Layer-by-layer construction of super-hydrophilic and self-healing polyvinylidene fluoride composite membrane for efficient oil/water emulsion separation

Bio-Inspired Textiles for Self-Driven Oil-Water Separation-A Simulative Analysis of Fluid Transport

In addition to water repellency, superhydrophobic leaves of plants such as Salvinia molesta adsorb oil and separate it from water surfaces. This phenomenon has been the inspiration for a new method of oil-water separation, the bionic oil adsorber (BOA). In this paper, we show how the biological effect can be abstracted and transferred to technical textiles, in this case knitted spacer textiles hydrophobized with a layered silicate, oriented at the biology push approach. Subsequently, the transport of the oil within the bio-inspired textile is analyzed by a three-dimensional fluid simulation. This fluid simulation shows that the textile can be optimized by reducing the pile yarn length, increasing the pile yarn spacing, and increasing the pile yarn diameter. For the first time, it has been possible with this simulation to optimize the bio-inspired textile with regard to oil transport with little effort and thus enable the successful implementation of a self-driven and sustainable oil removal method.

Construction of a multi-layer protection of CS polymer brush grafted DA@CNTs coating on PVDF membrane for effective removal of dye effluent

In the process of removing dye wastewater, the membrane surface is susceptible to contamination, resulting in reduced performance and limited dye separation efficiency. A single hydrophilic modification layer is not enough to achieve effective separation of different types of dyes. The present research designed a "double layer protection" method in order to overcome the above deficiencies. A solution of dopamine (DA) coated carbon nanotubes (CNTs-COOH) was covered on the surface of the polyvinylidene fluoride (PVDF) membrane by deposition, followed by grafting a layer of chitosan (CS) polymer brushes on its surface. The spatial double layer structure provides an excellent barrier effect and effectively reduces the contamination of dyes. When filtering different types of dyes, effective filtration of anionic and cationic dyes through the electrostatic effect of the first layer, the adsorption of CNTs in the second layer and the hydration layer of both layers. All membranes have excellent rejection properties. More importantly, the membranes also had good chemical and mechanical stability and their serviceability was not degraded. Therefore, the prepared PVDF-based multi-layer composite membranes behave a potential application prospect in the wastewater purification field.

Modification of Thin Film Composite PVA/PAN Membranes for Pervaporation Using Aluminosilicate Nanoparticles

The effect of the modification of the polyvinyl alcohol (PVA) selective layer of thin film composite (TFC) membranes by aluminosilicate (Al₂O₃·SiO₂) nanoparticles on the structure and pervaporation performance was studied. For the first time, PVA-Al₂O₃·SiO₂/polyacrylonitrile (PAN) thin film nanocomposite (TFN) membranes for pervaporation separation of ethanol/water mixture were developed via the formation of the selective layer in dynamic mode. Selective layers of PVA/PAN and PVA-Al₂O₃·SiO₂/PAN membranes were formed via filtration of PVA aqueous solutions or PVA-Al₂O₃·SiO₂ aqueous dispersions through the ultrafiltration PAN membrane for 10 min at 0.3 MPa in dead-end mode. Average particle size and zeta potential of aluminosilicate nanoparticles in PVA aqueous solution were analyzed using the dynamic light scattering technique. Structure and surface properties of membranes were studied using scanning electron microscopy (SEM), atomic force microscopy (AFM) and water contact angle measurements. Membrane performance was investigated in pervaporation dehydration of ethanol/water mixtures in the broad concentration range. It was found that flux of TFN membranes decreased with addition of Al₂O₃·SiO₂ nanoparticles into the selective layer due to the increase in selective layer thickness. However, ethanol/water separation factor of TFN membranes was found to be significantly higher compared to the reference TFC membrane in the whole range of studied ethanol/water feed mixtures with different concentrations, which is attributed to the increase in membrane hydrophilicity. It was found that developed PVA-Al₂O₃·SiO₂/PAN TFN membranes were more stable in the dehydration of ethanol in the whole range of investigated concentrations as well as at different temperatures of the feed mixtures (25 °C, 35 °C, 50 °C) compared to the reference membrane which is due to the additional cross-linking of the selective layer by formation hydrogen and donor-acceptor bonds between aluminosilicate nanoparticles and PVA macromolecules.