Inactivation kinetics of a piezotolerant Staphylococcus aureus isolated from high-pressure-treated sliced ham by high pressure in buffer and in a ham model system: Evaluation in selective and non-selective medium

The efficacy and safety of high-pressure processing of food

High-pressure processing (HPP) is a non-thermal treatment in which, for microbial inactivation, foods are subjected to isostatic pressures (P) of 400-600 MPa with common holding times (t) from 1.5 to 6 min. The main factors that influence the efficacy (log10 reduction of vegetative microorganisms) of HPP when applied to foodstuffs are intrinsic (e.g. water activity and pH), extrinsic (P and t) and microorganism-related (type, taxonomic unit, strain and physiological state). It was concluded that HPP of food will not present any additional microbial or chemical food safety concerns when compared to other routinely applied treatments (e.g. pasteurisation). Pathogen reductions in milk/colostrum caused by the current HPP conditions applied by the industry are lower than those achieved by the legal requirements for thermal pasteurisation. However, HPP minimum requirements (P/t combinations) could be identified to achieve specific log10 reductions of relevant hazards based on performance criteria (PC) proposed by international standard agencies (5-8 log10 reductions). The most stringent HPP conditions used industrially (600 MPa, 6 min) would achieve the above-mentioned PC, except for Staphylococcus aureus. Alkaline phosphatase (ALP), the endogenous milk enzyme that is widely used to verify adequate thermal pasteurisation of cows' milk, is relatively pressure resistant and its use would be limited to that of an overprocessing indicator. Current data are not robust enough to support the proposal of an appropriate indicator to verify the efficacy of HPP under the current HPP conditions applied by the industry. Minimum HPP requirements to reduce Listeria monocytogenes levels by specific log10 reductions could be identified when HPP is applied to ready-to-eat (RTE) cooked meat products, but not for other types of RTE foods. These identified minimum requirements would result in the inactivation of other relevant pathogens (Salmonella and Escherichia coli) in these RTE foods to a similar or higher extent.

Combination of High-Pressure Treatment at 500 MPa and Biopreservation with a Lactococcus lactis Strain for Lowering the Bacterial Growth during Storage of Diced Cooked Ham with Reduced Nitrite Salt

We investigated the combined effects of biopreservation and high-pressure treatment on bacterial communities of diced cooked ham prepared with diminished nitrite salt. First, bacterial communities of four commercial brands of diced cooked ham from local supermarkets were characterized and stored frozen. Second, sterile diced cooked ham, prepared with reduced levels of nitrite, was inoculated with two different microbiota collected from the aforementioned commercial samples together with a nisin-producing Lactococcus lactis protective strain able to recover from a 500 MPa high-pressure treatment. Samples were then treated at 500 MPa for 5 min, and bacterial dynamics were monitored during storage at 8 °C. Depending on samples, the ham microbiota was dominated by different Proteobacteria (Pseudomonas, Serratia, Psychrobacter, or Vibrio) or by Firmicutes (Latilactobacillus and Leuconostoc). Applied alone, none of the treatments stabilized during the growth of the ham microbiota. Nevertheless, the combination of biopreservation and high-pressure treatment was efficient in reducing the growth of Proteobacteria spoilage species. However, this effect was dependent on the nature of the initial microbiota, showing that the use of biopreservation and high-pressure treatment, as an alternative to nitrite reduction for ensuring cooked ham microbial safety, merits attention but still requires improvement.

Non-Destructive Luminescence-Based Screening Tool for Listeria monocytogenes Growth on Ham

Listeria monocytogenes is a food-borne pathogen often associated with ready-to-eat (RTE) food products. Many antimicrobial compounds have been evaluated in RTE meats. However, the search for optimum antimicrobial treatments is ongoing. The present study developed a rapid, non-destructive preliminary screening tool for large-scale evaluation of antimicrobials utilizing a bioluminescent L. monocytogenes with a model meat system. Miniature hams were produced, surface treated with antimicrobials nisin (at 0-100 ppm) and potassium lactate sodium diacetate (at 0-3.5%) and inoculated with bioluminescent L. monocytogenes. A strong correlation (r = 0.91) was found between log scale relative light units (log RLU, ranging from 0.00 to 3.35) read directly from the ham surface and endpoint enumeration on selective agar (log colony forming units (CFU)/g, ranging from 4.7 to 8.3) when the hams were inoculated with 6 log CFU/g, treated with antimicrobials, and L. monocytogenes were allowed to grow over a 12 d refrigerated shelf life at 4 °C. Then, a threshold of 1 log RLU emitted from a ham surface was determined to separate antimicrobial treatments that allowed more than 2 log CFU/g growth of L. monocytogenes (from 6 log CFU/g inoculation to 8 log CFU/g after 12 d). The proposed threshold was utilized in a luminescent screening of antimicrobials with days-to-detect growth monitoring of luminescent L. monocytogenes. Significantly different (p < 0.05) plate counts were found in antimicrobial treated hams that had reached a 1 log RLU increase (8.1-8.5 log(CFU/g)) and the hams that did not reach the proposed light threshold (5.3-7.5 log(CFU/g)). This confirms the potential use of the proposed light threshold as a qualitative tool to screen antimicrobials with less than or greater than a 2 log CFU/g increase. This screening tool can be used to prioritize novel antimicrobials targeting L. monocytogenes, alone or in combination, for future validation.

