Effect of salt addition on iota-carrageenan solution properties

Tailoring structural and mechanical properties of konjac glucomannan/curdlan composite hydrogels by freeze-thaw treatment

To improve the gelling properties of konjac glucomannan/curdlan (KGM/CUD) composite hydrogels, KGM/CUD composite hydrogels were treated by freeze-thawing. Herein, we focus on the effects of freeze-thaw cycles, freezing temperature, and freezing time on the structural and mechanical properties of KGM/CUD composite hydrogels. SEM and SAXS results showed that ice crystals generated by freezing extruded the molecular chains and increased the cross-linking density between molecular chains, which resulted in a denser gel microstructure. Among them, the freeze-thaw treatment at -20 °C for 12 h can effectively reduce the correlation length (ξ). According to mechanical testing, freeze-thawed gels for 48 h reached 408-, 826-, and 840-fold of the hardness, gumminess and chewiness of unfrozen, respectively. After freeze-thaw treatment, the energy storage modulus (G') of the gel increased to 9872 Pa, the residual mass after heating was up to 27.9 %, the water holding capacity (WHC) was reduced to 80.85 %. In addition, low-field nuclear magnetic resonance results confirmed that the freeze-thaw treatment promoted the formation of ice crystals from water molecules, which realized the transition of the water state, thus reducing the water mobility of the gel. This study provides a facile and efficient strategy for designing hydrogels products with exceptional texture and sensory characteristics.

Enhanced stabilization of multifunctional phenolic acids-grafted chitin nanofibers for Pickering emulsions

The objective of this study was to develop novel functional stabilizers for Pickering emulsions using phenolic acids-grafted chitin nanofibers (phenolic acids-g-ChNF), which were fabricated by grafting ferulic acid (FA), sinapic acid (SA) and caffeic acid (CA) onto ChNF via free radical-mediated method. The Fourier transform infrared spectrum and Proton nuclear magnetic resonance showed that graft copolymerization occurred between the amino groups of ChNF and the carbonyl of the phenolic acids. Further, it was revealed that CA-g-ChNF and SA-g-ChNF possessed stronger antioxidant and antibacterial properties than the original ChNF and FA-g-ChNF. Additionally, we applied phenolic acids-g-ChNF to develop Pickering emulsions and found that SA-g-ChNF- and CA-g-ChNF-stabilized emulsions displayed reduced droplet sizes compared to FA, the main reason for which was that SA and CA had a rather close bonding relationship with ChNF. Taken together, SA-g-ChNF and CA-g-ChNF as novel multi-functional particles can be employed for facilitating the stability of Pickering emulsions.

Hydrocolloid-based nutraceutical delivery systems: Potential of κ-carrageenan hydrogel beads for sustained release of curcumin

This study investigates the potential of κ-carrageenan hydrogel beads as a delivery system for curcumin, a bioactive compound with various health benefits. Hydrogel beads were prepared using the extrusion technique with a hypodermic needle. The encapsulation efficiency of curcumin in the κ-carrageenan hydrogel beads was found to be 74.61 ± 3.2 %. FTIR spectroscopy analysis revealed shifts in absorption peaks, indicating possible hydrogen bonding and/or ionic interactions between the polymer and salt. An increase in the melting point of curcumin, by 25 °C, in curcumin- κ-carrageenan beads suggests the heat protection offered by the carrageenan chains to curcumin molecules. The in vitro release of curcumin from the beads suggests a sustained and pH-dependent release nature. The release kinetics follow the first order and the Korsmeyer-Peppas model. The outcome offers value-added delivery systems of bioactive compounds toward developing novel food and pharmaceutical applications.

