Structure-property relations of β-lactoglobulin/κ-carrageenan mixtures in aqueous foam

Yellow mustard gum: pilot-scale production and characterization

BACKGROUND

Yellow mustard gum (YMG), which is extracted from the mucilaginous part of yellow mustard bran, has been considered an emerging natural hydrocolloid gum but lacks commercial development and production. To promote the commercial utilization of YMG, this study developed a pilot-scale YMG production protocol in an economic and environmentally friendly way to produce a clean-label YMG product. This YMG produced at pilot scale (YMW) was characterized in terms of chemical composition, rheological properties, and interaction with a commercial gum, κ-carrageenan, and was compared with purified YMG through ethanol precipitation (YME).

RESULTS

The protocol processed up to 100 L of raw material with zero solvent and a minimal number of steps and showed strong quasi-industrial potential. The YMW showed a similar chemical composition as YME. However, the YMW contained a slightly lower amount of carbohydrate and a much larger amount of ash and potassium than the YME. The rheological results concluded that both the YMW and YME solutions exhibited shear-thinning flow behavior and a weak gel, with YME showing higher viscosity and stronger gel structure. Most interestingly, YMW could form unpourable gels when blended with native κ-carrageenan whereas YME barely achieved this despite the equivalent total gum concentration.

CONCLUSION

This study demonstrated the feasibility of YMG production at a large scale with economic and green procedures and discovered its new functionality for commercial utilization. The gelling ability of YMG could provide it with wider applications as a result of a new potential synergistic combination. All this information should accelerate the process of full commercialization of YMG as a clean-label functional ingredient. © 2024 His Majesty the King in Right of Canada. Journal of The Science of Food and Agriculture © 2024 Society of Chemical Industry. Reproduced with the permission of the Minister of Agriculture and Agri-Food Canada.

Enzymatic hydrolysates of κ-carrageenan by κ-carrageenase-CLEA immobilized on amine-modified ZIF-8 confer hypolipidemic activity in HepG2 cells

κ-Carrageenase can degrade κ-carrageenan to produce bioactive κ-carrageenan oligosaccharides (KCOs) that have potential applications in pharmaceutical, food, agricultural, and cosmetics industries. Immobilized enzymes gain their popularity due to their good reusability, enhanced stability, and tunability. In this study, the previously characterized catalytic domain of Pseudoalteromonas purpurea κ-carrageenase was covalently immobilized on the synthesized amine-modified zeolitic imidazolate framework-8 nanoparticles with the formation of cross-linked enzyme aggregates, and the immobilized κ-carrageenase was further characterized. The immobilized κ-carrageenase demonstrated excellent pH stability and good reusability, and exhibited higher optimal reaction temperature, better thermostability, and extended storage stability compared with the free enzyme. The KCOs produced by the immobilized κ-carrageenase could significantly decrease the TC, TG, and LDL-C levels in HepG2 cells, increase the HDL-C level in HepG2 cells, and reduce the free fatty acids level in Caco-2 cells. Biochemical assays showed that the KCOs could activate AMPK activity, increase the ratios of p-AMPK/AMPK and p-ACC/ACC, and downregulate the expression of the lipid metabolism related proteins including SREBP1 and HMGCR in the hyperlipidemic HepG2 cells. This study provides a novel and effective method for immobilization of κ-carrageenase, and the KCOs produced by the immobilized enzyme could be a potential therapeutic agent to prevent hyperlipidemia.

The Stability, Rheological Properties and Interfacial Properties of Oil-in-Water (O/W) Emulsions Prepared from Dielectric Barrier Discharge (DBD) Cold Plasma-Treated Chickpea Protein Isolate and Myofibrillar Protein Complexes

In order to increase the development and utilization of chickpea protein isolate (CPI) and improve the stability of myofibrillar protein (MP) emulsions, the effect of dielectric barrier discharge (DBD) plasma-modified CPI on the emulsifying properties of MP was investigated. Three different O/W emulsions were prepared using MP, MP + CPI complex, or MP + DBD-treated CPI complex as the emulsifier. Compared with the emulsion prepared from MP, the emulsifying activity index and stability of DBD-treated CPI and MP complex (MP + CPIDBD) were increased (p < 0.05) from 55.17 m2/g to 74.99 m2/g and 66.31% to 99.87%, respectively. MP + CPIDBD produced more stable emulsions with the lowest Turbiscan stability index (TSI) values for a given 3600 s. At shear rates from 0 to 1000-1, MP + CPIDBD-stabilized emulsions had higher viscosities, which helped to reduce the chance of aggregation between oil droplets. The optical microscope and particle size distribution of emulsions showed that MP + CPIDBD emulsions had the lowest droplet size (d4,3) and exhibited more uniform distribution. MP + CPIDBD emulsions had lower interfacial tension. DBD pretreatment increased the adsorbed protein content in the emulsion stabilized by MP + CPIDBD as compared to the MP + CPI complex and promoted the adsorption of CPI by higher ratios of adsorbed proteins as indicated by its intensity in SDS-PAGE. Scanning electron microscopy confirmed that the emulsion prepared from MP + CPIDBD had smaller particle size and more uniform dispersion. Therefore, using DBD-modified CPI could enhance the stability of MP emulsions.

