Rapid photothermal detection of foodborne pathogens based on the aggregation of MPBA-AuNPs induced by MPBA using a thermometer as a readout

A novel multifunctional magnetically recyclable BiOBr/ZnFe2O4-GO S-scheme ternary heterojunction: Photothermal synergistic catalysis under Vis/NIR light and NIR-driven photothermal detection of tetracycline

The threat of tetracycline (TC) to human health has become a significant issue that cannot be disregarded. Herein, in order to achieve effective degradation and high-sensitivity detection of TC, BiOBr/ZnFe2O4-GO (BOB/ZFO-GO) S-scheme heterojunction nanocomposites (NCs) have been prepared using hydrothermal method. GO with high light absorption capacity accelerated the electron transfer between BiOBr and ZnFe2O4 nanocrystals and extended the light absorption region of BOB/ZFO NCs. The optimal GO addition of BOB/ZFO-GO NCs could degrade TC solution of 10 mg/L in 80 min and have a high reaction rate constant (k) of 0.072 min-1 under visible/NIR light. According to calculations, the non-metal photocatalyst (BOB/ZFO-GO(2)) with the best degradation performance had a photothermal conversion efficiency of up to 23%. Meanwhile, BOB/ZFO-GO NCs could be recycled by magnetic field. The excellent photocatalytic and photothermal performance could be maintained even after several cycles. In addition, a photothermal detection sensor based on a photothermal material/specific recognition element/tetracycline sandwich-type structure was constructed for the trace detection of TC concentration with a detection limit as low as 10-4 ng/mL. This research provides a unique idea for the multi-functionalization of photocatalysts and has a wide range of potential applications for the identification and treatment of organic wastewater.

An intelligent readable and capture-antibody-independent lateral flow immunoassay based on Cu2-xSe nanocrystals for point-of-care detection of Escherichia coli O157:H7

Escherichia coli (E. coli) O157:H7 is a common foodborne pathogen which can cause serious harm. It is particularly important to establish a simple and portable method to achieve on-site pathogen detection. In this study, a capture-antibody-independent lateral flow immunoassay (LFIA) was constructed based on Cu2-xSe nanocrystals (Cu2-xSe NCs) for rapid detection of E. coli O157:H7. Cu2-xSe NCs can not only be regarded as the "nano-antibody" for the recognition of E. coli O157:H7 through electrostatic adsorption, but also as nanozymes that show good peroxidase-like catalytic activity. The formed compound of E. coli O157:H7 and Cu2-xSe NCs would be captured by a detection antibody on the T line due to the specific recognition of the antibody and E. coli O157:H7. Then, Cu2-xSe NCs could catalyze the oxidation of TMB by H2O2 to generate oxTMB, thereby generating blue bands. Meanwhile, we developed a mobile app for rapid data analysis. Under the optimal reaction conditions, E. coli O157:H7 could be detected within 70 min. The detection limit of this method was 2.65 × 105 CFU mL-1 with good specificity and stability. Additionally, it could achieve on-site rapid detection of E. coli O157:H7 in environmental water samples, providing a promising biosensor for portable pathogen detection.

Development of a thermochromic lateral flow assay to improve sensitivity for dengue virus serotype 2 NS1 detection

Dengue disease is a viral infection that has been widespread in tropical regions, such as Southeast Asia, South Asia and South America. A worldwide effort has been made over a few decades to halt the spread of the disease and reduce fatalities. Lateral flow assay (LFA), a paper-based technology, is used for dengue virus detection and identification because of its simplicity, low cost and fast response. However, the sensitivity of LFA is relatively low and is usually insufficient to meet the minimum requirement for early detection. In this study, we developed a colorimetric thermal sensing LFA format for the detection of dengue virus NS1 using recombinant dengue virus serotype 2 NS1 protein (DENV2-NS1) as a model antigen. Plasmonic gold nanoparticles, including gold nanospheres (AuNSPs) and gold nanorods (AuNRs), and magnetic nanoparticles (MNPs), namely iron oxide nanoparticles (IONPs) and zinc ferrite nanoparticles (ZFNPs), were studied for their thermal properties for sensing assays. AuNSPs with 12 nm diameter were chosen due to their great photothermal effect against light-emitting diodes (LEDs). In the thermal sensing assay, a thermochromic sheet is used as a temperature sensor transforming heat into a visible colour. In the typical LFA, the test line is visible at 6.25 ng mL-1 while our thermal sensing LFA offers a visual signal that can be observed at as low as 1.56 ng mL-1. The colorimetric thermal sensing LFA is capable of reducing the limit of detection (LOD) of DENV2-NS1 by 4 times compared to the typical visual readout. The colorimetric thermal sensing LFA can enhance the sensitivity of detection and deliver visuality to the user to translate without the need for an infrared (IR) camera. It has the potential to expand the utilities of LFA and satisfy early diagnostic applications.

