Relation between structure and ions mobility in polypyrrole electrosynthesized under high frequency ultrasound irradiation

Characterization of HIFU transducers designed for sonochemistry application: Acoustic streaming

Cavitation distribution in a High Intensity Focused Ultrasound sonoreactors (HIFU) has been extensively described in the recent literature, including quantification by an optical method (Sonochemiluminescence SCL). The present paper provides complementary measurements through the study of acoustic streaming generated by the same kind of HIFU transducers. To this end, results of mass transfer measurements (electrodiffusional method) were compared to optical method ones (Particle Image Velocimetry). This last one was used in various configurations: with or without an electrode in the acoustic field in order to have the same perturbation of the wave propagation. Results show that the maximum velocity is not located at the focal but shifted near the transducer, and that this shift is greater for high powers. The two cavitation modes (stationary and moving bubbles) are greatly affect the hydrodynamic behavior of our sonoreactors: acoustic streaming and the fluid generated by bubble motion. The results obtained by electrochemical measurements show the same low hydrodynamic activity in the transducer vicinity, the same shift of the active focal toward the transducer, and the same absence of activity in the post-focal axial zone. The comparison with theoretical Eckart's velocities (acoustic streaming in non-cavitating media) confirms a very high activity at the "sonochemical focal", accounted for by wave distortion, which induced greater absorption coefficients. Moreover, the equivalent liquid velocities are one order of magnitude larger than the ones measured by PIV, confirming the enhancement of mass transfer by bubbles oscillation and collapse close to the surface, rather than from a pure streaming effect.

Effects of high frequency ultrasound irradiation on incorporation of SiO2 particles within polypyrrole films

This paper deals with the effect of ultrasound on polypyrrole/SiO2 composite film elaboration through various steps (particle dispersion, electrosynthesis). Experiments were carried out on stainless steel in phosphoric acid solution. An efficient method for dispersion of SiO2 particles prior to electropolymerization, based on low frequency irradiation (20kHz), was proposed. It was shown that mechanical effects of high frequency ultrasound (i.e. mass transfer improvement) led to enhancement of electropolymerization kinetics. Scanning electron microscopy imaging and glow discharge optical emission spectroscopy revealed localization of SiO2 particles in the outer region of the films as well as better incorporation of particles under high frequency ultrasound irradiation. Finally, anticorrosion behavior of formed films was investigated in sodium chloride solution by Open Circuit Potential and anodic polarization methods. The results showed that polypyrrole/SiO2 films elaborated under ultrasound irradiation exhibit the best protective performances.