Reduced nutrient release and greenhouse gas emissions of lignin-based coated urea by synergy of carbon black and polysiloxane

A coupling strategy combined with acid-hydrothermal and novel DES pretreatment: Enhancing biomethane yield under solid-state anaerobic digestion and efficiently producing xylo-oligosaccharides and recovered lignin from poplar waste

Lignocellulose is an abundant renewable bio-macromolecular complex, which can be used to produce biomethane and other high-value products. The lignin, presents in lignocellulose is typically regarded as an inhibitor of anaerobic digestion. Therefore, it is crucial to develop a novel selective separation strategy to achieve efficient biomethane production and all-component utilization of biomass. Hence, a combination of two-step pretreatment and solid-state anaerobic digestion was employed to enhance the production of biomethane and to generate valuable chemicals from poplar waste. Optimal conditions (4 % acetic acid, 170 °C, and 40 min) resulted in 70.85 % xylan removal, yielding 50.28 % xylo-oligosaccharides. The effect of a strong acid 4-CSA-based novel three-constituent DES on delignification was investigated from 80 °C to 100 °C; the cellulose content of DES pretreated poplar increased from 64.11 % to 80.92 %, and the delignification rate increased from 49.0 % to 90.4 %. However, high delignification of the pretreated poplar (DES-100 and DES-110) led to a rapid accumulation of volatile organic acids during the hydrolysis and acidogenesis stages, resulting in methanogenesis inhibition. The highest biomethane yield of 208 L/kg VS was achieved with DES-80 (49.0 % delignification), representing a 148 % improvement compared over untreated poplar. This approach demonstrates the potential for comprehensive utilization of all components of biomass waste.

Enhancing enzymatic saccharification of sunflower straw through optimal tartaric acid hydrothermal pretreatment

Sunflower straw, a usually neglected and abundant agricultural waste, has great potential for contributing to environmental protection realizing its high-value of valorization if utilizing properly. Because hemicellulose contains amorphous polysaccharide chains, relatively mild organic acid pretreatment can effectively reduce its resistance. Through hydrothermal pretreatment, sunflower straw was pretreated in tartaric acid (1 wt%) at 180 ^oC for 60 min to enhance its reducing sugar recovery. After tartaric acid-assisted hydrothermal pretreatment, 39.9% of lignin and 90.2% of hemicellulose were eliminated. The reducing sugar recovery increased threefold, while the solution could be effectively reused for four cycles. The properties of more porous surface, improved accessibility, and decreased surface lignin area of sunflower straw were observed through various characterizations, which explained the improved saccharide recovery and provided a basis for the mechanism of tartaric acid-assisted hydrothermal pretreatment. Overall, this tartaric acid hydrothermal pretreatment strategy greatly provided new impetus for the biomass refinery.

Green construction and release mechanism of lignin-based double-layer coated urea

BACKGROUND

Lignin played an important role in the establishment of coated fertilizers coating material as a substitute for petrochemical raw materials. However, so far, the lignin-based coated fertilizers was limited in only the poor slow-release performance. To achieve good slow-release performance of lignin-based coated fertilizers, hydrophilic of lignin need to be resolved to establish an green and better controllable lignin-based coated fertilizers.

RESULTS

In the study, a novel green double layer coating with lignin-based polyurethane (LPU) as the inner coating and epoxy resin (EP) as the outer coating was effectively constructed for coated urea. Fourier transform infrared spectra confirmed that lignin and polycaprolactone diol successfully reacted with Hexamethylene diisocyanate. The loss weight and water contact angle (WCA, 75.6-63.6°) of the LPUs decreased with the increased lignin content. The average particle hardness of the lignin-based double-layer coated urea (LDCU) first increased from 58.1 N (lignin of 30%) to 67.0 N (lignin of 60%), but then decreased to 62.3 N (lignin of 70%). The release longevity of the coated urea was closely related to the preparation parameters of the coating material. The optimal cumulative nutrient release rate (79.4%) of LDCU was obtained (lignin of 50%, -CNO/-OH molar ratios of 1.15, EP of 35%, and coating ratio of 5%). The aggregates of hydrone on the LDCU caused the dissolution and swelling of nutrients, and then the diffusion of nutrients through the concentration gradient.

CONCLUSIONS

A though the nutrient release of the LDCUs was affected by many factors, the successful development of the LDCUs will help improve the rapid development of the coated fertilizer industry.

Understanding the cadmium passivation and nitrogen mineralization of aminated lignin in soil

Aminated lignin (AL) was prepared and first applied to remediation of cadmium (Cd) pollution in soil. Meanwhile, the nitrogen mineralization characteristics of AL in soil and its effect on soil physicochemical properties were elucidated by soil incubation experiment. The results showed that the Cd availability was dramatically lowered in soil by adding the AL. The DTPA-extractable Cd content of AL treatments was considerably reduced by 40.7-71.4 %. The soil pH (5.77-7.01) and absolute value of zeta potential (30.7-34.7 mV) enhanced simultaneously as the AL additions increased. The content of soil organic matter (SOM) (99.0-264.0 %) and total nitrogen (95.9-301.3 %) were gradually enhanced due to high C (63.31 %) and N (9.69 %) content in AL. Moreover, AL significantly elevated the content of mineral nitrogen (77.2-142.4 %) and available nitrogen (95.5-301.7 %). The first-order kinetic equation of soil nitrogen mineralization revealed that AL greatly enhanced nitrogen mineralization potential (84.7-143.9 %) and reduced environmental pollution by lowering the loss of soil inorganic nitrogen. AL could effectively reduce the availability of Cd through direct (self-adsorption) and indirect effects (improvement of soil pH, SOM and reduction of soil zeta potential), thereby achieving passivation of Cd in soil. In short, this work will develop a novel approach and technical support for soil heavy metal remediation, which is of great significance for improving the sustainable development of agricultural production.

Wood-derived bio-coating materials incorporating hydrophobic lignin and hierarchically porous biochar for high-efficiency coating slow-release fertilizers

Coating slow-release fertilizers (CSRFs) have gained significant attention for their potential to improve nutrient utilization efficiency and prevent environmental pollution through mitigating soil and water contamination. This study developed a novel wood waste-derived composition as a bio-coating material for urea slow-release by integrating modified lignin (PCL) and activated biochar (ABC). PCL was prepared by grafting palmitoyl chloride (PC) with hydrophobic groups to the lignin via an esterification reaction. ABC with a high surface area and hierarchically porous structure created rich channels for ion transportation. These results increased the water-retention ability with a reduced absorbing/expelling rate and confer an excellent Cr(VI) adsorption capacity to the PCL and ABC hybrid coating material (PCL/ABC). The as-prepared PCL/ABC-based CSRF (PCL/ABC-CSRF) showed improving fertilizer slow-release properties for real application (nitrogen release persistence for 40 days at soil). The rice (Oryza sativa L.) hydroponics study suggested that such novel PCL/ABC was conducive to the rice growth in micro metallic contaminated hydroponics by eliminating the accumulation of chromium metal in rice roots. Overall, this study provides an attractive platform for developing biodegradable, heavy-metal adsorbable, and high-efficient CSRFs and a feasible and effective way for functionalized utilization of wood waste.