Degradation of dimethyl phthalate (DMP) in aqueous solution by UV/Si–FeOOH/H2O2

Rapidly degradation of di-(2-ethylhexyl) phthalate by Z-scheme Bi2O3/TiO2@reduced graphene oxide driven by simulated solar radiation

Di(2-ethylhexyl) phthalate (DEHP) is a priority environmental pollutant with carcinogenic, teratogenic, and mutagenic toxicity. Because it is widely used and ubiquitous in water, it is urgent to use a non-toxic, fast, and non-temperature dependent photocatalyst for degradation. Herein, a Z-scheme heterojunction composite catalyst consisting of Bi₂O₃ and TiO₂ with reduced graphene oxide (rGO) as a two-dimensional template was designed and characterized. Under simulated solar radiation, the catalyst doped with 4% rGO presented the best photocatalytic DEHP (10 mg L^-1) degradation at pH = 6, reaching 89% conversion in 90 min, and the degradation rate was 2.05 times higher than unmodified materials. The successful preparation of the Z-scheme junction enhanced the utilization of visible light region, thereby improving the DEHP's photocatalytic degradation performance. Subsequently, density functional theory (DFT) combined with GC-MS metabolite detection to propose a complete DEHP photocatalytic degradation mechanism. ·O₂^- and ·OH were detected as the primary reactive oxygen radicals involved in DEHP degradation, which easily attacked the O11 site with a high Fukui index (f⁰) through de-esterification, β-oxidation, and hydroxylation. While satisfying the rapid degradation, the highly repeatable catalyst cleaved the aromatic ring so that DEHP achieved mineralization during the degradation process. Therefore, its ability to completely degrade was very promising for environmental remediation, especially in water treatment. Besides, there were only a few studies on the degradation mechanism and reaction pathway of DEHP under visible light, which provided a theoretical basis for the aromatic compounds' photocatalysis research.

α-FeOOH-MoO3 Nanorod for Effective Photo-Fenton Degradation of Dyes and Antibiotics at a Wide Range of pH

It's highly significant to develop a novel catalyst, which can be active at a wide range of pH, for an effective photo-Fenton reaction. In this work, α-FeOOH-MoO₃ nanorod was prepared by a one-step hydrothermal method and applied in photo-Fenton degradation of organic pollutants. Benefit from the electron migration mechanism of Z-scheme and excellent photoelectric performance, the catalyst exhibited superior photo-Fenton activity in degradation of organic pollutants. In addition, the catalyst holds good stability after 5 recycles. These results demonstrated that this catalyst has wide application prospect in organic wastewater treatment.

Wet scrubber coupled with heterogeneous UV/Fenton for enhanced VOCs oxidation over Fe/ZSM-5 catalyst

The traditional treatment processes for volatile organic compounds (VOCs) removal generally suffered several disadvantages, such as secondary air-pollutants. To overcome these issues, wet scrubber coupled with heterogeneous UV/Fenton was developed for gaseous VOCs (i.e. toluene) removal. ZSM-5 supported iron oxide (Fe/ZSM-5) was prepared as a multifunctional catalyst for activation of H₂O₂ and enhancement of gas-liquid mass transfer. Toluene was removed efficiently by this coupled process with the removal efficiency of 85% during 120 min. Many intermediates were detected in the solution by GC-MS while no intermediates were observed in the outlet gas, suggesting that wet scrubber coupled with heterogeneous UV/Fenton could significantly reduce secondary air pollutants. The possible mechanism of toluene oxidation was proposed including the physical adsorption by Fe/ZSM-5 and OH oxidation. This study provides an environmentally benign and highly efficient chemical scrubbing process for gaseous VOCs removal.

Degradation of methylene blue with magnetic Co-doped Fe3O4@FeOOH nanocomposites as heterogeneous catalysts of peroxymonosulfate

Magnetic Co-doped Fe₃O₄@FeOOH nanocomposites were prepared in one step using the hydrothermal synthesis process for catalyzing peroxymonosulfate (PMS) to degrade refractory methylene blue (MB) at a wide pH range (3.0–10.0). The catalysts' physiochemical properties were characterized by different equipment; Fe³⁺/Fe²⁺ and Co³⁺/Co²⁺ were confirmed to coexist in the nanocomposite by X-ray photoelectron spectroscopy. The nanocomposite effectively catalyzed PMS's decoloration (99.2%) and mineralization (64.7%) of MB. The formation of Co/Fe–OH complexes at the surface of nanoparticles was proposed to facilitate heterogeneous PMS activation. Compared with the observation for Fe₃O₄@FeOOH, the pseudo-first-order reaction constant was enhanced by 36 times due to Co substitution (0.1620 min⁻¹vs. 0.0045 min⁻¹), which was assigned to the redox recycle of Fe³⁺/Fe²⁺ and Co³⁺/Co²⁺ in Co-doped Fe₃O₄@FeOOH. Besides, the catalyst could be easily reused by magnetic separation and exhibited relatively long-term stability.

Magnetic Co-doped Fe₃O₄@FeOOH nanocomposites were prepared in one step using the hydrothermal synthesis process for catalyzing peroxymonosulfate (PMS) to degrade refractory methylene blue (MB) at a wide pH range (3.0–10.0).

