New insight into electropolymerization of melamine. I: Chloride promoted growth of polymelamine in different pH medium

Exploring various carbon nanomaterials-based electrodes modified with polymelamine for the reagentless electrochemical immunosensing of Claudin18.2

Claudin18.2 (CLDN18.2) is a tight junction protein often overexpressed in various solid tumors, including gastrointestinal and esophageal cancers, serving as a promising target and potential biomarker for tumor diagnosis, treatment assessment, and prognosis. Despite its significance, no biosensor has been reported to date for the detection of CLDN18.2. Here, we present the inaugural immunosensor for CLDN18.2. In this study, an amine-rich conducting polymer of polymelamine (PM) was electrografted onto different carbon nanomaterial-based screen-printed electrodes (SPEs), including carbon (C), graphene (Gr), graphene oxide (GO), carbon nanotube (CNT), and carbon nanofiber (CNF) via cyclic voltammetry. A comparative study was performed to explore the best material for the preparation of the PM-modified electrodes to be used as in-situ redox substrate for the immunosensor fabrication. The surface chemistry and structural features of pristine and PM-deposited electrodes were analyzed using Raman and scanning electron microscopy (SEM) techniques. Our results showed that the PM deposited on Gr and CNT/SPEs exhibited the most significant and stable redox behavior in PBS buffer. The terminal amine moieties on the PM-modified electrode surfaces were utilized for immobilizing anti-CLDN18.2 monoclonal antibodies via N-ethyl-N'-(3-(dimethylamino)propyl)carbodiimide/N-hydroxysuccinimide chemistry to construct the electrochemical immunosensor platform. Differential pulse voltammetry-based immunosensing of CLDN18.2 protein on BSA/anti-CLDN18.2/PM-Gr/SPE and BSA/anti-CLDN18.2/PM-CNT/SPE exhibited excellent selectivity against other proteins such as CD1, PDCD1, and ErBb2. The limits of detection of these two immunosensor platforms were calculated to be 7.9 pg/mL and 0.104 ng/mL for the CNT and Gr immunosensors, respectively. This study demonstrated that the PM-modified Gr and CNT electrodes offer promising platforms not only for the reagentless signaling but also for covalent immobilization of biomolecules. Moreover, these platforms offer excellent sensitivity and selectivity for the detection of CLDN18.2 due to its enhanced stable redox activity. The immunosensor demonstrated promising results for the sensitive detection of CLDN18.2 in biological samples, addressing the critical need for early gastric cancer diagnosis.

Redox probe-free electrochemical immunosensor utilizing electropolymerized melamine on reduced graphene oxide for the point-of-care diagnosis of gastric cancer

Pepsinogen I (PG I) is a biomarker that plays a crucial role in the diagnosis of gastric cancer. The development of biosensor to monitor PG I overexpression in serum is crucial for early gastric cancer diagnosis, offering a less invasive alternative to the costly and uncomfortable gastroscopy procedure. This study presents a cost-efficient, scalable and disposable label-free biosensing strategy for detecting PG I, utilizing a redox-active polymelamine electrodeposited on a reduced graphene oxide screen-printed electrode surface (PM-rGO/SPE). Under optimized conditions, the conducting polymer PM was deposited on the rGO/SPE via a potentiodynamic method. The structural and morphological features of PM-rGO/SPE were analyzed with the assistance of Raman and Scanning Electron Microscopy analysis. Specific monoclonal anti-PG I antibodies were immobilized on the in situ prepared redox-active layer via EDC/NHS chemistry to develop a novel electrochemical immunosensor. Unlike the traditional immunosensing strategies which utilizes external redox probe solution for measuring the signal, the developed configuration allowed for redox-probe free monitoring of current changes of the redox active PM resulting from the formation of the immunocomplex on the electrode surface. Utilizing this method, PG I detection spanned a clinically relevant concentration range of 0.01-200 ng/mL, with a low limit of detection at 9.1 pg/mL. The electrochemical immunosensor demonstrated specificity against other biomarkers such as PDCD1, ErBb2, and CD28 with negligible interference. The immunosensor exhibited excellent recovery capabilities for PG I detection in serum samples. These findings underscore the potential of the PM-rGO/SPE immunosensor as a point-of-care diagnostic tool for gastric cancer.

Electrochemical preparation and the characterizations of poly(3,5-diamino 1,2,4-triazole) film for the selective determination of pyridoxine in pharmaceutical formulations

This work describes the synthesis and characterization of a polymeric film of 3,5-diamino 1,2,4-triazole on a pencil graphite electrode for the selective sensing of pyridoxine (PY). The PGE was modified using the electropolymerization process by the potentiodynamic method. The polymerized electrode (PDAT/PGE) was characterized by IR, SEM, AFM, cyclic voltammetry, and electrochemical impedance spectroscopy. PY undergoes irreversible oxidation at 0.79 V on PDAT/PGE in phosphate buffer of pH 5. Using the differential pulse voltammetric technique (DPV), PY showed a linear range from 5 to 950 μM with a lower detection limit of 2.96 μM. The PDAT/PGE was applied for the analytical determination of PY in pharmaceutical tablets with good recovery.

Graphical abstract

Supplementary Information

The online version contains supplementary material available at 10.1007/s11696-023-02777-5.

