A novel H2O2photoelectrochemical sensor based on ternary RGO/Ag-TiO2 nanotube arrays nanocomposite

Photoelectrochemical detection of superoxide anions released from mitochondria in HepG2 cells based on the synergistic effect of MnO2@Co3O4 core-shell p-n heterojunction

The detection and comparison of the amount of superoxide anion (O2.-) released by different complexes in mitochondrial electron transport chain (ETC) can locate the main electron leakage sites in mitochondria. In order to realize this, we designed an ultrasensitive photoelectrochemical (PEC) sensor by in situ hydrothermal growth of MnO2 nanosheets on Co3O4 nanowires array modified Ti substrate (NWA|Ti). Due to the formation of a core-shell p-n heterojunction with high specific surface area, tight surface contact and plentiful oxygen vacancies (OVs), MnO2@Co3O4 NWA|Ti possesses a strong visible light absorption, high charges transfer and separation ability. The proposed PEC sensor exhibited a wide linear range of 0.1-50000 nM and a low detection limit of 0.025 nM towards H2O2. Due to the rapid conversion of O2.- to H2O2 inside mitochondria, the PEC sensor can indirectly monitor the electron leakage in the ETC. Specifically, four selected mitochondrial inhibitors specifically inhibited the corresponding complex in mitochondria extracted from living HepG2 cells (hepatocellular carcinoma cells), and the H2O2 levels converted from O2.- was measured by the PEC sensor. It is evident that IQ (ubiquinone binding) site of complex I and Qo (ubiquinol oxidation) site of complex III are the key sites at which electron leakage occurred. This study could provide meaningful information for the diagnosis and treatment of certain disease caused by oxidative stress due to the electron leakage.

Insights into the multirole CoAl layered double hydroxide on boosting photoelectrochemical activity of hematite: Application to hydrogen peroxide sensing

As an important compound in many industrial and biological processes, hydrogen peroxide (H₂O₂) would cause harmfulness to human health at high concentration level. It thus is urgent to develop highly sensitive and selective sensors for practical H₂O₂ detection in the fields of water monitoring, food quality control, and so on. In this work, CoAl layered double hydroxide ultrathin nanosheets decorated hematite (CoAl-LDH/α-Fe₂O₃) photoelectrode was successfully fabricated by a facile hydrothermal process. CoAl-LDH/α-Fe₂O₃ displays the relatively wide linear range from 1 to 2000 μM with a high sensitivity of 132.0 μA mM^-1 cm^-2 and a low detection limit of 0.04 μM (S/N ≥ 3) for PEC detection of H₂O₂, which is superior to other similar α-Fe₂O₃-based sensors in literatures. The (photo)electrochemical characterizations, such as electrochemical impedance spectroscopy, Mott-Schottky plot, cyclic voltammetry, open circuit potential and intensity modulated photocurrent spectroscopy, were used to investigate the roles of CoAl-LDH on the improved PEC response of α-Fe₂O₃ toward H₂O₂. It revealed that, CoAl-LDH could not only passivate the surface states and enlarge the band bending of α-Fe₂O₃, but also could act as trapping centers for holes and followed by as active sites for H₂O₂ oxidation, thus facilitated the charge separation and transfer. The strategy for boosting PEC response would be help for the further development of semiconductor-based PEC sensors.

Photoelectrochemical sensing of glutathione using bismuth vanadate (BiVO4) decorated with polyaniline (PANI) and cadmium sulfide (CdS)

A ternary nanocomposite photoelectrode composed of cadmium sulfide (CdS), polyaniline (PANI), and bismuth vanadate (BiVO₄) was successfully designed by combining cyclic voltammetry (CV) with electrochemical deposition and high-temperature calcination. The first synthesized CdS/PANI/BiVO₄ composite was used as a photoelectrochemical (PEC) monitoring platform for glutathione (GSH). The ternary CdS/PANI/BiVO₄ nanocomposites exhibited higher PEC activity, which was attributed to the accelerated electron transfer by the loading of CdS and PANI, which enables the material surface to better adsorb the electrons separated by GSH, thereby oxidizing it into GSSH. The photoanodes were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), UV-vis diffuse reflectance spectroscopy, and photoelectrochemical experiments. Under the optimal experimental conditions, the BiVO₄ electrode modified with CdS and PANI exhibited a linear response in the concentration range of 0.1-20 μM with a sensitivity of 0.669 μA mM^-1 cm^-2 and a detection limit of 40 nM. Moreover, the PEC sensor exhibits good reproducibility and long-term stability. In summary, the designed materials have excellent electrochemical properties, which make them ideal candidates for PEC detection of GSH.

