Combining microwave-assisted extraction and liquid chromatography–ion-trap mass spectrometry for the analysis of hexabromocyclododecane diastereoisomers in marine sediments

Analysis of brominated flame retardants in the aquatic environment: a review

The most common and consequently analysed brominated flame retardants (BFRs) are polybrominated biphenyls (PBBs), polybrominated diphenyl ethers (PBDEs), tetrabromobisphenol A (TBBPA), tetrabromobisphenol S (TBBPS), and hexabromocyclododecane (HBCD). As these persistent organic pollutants are widespread in the environment and have a number of harmful effects on human health, the production and use of most has been banned for several years. The aquatic environment is polluted by these compounds through their deposition from the atmosphere, sewage sludge, wastewater treatment plants, and landfills, and higher levels are found in areas with developed industry and agriculture and near landfills. Each compound also seems to show preference for specific compartments of the aquatic environment, i.e. water, sediment, or aquatic organisms, according to their physicochemical properties. The aim of this review was to take a closer look at the analysis of BFRs, as without reliable analysis we would not be able to determine their levels and distribution across the aquatic compartments and assess human exposure and health risks. Particularly worrying are the health risks associated with PBDEs in fish, whose levels generally exceed the permitted values.

Determination of ten hexabromocyclododecane diastereoisomers using two coupled reversed-phase columns and liquid chromatography/tandem mass spectrometry

RATIONALE

Hexabromocyclododecanes (HBCDs) are raising concern due to their potential persistence, bioaccumulation and toxicity. Apart from the widely reported isomers α-, β-, γ-HBCD, other HBCD diastereoisomers such as δ-HBCD have been also recently found in environmental media and biota. These newly reported diastereoisomers might give more insight into the degradation and biotransformation of HBCDs.

METHODS

A reversed-phase C18 column coupled to a C8 column was used to improve the chromatographic resolution. A gradient mobile phase consisting of methanol, acetonitrile, and water, as well as tandem mass spectrometry parameters, were optimized. Ten HBCD diastereoisomers were finally determined by liquid chromatography/tandem mass spectrometry in multiple reaction monitoring mode with negative electrospray ionization.

RESULTS

Eight of the ten HBCDs could be chromatographically separated by using the coupled reversed-phase columns. Results of the method validation indicate high reproducibility and good sensitivity. The limit of detection ranged from 0.4 to 0.8 pg, and the relative standard deviations of intra- and inter-day injections ranged from 1.8 to 5.1% and from 2.7 to 9.5%, respectively. The developed method was further applied to the analysis of HBCDs in HBCD commercial products and soil samples. δ-, η-, θ-, and ε-HBCD were detected in commercial products and soil samples.

CONCLUSIONS

The present study revealed that δ-, η-, θ-, and ε-HBCD might occur ubiquitously in environmental media and biota. These newly reported diastereoisomers may help us to better understand the fate and transformation of HBCDs in the environment.

The Simultaneous Determination of Six Flame Retardants in Water Samples Using SPE Pre-concentration and UHPLC-UV Method

Analytical method for the determination of six flame retardants (FRs) from two groups was proposed. These groups included the brominated flame retardants (BFRs) 3,3',5,5'-tetrabromobisphenol A (TBBPA), 1,2,5,6,9,10-hexabromocyclododecane (HBCD) and tetrabromophthalic anhydride (TBPA) and triester organophosphate flame retardants (OPFRs) tris(2,3-dibromopropyl) phosphate (TBPP), ethylhexyl diphenyl phosphate (EHDP) and triphenyl phosphate (TPhP). Reversed phase ultrahigh-performance liquid chromatography (UHPLC) with a UV detector, different chromatographic columns, different mobile phases and gradient elution programmes were used to obtain the best separations within the shortest possible time. Solid-phase extraction (SPE) was examined as a pre-concentration step from distilled water. The column with the highest recoveries (the Bond Elut ENV column gave recoveries over 70 % for all compounds) was then tested on 1-L blank surface water samples. The proposed analytical procedure was applied for the determination of FRs in surface water samples. The concentrations of FRs found in water samples ranged from 0.03 (TPhP) to 3.10 μg L^-1 (HBCD). Method detection limits (MDLs) ranged from 0.008 to 0.518 μg L^-1, and method quantification limits (MQLs) ranged from 0.023 to 1.555 μg L^-1 for all compounds.

