Differential growth and photoluminescence of ZnS nanocrystals with variation of surfactant molecules

Aqueous Synthesis of Protein-Encapsulated ZnSe Quantum Dots and Physical Significance of Semiconductor-Induced CuII Ion Sensing

In view of their promising bio-applicability, we have synthesized water-soluble bovine serum albumin (BSA)-encapsulated ZnSe quantum dots (QDs) with visible emission with longer average luminescence lifetimes of approximately 125 ns at ambient conditions. BSA-ZnSe QDs are shown to be efficient selective copper ion probes in the presence of physiologically important metal ions through luminescence quenching with a high Stern-Volmer constant (3.3×10⁵  m^-1 ). The mechanism of sensing has been explained in terms of electron transfer processes and the apparent rate of electron transfer (K_et ) from ZnSe QDs to Cu²⁺ has been calculated to be 2.8×10⁸  s^-1 . It is demonstrated that the negative conduction band potential plays a major role in the feasibility of the electron transfer process, which is reflected in the higher efficacy of ZnSe QDs in sensing copper(II) ions over other group II-VI quantum dots, namely, CdSe, ZnS, or CdS. The results observed with cysteine-capped QDs are almost identical to those with BSA-encapsulated QDs and this presumably negates the possible reason of Cu^II ion induced quenching ascribed to its binding with surface groups or replacement of metal sites as proposed by several groups previously.

Water-soluble, luminescent ZnTe quantum dots: supersaturation-controlled synthesis and self-assembly into nanoballs, nanonecklaces and nanowires

A supersaturation-controlled aqueous synthesis route has been developed for ZnTe quantum dots (QDs) with high monodispersity, size tunability, stability, band-edge luminescence (full-width at half-maximum (FWHM) 10-12 nm) and negligibly small Stokes' shift (2-4 nm). The degree of supersaturation of the initial reaction mixture was varied by increasing the reagent concentration, but keeping the molar ratio Zn(2+) : thioglycolic acid : Te(2-) constant at 1 : 2.5 : 0.5. For a 10× increase in supersaturation, the photoluminescence (PL) peak underwent a 50 nm blue shift from 330 to 280 nm at pH 6. The effect was more pronounced at pH 12, where the PL peak blue-shifted by 100 nm from 327 to 227 nm. Concomitantly, the FWHM was also reduced to a low value of 10 nm, indicating high monodispersity. For a 10× change in supersaturation, the particle size decreased by 63% (from 2.2 to 0.8 nm) at pH 12, whereas it changed by 19% (from 2.1 to 1.7 nm) at pH 6. High-resolution transmission electron microscopy and selected area electron diffraction data further revealed that the QDs synthesized at higher supersaturation had a better crystallinity. These QDs exhibited the unique property of undergoing isotropic and anisotropic self-assembly, which resulted in a blue shift and a red shift in the absorption and PL spectra, respectively. Isotropic assembly into spherical nanoballs (100 nm diameter, 1 nm inter-QD separation) occurred when the QDs were stored at pH 12 for 3 weeks at room temperature. The nanoballs further self-assembled into a 'pearl necklace' arrangement. On the partial removal of the capping agents, the QDs self-organized anisotropically into nanowires (1.3 μm long and 4.6 nm in diameter). The self-assembled nanostructures showed exciton-exciton coupling and excellent PL properties, which may be useful in enhanced optoelectronics, photovoltaics and biochemical sensing.

Influence of thiol capping on the photoluminescence properties of L-cysteine-, mercaptoethanol- and mercaptopropionic acid-capped ZnS nanoparticles

Mercaptoethanol (ME), mercaptopropionic acid (MPA) and L-cysteine (L-Cys) having -SH functional groups were used as surface passivating agents for the wet chemical synthesis of ZnS nanoparticles. The effect of the thiol group on the optical and photoluminescence (PL) properties of ZnS nanoparticles was studied. L-Cysteine-capped ZnS nanoparticles showed the highest PL intensity among the studied capping agents, with a PL emission peak at 455 nm. The PL intensity was found to be dependent on the concentration of Zn(2+) and S(2-) precursors. The effect of buffer on the PL intensity of L-Cys-capped ZnS nanoparticles was also studied. UV/Vis spectra showed blue shifting of the absorption edge.

ZnS:Cu,Co water-soluble afterglow nanoparticles: synthesis, luminescence and potential applications

Cu(2+) and Co(2+) co-doped zinc sulfide water-soluble nanoparticles (ZnS:Cu,Co) were prepared and their afterglow luminescence was observed and reported for the first time. The nanoparticles have a cubic zinc blende structure with average sizes of about 4 nm as determined by high-resolution transmission electron microscopy (HRTEM) and x-ray diffraction (XRD). In the photoluminescence, two emission peaks are observed at 470 and 510 nm. However, in the afterglow, only one peak is observed at around 525 nm. The blue emission at 470 nm is from surface states and the green emission at 525 nm is from Cu(2+). This means that Cu(2+) is responsible for the afterglow from the nanoparticles, while the co-doping of Co(2+) is critical for the afterglow because no afterglow could be seen without co-doping with Co(2+). The successful observation of the afterglow from water-soluble nanoparticles may open up new applications of afterglow phosphors in biological imaging, detection and treatment.

L-cysteine-assisted growth of core-satellite ZnS-Au nanoassemblies with high photocatalytic efficiency

Core-satellite ZnS-Au nanoassemblies, in which each of the ZnS nanospheres was surrounded by a few Au nanoparticles, have been successfully prepared with a facile L-cysteine-assisted hydrothermal approach. The density of Au nanoparticles encircling each ZnS nanosphere can be readily controlled through suitably modulating the concentration of Au added. Because of the difference in band structures between ZnS and Au, a pronounced photoinduced charge separation was observed for the as-synthesized ZnS-Au nanoassemblies. As compared to the relevant commercial products like Au-loaded P-25 TiO(2) and ZnS powders, ZnS-Au nanoassemblies exhibited superior photocatalytic performance, demonstrating their potential as an efficient photocatalyst in relevant redox reactions. Furthermore, the recycling test revealed that core-satellite nanoassemblies of ZnS-Au could be promisingly utilized in the long-term course of photocatalysis. The present study provides a new paradigm for designing the highly efficient semiconductor/metal hybrid photocatalysts that can effectively produce chemical energy from light.

Surface modification of CdS quantum dots using thiols-structural and photophysical studies

This study is aimed at identifying a suitable organic thiol for CdS by studying its structural, thermal and photophysical characteristics. Quantum dots of the II-VI semiconductor CdS, in the size regime of 2.0-3.3 nm, were prepared in the cubic phase by a wet chemical method. Five organic thiols were used for capping: (i) 1,4-dithiothreitol (DTT), (ii) 2-mercaptoethanol (ME), (iii) cysteine (Cys), (iv) methionine (Meth), and (v) glutathione (GSH). Structural studies were carried out by x-ray diffraction (XRD) and transmission electron microscopy (TEM), which revealed the cubic phase of CdS. Optical properties were studied by FT-IR, UV-visible and fluorescence spectroscopic techniques, and a comparison was made between uncapped and capped CdS. FT-IR studies suggested two different bonding mechanisms of the capping agents with the CdS. GSH and DTT capped CdS showed significant decrease in absorption wavelengths. An increase in band gap was observed in two cases: when (i) capped and (ii) decreased in size. The band gap was increased from 2.50 eV for the uncapped to 2.77 eV for the DTT capped CdS. DTT was found to be the best capping agent for CdS among these five organic thiols in two aspects: (i) yielding lower grain size in cubic phase, and (ii) good fluorescence properties with efficient quenching of the surface traps.