Cross-validation of a non-invasive positron detector to measure the arterial input function for pharmacokinetic modelling in dynamic positron emission tomography

EANM guidance document: dosimetry for first-in-human studies and early phase clinical trials

The numbers of diagnostic and therapeutic nuclear medicine agents under investigation are rapidly increasing. Both novel emitters and novel carrier molecules require careful selection of measurement procedures. This document provides guidance relevant to dosimetry for first-in human and early phase clinical trials of such novel agents. The guideline includes a short introduction to different emitters and carrier molecules, followed by recommendations on the methods for activity measurement, pharmacokinetic analyses, as well as absorbed dose calculations and uncertainty analyses. The optimal use of preclinical information and studies involving diagnostic analogues is discussed. Good practice reporting is emphasised, and relevant dosimetry parameters and method descriptions to be included are listed. Three examples of first-in-human dosimetry studies, both for diagnostic tracers and radionuclide therapies, are given.

Feasibility study of a SiPM-fiber detector for non-invasive measurement of arterial input function for preclinical and clinical positron emission tomography

Pharmacokinetic positron emission tomography (PET) studies rely on the measurement of the arterial input function (AIF), which represents the time-activity curve of the radiotracer concentration in the blood plasma. Traditionally, obtaining the AIF requires invasive procedures, such as arterial catheterization, which can be challenging, time-consuming, and associated with potential risks. Therefore, the development of non-invasive techniques for AIF measurement is highly desirable. This study presents a detector for the non-invasive measurement of the AIF in PET studies. The detector is based on the combination of scintillation fibers and silicon photomultipliers (SiPMs) which leads to a very compact and rugged device. The feasibility of the detector was assessed through Monte Carlo simulations conducted on mouse tail and human wrist anatomies studying relevant parameters such as energy spectrum, detector efficiency and minimum detectable activity (MDA). The simulations involved the use of 18F and 68Ga isotopes, which exhibit significantly different positron ranges. In addition, several prototypes were built in order to study the different components of the detector including the scintillation fiber, the coating of the fiber, the SiPMs, and the operating configuration. Finally, the simulations were compared with experimental measurements conducted using a tube filled with both 18F and 68Ga to validate the obtained results. The MDA achieved for both anatomies (approximately 1000 kBq/mL for mice and 1 kBq/mL for humans) falls below the peak radiotracer concentrations typically found in PET studies, affirming the feasibility of conducting non-invasive AIF measurements with the fiber detector. The sensitivity for measurements with a tube filled with 18F (68Ga) was 1.2 (2.07) cps/(kBq/mL), while for simulations, it was 2.81 (6.23) cps/(kBq/mL). Further studies are needed to validate these results in pharmacokinetic PET studies.

Simulation of a novel, non-invasive radiation detector to measure the arterial input function for dynamic positron emission tomography

BACKGROUND

Dynamic positron emission tomography (dPET) is a nuclear medicine imaging technique providing functional images for organs of interest with applications in oncology, cardiology, and drug discovery. This technique requires the acquisition of the time-course arterial plasma activity concentration, called the arterial input function (AIF), which is conventionally acquired via arterial blood sampling.

PURPOSE

The aim of this study was to (A) optimize the geometry for a novel and cost efficient non-invasive detector called NID designed to measure the AIF for dPET scans through Monte Carlo simulations and (B) develop a clinical data analysis chain to successfully separate the arterial component of a simulated AIF signal from the venous component.

METHODS

The NID was optimized by using an in-house Geant4-based software package. The sensitive volume of the NID consists of a band of 10 cm long and 1 mm in diameter scintillating fibers placed over a wrist phantom. The phantom was simulated as a cylinder, 10 cm long and 6.413 cm in diameter comprised of polyethylene with two holes placed through it to simulate the patient's radial artery and vein. This phantom design was chosen to match the wrist phantom used in our previous proof of concept work. Two geometries were simulated with different arrangements of scintillating fibers. The first design used a single layer of 64 fibers. The second used two layers, an inner layer with 29 fibers and an outer layer with 30 fibers. Four positron emitting radioisotopes were simulated: ¹⁸ F, ¹¹ C, ¹⁵ O, and ⁶⁸ Ga with 100 million simulated decay events per run. The total and intrinsic efficiencies of both designs were calculated as well as the full width half maximum (FWHM) of the signal. In addition, contribution by the annihilation photons versus positrons to the signal was investigated. The results obtained from the two simulated detector models were compared. A clinical data analysis chain using an expectation maximization maximum likelihood algorithm was tested. This analysis chain will be used to separate arterial counts from the total signal.

RESULTS

The second NID design with two layers of scintillating fibers had a higher efficiency for all simulations with a maximum increase of 17% total efficiency for ¹¹ C simulation. All simulations had a significant annihilation photon contribution. The signal for ¹⁸ F and ¹¹ C was almost entirely due to photons. The clinical data analysis chain was within 1% of the true value for 434 out of 440 trials. Further experimental studies to validate these simulations will be required.

CONCLUSIONS

The design of the NID was optimized and its efficiency increased through Monte Carlo simulations. A clinical data analysis chain was successfully developed to separate the arterial component of an AIF signal from the venous component. The simulations show that the NID can be used to accurately measure the AIF non-invasively for dPET scans.