Inactivation and Damage of Histamine-Forming Bacteria by Treatment with High Hydrostatic Pressure

The inactivation and damage of histamine-forming bacteria (HFB), Enterobacter aerogenes and Staphylococcus capitis, in a 0.1 M potassium phosphate buffer (pH 6.8) and marlin meat slurry by high hydrostatic pressure (HHP) treatments were studied using viability measurement and scanning electron microscopy (SEM). HHP treatments showed first order destruction kinetics to E. aerogenes and S. capitis during the pressure holding period. HFB in marlin meat slurry had higher D values and were more resistant to HHP treatments than in phosphate buffer. In phosphate buffer, E. aerogenes had higher D values than S. capitis at >380 MPa of pressure, whereas the reverse trend was noticed at lower pressures (<380 MPa). In marlin meat slurry, S. capitis had a higher D value than E. aerogenes at the same treatment pressure, indicating that S. capitis was more resistant to HHP treatment. To our knowledge, this is the first report to demonstrate that HHP can be used to inactivate HFB, E. aerogenes, and S. capitis, by causing disruption to bacterial cell membrane and cell wall as demonstrated by SEM micrographs.

Inactivation of Listeria monocytogenes, Staphylococcus aureus, and Salmonella enterica under High Hydrostatic Pressure: A Quantitative Analysis of Existing Literature Data

High hydrostatic pressure processing (HPP) is a mild preservation technique, and its use for processing foods has been widely documented in the literature. However, very few quantitative synthesis studies have been conducted to gather and analyze bacterial inactivation data to identify the mechanisms of HPP-induced bacterial inactivation. The purpose of this study was to conduct a quantitative analysis of three-decimal reduction times (t_3δ) from a large set of existing studies to determine the main influencing factors of HPP-induced inactivation of three foodborne pathogens (Listeria monocytogenes, Staphylococcus aureus, and Salmonella enterica) in various foods. Inactivation kinetics data sets from 1995 to 2017 were selected, and t_3δ values were first estimated by using the nonlinear Weibull model. Bayesian inference was then used within a metaregression analysis to build and test several models and submodels. The best model (lowest error and most parsimonious) was a hierarchical mixed-effects model including pressure intensity, temperature, study, pH, species, and strain as explicative variables and significant factors. Values for t_3δ and Z_P associated with inactivation under HPP were estimated for each bacterial pathogen, with their associated variability. Interstudy variability explained most of the variability in t_3δ values. Strain variability was also important and exceeded interstudy variability for S. aureus, which prevented the development of an overall model for this pathogen. Meta-analysis is not often used in food microbiology but was a valuable quantitative tool for modeling inactivation of L. monocytogenes and Salmonella in response to HPP treatment. Results of this study could be useful for refining quantitative assessment of the effects of HPP on vegetative foodborne pathogens or for more precisely designing costly and labor-intensive experiments with foodborne pathogens.

Effect of High Hydrostatic Pressure Combined with Moderate Heat to Inactivate Pressure-Resistant Bacteria in Water-Boiled Salted Duck

The objective of this work was to study the effect of high hydrostatic pressure combined with moderate heat to inactivate pressure-resistant bacteria in water-boiled salted duck meat (WBSDM), and to establish suitable procedures to improve the quality of WBSDM. The conditions (300 MPa/60 °C, 400 MPa/60 °C, and 500 MPa/50 °C) effectively inactivated the pressure-resistant bacteria (Bacillus cereus and Staphylococcus warneri) in WBSDM. Although more pressure-resistant than S. warneri, the above treatment conditions inactivated B. cereus more than 10(7) CFU/mL in buffer, and more than 10(6) CFU/g in WBSDM, and did not cause any changes in color, texture, or moisture content of products. The interaction between pressure and temperature is a more significant factor than only pressure in inactivating both B. cereus and S. warneri, the treatment of WBSDM at 400 MPa/ 60 °C/ 10 min is the most practical condition for postprocess of WBSDM after cooking.

Effect of olive powder and high hydrostatic pressure on the inactivation of Bacillus cereus spores in a reference medium

The aim of this work was to study the effect of olive powder combined with high hydrostatic pressure (HHP) on the inactivation of Bacillus cereus spores, to use it as an additional control hurdle in beverages pasteurised by this technology. With this purpose, reference medium prepared at different concentrations of olive powder was inoculated with B. cereus spores and subjected to different pressure treatments. The outgrowth capacity of the treated spores was then determined at 20°C and 32°C. The addition of olive powder was found to slightly reduce the effectiveness of HHP, although in post-treatment storage there was an increased bacteriostatic effect in the samples with 2.5% of olive powder at both temperatures in the samples pressurised at 400 and 500 MPa, and only at 20°C in the samples pressurised at 200 MPa. The addition of olive powder therefore had an additive effect with storage temperature and HHP processing and could act as an additional control hurdle during the shelf-life of products pasteurised by HHP technologies or in the case of cold-chain breakage.

Biological approach to modeling of Staphylococcus aureus high-hydrostatic-pressure inactivation kinetics

Graphs for survival under high hydrostatic pressure (450 MPa; 25°C; citrate-phosphate buffer, pH 7.0) of stationary-growth-phase cells of eight Staphylococcus aureus strains were found to be nonlinear. The strains could be classified into two groups on the basis of the shoulder length. Some of them showed long shoulders of up to 20 min at 450 MPa, while others had shoulders of <3.5 min. All strains showed tails. No significant differences in the inactivation rate were found during the log-linear death phase among the eight strains. The entry into stationary growth phase resulted both in an increase in shoulder length and in a decrease in the inactivation rate. However, whereas shoulder length proved to depend on sigma B factor activity, the inactivation rate did not. Recovery in anaerobiosis decreased the inactivation rate but did not affect the shoulder length. Addition of the minimum noninhibitory concentration of sodium chloride to the recovery medium resulted in a decrease in shoulder length and in an increase in the inactivation rate for stationary-growth-phase cells. In the tail region, up to 90% of the population remained sensitive to sodium chloride.