Structure and physical stability of hybrid model systems containing pork meat and superworm (Zophobas morio larvae): The influence of heating regime and insect: meat ratio

Feasibility of Tenebrio molitor larvae protein to partially replace lean meat in the processing of hybrid frankfurters: Perspectives on quality profiles and in vitro digestibility

The aim of this study was to investigate the effect of replacing different amounts (5 %, 10 %, 15 %, 20 % and 25 %) of lean meat with Tenebrio molitor larvae protein (TMLP) on the quality profiles of hybrid frankfurters. The results showed that there were no obvious differences in moisture, protein or fat content of all the hybrid frankfurters (P > 0.05), only a higher substitution rate (from 10 % to 25 %) resulted in a higher ash content than the control group (P < 0.05). With the increasing replacement rate (5 %, 10 % and 15 %), the cooking loss of the hybrid frankfurters showed the similar effects as the control group (P > 0.05), whereas the higher replacement rates of 20 % and 25 % obviously decreased the emulsion stability of the hybrid frankfurters. Moreover, with lower substitution rate (5 %, 10 % and 15 %) there were no significant differences in cooking loss between the hybrid frankfurters and the control group (P > 0.05), whereas the higher substitution rates (20 % and 25 %) obviously increased the cooking loss of the hybrid frankfurters (P < 0.05). Meanwhile, as the level of substitution increased, the hybrid frankfurters had higher digestibility, poorer texture than the standard frankfurters, as well as the rheological behaviour of hybrid meat batters (P < 0.05). The results showed that a moderate level (15 %) of TMLP was used to replace lean pork could be potentially and successfully be used to produce hybrid frankfurters.

Effects of protein aggregation induced by NaCl and temperature on gelation of silkworm (Antheraea pernyi) pupa raw powder

Edible insects have great potential for producing protein-rich ingredients. This study aimed to investigate the effects of protein aggregation induced by NaCl (0-1 M) and temperature (65-95 °C) on gelation of Antheraea pernyi (A. pernyi) pupa raw powder. No thermal aggregates were observed at low temperature (65 °C), on the basis of there being no significant enhancement in turbidity and particle size (P > 0.05), regardless of NaCl concentrations. At elevated temperatures (75-95 °C), protein solutions exhibited significantly higher turbidity and particle size (P < 0.05), accompanied by an initial rise in surface hydrophobicity followed by a decline, alongside declining sulfhydryl. This marks the beginning of massive thermal aggregation driven by molecular forces. In addition, covalent (disulfide bonds) and non-covalent (hydrogen bonding, electrostatic interactions, and hydrophobicity) forces were influenced by NaCl, leading to variability in the protein aggregation and gelation. Correlation analysis indicates that the higher protein aggregation induced by ions was beneficial to the construction of more compact three-dimensional structures, as well as to the rheology, texture, and water-holding capacity of A. pernyi pupa gels. However, excessive salt ions destroyed the gel structure. Our findings will aid the use of A. pernyi pupae as textural ingredients in formula foods.

Hybrid Sausages Using Pork and Cricket Flour: Texture and Oxidative Storage Stability

This study aimed to study the functionalities of cricket flour (CF) and the effects of the addition of CF on the texture and oxidative stability of hybrid sausages made from lean pork and CF. Functional properties of CF, including protein solubility, water-holding capacity, and gelling capacity, were examined at different pHs, NaCl concentrations, and CF contents in laboratory tests. The protein solubility of CF was significantly affected by pH, being at its lowest at pH 5 (within the range 2–10), and the highest protein solubility toward NaCl concentrations was found at 1.0 M (at pH 6.8). A gel was formed when the CF content was ≥10%. A control sausage was made from lean pork, pork fat, salt, phosphate, and ice water. Three different hybrid sausages were formulated by adding CF at 1%, 2.5%, and 5.0% levels on top of the base (control) recipe. In comparison to control sausage, the textural properties of the CF sausages in terms of hardness, springiness, cohesiveness, chewiness, resilience, and fracturability decreased significantly, which corresponded to the rheological results of the raw sausage batter when heated at a higher temperature range (~45–80 °C). The addition of CF to the base recipe accelerated both lipid and protein oxidation during 14 days of storage, as indicated by the changes in TBARS and carbonyls and the loss of free thiols and tryptophan fluorescence intensity. These results suggest that the addition of CF, even at low levels (≤5%), had negative effects on the texture and oxidative stability of the hybrid sausages.

