Dispersive derivatization liquid–liquid extraction of degradation products/precursors of mustards and V-agents from aqueous samples

Highly Efficient Separation of Ethanol Amines and Cyanides via Ionic Magnetic Mesoporous Nanomaterials

Simple and efficient sample pretreatment methods are important for analysis and detection of chemical warfare agents (CWAs) in environmental and biological samples. Despite many commercial materials or reagents that have been already applied in sample preparation, such as SPE columns, few materials with specificity have been utilized for purification or enrichment. In this study, ionic magnetic mesoporous nanomaterials such as poly(4-VB)@M-MSNs (magnetic mesoporous silicon nanoparticles modified by 4-vinyl benzene sulfonic acid) and Co2+@M-MSNs (magnetic mesoporous silicon nanoparticles modified by cobalt ions) with high absorptivity for ethanol amines (EAs, nitrogen mustard degradation products) and cyanide were successfully synthesized. The special nanomaterials were obtained by modification of magnetic mesoporous particles prepared based on co-precipitation using -SO3H and Co2+. The materials were fully characterized in terms of their composition and structure. The results indicated that poly(4-VB)@M-MSNs or Co2+@M-MSNs had an unambiguous core-shell structure with a BET of 341.7 m2·g-1 and a saturation magnetization intensity of 60.66 emu·g-1 which indicated the good thermal stability. Poly(4-VB)@M-MSNs showed selective adsorption for EAs while the Co2+@M-MSNs were for cyanide, respectively. The adsorption capacity quickly reached the adsorption equilibrium within the 90 s. The saturated adsorption amounts were MDEA = 35.83 mg·g-1, EDEA = 35.00 mg·g-1, TEA = 17.90 mg·g-1 and CN-= 31.48 mg·g-1, respectively. Meanwhile, the adsorption capacities could be maintained at 50-70% after three adsorption-desorption cycles. The adsorption isotherms were confirmed as the Langmuir equation and the Freundlich equation, respectively, and the adsorption mechanism was determined by DFT calculation. The adsorbents were applied for enrichment of targets in actual samples, which showed great potential for the verification of chemical weapons and the destruction of toxic chemicals.

Practical benzylation of N,N-substituted ethanolamines related to chemical warfare agents for analysis and detection by electron ionization gas chromatography-mass spectrometry

The benzylation of three low molecular weight N,N-disubstituted ethanolamines related to chemical warfare agents (CWAs) to furnish derivatives with improved gas chromatography-mass spectrometry (GC-MS) profiles is described. Due to their low molecular weight and polar nature, N,N-disubstituted ethanolamines are notoriously difficult to detect by routine GC-MS analyses during Organisation for the Prohibition of Chemical Weapons (OPCW) proficiency tests (PTs), particularly in scenarios when they are present at low levels (~1-10 ppm) amidst more abundant interferences. Our studies revealed that the optimal derivatization conditions involved the treatment of the ethanolamine with benzyl bromide in the presence of an inorganic base (e.g., Na2 CO3 ) in dichloromethane at 55°C for 2 h. This optimized set of conditions was then successfully applied to the derivatization of N,N-dimethylethanolamine, N,N-diethylethanolamine and N,N-diisopropylethanolamine present separately at 1 and 10 μg/mL concentrations in a glycerol-rich matrix sample featured in the 48th OPCW PT. The benzylated derivatives of the three ethanolamines possessed retention times long enough to clear the massive glycerol-containing matrix interferences. The protocol herein is introduced as an alternative method for derivatization of these CWA and pharmaceutically important species and should find broad applicability in laboratories where routine forensic analysis is carried out.

Rapid detection of sulfur mustard hydrolysis products based on microextraction by packed sorbent combined with nano-electrospray ionization mass spectrometry

RATIONALE

Sulfur mustard is a blister agent prohibited by the Chemical Weapons Convention, and the detection of its hydrolysis product, thiodiglycol (TDG), is an important indicator of blister agent contamination. Due to the poor volatility and low extraction efficiency of TDG, derivatization gas chromatography or liquid chromatography is required for conventional methods, and the detection process is cumbersome and time-consuming.

METHODS

A microextraction by packed sorbent (MEPS) device and a nano-electrospray ionization (nano-ESI) device were used. The central composite design (CCD) model of Response Surface Methodology was used to optimize the elution procedure; the variance analysis under equal repeated trials with multiple factors was used to quantitatively analyze the significance of the impact of related factors on the nano-ESI efficiency. The MEPS-nano-ESI-MS experimental conditions were optimized.

RESULTS

A new detection method of sulfur mustard hydrolysis products in water based on MEPS-nano-ESI-MS was established; the detection limit was 1 ng/mL and was linear between 5 ng/mL and 100 ng/mL (R²  = 0.9911) with a precision of ≤7.2%, and the recovery rate was 107.89% when the sample concentration was 40 ng/mL.

CONCLUSIONS

The experimental results showed that the proposed method could quickly detect the contaminated water samples without chromatographic separation and derivatization, thereby verifying the contamination of sulfur mustard on site.