Electropolymerized Melamine on Electrochemically Reduced Graphene Oxide: Growth Mechanistics, Electrode Processing, and Amperometric Sensing of Acyclovir

Metal-free, cost-efficient, redox-active electrode materials, combining graphene derivatives with nitrogen-rich polymelamine (PM), are widely explored as an interface layer for electrocatalysis and an electrochemical sensor platform. However, conventional chemical routes often yield derivatives of PM suffering from impaired redox behavior, restricting their electron-transfer kinetics. Herein, an optimal potentiodynamic method has been established to electrodeposit PM on electrochemically reduced graphene oxide (ErGO). A supporting electrolyte, containing Cl^-, enhances the formation of intermediates NH₃⁺ and ═NH₂⁺ at the monomeric melamine, eventually interacting with the residual oxygenated functional groups of ErGO to form PM. In situ Raman spectrum analysis revealed the influence of the defective area and the graphitization ratio on the ErGO surface during the course of electropolymerization of melamine. Under optimal electrodeposition conditions (E = 0-1.6 V; ν = 0.1 V/s), the amount of electrodeposited PM on the ErGO surface was determined to be 16.5 μg/(cycle·cm²), using electrochemical quartz crystal microbalance analysis. An ErGO-PM-modified glassy carbon electrode (GCE) and a screen-printed electrode exhibit the direct electrooxidation of acyclovir (ACV). Amperometric analyses of ErGO-PM-modified electrodes exhibited the lowest detection limit of 137.4 pM with analytical robustness, rapid steady state, and reproducibility promising for ACV detection in complex biological matrices.

In Vivo Monitoring of pH in Subacute PD Mouse Brains with a Ratiometric Electrochemical Microsensor Based on Poly(melamine) Films

In vivo monitoring of cerebral pH is of great significance because its disturbance is related to some pathological processes such as neurodegenerative diseases, for example, Parkinson's disease (PD). In this study, we developed an electrochemical microsensor based on poly(melamine) (P_Mel) films for ratiometric monitoring of pH in subacute PD mouse brains. In this microsensor, P_Mel films were prepared from a simple electropolymerization approach in a melamine-containing solution, serving as the selective pH recognition membrane undergoing a 2H⁺/2e^- process. Meanwhile, electrochemically oxidized graphene oxide (EOGO) produced a built-in correction signal which helped avoid the environmental interference of the complicated brain systems. The potential difference between the peaks generated from EOGO and P_Mel gradually decreased with the aqueous pH increasing from 4.0 to 9.0, constituting the detection foundation of the ratiometric electrochemical microsensor (REM). The in vitro studies demonstrated that this proposed method exhibited a high sensitivity (a Nernstian response of -61.35 mV/pH) and remarkable selectivity against amino acids, anions, cations, and biochemical and reactive oxygen species coexisting in the brain. Coupled with its excellent stability and reproducibility and good antibiofouling based on short-term detection, the developed REM could serve as a disposable sensor for the determination of cerebral pH in vivo. Its following successful application in the real-time measurement of pH in the striatum, hippocampus, and cortex of rat brains in the events of global cerebral ischemia/reperfusion verified the reliability of this method. Finally, we adopted this robust REM to systematically analyze and compare the average pH in different regions of normal and subacute PD mouse brains.

Mechanism of Nanocomposite Formation in the Layer-by-Layer Single-Step Electropolymerization of π-Conjugated Azopolymers and Reduced Graphene Oxide: An Electrochemical Impedance Spectroscopy Study

This work presents a study of the formation mechanism of electrochemically deposited alternating layers of azopolymer and graphene oxide, as well as a systematic study of the physicochemical characteristics of the resulting nanocomposite films by electrochemical impedance spectroscopy. The nanocomposite films were constructed by cyclic electropolymerization, which allowed for the assembly of thin films with alternating azopolymers and reduced graphene oxide (rGO) layers in one step. Morphological characterizations were performed by atomic force microscopy and scanning electron microscopy and verified that the electrodeposition of the poly(azo-BBY) polymeric film occurred during the anodic sweep, and the deposition of graphene oxide sheets took place during the cathodic sweep. By analyzing the electrochemical impedance spectra using equivalent circuit models, variations in the resistance and capacitance values of the system were monitored as a function of the amount of electrodeposited material on the fluorine doped tin oxide electrode. In addition, the interfacial phenomena that occurred during the electroreduction of the rGO sheets were monitored with the same method.

A quantitative electrochemical assay for liver injury

Liver diseases represent a vastly underestimated and historically neglected public health problem, disproportionately affecting those in low- and middle- income countries (LMICs). Patients on hepatotoxic medications, such as HIV and TB medications, need consistent monitoring of liver function as part of their standard of care. In high resource settings, this is often the case, but in LMICs traditional methods fail due to high cost and lack of proper equipment, supplies and trained personnel. To address this gap in technology and patient care, we have developed a quantitative, electrochemical assay capable of quantifying levels of alanine aminotransferase (ALT), a primary biomarker associated with liver function. We can quantify ALT with increased sensitivity (1.53 nA/(U/L*mm²) and over a wide, linear concentration range (40-1990 U/L). The assay demonstrated in this study can be used to overcome several pressing challenges associated with effective, timely treatment of liver disease in LMICs.