Riboflavin-mediated extracellular electron transfer process involving Pachysolen tannophilus

Moving towards in pouch diagnostics for ostomy patients: exploiting the versatility of laser induced graphene sensors

The development of a 3D printed sensor for direct incorporation within stoma pouches is described. Laser induced graphene scribed on either side of polyimide film served as the basis of a 2 electrode configuration that could be integrated within a disposable pouch sensor for the periodic monitoring of ileostomy fluid pH. The graphene sensors were characterised using electron microscopy, Raman spectroscopy, DekTak profilometry with the electrochemical properties investigated using both cyclic and square wave voltammetry. Adsorbed riboflavin was employed as a biocompatible redox probe for the voltammetric measurement of pH. The variation in peak position with pH was found to be linear over pH 3-8 with a sub Nernstian response (43 mV/pH). The adsorbed probe was found to be reversible and exhibited minimal leaching through repeated scanning. The performance of the system was assessed in a heterogeneous bacterial fermentation mixture simulating ileostomy fluid with the pH recorded before and after 96 h incubation. The peak profile in the bacterial medium provided an unambiguous signal free from interference with the calculated pH before and after incubation (pH 5.3 to 3.66) in good agreement with that obtained with commercial pH probes.

Graphical abstract

Supplementary Information

The online version contains supplementary material available at 10.1007/s10853-023-08881-x.

Assessment of Rhizobium anhuiense Bacteria as a Potential Biocatalyst for Microbial Biofuel Cell Design

The development of microbial fuel cells based on electro-catalytic processes is among the novel topics, which are recently emerging in the sustainable development of energetic systems. Microbial fuel cells have emerged as unique biocatalytic systems, which transform the chemical energy accumulated in renewable organic fuels and at the same time reduce pollution from hazardous organic compounds. However, not all microorganisms involved in metabolic/catalytic processes generate sufficient redox potential. In this research, we have assessed the applicability of the microorganism Rhizobium anhuiense as a catalyst suitable for the design of microbial fuel cells. To improve the charge transfer, several redox mediators were tested, namely menadione, riboflavin, and 9,10-phenanthrenequinone (PQ). The best performance was determined for a Rhizobium anhuiense-based bio-anode mediated by menadione with a 0.385 mV open circuit potential and 5.5 μW/cm² maximal power density at 0.35 mV, which generated 50 μA/cm² anode current at the same potential.

3D Hierarchical Co8FeS8-FeCo2O4/N-CNTs@CF with an Enhanced Microorganisms-Anode Interface for Improving Microbial Fuel Cell Performance

Microbial fuel cells (MFCs) are promising ecofriendly techniques for harvesting bioenergy from organic and inorganic matter. Currently, it is challenging to design MFC anodes with favorable microorganism attachment and fast extracellular electron transfer (EET) rate for high MFC performance. Here we prepared N-doped carbon nanotubes (NCNTs) on carbon felt (CF) and used it as a support for growing hierarchical Co₈FeS₈-FeCo₂O₄/NCNTs core-shell nanostructures (FeCo/NCNTs@CF). We observed improved wettability, specific areal capacitance, and diffusion coefficient, as well as small charge transfer resistance compared with bare CF. MFCs equipped with FeCo/NCNTs@CF displayed a power density of 3.04 W/m² and COD removal amount of 221.0 mg/L/d, about 47.6 and 290.1% improvements compared with that of CF. Biofilm morphology and 16s rRNA gene sequence analysis proved that our anode facilitated the enrichment growth of exoelectrogens. Flavin secretion was also promoted on our hierarchical elelctrode, effectively driving the EET process. This work disclosed that hierarchical nanomaterials modified electrode with tailored physicochemical properties is a promising platform to simultaneously enhance exoelectrogen attachment and EET efficiency for MFCs.

Engineering of salt-tolerant Shewanella aquimarina XMS-1 for enhanced pollutants transformation and electricity generation

Saline wastewater poses a challenge during bio-treatment process due to salinity affecting the physiological activity of microorganisms and inhibiting their growth and metabolism. Thus, screening and engineering the salt-tolerant strains with stronger performances are urgent. Shewanella aquimarina XMS-1, a salt-tolerant dissimilated metal reducing bacteria (DMRB), was isolated from seawater environment. Its ability for reducing pollutants and generating electricity was enhanced by overexpression of riboflavin synthesis pathway encoding genes from S. oneidensis MR-1 under salt stress. Furthermore, upon contact with graphene oxide (GO), the engineered strain XMS-1/pYYDT-rib with enhanced flavins synthesis could reduce GO and self-assemble to form a three-dimensional (3D) biohybrid system named XMS-1/flavins/rGO. This 3D biohybrid system significantly enhanced the EET efficiency of S. aquimarina XMS-1. Our findings provide a feasible strategy for treatment of salt-containing industrial wastewater contaminated by metal and organic pollutants.

