Biotransformation of bisphenol A in vivo and in vitro by laccase-producing Trametes hirsuta La-7: Kinetics, products, and mechanisms

Biodegradation of bisphenol A by a Pichia pastoris whole-cell biocatalyst with overexpression of laccase from Bacillus pumilus and investigation of its potential degradation pathways

Bisphenol A (BPA), an endocrine disrupter with estrogen activity, can infiltrate animal and human bodies through the food chain. Enzymatic degradation of BPA holds promise as an environmentally friendly approach while it is limited due to lower stability and recycling challenges. In this study, laccase from Bacillus pumilus TCCC 11568 was expressed in Pichia pastoris (fLAC). The optimal catalytic conditions for fLAC were at pH 6.0 and 80 °C, with a half-life T1/2 of 120 min at 70 °C. fLAC achieved a 46 % degradation rate of BPA, and possible degradation pathways were proposed based on identified products and reported intermediates of BPA degradation. To improve its stability and degradation capacity, a whole-cell biocatalyst (WCB) was developed by displaying LAC (dLAC) on the surface of P. pastoris GS115. The functionally displayed LAC demonstrated enhanced thermostability and pH stability along with an improved BPA degradation ability, achieving a 91 % degradation rate. Additionally, dLAC maintained a degradation rate of over 50 % after the fourth successive cycles. This work provides a powerful catalyst for degrading BPA, which might decontaminate endocrine disruptor-contaminated water through nine possible pathways.

Biochar supported Pseudomonas putida based globules for effective removal of Bisphenol A with a practical approach

The widespread and inevitable use of plastic has led to prospective ecological problems through Bisphenol A (BPA), a synthetic chemical in plastic manufacturing. The present study addresses a unique methodology for eliminating BPA using the assistance of Pseudomonas putida. In the present work, biomass was torrefied to generate biochar with highly porous networks that could accommodate the bacterial species for effective colonization and multiplication. The designed biochar-bacterial globules demonstrated the ability to effectively remove BPA (96.88%) at a concentration of up to 2 g/L. The biochar-bacterial globules could effectively adsorb BPA at a low concentration of 20 mg/L. The alteration in pH did not impact the globule's performance, providing additional support for the practical utilization of these globules in polluted water bodies. In addition, the biochar-bacterial globules exhibited superior effectiveness in degradation compared to the standard levels, particularly in saline conditions. The simplicity and effectiveness of the approach make it promising for real-world implementation in addressing ecological problems associated with BPA contamination.

Green synthesis of ZnO nanocubes from Ceropegia omissa H. Huber extract for photocatalytic degradation of bisphenol An under visible light to mitigate water pollution

Plastic pollution has become a major environmental problem because it does not break down and poses risks to ecosystems and human health. This study focuses on the environmentally friendly synthesis of ZnO nanocubes using an extract from Ceropegia omissa H. Huber plant leaves. The primary goal is to investigate the viability of these nanocubes as visible-light photocatalysts for the degradation of bisphenol A (BPA). The synthesized ZnO nanocubes have a highly crystalline structure and a bandgap of 3.1 eV, making them suitable for effective visible-light photocatalysis. FTIR analysis, which demonstrates that the pertinent functional groups are present, demonstrates the chemical bonding and reducing processes that take place in the plant extract. The XPS method also studies zinc metals, oxygen valencies, and binding energies. Under visible light irradiation, ZnO nanocubes degrade BPA by 86% in 30 min. This plant-extract-based green synthesis method provides a long-term replacement for traditional procedures, and visible light photocatalysis has advantages over ultraviolet light. The study's results show that ZnO nanocubes may be good for the environment and can work well as visible light photocatalysts to break down organic pollutants. This adds to what is known about using nanoparticles to clean up the environment. As a result, this study highlights the potential of using environmentally friendly ZnO nanocubes as a long-lasting and efficient method of reducing organic pollutant contamination in aquatic environments.

