An environmental friendly electrode and extended cathodic potential window for anodic stripping voltammetry of zinc detection

Electropolymerization of poly(phenol red) on laser-induced graphene electrode enhanced adsorption of zinc for electrochemical detection

We present a highly sensitive and selective electrode of laser-induced graphene modified with poly(phenol red) (P(PhR)@LIG) for measuring zinc nutrition in rice grains using square wave anodic stripping voltammetry (SWASV). The physicochemical properties of P(PhR)@LIG were investigated with scanning electron microscopy (SEM), energy-dispersive X-ray (EDX), Fourier infrared spectroscopy (FT-IR) and Raman spectroscopy. The modified electrode demonstrated an amplified anodic stripping response of Zn2+ due to the electropolymerization of P(PhR), which enhanced analyte adsorption during the accumulation step of SWASV. Under optimized parameters, the developed sensor provided a linear range from 30 to 3000 μg L-1 with a detection limit of 14.5 μg L-1. The proposed electrode demonstrated good reproducibility and good anti-interference properties. The sensor detected zinc nutrition in rice grain samples with good accuracy and the results were consistent with the standard ICP-OES method.

Extended sawhorse waveform for stable zinc detection with fast-scan cyclic voltammetry

Zinc (Zn(II)) is a divalent cation involved in regulating intracellular signal transduction and gene expression through transcription factor activity, and can act as a metal neurotransmitter by modulating synaptic activity and neuronal plasticity. Previous research has demonstrated spatial heterogeneity of Zn(II) in the brain, has estimated extracellular concentrations of Zn(II) across various brain regions, and has measured rapid intracellular changes in Zn(II) concentration during glutamate flux. Despite this work, quantification of rapid extracellular Zn(II) release from neurons, on a millisecond time scale, in real time has remained difficult with existing technologies. Here, we have developed an electrochemical waveform, called the "extended sawhorse waveform (ESW)," for fast-scan cyclic voltammetry detection at carbon-fiber microelectrodes which enabled rapid and stable Zn(II) monitoring over time. This waveform was developed to overcome existing challenges in monitoring metallotransmitters stably over time electrochemically by introducing a brief cleaning step to facilitate rapid cleaning of the electrode surface in between scans. The ESW scans from 0.5 V down to -1.0 V, up to 1.45 V for 3 ms (cleaning step), and back to 0.5 V at a scan rate of 400 V/s. Repeated introductions of Zn(II) at the electrode using a traditional waveform cause plating which ultimately deteriorates the sensitivity over time; however, using the ESW, significant improvements in stability were observed. Overall, we provide a unique approach to monitor and quantitate rapid Zn(II) signaling in the brain at carbon electrodes which will impact our ability to advance fundamental knowledge of Zn(II) involvement in extracellular signaling pathways in the brain.

Electrochemical sensor for the quantification of iodide in urine of pregnant women

An electrochemical method has been developed to determine iodide in urine using an electrode modified with silver oxide microparticles-poly acrylic acid/poly vinyl alcohol (Ag₂OMPs-PAA/PVA). Silver oxide particles were formed by electrochemical oxidation via cyclic voltammetry. The modified electrode exhibited an excellent response to iodide detection by cathodic stripping voltammetry. The fabrication and operation conditions were optimized in terms of PVA concentration, K₂HPO₄ concentration, amount of AgMPs-PAA/PVA, number of cycles for oxide formation, electrolyte, applied potential (vs. Ag/AgCl), and time. Under the optimum conditions, iodide determination produced a linear range from 1 to 40 μM. The limit of detection was 0.3 μM. Precision was found to be within 7.4% RSD. The developed method was applied to the determination of iodide in urine samples of pregnant women with satisfying recoveries (86 ± 1 to 108 ± 1%). Graphical abstract.

An efficient water-soluble fluorescent chemosensor based on furan Schiff base functionalized PEG for the sensitive detection of Al3+ in pure aqueous solution

An efficient reversible fluorescent chemosensor, PEGFB, based on polyethylene glycol bearing a furan Schiff base unit has been successfully developed to sensitively detect Al³⁺ in pure aqueous solution.

Effect of charge transfer and structural rigidity on divergent luminescence response of a metal organic framework towards different metal ions: luminescence lifetime decay experiments and DFT calculations

We have thoroughly studied the luminescence behaviour of a cadmium based MOF, [Cd(C12N2H8)(C7N1O4H3)] {C12N2H8 = 1,10-phenanthroline, C7N1O4H3 = 2,5-pyridine dicarboxylate}, 1. Both steady-state and time-resolved luminescence spectroscopic experiments were performed to understand the dissimilar responses of compound 1 towards different metal ions in aqueous medium. Upon excitation at 280 nm, compound 1 showed a luminescence spectrum centered at 365 nm, which exhibited a three-fold turn-on in the presence of a trace amount of Zn2+ in aqueous solution, whereas in the presence of Co2+, Hg2+, Ni2+, Fe2+ and Cu2+ the luminescence of compound 1 got largely quenched. Compound 1 did not show any response in the presence of other common metal ions such as K+, Mg2+, Na+, Mn2+, and Cr3+. By analysing all the experimental results, we successfully explained the versatile luminescence behaviour of compound 1. The turn-on of luminescence in the presence of Zn2+ ions was due to coordination bond formation and enhancement of the rigidity of compound 1 which resulted in the reduction of non-radiative decay processes to a large extent. The quenching of luminescence in the presence of transition metal ions was found to be static in nature, and was due to the possibility of ligand to metal charge transfer using the vacant d-orbital of the metal ions. In the case of Hg2+ which is a closed cell heavy metal ion, the quenching of luminescence was also static in nature and was due to a two-way charge transfer mechanism. We have also performed density functional theory calculations and obtained supportive results for the proposed mechanisms of luminescence turn-on and quenching. Moreover, compound 1 could be established as a selective and efficient sensor of Zn2+ in aqueous solution even in the presence of Cd2+ and other metal ions.

A biomimetic approach to conjugate vitamin B6 cofactor with the lysozyme cocooned fluorescent AuNCs and its application in turn-on sensing of zinc(II) in environmental and biological samples

This communication focusses on the synthesis of red fluorescent lysozyme cocooned gold nanoclusters (Lyso-AuNCs) that have been successfully applied for the selective and specific recognition of the vitamin B₆ cofactor pyridoxal-5'-phosphate (PLP). The red fluorescence of Lyso-AuNCs showed remarkable color change to yellow upon conjugation with PLP due to the formation of a Schiff base between the free -NH₂ present in the lysozyme and the -CHO group of PLP. The developed PLP conjugated Lyso-AuNCs (PLP_Lyso-AuNCs) was applied for the selective turn-on recognition of Zn²⁺ ions in aqueous medium. The yellow fluorescence of PLP_Lyso-AuNCs exhibited significant enhancement at 475 nm in the presence of Zn²⁺ producing bluish-green fluorescence attributed to the complexation-induced aggregation of nanoclusters. The nanoprobe exhibits nanomolar limit of detection for Zn²⁺ ions (39.2 nM) and the practicality of the nanoprobe was validated in various environmental water samples and biological plasma, urine, and beetroot extract, with fairly good recovery percent. Also, the system was successfully implemented for the intracellular detection and monitoring of Zn²⁺ in live HeLa cells. Graphical abstract Applications of red emitting lysozyme cocooned gold nanoclusters (Lyso-AuNCs) for the selective recognition of the vitamin B₆ cofactor pyridoxal-5'-phosphate (PLP) and the conjugated nano-assembly PLP_Lyso-AuNCs for turn-on detection of Zn²⁺ ions in various environmental and biological samples.