Characterization and swelling properties of composite gel microparticles based on the pectin and κ-carrageenan

Encapsulation of probiotics in freeze-dried calcium alginate and κ-carrageenan beads using definitive screening design: A comprehensive characterisation and in vitro digestion study

This research aimed to evaluate the encapsulation of the probiotic strain, Streptococcus thermophilus, in hydrogels employing sodium alginate (SA) with κ-carrageenan (κC) in gelation baths with varying salt concentrations (CaCl2 and KCl) followed by freeze-drying. The experimentation was conducted at varying levels of κC (0-0.5 % w/v) and SA (2-4 %). Freeze-dried hydrogels were evaluated based on encapsulation efficiency and loss of viability and further characterised. The study could successfully establish an encapsulation efficiency of 87.814 % and a viability loss of 1.201 log CFU·g-1 for the optimised samples. The SEM micrographs of the optimised Ca-alginate/κC hydrogels exhibited a much denser network with fewer pores. The influence of SA/κC in the beads was confirmed by FTIR and DSC, where distinct peak shifts were observed, which indicated the presence of κC and SA polymers. The probiotic survival under simulated gastrointestinal tract (GIT) conditions, performed in accordance with the INFOGEST protocol, indicated that the optimised Ca-alginate/κC beads had a lower rate of release in the gastric phase and a much higher rate of survival and release in the intestinal phase than the control sample. The swelling behaviour of beads varied due to varying pH in both gastric and intestinal phases, and the κC in the optimised beads affected the swelling ratio significantly.

Controlled release of Lactiplantibacillus plantarum by colon-targeted adhesive pectin microspheres: Effects of pectin methyl esterification degrees

The aim of this study is to report the preparation of pectin microspheres by varying degrees of methyl esterification (DM) cross-linked with divalent cationic calcium to encapsulate Lactiplantibacillus plantarum STB1 and L. plantarum LJ1, respectively. Scanning electron microscopy revealed the compact and smooth surface of pectin of DM 28 %, and the stochastic distribution of L. plantarum throughout the gel reticulation. And the pectin of DM 28 % considerably increased probiotics tolerance after continuous exposure to stimulated gastrointestinal tract conditions, with viable counts exceeding 10⁹ CFU/mL. This data indicated that low methoxy-esterification pectin was more efficient to improve the targeted delivery of probiotics in GIT. Additionally, the controlled release of microspheres was dependent on various pH levels. At pH 7.4, the release rates of L. plantarum STB1 and L. plantarum LJ1 reached up to 97.63 % and 95.33 %, respectively. Finally, the Caco-2 cell adhesion model was used to evaluate the cell adhesion rate after encapsulation, which exhibited better adhesion at DM of 60 %.

Effect of calcium chloride and gelling agents on the physicochemical and sensory characteristics of sugar-free banana preserves

Banana preserve is produced by mixing the puree of the fruit with sucrose and organic acids. However, concerns about body esthetics or health reasons have encouraged the search for low-calorie products. Therefore, the objective of this study was to evaluate the effect of calcium chloride (CaCl2), carrageenan gum, and low methoxyl pectin (LM-pectin) on the physicochemical and sensory characteristics of sugar-free banana preserves. By using a central composite rotational design (CCRD) of 2³ + 6 axial points + 4 central points, we obtained 18 formulations that were further tested. Lower CaCl2 concentrations (0.54% to 0.61%) resulted in preserves with lower pH and more vivid color. The increased concentration of LM-pectin (1.40% to 1.64%) resulted in formulations with a yellowish-red hue and with lower moisture, thus, reducing the flavor and purchase intention of the product. Higher concentrations of carrageenan gum (1.04% to 1.15%) decreased the perception of banana preserve aroma. Therefore, concentrations of CaCl2 ranging from 0.54% to 0.61%, carrageenan gum ranging from 0.74% to 0.89% and LM-pectin ranging from 1.40% to 1.64% resulted in sugar-free banana preserves with ideal sweetness and consistency and were, therefore, more acceptable.

Gelling Power Alteration on Kappa-Carrageenan Dispersion through Esterification Method with Different Fatty Acid Saturation

The physicochemical properties of κ-carrageenan gels and their ester forms derived from different fatty-acid saturations were characterized and compared with those of native κ-carrageenan. Furthermore, stearic and oleic acids were used as the saturated and unsaturated fatty acids, respectively. Fourier-transform infrared (FTIR) spectra confirmed the introduction of the ester into the κ-carrageenan backbone. The thermogravimetric analysis showed that thermal stability increased along with the level of unsaturation, but there was a decrease in viscosity, hardness, and syneresis, which caused the consistency of the product to become more elastic. The results also showed that the ester form still has a swelling ability that is almost the same as that of κ-carrageenan. After being formulated into a gel dosage form, the product was successfully produced from the ester with unsaturated fatty acids, and it was more elastic than native κ-carrageenan and had good physical properties with spreadability that meets the requirements for topical preparations.

