Enhancing the detection sensitivity of trace analysis of pharmaceutical genotoxic impurities by chemical derivatization and coordination ion spray-mass spectrometry

A comprehensive review of chloropropanol analytical method in the context of food safety

Chloropropanols are among the major food contaminants, and quantifying their content in food is a key food-safety issue. In response to the demand for highly sensitive and selective analysis, the scientific community is committed to continuous innovation and optimization of various analytical techniques. This paper comprehensively reviews the latest developments in chloropropanol analysis technologies and systematically compares and analyzes the working principles, application conditions, advantages, and challenges of these methods. Gas chromatography-mass spectrometry is the preferred choice for chloropropanol analysis in complex sample matrices owing to its high resolution, sensitivity, and accuracy. Electrochemical methods provide strong support for the real-time monitoring of chloropropanols because of their high selectivity and sensitivity towards electrochemically active molecules. Other techniques offer innovative solutions for the rapid and accurate analysis of chloropropanol at different levels. Finally, innovative directions for the development of chloropropanol analysis methods for food safety are highlighted.

Deep eutectic solvents as green and sustainable diluents in headspace gas chromatography for the determination of trace level genotoxic impurities in pharmaceuticals

Genotoxic impurities (GTIs) are potential carcinogens that need to be controlled down to ppm or lower concentration levels in pharmaceuticals under strict regulations. The static headspace gas chromatography (HS-GC) coupled with electron capture detection (ECD) is an effective approach to monitor halogenated and nitroaromatic genotoxins. Deep eutectic solvents (DESs) possess tunable physico-chemical properties and low vapor pressure for HS-GC methods. In this study, zwitterionic and non-ionic DESs have been used for the first time to develop and validate a sensitive analytical method for the analysis of 24 genotoxins at sub-ppm concentrations. Compared to non-ionic diluents, zwitterionic DESs produced exceptional analytical performance and the betaine : 7 (1,4- butane diol) DES outperformed the betaine : 5 (1,4-butane diol) DES. Limits of detection (LOD) down to the 5-ppb concentration level were achieved in DESs. Wide linear ranges spanning over 5 orders of magnitude (0.005-100 µg g-1) were obtained for most analytes with exceptional sensitivities and high precision. The method accuracy and precision were validated using 3 commercially available drug substances and excellent recoveries were obtained. This study broadens the applicability of HS-GC in the determination of less volatile GTIs by establishing DESs as viable diluent substitutes for organic solvents in routine pharmaceutical analysis.

A simple fluorescence pyrocatechol-polyethyleneimine detection method for 3-MCPD

A rapid fluorescence detection method was established for 3-monochloropropane-1,2-diol (3-MCPD). The detection system works based on the fluorescence quenching of pyrocatechol-polyethyleneimine (PCh-PEI) polymer by 3-MCPD. The fluorescence quenching ability of 3-MCPD for PCh-PEI polymer was measured at different pH and temperatures. Indeed, in the presence of 3-MCPD, the fluorescence intensity of PCh-PEI polymer solution was quenched best at 100 °C and pH 8.5. Also, the effect of different concentrations of 3-MCPD on the optical properties of the PCh-PEI polymer was examined. Under optimal experimental conditions, fluorescence detection was linear in a range of 0.08-2.0 mg per L 3-MCPD, with a calculated detection limit of 0.06 mg L-1 and a correlation coefficient of 0.9974. Concisely, the reported method has good sensitivity and can be used for the rapid detection of 3-MCPD contamination in food products.

A fluorescent probe for alkylating agents and its quantification of triflate as a genotoxic impurity

The responses of a reaction-based fluorescent probe BI-Py towards alkyl halide, epoxide, carbonate, sulfate, sulphonate and triflate were evaluated and the probe achieved selective detection of ethyl triflate in acetonitrile with a LOD of 1.08 μM. BI-Py exhibited great potential for detecting triflate as a genotoxic impurity in drug substances.

Critical Analysis of Drug Product Recalls due to Nitrosamine Impurities

A product recall is the outcome of a careful pharmacovigilance; and it is an integral part of drug regulation. Among various reasons for product recall, the detection of unacceptable levels of carcinogenic impurities is one of the most serious concerns. The genotoxic and carcinogenic potential of N-nitrosamines raises a serious safety concern, and in September 2020, the FDA issued guidance for the pharmaceutical industry regarding the control of nitrosamines in drug products. The FDA database shows that >1400 product lots have been recalled from the market due to the presence of carcinogenic N-nitrosamine impurities at levels beyond the acceptable intake limit of 26.5 ng/day. The drugs that were present in recalled products include valsartan, irbesartan, losartan, metformin, ranitidine, and nizatidine. This perspective provides a critical account of these product recalls with an emphasis on the source and mechanism for the formation of N-nitrosamines in these products.

