indicated that the concentrations were increased disproportionately during the second sampling, as a result of the varying contribution of pollution sources right after the application period. In all cases, the total concentration of pesticides increased during the second sampling period.

Application of a developed method for the extraction of triazines in surface waters and storage prior to analysis to seawaters of Galicia (northwest Spain)

A simple method based on solid-phase extraction combined with liquid chromatography for simultaneous determination of nine triazine herbicides (ametryn, atrazine, cyanazine, prometryn, propazine, simazine, simetryn, terbuthylazine, and terbutryn) in surface water samples was developed and validated. Under optimized conditions, 50 mL of water sample was pumped through the Oasis HLB cartridge, and triazines were eluted with 3 mL acetone. Finally the extract was concentrated to dryness, reconstituted with 1 mL methanol : water (1 : 1) and injected into the HPLC-DAD system. The stability of the herbicides on the cartridges at −18 and 4°C was also evaluated, and the recoveries obtained after three weeks of storage were satisfactory for all compounds. The analytical features of the proposed method were satisfactory: repeatability and intermediate precision were <10% and recoveries in spiked river water and seawater samples were higher than 93% for all compounds studied. Limits of quantification (varied from 0.46 to 0.98 µg L⁻¹) were adequately allowing the determination of these compounds at the levels requested by the 2008/105/EC Directive. Finally, this method was applied to the analysis of 50 seawater samples from Galicia (northwest Spain).

Membrane-assisted solvent extraction coupled to large volume injection–gas chromatography–mass spectrometry for the determination of a variety of endocrine disrupting compounds in environmental water samples

Membrane-assisted solvent extraction coupled to large volume injection in a programmable temperature vaporisation injector using gas chromatography–mass spectrometry analysis was optimised for the simultaneous determination of a variety of endocrine disrupting compounds in environmental water samples (estuarine, river and wastewater). Among the analytes studied, certain hormones, alkylphenols and bisphenol A were included. The nature of membranes, extraction solvent, extraction temperature, solvent volume, extraction time, ionic strength and methanol addition were evaluated during the optimisation of the extraction. Matrix effects during the extraction step were studied in different environmental water samples: estuarine water, river water and wastewater (influent and effluent). Strong matrix effects were observed for most of the compounds in influent and effluent samples. Different approaches were studied in order to correct or minimise matrix effects, which included the use of deuterated analogues, matrix-matched calibration, standard addition calibration, dilution of the sample and clean-up of the extract using solid-phase extraction (SPE). The use of deuterated analogues corrected satisfactorily matrix effect for estuarine and effluent samples for most of the compounds. However, in the case of influent samples, standard addition calibration and dilution of the sample were the best approaches. The SPE clean-up provided similar recoveries to those obtained after correction with the corresponding deuterated analogue but better chromatographic signal was obtained in the case of effluent samples. Method detection limits in the 5-54 ng L(-1) range and precision, calculated as relative standard deviation, in the 2-25% range were obtained.

Determination of pesticide residues in wine by membrane-assisted solvent extraction and high-performance liquid chromatography-tandem mass spectrometry

The determination of pesticides in food products is an essential issue to guarantee food safety and minimise health risks of consumers. A protocol based on membrane-assisted solvent extraction and liquid chromatography-tandem mass spectrometry (HPLC-MS/MS) that allows the determination of 18 pesticides in red wine at minimum labour effort for sample preparation was developed and validated. Ten millilitres of wine were extracted using 100 μL of toluene filled in a non-porous polyethylene membrane bag which is immersed in the wine sample. After 150 min extraction under stirring, an aliquot of the extraction solution is analysed using HPLC-MS/MS. The limits of quantification ranged from 3 ng/L for Pirimicarb to 1.33 μg/L for Imidacloprid. Quantification by matrix-matched calibration provided relative standard deviations ≤16 % for most of the target pesticides. The linearity of calibration was given over three to four orders of magnitude, which enables the reliable measurement of a broad range of pesticide concentrations, and for each target pesticide, the sensitivity of the protocol meets the maximum residue levels set by legislations at least for wine grapes. Good agreement of results was found when the new method was compared with a standard liquid-liquid extraction protocol. In five wine samples analysed, Carbendazim and Metalaxyl were determined at micrograms per litre concentrations, even in some of the organic wines. Tebuconazol and Cyprodinitril were determined at lower abundance and concentration, followed by Spiroxamin and Diuron.