Analytical methodologies for the determination of endocrine disrupting compounds in biological and environmental samples

Endocrine-disruptor compounds (EDCs) can mimic natural hormones and produce adverse effects in the endocrine functions by interacting with estrogen receptors. EDCs include both natural and synthetic chemicals, such as hormones, personal care products, surfactants, and flame retardants, among others. EDCs are characterised by their ubiquitous presence at trace-level concentrations and their wide diversity. Since the discovery of the adverse effects of these pollutants on wildlife and human health, analytical methods have been developed for their qualitative and quantitative determination. In particular, mass-based analytical methods show excellent sensitivity and precision for their quantification. This paper reviews recently published analytical methodologies for the sample preparation and for the determination of these compounds in different environmental and biological matrices by liquid chromatography coupled with mass spectrometry. The various sample preparation techniques are compared and discussed. In addition, recent developments and advances in this field are presented.

Simultaneous determination of bisphenol A, tetrabromobisphenol A, and perfluorooctanoic acid in small household electronics appliances of "Prohibition on Certain Hazardous Substances in Consumer Products" instruction using ultra-performance liquid chromatography-tandem mass spectrometry with accelerated solvent extraction

Simultaneous determination of bisphenol A, tetrabromobisphenol A, and perfluorooctanoic acid in small household electronics appliances by accelerated solvent extraction-ultra-performance liquid chromatography-tandem mass spectrometry was established. Samples, heated for 5 min, were extracted by toluene/methanol (10:1, v/v) under the pressure 1500 psi at 100°C, and were extracted 3 static cycles with 20 min per cycle. And then 15 mL extractant solvent was used to wash the samples, and at last the sample was purged by nitrogen for 100 s. The partial extractant (10 mL) was concentrated by nitrogen and re-dissolved with 1 mL methanol/water (1:1, v/v). The three compounds were separated by BEH C18 column effectively in 3 min and detected by electrospray ionization mode mass spectrometry. The linear ranges for bisphenol A, perfluorooctanoic acid, and tetrabromobisphenol A were 1-100, 10-1000 ng/mL, and 0.1-10 μg/mL, respectively. The correlation coefficient was greater than 0.996. The LOD and limit of quantitation for three compounds were 0.1, 10, 1 ng/mL, and 0.5, 50, 5 ng/mL, respectively. And the recoveries were 84-92, 76-82, and 72-74%, respectively, with RSD < 5%. The method was successfully used in determining the real samples. The method and the result were confirmed by liquid chromatography-ion trap-time of flight mass spectrometry.

New Developments in Liquid Chromatography Mass Spectrometry for the Determination of Micropollutants

The combination of liquid chromatography (LC) with mass spectrometry (MS) in the environmental field has appeared as a valuable tool for the determination of micropollutants. Several groups of compounds have been considered as particularly relevant (e.g., pharmaceuticals, hormones and other endocrine-disrupting, personal care products and their metabolites, flame retardants, surfactants, and plasticizers, among others) since the same ones are continuously being released in the environment mainly as a result of the manufacturing processes, the disposal of unused or expired products, and the excreta. Because these micropollutants are not completely removed in the environment, very specific and sensitive analytical procedures are needed for their identification and quantification. High performance liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS) (or LC-MS2) and especially time-of-flight mass spectrometry (TOF/MS), has allowed that many environmental contaminants that are highly polar or nonvolatile or have a high molecular weight to be analyzed or identified. In this work we present an overview focused on the developments of liquid chromatography mass spectrometry applied to the analysis of the main classes of micropollutants in aqueous and solid environmental samples. Various aspects of methodologies based on these techniques, including sample preparation (extraction/preconcentration) and matrix effects, are discussed.