NIR II light response-based PDA/AuPt@CuS composites: Simultaneous readout of temperature and pressure sensing strategy for portable detection of pathogenic bacteria

In this study, we developed a simultaneous readout of pressure and temperature dual-signals platform based on the second near-infrared (NIR II) light response-based polydopamine (PDA)-functionalized-AuPt nanoparticles (NPs)@CuS nanosheets (PDA/AuPt@CuS NS) composite. Due to the excellent NIR photothermal performance of PDA/AuPt@CuS NS, it contribute to the decomposition of H₂O₂ and NH₄HCO₃ to generate gases (including O₂, CO₂, and NH₃₎ can be promoted, which can amplify the pressure signals in a sealed container. A sandwich mode is formed between Fe₃O₄ NPs and PDA/AuPt@CuS NS based on the dual-aptamer when target pathogenic bacteria is present. And, it is possible to convert the molecular recognition signals between the dual-aptamers into amplified pressures and temperatures, which can be read out by a portable pressure meter and smartphones simultaneously. It may offer the possibility for quantitative POCT analysis of Pathogenic Bacteria. Moreover, because of the high photothermal efficiency of this method, the developed dual-mode method can achieve that following the detection of bacteria and killing them immediately. As a result, secondary contamination is eliminated and bacterial transmission is avoided. The developed dual-signal sensing platform is also inexpensive, simple to operate and rapidly, indicating that it can be used for food safety analysis, clinical applications, and environmental monitoring.

Colorimetric Sensing of Gram-Negative and Gram-Positive Bacteria Using 4-Mercaptophenylboronic Acid-Functionalized Gold Nanoparticles in the Presence of Polyethylene Glycol

Gold nanoparticles (GNPs) have been used as detection probes for rapid and sensitive detection of various analytes, including bacteria. Here, we demonstrate a simple strategy for bacterial detection using GNPs functionalized with 4-mercaptophenylboronic acid (4-MPBA). 4-MPBA can interact with peptidoglycan or lipopolysaccharides present in bacterial organelles. After the addition of a high concentration of sodium hydroxide (NaOH), the functionalization of the surface of 50 nm GNPs with 4-MPBA (4-MPBA@GNPs) in the presence of polyethylene glycol results in a color change because of the aggregation of 4-MPBA@GNPs. This color change is dependent on the amount of bacteria present in the tested samples. Escherichia coli (E. coli) K-12 and Staphylococcus aureus (S. aureus) are used as Gram-negative and Gram-positive bacterial models, respectively. The color change can be detected within an hour by the naked eye. A linear relationship is observed between bacterial concentrations and the absorbance intensity at 533 nm; R ² values of 0.9152 and 0.8185 are obtained for E. coli K-12 and S. aureus, respectively. The limit of detection of E. coli K-12 is ∼2.38 × 10² CFU mL^-1 and that of S. aureus is ∼4.77 × 10³ CFU mL^-1. This study provides a promising approach for the rapid detection of target Gram-negative and Gram-positive bacteria.

Single-Probe-Based Colorimetric and Photothermal Dual-Mode Identification of Multiple Bacteria

Effective identification of multiple pathogenic bacteria in unknown samples is important for disease prevention and control but remains a challenge yet. A single-mode array-based sensing approach is simple and sensitive, but it usually relies on the use of multiple cross-reactive receptors to construct sensor arrays, which is cumbersome and insufficiently accurate. Here, we developed a sensor array with colorimetric and photothermal dual mode of differentiating multiple pathogenic bacteria. The sensor array was based on boronic acid-functionalized Au-Fe₃O₄ nanoparticles (BA-GMNPs), which not only possess localized surface plasmon resonance properties, showing a burgundy color similar to that of AuNPs, but also exhibit mild superparamagnetism, allowing for the differentiation of bacteria before and after binding to the nanoparticles. Immobilization of BA-GMNPs on the bacterial cell surface by covalent bonding would diminish NaCl-induced assembly of BA-GMNPs. Different BA-GMNPs@bacterial complexes differed in their ability to resist assembly and produced different colorimetric and photothermal response signals. A unique molecular fingerprint of each bacterium was obtained by linear discriminant analysis of the response patterns, demonstrating an effective differentiation among the six species studied. Compared with single-mode sensing arrays based on multiple receptors, this method only requires the preparation of a single nanomaterial, which produces two signal outputs for the identification of multiple bacteria with better differentiation. It can distinguish not only multiple pathogenic bacteria but also Gram-negative and Gram-positive bacteria, and, more importantly, it can perform preliminary discrimination of unknown samples.