Foaming properties are improved by interactions between brewer's spent grain proteins and carrageenans in aqueous solution

BACKGROUND

Foaming properties and macromolecular interactions in solution among brewer's spent grain proteins (CP) and iota and lambda carrageenans (i-CG and l-CG, respectively) as a function of aqueous medium pH (2-6) and protein-polysaccharide ratio, R_CP:CG (1:1, 2:1 and 4:1), were studied. At these conditions, the CP colloidal stability was favored by the formation of soluble electrostatic complexes with CG. Fluorescence (intrinsic and extrinsic) spectroscopy and dynamic light scattering techniques, including particle size and ζ-potential analysis, were applied to know the phase behavior of the biopolymer systems. The bubbling method was used to produce foams, and the foam expansion (%) and half-life time (t_1/2 ) were determined.

RESULTS

Both CG promoted an increased Trp fluorescence emission depending on the pH, suggesting conformational changes in CP. The CG in mixed systems produced a significant decrease in the extrinsic fluorescence intensity, mainly at low pH values, highlighting a reduction in CP surface hydrophobicity. At the examined pH range, the ζ-potential values for mixed-systems were negative, and their magnitudes were intermediate between CP and CG, revealing the associative electrostatic nature of biopolymer interactions, which were dependent on the R_CP:CG . The particle size analysis confirmed the formation of soluble electrostatic complexes in solution. Finally, using i-CG at pH 2 or 3 and 2:1 R_CP:CG , the best foaming properties for mixed systems were observed.

CONCLUSION

The formation of electrostatic complexes with a compact assembly among biopolymers, high negative net charge, and colloidal stability convert the CP-CG mixed solutions into promising biopolymer systems for food foams production. © 2022 Society of Chemical Industry.

Effect of Lipase and Phospholipase A1 on Foaming and Batter Properties of Yolk Contaminated Egg White

Egg white (EW) is frequently used in bakery products because of its excellent foaming capabilities. However, egg yolk (EY) contamination often degrades the foaming characteristics of EW. The purpose of this study was to investigate the effect of different concentrations of phospholipase A1 (PLPA1) and lipase (LP) on EW. The changes in particle size distribution and potential before and after enzymatic digestion of EW with contaminated 0.5 wt% and 1.0%wt EY were tested. The foaming rate and foam stability were measured after the dispersions were digested with different concentrations of PLPA1 and LP. Additionally, the dispersion samples were used to prepare batter and angel cake, and the modulus, density, and microstructure of the batter were analyzed. Results showed that the potential absolute value increased when the EY was hydrolyzed by PLPA1. The distribution of yolk particle size showed a new aggregation and the average particle size decreased after LP hydrolysis. The dispersion samples hydrolyzed by PLPA1 and LP recovered all the properties of the samples at enzymatic concentrations of 500 U/g and 2500 U/g. This may be attributed to the changes in yolk particles resulting from the enzymatic digestion of EY and the production of amphiphilic lysophospholipids, fatty acids, and glycerol.

Effects of Concentration and Heating/Cooling Rate on Rheological Behavior of Sesamum indicum Seed Hydrocolloid

Hydrocolloids are known as natural hydrophilic biopolymers that can contribute viscosity and gelation in solution, as well as nutritional benefits, thus, they are widely used in the food industry. In our work, hydrocolloid was isolated by aqueous extraction of Sesamum indicum seed at 80 °C and pH 8.0. The chemical composition and functional properties of Sesamum indicum seed hydrocolloid (SISH) were characterized, and the effects of concentration including 1%, 2%, and 3% as well as heating/cooling rate (1, 5, and 10 °C/min) on the rheological behavior of SISH dispersions in aqueous solution were investigated. The viscoelastic properties of SISH dispersions were characterized by small-amplitude oscillatory shear measurement. The resultant SISH consisted of 60.95% carbohydrate and 23.32% protein, and was thus endowed with a relatively high water-holding capacity, solubility, appropriate emulsifying and foaming properties. Rheological results revealed that the aqueous dispersion of SISH exhibited a non-Newtonian shear-thinning flow behavior. The viscoelastic moduli changes were found to be dependent on SISH concentration, temperature, and heating/cooling rate. Increasing SISH concentrations from 1% to 3% promoted the development of stronger cross-link network. The mechanical spectra derived from strain and frequency sweep measurements showed that the storage moduli were always higher than the loss moduli, and the loss tangent was calculated to be above 0.1 and below 1.0. Furthermore, both moduli had slight frequency dependency, and the complex viscosity exhibited an almost linear reduction with the increase of frequency. Therefore, SISH dispersion behaved as a weak gel-like system. The hysteresis of viscoelastic moduli during heating and cooling reduced with decreasing the heating-cooling rates from 10 to 1 °C/min, suggesting that SISH molecules had enough time to develop a stable and thermally irreversible network. Overall, SISH can be regarded as an acceptable hydrocolloid for generating natural food components with intriguing functional and rheological qualities in the formulation of microstructured goods.

Dos and don'ts tutorial for sample alignment in sum frequency generation spectroscopy

This Tutorial aims to provide a concise yet practical guideline for different scenarios that one may face in a sum frequency generation (SFG) spectroscopy laboratory, especially when it comes to sample alignment. The effort is made to reconstruct the real and often challenging sample alignment conditions for a broad range of liquid or solid samples interfacing solid, liquid, or gas phases, with a pedagogical approach. Both newcomer operators of an SFG setup without a strong experience in nonlinear spectroscopy and the more experienced SFG users can utilize the approaches that are provided in this Tutorial for an easier and more reliable sample alignment in their SFG laboratories.