Helicity degree of carrageenan conformation determines the polysaccharide and water interactions

The polysaccharide in solution at critical concentration, Cc (g/L), is assimilated to a nano hydrogel (nHG) made of a single polysaccharide chain. Taking as reference the characteristic temperature of 20 ± 2 °C at which kappa-carrageenan (κ-Car) nHG swelling is greater with a Cc = 0.55 ± 0.05 g/L, the temperature of the minimum deswelling in the presence of KCl was found at 30 ± 2 °C for 5 mM with a Cc = 1.15 ± 0.05 g/L but not measurable above 100 °C for 10 mM of which Cc = 1.3 ± 0.05 g/L. Lowering the temperature to 5 °C, contraction of the nHG and further coil-helix transition with self-assembly increases the sample's viscosity, which steadily evolves with time in a logarithmic scale. Accordingly, the relative increment of the viscosity per unit of concentration, R_v (L/g), should increase in agreement with increasing polysaccharide concentration. But the R_v decreases for κ-Car samples above 3.5 ± 0.5 g/L in the presence of 10 mM KCl under steady shear 15 s^-1. This reflects a decrease of κ-Car helicity degree knowing that the polysaccharide is rather hydrophilic when its helicity degree is the lowest.

Sulfate groups position determines the ionic selectivity and syneresis properties of carrageenan systems

The salt sensitivity and selectivity feature of α-carrageenan (α-Car) were investigated and compared with κ-carrageenan (κ-Car) and iota-carrageenan (ι-Car). These carrageenans are identified by one sulfate group on the 3,6-anhydro-D-galactose (DA) for α-Car, D-galactose (G) for κ-Car and on both carrabiose moieties (G and DA) for ι-Car. The viscosity and temperature, where order-disorder transition have been observed, were greater in presence of CaCl₂ for α-Car and ι-Car compared with KCl and NaCl. Conversely, the reactivity of κ-Car systems were greater in presence of KCl than CaCl₂. Unlike κ-Car systems, the gelation of α-Car in presence of KCl was observed without syneresis. Thus, the position of sulfate group on the carrabiose determines the importance of counterion valency too. The α-Car could be a good alternative to κ-Car to reduce the syneresis effects.

Recent advances in carrageenan-based films for food packaging applications

In order to solve the increasingly serious environmental problems caused by plastic-based packaging, carrageenan-based films are drawing much attentions in food packaging applications, due to low cost, biodegradability, compatibility, and film-forming property. The purpose of this article is to present a comprehensive review of recent developments in carrageenan-based films, including fabrication strategies, physical and chemical properties and novel food packaging applications. Carrageenan can be extracted from red algae mainly by hydrolysis, ultrasonic-assisted and microwave-assisted extraction, and the combination of multiple extraction methods will be future trends in carrageenan extraction methods. Carrageenan can form homogeneous film-forming solutions and fabricate films mainly by direct coating, solvent casting and electrospinning, and mechanism of film formation was discussed in detail. Due to the inherent limitations of the pure carrageenan film, physical and chemical properties of carrageenan films were enhanced by incorporation with other compounds. Therefore, carrageenan-based films can be widely used for extending the shelf life of food and monitoring the food freshness by inhibiting microbial growth, reducing moisture loss and the respiration, etc. This article will provide useful guidelines for further research on carrageenan-based films.

Structure-Elastic Properties Relationships in Gelling Carrageenans

Gelling carrageenans are polysaccharides extracted from the Gigartinales order of red algae. These are additives used essentially in the food industry for texturizing, stabilizing or gelling various formulations. Although a consensual gel mechanism has been reached which encompasses a coil-to-helix transition followed by the self-assembling of helices in a network, the structure–elastic relationships in the network are still to be clearly established. This paper reviews the reports in which carrageenan gel structures have been systematically compared with gel elastic properties. The focus is on the sizes documented for structural units, such as strands, aggregates, voids or network meshes, as well as on the reported linear and nonlinear elastic characteristics. The insufficient rationalization of carrageenan gel elasticity by models which take on board mechanically relevant structural features is underlined. After introducing selected linear and nonlinear elastic models, preliminary results comparing such models to structural and rheological data are presented. In particular, the concentration scaling of the strain hardening exhibited by two types of carrageenan gels is discussed.