Dispersive liquid-liquid microextraction with high-performance liquid chromatography for the analysis of 1,4-benzodioxane-6-aldehyde in eliglustat tartrate active pharmaceutical ingredient

Potential genotoxic impurities (PGIs) are a series of compounds that could potentially damage DNA. Therefore, a sensitive method is needed for detection and quantification. The present work described and validated a method for the quantification of one PGI (namely 1,4-benzodioxane-6-aldehyde) in Eliglustat tartrate (EGT) active pharmaceutical ingredient (API) substances using dispersive liquid-liquid microextraction (DLLME) as sample preparation to remove matrix effect and detected by HPLC-UV. Parameters influencing the microextraction efficiency were systematically investigated. The combined application of DLLME and HPLC-UV provided the sensitivity of the method. The achieved limit of detection (LOD) and the limit of quantification (LOQ) were adequate for the specific purpose and found to be 1.29 μg g^-1 and 2.58 μg g^-1, respectively. This simple and effective methodology offers a key advantage in the ease of removing matrix effect and improves sensitivity obviously. In addition, no costly instrumentation and skilled personnel are needed when using this method, which is available and can be successfully implemented in routine factory drug quality control analysis.

Sensitive determination of trace urinary 3-hydroxybenzo[a]pyrene using ionic liquids-based dispersive liquid-liquid microextraction followed by chemical derivatization and high performance liquid chromatography-high resolution tandem mass spectrometry

3-Hydroxybenzo[a]pyrene (3-OHBaP) is widely used as a biomarker for assessing carcinogenic benzo[a]pyrene exposure risks. However, monitoring urinary 3-OHBaP suffers from an insufficient sensitivity due to the pg/mL level in urine excretion. In this study, a sensitive method for determination trace urinary 3-OHBaP was developed, involving enzymatic hydrolysis of the glucuronide and sulfate conjugates, ionic liquids dispersive liquid-liquid microextraction (IL-DLLME) enrichment, derivatization with dansyl chloride and HPLC-HRMS/MS analysis in the positive ion mode. Using IL-DLLME makes the enrichment of trace 3-OHBaP very simple, time-saving, efficiency and environmentally-friendly. To enhanced HPLC-HRMS/MS response, an MS-friendly dansyl group was introduced to increase the ionization and fragmentation efficiency. The optimal IL-DLLME extraction parameters and derivatization reaction conditions were investigated. Good linearity was obtained over a concentration range of 0.6-50.0pg/mL with correlation coefficients (r(2)) of 0.9918. The limit of detection (LOD) and limit of quantification (LOQ) values were 0.2pg/mL and 0.58pg/mL, respectively. The recoveries were 92.0±4.2% with the intra-day and inter-day RSD values ranged from 2.2% to 3.8% and from 3.3% to 6.8%, respectively. The proposed IL-DLLME-Dansylation-HPLC-HRMS/MS method was successfully applied to determine urinary 3-OHBaP of non-occupational exposed smokers and nonsmokers.

Hydrophilic interaction chromatography in drug analysis

Hydrophilic interaction chromatography (HILIC) is an increasingly popular alternative to conventional HPLC for drug analysis. It offers increased selectivity and sensitivity, and improved efficiency when quantifying drugs and related compounds in complex matrices such as biological and environmental samples, pharmaceutical formulations, food, and animal feed. In this review we summarize HILIC methods recently developed for drug analysis (2006–2011). In addition, a list of important applications is provided, including experimental conditions and a brief summary of results. The references provide a comprehensive overview of current HILIC applications in drug analysis.

Metabolic profiling of lipids by supercritical fluid chromatography/mass spectrometry

This review describes the usefulness of supercritical fluid chromatography (SFC) for the metabolic profiling of lipids. First, non-targeted lipid profiling by SFC/MS is described. The use of SFC/MS allows for high-throughput, exhaustive analysis of diverse lipids, and hence, this technique finds potential applications in lipidomics. Development of a polar lipid profiling method with trimethylsilyl (TMS) derivatization widens the scope of applicability of SFC/MS. SFC is a high-resolution technique that is suitable for non-targeted profiling aimed at the simultaneous analysis of many components. Next, targeted lipid profiling by SFC/MS is described. SFC is useful for the separation of lipids, such as carotenoids and triacylglycerols, which have numerous analogs with similar structures. In addition, SFC/MS shows the maximum efficiency for the target analysis of lipids in a biological sample that includes many matrices. Finally, a high-resolution, high-throughput analytical system based on SFC/MS is stated to be suitable for lipidomics because it is useful not only for the screening of lipid mixtures (as a fingerprint method) but also for the detailed profiling of individual components.