Encapsulation of resveratrol-loaded Pickering emulsions in alginate/pectin hydrogel beads: Improved stability and modification of digestive behavior in the gastrointestinal tract

In this study, alginate/pectin hydrogel beads were prepared with different mixing ratios (9:1, 8:2, 7:3, 6:4, and 5:5) to encapsulate resveratrol-loaded Pickering emulsions using Ca²⁺ crosslinking. The system with a suitable ratio of pectin and alginate can enhance the encapsulation efficiency and loading capacity. Scanning electron microscopy (SEM) study confirmed that the hydrogel beads were spherical, in which Pickering emulsion was distributed evenly within the polymer network. Fourier Transform Infrared Spectroscopy (FTIR) study indicated that the hydrogel beads were formed by physical cross-linking. X-ray diffraction (XRD) study demonstrated that resveratrol existed in hydrogel beads with an amorphous or dissolved form. Besides, the stability and antioxidant capacity suggested that hydrogel beads could offer protection to resveratrol by preventing degradation through environmental stresses, while maintaining its antioxidant capacity. Importantly, hydrogels significantly reduced the release of free fatty acids and resveratrol during in vitro digestion compared to emulsions, especially with the appropriate ratio of sodium alginate and pectin. Overall, Pickering emulsions-loaded alginate/pectin hydrogel beads could offer a novel option for the preparation of low-calorie foods and a potential substitute model for controlling the release of free fatty acids contributing to the transportation of resveratrol.

The Effect of Pectin Branching on the Textural and Swelling Properties of Gel Beads Obtained during Continuous External Gelation Process

The aim of the study was to produce gel beads under continuous conditions. Pectins obtained from black and red currants and commercial apple pectin were used as the material. For the production of gel beads, a self-designed device was used. The designed device allows for the production of gel beads in a continuous process, the properties of which are similar to those obtained in the classic, batch process. Thanks to the device, it is possible to obtain a repeatable product while reducing the workload. The produced gel beads were tested for water absorption and textural properties. The water absorption of the obtained gel capsules is strongly influenced by the pectin chain structure. Pectin beads obtained from currant pectins have a less hard structure and are more sensitive to deformation than those from apple pectin. Shorter and more branched chains of currant pectin than apple pectin form gels with a delicate structure, which strongly absorbs water, and unlike apple pectin gel, it disintegrates. The results show that the use of raw material obtained from different sources allows for obtaining products with various properties, using the same method; moreover, the used device is fully scalable and can be used in large scale.

Potential low-calorie model that inhibits free fatty acid release and helps curcumin deliver in vitro: Ca2+-induced emulsion gels from low methyl-esterified pectin with the presence of erythritol

Our previous study showed that pectin de-esterified by high hydrostatic pressure assisted enzymatic method (HHP-pectin) had better Ca2+-induced gel performance and more stable emulsion than those from conventional enzymatic and alkaline methods. In this study, Ca2+-induced emulsion gels were further prepared by HHP-pectin in the presence of erythritol, and their texture properties, moisture distribution, the release of free fatty acids (FFAs) and curcumin were investigated. Results showed that gel strength, gel elasticity, and water cut-off capacity of the prepared emulsion gels significantly increased with Ca2+ concentration increasing. Compared with emulsions, HHP-pectin emulsion gels can significantly decrease FFAs and curcumin release in vitro digestion, especially for samples with better texture properties (higher Ca2+ concentration). This study indicated that Ca2+-induced HHP-pectin emulsion gels prepared with erythritol may provide a new choice for low-calorie foods preparing, and may become a potential alternative model that inhibiting FFAs release and helping fat-soluble nutrients (curcumin) deliver.