Engineering Wired Life: Synthetic Biology for Electroactive Bacteria

Electroactive bacteria produce or consume electrical current by moving electrons to and from extracellular acceptors and donors. This specialized process, known as extracellular electron transfer, relies on pathways composed of redox active proteins and biomolecules and has enabled technologies ranging from harvesting energy on the sea floor, to chemical sensing, to carbon capture. Harnessing and controlling extracellular electron transfer pathways using bioengineering and synthetic biology promises to heighten the limits of established technologies and open doors to new possibilities. In this review, we provide an overview of recent advancements in genetic tools for manipulating native electroactive bacteria to control extracellular electron transfer. After reviewing electron transfer pathways in natively electroactive organisms, we examine lessons learned from the introduction of extracellular electron transfer pathways into Escherichia coli. We conclude by presenting challenges to future efforts and give examples of opportunities to bioengineer microbes for electrochemical applications.

Evaluation of cell wall-associated direct extracellular electron transfer in thermophilic Geobacillus sp

In this study, a cell wall-associated extracellular electron transfer (EET) was determined in the thermophilic Geobacillus sp. to utilize iron as a terminal electron acceptor. The direct extracellular transfer of its electrons was primarily linked to the cell wall cytochrome-c and diffusible redox mediators like flavins during the anoxic condition. Based on the azo dye decolouration and protein film voltammetry, it was revealed that, in the absence of surface polysaccharide and diffusible mediators, the cell wall-associated EET pathway was likely to be a favorable mechanism in Geobacillus sp. Since the permeability of such redox molecule is primarily limited to the cell wall, the electron transfer occurs by direct contact with cell wall-associated cytochrome and final electron acceptor. Furthermore, transfer of electrons with the help of redox shuttling molecules like riboflavin from cytochrome to cells, vice versa indicates that Geoabcillus sp. has adopted this unique pathway during an anoxic environment for its respiration.

SUPPLEMENTARY INFORMATION

The online version contains supplementary material available at 10.1007/s13205-021-02917-2.

Study on the effect of synergy effect between the mixed cultures on the power generation of microbial fuel cells

Microbial fuel cells (MFC) can use microorganisms to directly convert the chemical energy of organic matter into electrical energy, and generate electrical energy while pollutants degradation. To solve the critical problem of lower power yield of power production, this study selected Saccharomyces cerevisiae, Escherichia coli, Pseudomonas aeruginosa, and Bacillus subtilis as the anodic inoculums. The influence of the mixed bacteria on the power-producing effect of MFC and the synergy effect between the electrochemically active bacteria in mixed cultures were discussed. The results showed that among the mixed culture system, only the mixed cultures MFC composed of Saccharomyces cerevisiae and Bacillus subtilis had a significant increase in power generation capacity, which could reach to 554 mV. Further analysis of the electrochemical and microbiological performance of this system was conducted afterward to verify the synergy effect between Saccharomyces cerevisiae and Bacillus subtilis. The riboflavin produced by Bacillus subtilis could be utilized by Saccharomyces cerevisiae to enhance the power generation capacity. Meanwhile, Saccharomyces cerevisiae could provide carbon source and electron donor for Bacillus subtilis through respiration. Finally, in the experiment of adding exogenous riboflavin in the mixed bacterial MFC, the result indicated that the mixed bacterial MFC chose the self-secreting riboflavin over the exogenous riboflavin as the electron mediator, and the excess riboflavin might hinder the electron trasfer.

Effect and ameliorative mechanisms of polyoxometalates on the denitrification under sulfonamide antibiotics stress

The environmental risks of the sulfonamide antibiotics have attracted much attention recently. In this study, the inhibition effects of sulfadiazine (SDZ) on denitrification electron transfer system (ETS) and ameliorative mechanisms of phosphomolybdic acid (PMo12) were first explored. When denitrification was under 2 mg/L SDZ stress, experiments indicated that PMo12 enhanced NO3--N reduction efficiency and rate from 68.30% to 100.00% and 124.22 to 184.59 N/g VSS/h, respectively. Electron transfer rate and consumption efficiency in denitrification ETS were enhanced to ameliorate SDZ inhibition, which was due to the more secreted riboflavin and cytochrome c and the increased denitrifying enzymes activity with PMo12 mediation. In addition, the microbial growth inhibition and cell membrane damage were ameliorated due to the more EPS surrounding microbe with PMo12 mediation. Higher diversity of denitrifying microbe with PMo12 mediation also promoted denitrification under SDZ stress. This work provided promising strategy to ameliorate antibiotics inhibition in the wastewater bio-treatment.

