Development of an ATP measurement method suitable for xenobiotic treatment activated sludge biomass

Formation of anaerobic granular sludge (AnGS) to treat high-strength perchlorate wastewater via anaerobic baffled reactor (ABR) system: Electron transfer characteristic, bacterial community and positive feedback mechanism

Anaerobic granular sludge (AnGS) was cultured to treat high-strength perchlorate (reaching to 4800 mg/L) wastewater by an anaerobic baffled reactor (ABR) system with five equal-volume compartments (C1-C5 compartments). Inoculated sludge completely granulated on day 104 with granule size of 0.50-0.75 mm and perchlorate removal efficiency reaching to 97% (influent perchlorate of 2000-4800 mg/L). The Cyclic voltammetry (CV) capacitance increased from 487.5, 465.8 and 407.8 μF to 576.5, 552.4, 549.6 μF in C1, C3 and C5 compartments of ABR system, respectively, suggesting the electron transfer capacity was enhanced under high-strength perchlorate stress. Meanwhile, adenosine triphosphate (ATP) value and electron transport system activity (ETSA) increased to 25.05, 22.87, 20.43 and 6.22, 4.87, 3.95 of C1, C3 and C5 compartments, respectively. The results suggested that high-strength perchlorate stress improved the microbial metabolic activity, which promoted secretion of extracellular polymeric substances (EPS). The more EPS could facilitate the formation and stability of AnGS under high-strength perchlorate stress. In addition, more reasonable metabolic division of labor in functional bacterial (Thauera and Comamonas) was beneficial to AnGS formation, which achieved high-strength perchlorate efficient removal. Finally, a positive feedback mechanism between AnGS formation and high-strength perchlorate removal was established through EPS, microbial metabolic activity and electron transfer characteristic in ABR system. However, excessive perchlorate (5800 mg/L) would exceed the treatment capacity of AnGS, which resulted in the deterioration of removal performance. This work provided an effective information for AnGS application to treat high-strength perchlorate wastewater.

Suspected-screening assessment of the occurrence of organic compounds in sewage sludge

The profiling of emerging organic pollutants present in sludge and generated during wastewater treatment is much more limited than in water. This is mainly due to the difficulty of sludge analysis because of its high content of organic matter and interfering compounds. In this study, a generic extraction method using a mixture of buffered water (pH 4.1) and solid phase extraction (SPE) clean-up was applied to samples of sludge obtained in different treatment plants. This extraction was followed by determination of the contaminants by ultra-high performance liquid chromatography coupled to high resolution mass spectrometry (UHPLC-HRMS), using suspected screening to detect the most relevant organic compounds that access the environment through sludge application. This screening (including >3000 substances, such as, pharmaceuticals, pesticides, metabolites and industrial chemicals) tentatively identified 122 compound and assigned most probable structure to 39. The set of compounds assigned to a probable structure was increased in 14 compounds by searching in a free database of metabolites. Fifteen compounds were unequivocally confirmed against the analytical standard. Pharmaceuticals and personal care products (PPCPs), with 31 substances identified and 8 confirmed were the main group of compounds. Compounds frequently detected in all sludge samples include nucleotides such as adenosine triphosphate, amino acids such as phenylalanine, or peptides such as leu-phe. Altogether, the results of this work highlight the interest of HRMS to draw the profile of organic compounds in complex matrices.

Validation of a Fast and Simple HPLC-UV Method for the Quantification of Adenosine Phosphates in Human Bronchial Epithelial Cells

A new HPLC method for the simultaneous quantitative analysis of adenosine triphosphate (ATP), adenosine diphosphate (ADP), and adenosine monophosphate (AMP) was developed and validated. ATP, ADP, and AMP were extracted from human bronchial epithelial cells with a rapid extraction procedure and separated with a C18 column (3 × 150 mm, 2.7 µm) using isocratic elution with a mobile phase consisting of 50 mM of potassium hydrogen phosphate (pH 6.80). The absorbance was monitored at 254 nm. The calibration curves were linear in 0.2 to 10 µM, selective, precise, and accurate. This method allowed us to quantify the nucleotides from two cell models: differentiated NHBE primary cells grown at the air-liquid interface (ALI) and BEAS-2B cell line. Our study highlighted the development of a sensitive, simple, and green analytical method that is faster and less expensive than other existing methods to measure ATP, ADP, and AMP and can be carried out on 2D and 3D cell models.

Operational impacts of heavy metals on activated sludge systems: the need for improved monitoring

Biological nutrient removal is highly reliant on maintaining a heterogeneous, balanced, and metabolically active microbial community that can adapt to the fluctuating composition of influent wastewater and encompassing environmental conditions. Maintaining this balance can be challenging in municipal wastewater systems that sporadically receive wastewater from industrial facilities due to the impact of heavy metals and other contaminants on the microbial ecology of the activated sludge. A thorough understanding of the impacts of heavy metals on activated sludge and of practical monitoring options is needed to support decision-making at the wastewater utility level. This paper is divided into two parts. In the first part, the review explains what happens when heavy metals interact with activated sludge systems by highlighting biosorption and bioaccumulation processes, and when an activated sludge system switches from bioaccumulation to toxic shock. Here, it also summarizes the impacts of heavy metal exposure on plant performance. In the second part, the review summarizes practical approaches that can be used at the plant outside the realm of traditional toxicological bioassays testing to determine the possible impacts of influent heavy metal concentrations on the BNR process. These approaches include the following: monitoring operational parameters for major shifts; respirometry; microscopy; ATP; chemical analyses of heavy metals with a focus on synergistic impacts and inhibitory limits; and other novel approaches, such as EPS chemical analyses, molecular techniques, and quorum sensing.

The role of salinity on the changes of the biomass characteristics and on the performance of an OMBR treating tannery wastewater

Tannery wastewaters are difficult to treat biologically due to the high salinity and organic matter concentration. Conventional treatments, like sequential batch reactors (SBR) and membrane bioreactors (MBR), have showed settling problems, in the case of SBR, and ultrafiltration (UF) membrane fouling in the case of MBR, slowing their industrial application. In this work, the treatment of tannery wastewater with an osmotic membrane bioreactor (OMBR) is assessed. Forward osmosis (FO) membranes are characterized by a much lower fouling degree than UF membranes. The permeate passes through the membrane pores (practically only water by the high membrane rejection) from the feed solution to the draw solution, which is also an industrial wastewater (ammonia absorption effluent) in this work. Experiments were carried out at laboratory scale with a FO CTA-NW membrane from Hydration Technology Innovations (HTI). Tannery wastewater was treated by means of an OMBR using as DS an actual industrial wastewater mainly consisting of ammonium sulphate. The monitoring of the biological process was carried out with biological indicators like microbial hydrolytic enzymatic activities, dissolved and total adenosine triphosphate (ATP) in the mixed liquor and microbial population. Results indicated a limiting conductivity in the reactor of 35 mS cm^-1 (on the 43th operation day), from which process was deteriorated. This process performance diminution was associated by a high decrease of the dehydrogenase activity and a sudden increase of the protease and lipase activities. The increase of the bacterial stress index also described appropriately the process performance. Regarding the relative abundance of bacterial phylotypes, 37 phyla were identified in the biomass. Proteobacteria were the most abundant (varying the relative abundance between 50.29% and 34.78%) during the first 34 days of operation. From this day on, Bacteroidetes were detected in a greater extent varying the relative abundance of this phylum between 27.20% and 40.45%.