Selection and synthesization of multi-carbon source composites to enhance simultaneous nitrification-denitrification in treating low C/N wastewater

Low carbon/nitrogen ratio (C/N) wastewater is widespread and difficult to treat. To find a resolution to this issue, this study systematically evaluated the constituents of composite solid carbon (i.e., skeletons, carbon sources and crosslinking agents), and proposed a new multi-carbon source composite S1 (MCSC.S1). The effects on nitrogen removal were further determined through a sequencing batch moving bed biofilm reactor (SBMBBR). The results showed that MCSC.S1, which was composed of polyvinyl alcohol-sodium alginate (PVA-SA), corncob + poly (R-β-hydroxybutyrate) (CC + PHB), and H₃BO₃-4% CaCl₂+Na₂SO₄ had high stability and absorption. With MCSC.S1, total nitrification removal was enhanced by more than 48.56% through releasing carbon and absorbing the attached denitrifying bacteria. In addition, it was found that MCSC.S1 can simulate the simultaneous nitrification and denitrification (SND) process and contribute to 29.85% of the total nitrogen removal. 16S gene-based analysis attributed this supplementary nitrogen removal to the enrichment of nitrification (i.e., Proteobacteria, Actinobacteria and Chloroflexi), denitrification of associated bacteria (i.e., Nitrospirota) in MCSC.S1 added reactor, and the increase in nitrogen recycling associated genes. These findings collectively demonstrate that the new MCSC.S1 could effectively enhance nitrogen removal efficiency in low C/N ratio wastewater.

Characterization and Biocompatibility Properties In Vitro of Gel Beads Based on the Pectin and κ-Carrageenan

This study aimed to investigate the influence of kappa (κ)-carrageenan on the initial stages of the foreign body response against pectin gel. Pectin-carrageenan (P-Car) gel beads were prepared from the apple pectin and κ-carrageenan using gelling with calcium ions. The inclusion of 0.5% κ-carrageenan (Car0.5) in the 1.5 (P1.5) and 2% pectin (P2) gel formulations decreased the gel strength by 2.5 times. Car0.5 was found to increase the swelling of P2 gel beads in the cell culture medium. P2 gel beads adsorbed 30–42 mg/g of bovine serum albumin (BSA) depending on pH. P2-Car0.2, P2-Car0.5, and P1.5-Car0.5 beads reduced BSA adsorption by 3.1, 5.2, and 4.0 times compared to P2 beads, respectively, at pH 7. The P1.5-Car0.5 beads activated complement and induced the haemolysis less than gel beads of pure pectin. Moreover, P1.5-Car0.5 gel beads allowed less adhesion of mouse peritoneal macrophages, TNF-α production, and NF-κB activation than the pure pectin gel beads. There were no differences in TLR4 and ICAM-1 levels in macrophages treated with P and P-Car gel beads. P2-Car0.5 hydrogel demonstrated lower adhesion to serous membrane than P2 hydrogel. Thus, the data obtained indicate that the inclusion of κ-carrageenan in the apple pectin gel improves its biocompatibility.

Development of mucoadhesive modified kappa-carrageenan/pectin patches for controlled delivery of drug in the buccal cavity

In this study, modified kappa-carrageenan/pectin hydrogel patches were fabricated for treatment of buccal fungal infections. For this purpose, kappa-carrageenan-g-acrylic acid was modified with different thiolated agents (L-cysteine and 3-mercaptopropionic acid), and the thiol content of the resulting modified kappa-carrageenan was confirmed by elemental analyzer. Then, the hydrogel patches were fabricated, and characterized by Fourier-transform infrared spectroscopy, thermogravimetric analysis, ex vivo mucoadhesion test, and swelling behavior. Triamcinolone acetonide was added either directly or by encapsulating within the poly(lactic-co-glycolic acid) nanoparticles. The release amount of the drug from the directly loaded patch was 7.81 mg/g polymer, while it was 3.28 mg/g polymer for the encapsulated patch with the same content at 7 hr. The hydrogel patches had no cytotoxicity by cell culture studies. Finally, the drug loaded hydrogel patches were demonstrated antifungal activity against Aspergillus fumigatus and Aspergillus flavus. These results provide that the novel modified kappa-carrageenan and pectin based buccal delivery system has promising antifungal property, and could have advantages compared to conventional buccal delivery systems.

Preparation of Pickering emulsion gels based on κ-carrageenan and covalent crosslinking with EDC: Gelation mechanism and bioaccessibility of curcumin

Pickering emulsions stabilized by zein/carboxymethyl dextrin nanoparticles were added to the κ-carrageenan-based gel matrix to prepare emulsion gels via EDC - induced covalent crosslinking. Texture, WHC and freeze-thaw stability of the emulsion gels increased after crosslinking. The Confocal laser scanning microscope and SEM suggested that droplet clusters could be observed in gel with higher concentration of emulsion. The rheological measurements indicated that the viscosity and gel-like structure were relied on crosslinking agent and emulsion concentration. The photothermal stability of curcumin was significantly enhanced after crosslinking. In addition, in vitro digestion study suggested that the bioaccessibility of curcumin in emulsion gel crosslinked was lower compared to emulsion gel without crosslinking agent. These studies might facilitate the preparation of emulsion gels with excellent stability for bioactive compounds delivery in food and pharmaceutical applications.