Novel product ions of 2-aminoanilide and benzimidazole Ag(I) complexes using electrospray ionization with multi-stage tandem mass spectrometry

RATIONALE

The 2-aminoaniline scaffold is of significant value to the pharmaceutical industry and is embedded in a number of pharmacophores including 2-aminoanilides and benzimidazoles. A novel application of coordination ion spray mass spectrometry (CIS-MS) for interrogating the silver ion (Ag(+)) complexes of a homologous series of these compounds using multi-stage tandem mass spectrometry is described. Unlike the ubiquitous alkali metal ion complexes, Ag(+) complexes of 2-aminoanilides and benzimidazoles were found to yield [M - H](+) ions in significant abundance via gas-phase elimination of the metal hydride (AgH) resulting in unique product ion cascades.

METHODS

Sample introduction was by liquid chromatography with mass spectrometry analysis performed on a hybrid linear ion trap/orbitrap instrument capable of high-resolution measurements.

RESULTS

Rigorous structural characterization by multi-stage tandem mass spectrometry using [M +  H](+), [M - H](-) and [M - H](+) precursor ions derived from ESI and CIS experiments was performed for the homologous series of 2-aminoanilide and benzimidazole compounds. A full tabular comparison of structural information resulting from these product ion cascades was produced.

CONCLUSIONS

Multi-stage tandem mass spectrometry of [M - H](+) ions resulting from Ag(+) complexes of 2-aminoanilides and benzimidazoles in CIS-MS experiments produced unique product ion cascades that exhibited complementary structural information to that obtained from tandem mass spectrometry of [M  +  H](+) and [M - H](-) ions by electrospray ionization (ESI). These observations may be broadly applicable to other compounds that are observed to form Ag(+) complexes and eliminate AgH.

Overall impact of the regulatory requirements for genotoxic impurities on the drug development process

In the last decade a considerable effort has been made both by the regulators and the pharmaceutical industry to assess genotoxic impurities (GTI) in pharmaceutical products. Though the control of impurities in drug substances and products is a well established and consolidated procedure, its extension to GTI has given rise to a number of problems, both in terms of setting the limits and detecting these impurities in pharmaceutical products. Several papers have dealt with this issue, discussing available regulations, providing strategies to evaluate the genotoxic potential of chemical substances, and trying to address the analytical challenge of detecting GTI at trace levels. In this review we would like to discuss the available regulations, the toxicological background for establishing limits, as well as the analytical approaches used for GTI assessment. The final aim is that of providing a complete overview of the topic with updated available information, to address the overall GTI issue during the development of new drug substances.

Gas-phase meerwein reaction of epoxides with protonated acetonitrile generated by atmospheric pressure ionizations

Ethylnitrilium ion can be generated by protonation of acetonitrile (when used as the LC-MS mobile phase) under the conditions of atmospheric pressure ionizations, including electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) as well as atmospheric pressure photoionization (APPI). Ethylnitrilium ion (CH(3)-C≡N+H and its canonical form CH(3)-C+=NH) is shown to efficiently undergo the gas-phase Meerwein reaction with epoxides. This reaction proceeds by the initial formation of an oxonium ion followed by three-to-five-membered ring expansion via an intramolecular nucleophilic attack to yield the Meerwein reaction products. The density functional theory (DFT) calculations at the B3LYP/6-311+G(d,p) level show that the gas-phase Meerwein reaction is thermodynamically favorable. Collision-induced dissociation (CID) of the Meerwein reaction products yields the net oxygen-by-nitrogen replacement of epoxides with a characteristic mass shift of 1 Da, providing evidence for the cyclic nature of the gas-phase Meerwein reaction products. The gas-phase Meerwein reaction offers a novel and fast LC-MS approach for the direct analysis of epoxides that might be of genotoxic concern during drug development. Understanding and utilizing this unique gas-phase ion/molecule reaction, the sensitivity and selectivity for quantitation of epoxides can be enhanced.