Function of c-type cytochromes of Shewanella xiamenensis in enhanced anaerobic bioreduction of Cr(VI) by graphene oxide and graphene oxide/polyvinyl alcohol films

Graphene-based materials have been demonstrated to facilitate electron extracellular transfer (EET) of Shewanella. In this study, compared to group lacking graphene oxide (GO)-based materials, GO films-added group and graphene oxide/polyvinyl alcohol (GO/PVA) film-added group delivered 2.67- and 3.13-fold increases in the Cr(VI) reduction by Shewanella xiamenensis, respectively. The whole reduction process could be divided into three stages, including microbial Cr(VI) reduction and GO reduction stage, microbial GO reduction stage and microbial Cr(VI) reduction mediated by reduced graphene oxide (rGO) stage. Moreover, gene analysis revealed that addition of GO and GO/PVA films stimulated overexpression of several c-type cytochrome (c-Cyts) genes, including mtrA, mtrB, mtrC, mtrD, mtrE, mtrF, omcA, petC and SO-4047. Specifically, appreciable Cr(VI) reduction by the strains that overexpressed mtrA, mtrB, mtrC, mtrD, mtrE, mtrF and omcA further confirmed that overexpression of c-Cyts genes indeed enhanced the efficiency of Cr(VI) reduction. Based on these results, the specific function of every c-Cyt was clearly found in Cr(VI) reduction by the induction of GO-based materials. Our finding has disclosed a synergetic mechanism stimulated by GO-based materials to enhance Cr(VI) bioreduction that was not only mediated through the modification of material but also upregulated the expression of functional genes.

Electron transfer involved in bio-Pd (0) synthesis by Citrobacter freundii at different growth phases

Gram-negative Citrobacter freundii with high Pd (II) reduction capacity was isolated from electroplating wastewater, and the electron transfer involved in Pd (II) bio-reduction by C. freundii JH was investigated in phosphate buffer saline solution with sodium formate as sole electron donor under anaerobic condition. FTIR spectra indicated that hydroxyl and amine groups on cell wall participated Pd (II) bio-sorption. TEM, XRD, XPS results confirmed that Pd (0) nanoparticles (NPs) could be bio-synthesized intra/extracellularly. Meanwhile, pH turn-over were observed owing to the reduction of cytochrome c (c-Cyt) in bio-reduction process. EPR spectra indicated that free radicals (OH) was generated from high concentration Pd (II), which would cause seriously damage to cell. Despite of the lower tolerance to Pd (II), the cells at logarithmic phase exhibited higher Pd (II) reduction capacity (72.21%) than that at stationary phase (56.21%), which might be related to the relatively stronger proton motive force (PMF) created by the substrate oxidation and the electron transfer, as evidenced by electrochemical experiments (CV, DPV, amperometric I-t curves) and protein denaturalization experiments. Additionally, c-Cyt and riboflavin were confirmed to be important participants in electron transfer. Finally, a putative synthesis mechanism of Pd (0)-NPs was deduced. This study contributed to further understanding the electron transfer in Pd (II) reduction, and provided more information for the bio-synthetic of metal nanoparticles.

Enhanced denitrification performance and biocatalysis mechanisms of polyoxometalates as environmentally-friendly inorganic redox mediators

Polyoxometalates (POMs) used in chemical catalysis field were first explored their effect on the denitrification process. Experiments demonstrated that NO₃^--N reduction rate with 0.05 mM phosphomolybdic acid (PMo₁₂) was approximately 3.93-fold higher than the PMo₁₂-free system. Simultaneously, PMo₁₂ also had positive effect on NO₂^--N reduction. Compared with the PMo₁₂-free system, the solution resistance and oxidation-reduction potential were decreased, and the activation energy (E_a) was reduced by 51.84 kJ/mol. Besides, electron conductive substances in extracellular polymeric substances were stimulated by PMo₁₂. NADH and riboflavin were enhanced to increase denitrification electron transport system activity. Higher microbial diversity and enrichment of Salmonella were observed in the PMo₁₂-supplemented system. Based on the above analysis, the catalyzing mechanisms of PMo₁₂ are proposed that PMo₁₂ made it easier for electron transferring from electron donor to electron acceptor and shifted bacterial community structure. These findings may provide a promising strategy for nitrogen wastewater treatment.

Sensor systems for bacterial reactors: A new flavin-phenol composite film for the in situ voltammetric measurement of pH

Monitoring pH within microbial reactors has become an important requirement across a host of applications ranging from the production of functional foods (probiotics) to biofuel cell systems. An inexpensive and scalable composite sensor capable of monitoring the pH within the demanding environments posed by microbial reactors has been developed. A custom designed flavin derivative bearing an electropolymerisable phenol monomer was used to create a redox film sensitive to pH but free from the interferences that can impede conventional pH systems. The film was integrated within a composite carbon-fibre-polymer laminate and was shown to exhibit Nernstian behaviour (55 mV/pH) with minimal drift and robust enough to operate within batch reactors.