Analysis of emerging organic contaminants in environmental solid samples

Spreading sewage sludge on agricultural lands has been actively promoted by national authorities as an economic way of recycling. However, as by-product of wastewater treatment, sewage sludge may contain toxic substances, which could be incorporated into agricultural products or be distributed in the environment. Moreover, sediments can be contaminated by the discharge of wastewater effluents into rivers. This article reviews the determination of emerging contaminants (surfactants, flame retardants, pharmaceuticals and personal care products) in environmental solid samples (sludge, soil and sediment). Sample preparation, including extraction and clean-up, as well as the subsequent instrumental determination of contaminants are discussed. Recent applications of extraction techniques, such as Soxhlet extraction, ultrasound assisted extraction, pressurised liquid extraction, microwave assisted extraction and matrix solid-phase dispersion to the analysis of emerging contaminants in environmental solid samples are reviewed. Determination of these contaminants, generally carried out by gas chromatography and liquid chromatography coupled with different detectors, especially mass spectrometry for the identification and quantification of residues, is also summarised and discussed.

Preparation and X-ray structural characterization of further stereoisomers of 1,2,5,6,9,10-hexabromocyclododecane

Technical 1,2,5,6,9,10-hexabromocyclododecane (HBCD) consists largely of three diastereomers (α-, β-, and γ-HBCD) produced by the trans addition of bromine to cis,trans,trans-cyclododeca-1,5,9-triene (CDT). However, another seven diastereomers are theoretically possible and may be produced by trans addition of bromine across the double bonds of the other three isomers of 1,5,9-CDT. There are indications that small amounts of the minor HBCD isomers may be present in commercial HBCD mixtures or in products containing this brominated flame retardant (BFR). Such minor components may indeed derive from traces of other 1,5,9-CDTs in the cis, trans, trans starting material, however their formation may also be possible through isomerizations during the processing of this BFR or by bioisomerization subsequent to its release into the environment. Two of the seven additional diastereomers (δ- and ε-HBCD) were synthesized previously from trans,trans,trans-CDT. We now report the preparation of the remaining five diastereomers, ζ-, η-, and θ-HBCD from cis,cis,trans-CDT and ι- and κ-HBCD from cis,cis,cis-CDT, and their characterization by (1)H NMR spectroscopy and X-ray crystallography. The availability of these further diastereomers of HBCDshould aid in determining if the minor isomers are present in commercial samples of this BFR, in products containing HBCDs, or in environmental samples. We have also carried out an X-ray crystal structure determination on ε-HBCD, so that crystal structures are now available for all 10 HBCD diastereomers.

Determination of hexabromocyclododecane diastereoisomers in Sargassum fusiforme and comparison of the extraction efficiency of ultrasonication, microwave-assisted extraction, Soxhlet extraction and pressurised liquid extraction

The concentrations of hexabromocyclododecanes (HBCD) in Sargassum fusiforme, the common Chinese edible seaweed, were investigated by LC-MS/MS. For the recovery of HBCD, the efficiency levels of ultrasonic-assisted extraction, microwave-assisted extraction, Soxhlet extraction and pressurised liquid extraction were compared under different conditions. Pressurised liquid extraction and ultrasonic-assisted extraction resulted in complete extraction of HBCD (92.7-102.5% recovery). Microwave-assisted extraction and Soxhlet extraction, on the other hand, offered relatively low extraction recoveries (82.1-90.6%). The instrumental LODs on columns in this study were 1.0, 0.3 and 0.7 ng/g for α-HBCD, β-HBCD and γ-HBCD, respectively. Because of its accuracy, this straightforward method is particularly suitable for routine HBCD analysis.