Optimized method for analysis of ethanolamines, hydrolysis products of nitrogen mustards, from urine samples using LC-MS/MS

Highly polar ethanolamines (EAs), excreted in urine, are hydrolysis products of nitrogen mustards (NMs), which are prohibited by the Chemical Weapons Convention (CWC). The methods established for biological matrices are essential for verification analysis of the CWC related chemicals. This paper describes a new liquid chromatography-tandem mass spectrometry (LC-MS/MS) method developed for qualitative and quantitative analysis of EAs, N-ethyldiethanolamine (EDEA), N-methyldiethanolamine (MDEA) and triethanolamine (TEAOH) from urine samples. After optimization of sample preparation and chromatographic conditions, the method was fully validated. Silica solid-phase extraction (SPE) cartridges and a porous graphite carbon (PGC) column were selected for validation studies. The method is linear from 5 to 500, 0.5 to 250, and 0.5 to 500 ng/mL for TEAOH, EDEA, and MDEA, respectively. It is also precise and accurate. A minimum sample amount of 0.5 mL urine was used. The limit of quantification using this approach was 0.4, 5.5, and 6.3 ng/mL for MDEA, EDEA and TEAOH, respectively. The combination of the PGC column and high pH eluents in analysis retained and separated the studied EAs. Retention times were 2.11, 2.56 and 2.98 min for MDEA, EDEA and TEAOH, respectively. The method is applicable for verification analysis of the CWC.

Mass spectral fragmentation of perfluoroacyl derivatives of half nitrogen mustards for their detection by gas chromatography/mass spectrometry

RATIONALE

Analytical methods for the detection and identification of half nitrogen mustards (halfNMs), i.e., partially hydrolyzed products of nitrogen mustards (pHpNMs), using silyl derivatives are often associated with low sensitivity and selectivity. In order to overcome these limitations, the derivatization of halfNMs was performed using perfluoroacylation.

METHODS

Two efficient derivatization techniques using trifluoroacetyl (TFA) and heptafluorobutyryl (HFB) groups were developed for the unambiguous identification of halfNMs. A mass spectral database was generated by performing gas chromatography/electron ionization mass spectrometry (GC/EI-MS) and gas chromatography/positive chemical ionization mass spectrometry (GC/PCI-MS). The fragmentation pathways were studied by tandem mass spectrometry (MS/MS) in both EI and PCI mode.

RESULTS

The EI-MS spectra of the TFA and HFB derivatives of halfNMs contain intense molecular ions and fragment ions, thus making perfluoroacylation preferable to silylation. In addition, the background-free chromatogram obtained using these derivatives provides unambiguous identification of these compounds in blind samples. The structures of the fragment ions were postulated, and the sources of significant ions were traced by performing MS/MS precursor ion scans. In the PCI-MS spectra, along with the protonated molecule, significant peaks due to neutral losses of HF, HCl, CH₃ Cl and CF₃ COOH were observed.

CONCLUSIONS

This is the first report of the elucidation of the fragmentation pathways of perfluoroacyl derivatives of halfNMs. The complementary GC/PCI-MS and GC/PCI-MS/MS data will be helpful in the identification of unknown metabolites in a fast and reliable fashion.

Cyclopentyl Methyl Ether (CPME): A Versatile Eco-Friendly Solvent for Applications in Biotechnology and Biorefineries

The quest for sustainable solvents is currently a matter of intense research and development, as solvents significantly contribute heavily to the waste generated by chemical industries. Cyclopentyl methyl ether (CPME) is a promising eco-friendly solvent with valuable properties such as low peroxide formation rate, stability under basic and acidic conditions, and relatively high boiling point. This Review discusses the potential use of CPME for applications in biotechnology (e.g., biotransformations, as solvent or cosolvent), biorefineries, and bioeconomy (e.g., for furan synthesis or as an extractive agent in liquid-liquid separations), as well as for other purposes, such as chromatography or peptide synthesis. Although CPME is currently produced by petrochemical means with a remarkably high atom economy, its biogenic production can be envisaged from substrates such as cyclopentanol or cyclopentanone, which can be derived from furfural or from (bio-based) adipic acid, respectively. The combination of the promising properties of CPME as a (co)solvent with a future (economic) biogenic origin would be advantageous for setting strategies aligned with the sustainable chemistry principles.

Analysis of the Precursors, Simulants and Degradation Products of Chemical Warfare Agents

Recent advances in analysis of precursors, simulants and degradation products of chemical warfare agents (CWA) are reviewed. Fast and reliable analysis of precursors, simulants and CWA degradation products is extremely important at a time, when more and more terrorist groups and radical non-state organizations use or plan to use chemical weapons to achieve their own psychological, political and military goals. The review covers the open source literature analysis after the time, when the chemical weapons convention had come into force (1997). The authors stated that during last 15 years increased number of laboratories are focused not only on trace analysis of CWA (mostly nerve and blister agents) in environmental and biological samples, but the growing number of research are devoted to instrumental analysis of precursors and degradation products of these substances. The identification of low-level concentration of CWA degradation products is often more important and difficult than the original CWA, because of lower level of concentration and a very large number of compounds present in environmental and biological samples. Many of them are hydrolysis products and are present in samples in the ionic form. For this reason, two or three instrumental methods are used to perform a reliable analysis of these substances.

Determination of nitrogen mustard degradation products in water samples using a portable capillary electrophoresis instrument

In this work, a new purpose-made portable CE instrument with a contactless conductivity detector was used for the determination of degradation products of nitrogen mustards in different water samples. The capillary was coated with poly(1-vinylpyrrolidone-co-2-dimethylaminoethyl methacrylate) to avoid analyte-wall interactions. The coating procedure was studied to obtain the best repeatability of the migration time of the analytes. Four different coating procedures were compared; flushing the capillary with the copolymer at 100 psi for 2 min at 60°C provided the best RSD values (<4%). The analytical method was also optimized. The use of 20 mM of MES adjusted to pH 6.0 with His as running buffer allowed a good baseline separation of the three analytes in different water samples without matrix interferences. The method permitted the detection of the three degradation products down to 5 μM.