Plasmon Effect of Ag Nanoparticles on TiO2/rGO Nanostructures for Enhanced Energy Harvesting and Environmental Remediation

We report Ag nanoparticles infused with mesosphere TiO₂/reduced graphene oxide (rGO) nanosheet (TiO₂/rGO/Ag) hybrid nanostructures have been successfully fabricated using a series of solution process synthesis routes and an in-situ growth method. The prepared hybrid nanostructure is utilized for the fabrication of photovoltaic cells and the photocatalytic degradation of pollutants. The photovoltaic characteristics of a dye-sensitized solar cell (DSSC) device with plasmonic hybrid nanostructure (TiO₂/rGO/Ag) photoanode achieved a highest short-circuit current density (J_SC) of 16.05 mA/cm², an open circuit voltage (V_OC) of 0.74 V and a fill factor (FF) of 62.5%. The fabricated plasmonic DSSC device exhibited a maximum power conversion efficiency (PCE) of 7.27%, which is almost 1.7 times higher than the TiO₂-based DSSC (4.10%). For the photocatalytic degradation of pollutants, the prepared TiO₂/rGO/Ag photocatalyst exhibited superior photodegradation of methylene blue (MB) dye molecules at around 93% and the mineralization of total organic compounds (TOC) by 80% in aqueous solution after 160 min under continuous irradiation with natural sunlight. Moreover, the enhanced performance of the DSSC device and the MB dye degradation exhibited by the hybrid nanostructures are more associated with their high surface area. Therefore, the proposed plasmonic hybrid nanostructure system is a further development for photovoltaics and environmental remediation applications.

TiO2 Gas Sensors Combining Experimental and DFT Calculations: A Review

Gas sensors play an irreplaceable role in industry and life. Different types of gas sensors, including metal-oxide sensors, are developed for different scenarios. Titanium dioxide is widely used in dyes, photocatalysis, and other fields by virtue of its nontoxic and nonhazardous properties, and excellent performance. Additionally, researchers are continuously exploring applications in other fields, such as gas sensors and batteries. The preparation methods include deposition, magnetron sputtering, and electrostatic spinning. As researchers continue to study sensors with the help of modern computers, microcosm simulations have been implemented, opening up new possibilities for research. The combination of simulation and calculation will help us to better grasp the reaction mechanisms, improve the design of gas sensor materials, and better respond to different gas environments. In this paper, the experimental and computational aspects of TiO2 are reviewed, and the future research directions are described.

In-situ electrodeposition synthesis of Z-scheme rGO/g-C3N4/TNAs photoelectrodes and its degradation mechanism for oxytetracycline in dual-chamber photoelectrocatalytic system

The dual-chamber photoelectrocatalytic (PEC) system possess advantages in the degradation efficiency and processing cost of organic contaminants. In this study, TiO₂ nanotube arrays modified by rGO and g-C₃N₄ (rGO/g-C₃N₄/TNAs) photoelectrodes were successfully prepared. The surface micromorphology, chemical structure, crystal structure, and basic element composition of rGO/g-C₃N₄/TNAs photoelectrodes were studied by SEM, FTIR, XRD, Raman, and XPS. UV-vis absorption, photoluminescence (PL) spectra, and photoelectrochemical (PECH) tests were used to explore the photoelectrochemical characteristics of rGO/g-C₃N₄/TNAs photoelectrodes. Under simulated sunlight illumination, the dual-chamber PEC system with external bias voltage was used to investigate the degradation of oxytetracycline (OTC) on rGO/g-C₃N₄/TNAs photoelectrodes. The results showed that rGO and g-C₃N₄ were successfully loaded on TNAs, and the separation efficiency of electrons and holes at rGO/g-C₃N₄/TNAs photoelectrodes was improved. The light absorption range of rGO/g-C₃N₄/TNAs photoelectrodes extends to the visible light region and has better light absorption performance. Compared with the photocatalytic process, when 1.2 V bias voltage was applied, the degradation efficiency of OTC in anode and cathode chambers in PEC were increased by 3.28% and 44.01% within 60 min, respectively. In addition, the anode and cathode chambers have different degradation effects on OTC. Both the external bias voltage and initial pH have significant effects in cathode chamber, but have little effect in photoanode chamber. The fluorescence excitation-emission matrix spectra and liquid chromatography-tandem mass spectrometry showed that there were different intermediates in the degradation process of OTC. This study indicated that for the dual-chamber PEC system, rGO/g-C₃N₄/TNAs photoelectrodes exhibited excellent photocatalytic performance and have potential application prospects in water environmental remediation.