Novel RGO/α-FeOOH supported catalyst for Fenton oxidation of phenol at a wide pH range using solar-light-driven irradiation

A novel solar-light-driven (SLD) Fenton catalyst was developed by reducing the ferrous-ion onto graphene oxide (GO) and forming reduced graphene oxide/α-FeOOH composites (RF) via in-situ induced self-assembly process. The RF was supported on several mesoporous supports (i.e., Al-MCM-41, MCM-41 and γ-Al₂O₃). The activity, stability and energy use for phenol oxidation were systematically studied for a wide pH range. Furthermore, the catalytic mechanism at acid and alkaline aqueous conditions was also elucidated. The results showed that Fe(II) was reduced onto GO nanosheets and α-FeOOH crystals were formed during the self-assembly process. Compared with Fenton reaction without SLD irradiation, the visible light irradiation not only dramatically accelerated the rate of Fenton-based reactions, but also extended the operating pH for the Fenton reaction (from 4.0 to 8.0). The phenol oxidation on RF supported catalysts was fitting well with the pseudo-first-order kinetics, and needed low initiating energy, insensitive to the reacting temperature changes (273-318K). The Al-MCM-41 supported RF was a more highly energy-efficient catalyst with the prominent catalytic activity at wide operating pHs. During the reaction, OH radicals were generated by the SLD irradiation from H₂O₂ reduction and H₂O oxidation in the Fe^Ⅱ/Fe^Ⅲ and Fe^Ⅲ/Fe^Ⅳ cycling processes.

Enhanced heterogeneous photo-Fenton process modified by magnetite and EDDS: BPA degradation

In this research, magnetite and ethylenediamine-N,N'-disuccinic acid (EDDS) are used in a heterogeneous photo-Fenton system in order to find a new way to remove organic contaminants from water. Influence of different parameters including magnetite dosage, EDDS concentration, H₂O₂ concentration, and pH value were evaluated. The effect of different radical species including HO^· and HO₂^·/O₂^·- was investigated by addition of different scavengers into the system. The addition of EDDS improved the heterogeneous photo-Fenton degradation of bisphenol A (BPA) through the formation of photochemically efficient Fe-EDDS complex. This effect is dependent on the H₂O₂ and EDDS concentrations and pH value. The high performance observed at pH 6.2 could be explained by the ability of O₂^·- to generate Fe(II) from Fe(III) species reduction. GC-MS analysis suggested that the cleavage of the two benzene rings is the first degradation step followed by oxidation leading to the formation of the benzene derivatives. Then, the benzene ring was opened due to the attack of HO^· radicals producing short-chain organic compounds of low molecular weight like glycerol and ethylene glycol. These findings regarding the capability of EDDS/magnetite system to promote heterogeneous photo-Fenton oxidation have important practical implications for water treatment technologies.

Oxidative Degradation of Dimethyl Phthalate (DMP) by Persulfate Catalyzed by Ag+ Combined with Microwave Irradiation

The removal of dimethyl phthalate (DMP), which is a pollutant of concern in water environments, was carried out by sodium persulfate (SPS,Na2S2O8) catalyzed by Ag+combined with microwave irradiation. Effects of persulfate concentration, reaction time, microwave(MW) power and catalytic ion Ag+ on the degradation efficiency of DMP by persulfate were examined in batch experiments. The results showed that optimum Na2S2O8 concentration was 0.083mmol/L, and Ag+ concentration was 0.042 mmol/L. Increasing the MW irradiation time , persulfate concentration or Ag+ concentration might significantly accelerate DMP degradation. Catalytic ion Ag+combined with microwave irradiation was an rapid method to activate persulfate, and thus to produce SO4−• which was a powerful oxidant and could degrade DMP effectively. About 80% of DMP and 70% of COD could be degraded in 140s under the conditions of 800W MW power.

Environmental impact of phthalic acid esters and their removal from water and sediments by different technologies--a review

This article describes the most recent methods developed to remove phthalic acid esters (PAEs) from water, wastewater, sludge, and soil. In general, PAEs are considered to be endocrine disrupting chemicals (EDCs), whose effects may not appear until long after exposure. There are numerous methods for removing PAEs from the environment, including physical, chemical and biological treatments, advanced oxidation processes and combinations of these techniques. This review largely focuses on the treatment of PAEs in aqueous solutions but also reports on their treatment in soil and sludge, as well as their effects on human health and the environment.

Removal of phthalates from aqueous solution by different adsorbents: a short review

This work presents a short review of adsorptive materials proposed and tested for removing phthalates from an aqueous environment. The objective is not to present an exhaustive review of all the types of adsorbents used, but to focus on selected types of "innovative" materials. Examples include modified activated carbon, chitosan and its modifications, β-cyclodextrin, and specific types of biomass, such as activated sludge from a wastewater treatment plant, seaweed and microbial cultures. Data from the literature do not confirm the existence of a broad-spectral adsorbent with high sorption efficiency, low production costs and environmentally friendly manufacture. According to the coefficients of Freundlich's isotherm, the most promising adsorbent of those mentioned in this work appears to be the biomass of activated sludge, or extracellular polysaccharides extracted from it. This material benefits from steady production, is cheap and readily available. Nevertheless, before putting it in practice, the treatment and adaptation of this raw material has to be taken into consideration.