Bisphenol A contamination in aquatic environments: a review of sources, environmental concerns, and microbial remediation

The production of polycarbonate, a high-performance transparent plastic, employs bisphenol A, which is a prominent endocrine-disrupting compound. Polycarbonates are frequently used in the manufacturing of food, bottles, storage containers for newborns, and beverage packaging materials. Global production of BPA in 2022 was estimated to be in the region of 10 million tonnes. About 65-70% of all bisphenol A is used to make polycarbonate plastics. Bisphenol A leaches from improperly disposed plastic items and enters the environment through wastewater from plastic-producing industries, contaminating, sediments, surface water, and ground water. The concentration BPA in industrial and domestic wastewater ranges from 16 to 1465 ng/L while in surface water it has been detected 170-3113 ng/L. Wastewater treatment can be highly effective at removing BPA, giving reductions of 91-98%. Regardless, the remaining 2-9% of BPA will continue through to the environment, with low levels of BPA commonly observed in surface water and sediment in the USA and Europe. The health effects of BPA have been the subject of prolonged public and scientific debate, with PubMed listing more than 17,000 scientific papers as of 2023. Bisphenol A poses environmental and health hazards in aquatic systems, affecting ecosystems and human health. While several studies have revealed its presence in aqueous streams, environmentally sound technologies should be explored for its removal from the contaminated environment. Concern is mostly related to its estrogen-like activity, although it can interact with other receptor systems as an endocrine-disrupting chemical. Present review article encompasses the updated information on sources, environmental concerns, and sustainable remediation techniques for bisphenol A removal from aquatic ecosystems, discussing gaps, constraints, and future research requirements.

Exolaccase Propels Humification to Decontaminate Bisphenol A and Create Humic-like Biostimulants

Exolaccase-propelled humification (E-PH) helps eliminate phenolic pollutants and produce macromolecular precipitates. Herein, we investigated the influencing mechanism of 12 humic precursors (HPs) on exolaccase-enabled bisphenol A (BPA) decontamination and humification. Catechol, vanillic acid, caffeic acid, and gentian acid not only expedited BPA removal but also created large amounts of copolymeric precipitates. These precipitates had rich functional groups similar to natural humic substances, which presented great aromatic and acidic characteristics. The releasing amounts of BPA monomer from four precipitates were 0.08-12.87% at pH 2.0-11.0, suggesting that BPA-HP copolymers had pH stability. More excitingly, certain copolymeric precipitates could stimulate the growth and development of radish seedlings. The radish growth-promotion mechanisms of copolymers were involved in two aspects: (1) Copolymers interacted with root exudates to accelerate nutrient uptake; (2) Copolymers released auxins to provoke radish growth. These results may provide an innovative strategy for decontaminating phenolic pollutants and yielding humic-like biostimulants in E-PH.

One stone, two birds: A Cu-S cluster as a laccase-mimicking nanozyme and sulfite activator for phenol remediation in marine environments

Phenols are infamous pollutants in marine environments and present a grave danger to human health, which makes their efficient detection and removal serious issues. Colorimetry is a simple method for detecting phenols in water because phenols can be oxidized by natural laccase and generate a brown product. However, high cost and poor stability impede the wide-spread implementation of natural laccase in phenol detection. To reverse this adverse situation, a nanoscale Cu-S cluster, Cu₄(MPPM)₄ (Cu₄S₄, MPPM = 2-mercapto-5-n-propylpyrimidine), is synthesized. As a stable and inexpensive nanozyme, Cu₄S₄ shows excellent laccase-mimicking activity and prompts the oxidation of phenols. This characteristic makes Cu₄S₄ a perfect option for phenol detection with colorimetry. In addition, Cu₄S₄ also exhibits sulfite activation properties. It can degrade phenols and other pollutants with advanced oxidation processes (AOPs). Theoretical calculations show good laccase-mimicking and sulfite activation properties originating from appropriate interactions between Cu₄S₄ and substrates. We anticipate that the phenol detection and degradation characteristics of Cu₄S₄ make it a promising material to be used for practical phenol remediation in water environments.