Silicon nanowire arrays for the preconcentration and separation of trace explosives vapors

Temporally resolved thermal desorption of volatile organics from nanoporous silica preconcentrator

Detection and separation of gas-phase volatile organic compounds (VOCs) is of great importance for many applications including air quality monitoring, toxic gas detection and medical diagnostics. A lack of small and low-cost detectors limits the potential applications of VOC gas sensors, especially in the areas of consumer products and the 'Internet of Things'. Most of the commercially available low-cost technologies are either only capable of measuring a single VOC type, or only provide a total VOC concentration, without the ability to provide information on the nature or type of the VOC. We present a new approach for improving the selectivity of VOC detection, based on temporally resolved thermal desorption of VOCs from a nanoporous material, which can be combined with any existing VOC detector. This work uses a nanoporous silica material that adsorbs VOC molecules, which are then thermally desorbed onto a broadband VOC detector. Different VOCs are desorbed at different temperatures depending on their boiling point and affinity to the porous surface. The nanoporous silica is inert; VOC adsorption is proportional to the concentration of VOC in the environment, and is fully reversible. An example of a detection system using a commercial total VOC photoionization detector and a nanoporous silica preconcentrator is demonstrated here for six different VOCs, and shows potential for discrimination between the VOCs.

Empirical determination of explosive vapor transport efficiencies

The transport efficiency of 2,4-dinitrotoluene (2,4-DNT), 2,4,6-trinitrotoluene (TNT) and 1,3,5-trinitro-1,3,5-triazinane (RDX) trace vapors through tubing materials that commonly constitute vapor handling infrastructures have been determined for a variety of tubing dimensions and sampling conditions. Using a programmable temperature vaporization inlet coupled with a gas chromatography mass spectrometer (PTV-GC-MS), the explosive vapors were quantified both with and without a length of tubing of a specific material in the sampling flow path. At vapor temperatures of 30 °C and 66 °C, minimal attenuations were observed for 2,4-DNT and TNT vapor concentrations when the tubing material was in-line with the sampling flow path, indicating that the transport is largely unaffected by interactions with the surface of the tubing materials. In contrast, RDX vapors showed large attenuations as a function of both sampling conditions and tubing materials/dimensions. For those experiments where attenuated RDX vapor transport was observed, the mass sequestered by interactions between the flowing vapor and the internal tubing surface was determined to be in the range of tens to hundreds of picograms. Of all the materials examined for RDX transport, fluorinated ethylene propylene (FEP) tubing resulted in the least amount of mass loss to surface interactions, with vapor transport efficiencies (VTEs) between 95-100%. However, for some materials, the combination of tubing dimensions and sampling conditions resulted in no RDX transport, even after sampling more than 250.0 L of vapor through the tubing.

Nanoporous Silica Preconcentrator for Vapor-Phase DMNB, a Detection Taggant for Explosives

The detection of trace amounts of explosives in the vapor phase is of great importance. Preconcentration of the analyte is a useful technique to lower the detection limit of existing sensors. A nanoporous silica (pSiO₂) substrate was evaluated as a preconcentrator for gas-phase 2,3-dimethyl-2,3-dinitrobutane (DMNB), a volatile detection taggant added by law to plastic explosives. After collection in pSiO₂, the DMNB vapor was thermally desorbed at 70 °C into a gas chromatography-mass spectrometry sorbent tube. This was analyzed for the total mass of DMNB collected in pSiO₂. The loading time and loading temperature of pSiO₂ were varied systematically between 15 and 60 min and 5-20 °C, respectively. The preconcentrator's performance was compared to that of a nonporous substrate of the same material as a control. The collection efficiency of pSiO₂ was calculated as approximately 20% of the total DMNB that passed over it in 30 min, at a concentration of 0.5 ppm in N₂ carrier gas. It had enhancement factors compared to the nonporous substrate of 12 and 16 for 0.5 and 4.1 ppm DMNB, respectively, under the same conditions. No advantage was found with cooling pSiO₂ below room temperature during the loading phase, which removes any need for a cooling system to aid preconcentration. The low desorption temperature of 70 °C is an advantage over other preconcentration systems, although a higher temperature could decrease the desorption time.

Non-target analysis of vapor mixtures using silicon nanowire array sampling and thermal desorption

This work presents and evaluates an algorithmic approach to deconvolving the elution profiles of chemical components of vapor mixtures that have been sampled and desorbed from a novel preconcentrator based on highly ordered silicon nanowire arrays. The arrays provide a medium for both preconcentration and partial chromatographic resolution, which is then further leveraged with multichannel detection. Here, mixtures of nitro aromatic vapors are sampled and then thermally desorbed from the device, at which point they are detected by a conventional mass selective detector. The overlapping elution profiles observed from the array are sequentially extracted using a chemometric analysis approach based on evolving factor analysis and multivariate curve resolution by alternating least squares, enabling qualitative and quantitative analysis of individual components without target analyte libraries or complete chromatographic separation. This work examines the analytical capabilities conferred to multichannel detection by silicon nanowire array pre-concentration and partial separation and discusses the technique's limitations, illustrated by both experimental and simulated data.