Filling carbon nanotubes with liquid acetonitrile

Water distillation modeling by disjoint CNT-based channels under the influence of external electric fields

Using molecular dynamics method, the ion rejection and water flow inside flexible disjoint carbon-based channels were examined in the presence of electric fields. The effects of the carbon nanotube diameters and field magnitude on the nano-channel efficiency were investigated. It was observed that water flow through the filter was modified by increasing the radius of nanotubes, while the salt rejection was reduced. The particles' behaviors inside the channel were described in view of Van der Waals interactions between the water molecules, ions, and carbon atoms. Furthermore, the results indicated that the ion rejection and water flow were increased under the application of proper magnitude of electric fields. Graphical abstract Using MD simulation method, a disjoint CNT-based filter was designed to produce freshwater from a NaCl solution by the aid of external electric field. It was observed that the filter operation was significantly affected by channel structural parameters and amount of applied electric fields.

A controllable water signal transistor

We performed molecular dynamics simulations to study the regulating ability of water chains confined in a Y-shaped nanochannel. It was shown that a signal at the molecular level could be controlled by two other charge-induced signals when the water chains were confined in a Y-shaped nanochannel, demonstrating promising applications as water signal transistors in nanosignal systems. The mechanism of a water signal transistor is similar to a signal logic device. This remarkable ability to control the water signal is attributed to the strong dipole-ordering of the water chains in the nanochannel. The controllable water signal process of the Y-shaped nanochannel provides opportunities for future application in the design of molecular-scale signal devices.

Simulation of water impregnation through vertically aligned CNT forests using a molecular dynamics method

The flow rate of water through carbon nanotube (CNT) membranes is considerably large. Hence, CNT membranes can be used in nanofluidic applications. In this work, we performed a molecular dynamics (MD) simulation of the introduction of water into CNTs in the CNT membranes, especially in vertically aligned CNT forests. The results showed that the Knudsen number (Kn) increased with an increasing volume fraction of CNT (V_C) and was greater than 10⁻³ for each V_C. Beyond this value, the flow became a slip flow. Further, the permeability increased as V_C increased in the actual state calculated by the MD simulation, whereas the permeability in the no-slip state predicted by the Hagen–Poiseuille relationship decreased. Thus, a clear divergence in the permeability trend existed between the states. Finally, the flow enhancement ranged from 0.1 to 23,800, and the results show that water easily permeates as V_C increases.

High-Pressure Phase Favored by a Symmetry-Recognized Nanoconfinement Effect

Recently, a high-pressure phase (B2) of KI has been experimentally observed in the inner space of single-walled carbon nanotubes. Our first-principles calculations indicate that in a confined nanospace, relative stabilities of the high-pressure B2 phase and the low-pressure B1 phase of KI are not necessarily determined by their external pressures. As a result of crystal symmetry differences, different phases are preferred at different K/I ratios. Such a symmetry-recognized confinement effect opens a new avenue for nanomaterials synthesis.

Solvent Effect on the Pore-Size Dependence of an Organic Electrolyte Supercapacitor

Organic electrolytes such as tetraethylammonium tetrafluoroborate dissolved in acetonitrile (TEA-BF4/ACN) are widely used in commercial supercapacitors and academic research, but conflicting experimental results have been reported regarding the dependence of surface-area-normalized capacitance on the pore size. Here we show from a classical density functional theory the dependence of capacitance on the pore size from 0.5 to 3.0 nm for a model TEA-BF4/ACN electrolyte. We find that the capacitance-pore size curve becomes roughly flat after the first peak around the ion diameter, and the peak capacitance is not significantly higher than the large-pore average. We attribute the invariance of capacitance with the pore size to the formation of an electric double-layer structure that consists of counterions and highly organized solvent molecules. This work highlights the role of the solvent molecules in modulating the capacitance and reconciles apparently conflicting experimental reports.

Molecular wire of urea in carbon nanotube: a molecular dynamics study

We perform molecular dynamics simulations of narrow single-walled carbon nanotubes (SWNTs) in aqueous urea to investigate the structure and dynamical behavior of urea molecules inside the SWNT. Even at low urea concentrations (e.g., 0.5 M), we have observed spontaneous and continuous filling of SWNT with a one-dimensional urea wire (leaving very few water molecules inside the SWNT). The urea wire is structurally ordered, both translationally and orientationally, with a contiguous hydrogen-bonded network and concerted urea's dipole orientations. Interestingly, despite the symmetric nature of the whole system, the potential energy profile of urea along the SWNT is asymmetric, arising from the ordering of asymmetric urea partial charge distribution (or dipole moment) in confined environment. Furthermore, we study the kinetics of confined urea and find that the permeation of urea molecules through the SWNT decreases significantly (by a factor of ∼20) compared to that of water molecules, due to the stronger dispersion interaction of urea with SWNT than water, and a maximum in urea permeation happens around a concentration of 5 M. These findings might shed some light on the better understanding of unique properties of molecular wires (particularly the wires formed by polar organic small molecules) confined within both artificial and biological nanochannels, and are expected to have practical applications such as the electronic devices for signal transduction and multiplication at the nanoscale.

Water boiling inside carbon nanotubes: toward efficient drug release

We show using molecular dynamics simulation that spatial confinement of water inside carbon nanotubes (CNTs) substantially increases its boiling temperature and that a small temperature growth above the boiling point dramatically raises the inside pressure. Capillary theory successfully predicts the boiling point elevation down to 2 nm, below which large deviations between the theory and atomistic simulation take place. Water behaves qualitatively different inside narrow CNTs, exhibiting transition into an unusual phase, where pressure is gas-like and grows linearly with temperature, while the diffusion constant is temperature-independent. Precise control over boiling by CNT diameter, together with the rapid growth of inside pressure above the boiling point, suggests a novel drug delivery protocol. Polar drug molecules are packaged inside CNTs; the latter are delivered into living tissues and heated by laser. Solvent boiling facilitates drug release.

Single-file water as a one-dimensional Ising model

We show that single-file water in nanopores can be viewed as a one-dimensional Ising model and investigate, on this basis, the static dielectric response of a chain of hydrogen-bonded water molecules to an external field. To this end, we use a recently developed dipole lattice model which accurately captures the free energetics of nanopore water. In this model, the total energy of the system can be expressed as a sum of effective interactions of chain ends and orientational defects. Neglecting these interactions, we essentially obtain the one-dimensional Ising model which allows us to derive analytical expressions for the free energy as a function of the total dipole moment and for the dielectric susceptibility. Our expressions, which agree very well with simulation results, provide the basis for the interpretation of future dielectric spectroscopy experiments on water-filled nanopore membranes.