Terminal temperature dominates the gel quality of chicken meat paste: An emphasis on multiple heating-cooling regimes

A survey of various heating strategies, including terminal temperature (70 and 90 °C), step heating (with or without holding at 50 °C for 10 min) and step cooling (with or without holding at 50 °C for 10 min), on the gelation properties of chicken meat paste was conducted. Compared to 70 °C, 90 °C heating drastically increased (p < 0.05) cooking loss (CL) from 5% to > 15% since more immobilized water was pushed out as free water. Step cooling could mitigate the high-temperature-induced CL. The impact of heating strategies on the textural properties of chicken meat is much lower than that on CL. For both 70 °C and 90 °C cooked samples, step heating reduced (p < 0.05) their whiteness by increasing the yellowness. The storage modulus (G') increase during cooling is mainly driven by cooling leaded lower mobility. Overall, low-temperature ramping heating produced excellent meat gel with low energy consumption.

Hybrid Sausages: Modelling the Effect of Partial Meat Replacement with Broccoli, Upcycled Brewer's Spent Grain and Insect Flours

The social, environmental and health concerns associated with the massive consumption of meat products has resulted in calls for a reduction in meat consumption. A simplex lattice design was used for studying the effect of combining broccoli, upcycled brewer’s spent grain (BSG) and insect flours from Tenebrio molitor (IF) as alternative sources of protein and micronutrients, in hybrid sausages formulation. The techno-functional properties of the ingredients and the nutritional and textural properties of nine hybrid sausages were analysed. The effect of adding these ingredients (constituting 35% of a turkey-based sausage) on protein, fat, fibre, iron and zinc content, and textural properties (Texture Profile Analysis (TPA) and Warner−Bratzler parameters) were modelled employing linear regression (0.72 < R2 < 1). The “desirability” function was used for multi-response optimisation of the samples for the highest protein content, optimum chewiness and a* value (closeness to red). The analysis of sensory data for the three optimised samples showed no significant differences in juiciness and odour between the hybrid meat sausage with 22% broccoli, 3% BSG, and 10% IF and the commercial Bratwurst sausage elaborated exclusively with animal protein. Colour, appearance, chewiness and pastiness were rated higher than for the reference. The instrumental chewiness highly correlated with sensorial chewiness (R2 = 0.98). Thus, a strategy introducing less refined and more sustainable sources of protein and micronutrients was successfully employed to model and statistically optimise a meat product formulation with reduced animal protein content.

The Superworm, Zophobas morio (Coleoptera:Tenebrionidae): A 'Sleeping Giant' in Nutrient Sources

The aim of this review is to compile up-to-date information on the superworm, Zophobas morio (F.), regarding its biology and ecology, but also its further potential for use as a nutrient source for food and feed. We illustrate certain basic characteristics of the morphology and bio-ecology of this species, which is marginally considered as a 'pest' in durable amylaceous commodities. More recent data show that Z. morio can be a valuable nutrient and antimicrobial source that could be utilized further in insect-based feed and food production. The inclusion of this species in aquafeed has provided promising results in a wide range of feeding trials, both in terms of fish development and health. Additional data illustrate its potential for use in poultry, indicating that this species provides comparable results with those of other insect species that are used in feed. Moreover, Z. morio can be a viable waste management agent. This review aims to summarize the available data and underline data gaps for future research, toward the potential of the utilization of Z. morio for human food and animal feed. Based on the data presented, Z. morio appears to be a well-promising insect-based protein source, which potential still remains to be unfold.

Gelation of a combination of insect and pork proteins as affected by heating temperature and insect:meat ratio

In order to better understand structure formation in hybrid meat products containing insects, viscoelastic properties, protein aggregation and surface hydrophobicity of extracted insect and meat proteins in different insect:meat nitrogen ratios (100:0, 75:25, 50:50, 25:75 and 0:100) at different heating temperatures (from 20 to 80 °C) were studied. During heating, meat proteins showed best gelling properties. This was probably associated with the formation of hydrophobic interactions, as was confirmed by the strong increase in surface hydrophobicity of the meat proteins upon heating. Insect proteins, on the other hand, formed a considerable amount of additional structure during cooling, resulting in gels with high gel strength, although their gel stability was low. As for the mixtures of insect and meat proteins, they showed lower final gel strengths compared to the pure insect and meat protein samples. Furthermore, proteins with molecular weights of 230 and 16 kDa, that aggregated in the pure samples, did not aggregate in the mixtures. Although the mechanism of the latter effect remains to be elucidated, it probably explains the lower gel strength observed in the protein mixtures.