Bifunctional M13 Phage as Enzyme Container for the Reinforced Colorimetric-Photothermal Dual-Modal Sensing of Ochratoxin A

"Point of care" (POC) methods without expensive instruments and special technicians are greatly needed for high-throughput analysis of mycotoxins. In comparison, the most widely used screening method of the conventional enzyme-linked immunosorbent assay (ELISA) confronts low sensitivity and harmful competing antigens. Herein, we develop a plasmonic-photothermal ELISA that allows precise readout by color-temperature dual-modal signals based on enzymatic reaction-induced AuNP aggregation for highly sensitive detection of ochratoxin A (OTA). The bifunctional M13 phage carrying OTA that mimics the mimotope on the end of p3 proteins and abundant biotin molecules on the major p8 proteins is adopted as an eco-friendly competing antigen and enzyme container for amplifying the signal intensity. Under optimal conditions, both colorimetric and photothermal signals enable good dynamic linearity for quantitative OTA detection with the limits of detection at 12.1 and 8.6 pg mL-1, respectively. Additionally, the proposed ELISA was adapted to visual determination with a cutoff limit of 78 pg mL-1 according to a vivid color change from deep blue to red. The recoveries of OTA-spiked corn samples indicate the high accuracy and robustness of the proposed method. In conclusion, our proposed strategy provides a promising method for eco-friendly and sensitive POC screening of OTA. Moreover, it can be easily applied to other analytes by changing the involved specific mimotope sequence.

Recent Progress in Nanotechnology-Based Approaches for Food Monitoring

Throughout the food supply chain, including production, storage, and distribution, food can be contaminated by harmful chemicals and microorganisms, resulting in a severe threat to human health. In recent years, the rapid advancement and development of nanotechnology proposed revolutionary solutions to solve several problems in scientific and industrial areas, including food monitoring. Nanotechnology can be incorporated into chemical and biological sensors to improve analytical performance, such as response time, sensitivity, selectivity, reliability, and accuracy. Based on the characteristics of the contaminants and the detection methods, nanotechnology can be applied in different ways in order to improve conventional techniques. Nanomaterials such as nanoparticles, nanorods, nanosheets, nanocomposites, nanotubes, and nanowires provide various functions for the immobilization and labeling of contaminants in electrochemical and optical detection. This review summarizes the recent advances in nanotechnology for detecting chemical and biological contaminations in the food supply chain.

One-step synthesized antimicrobial peptide-functionalized gold nanoclusters for selective imaging and killing of pathogenic bacteria

The development of multifunctional nanomaterials with bacterial imaging and killing activities is of great importance for the rapid diagnosis and timely treatment of bacterial infections. Herein, peptide-functionalized gold nanoclusters (CWR11-AuNCs) with high-intensity red fluorescence were successfully synthesized via a one-step method using CWR11 as a template and by optimizing the ratio of CWR11 to HAuCl4, reaction time, pH, and temperature. The CWR11-AuNCs bound to bacteria and exhibited selective fluorescence microscopy imaging properties, which is expected to provide a feasible method for locating and imaging bacteria in complex in vivo environments. In addition, CWR11-AuNCs not only retained the antibacterial and bactericidal activities of CWR11 but also exhibited certain inhibitory or killing effects on gram-negative and gram-positive bacteria and biofilms. The MICs of CWR11-AuNCs against Escherichia coli and Staphylococcus aureus were 178 and 89 μg/ml, respectively. Surprisingly, cell viability in the CWR11-AuNC-treated group was greater than that in the CWR11-treated group, and the low cytotoxicity exhibited by the CWR11-AuNCs make them more promising for clinical applications.

Shape-Encoded Functional Hydrogel Pellets for Multiplexed Detection of Pathogenic Bacteria Using a Gas Pressure Sensor

Gas pressure is a promising signal readout mode in point-of-care testing for its merits such as rapidity, simplicity, affordability, and no need for sophisticated instrumentation. Herein, a gas pressure sensor for multiplexed detection of pathogenic bacteria was developed on a hydrogel platform. Spherical and square hydrogel pellets prepared by cross-linking of sodium alginate were functionalized with nisin and ConA for the capture of Staphylococcus aureus and Escherichia coli O157:H7, respectively. By using the shape-encoded functional hydrogel pellets and aptamer-modified platinum-coated gold nanoparticles (Au@PtNPs), a dual-molecule recognition mode was established for rapid and specific detection of the two pathogenic bacteria. Au@PtNPs were applied as signal probes to efficiently catalyze the decomposition of H₂O₂ for generating abundant O₂, which was converted into an amplified gas pressure signal. In two closed containers, the significant gas pressure signals were monitored with a portable pressure meter to quantitate the two pathogenic bacteria. The sensor was successfully applied to detect the pathogenic bacteria in various environmental, biological, and food samples. Thus, the proof-of-principle work paves a new avenue for multiplexed detection of pathogenic bacteria with shape-encoded hydrogel pellets combined with gas pressure signal readout.