Surface enhanced Raman scattering based on silver dendrites substrate

Application of sensitive SERS plasmonic biosensor for high detection of metabolic disorders

Due to the importance of early detection of metabolic diseases in newborns, it is essential to measure organoacids; L-Tryptophan, Sebacic acid, and Glutaric acid in very low concentrations. Therefore, the necessity of the construction of a powerful nondestructive biosensor just like the surface-enhanced Raman scattering (SERS) sensor is demonstrated. Through the growth of silver dendritic nanostructures on different substrates like aluminum (Al), copper (Cu), indium tin oxide (ITO), and silicon (Si), a new SERS-based biosensor was developed. Because the Raman signal of molecules adsorbed on dendritic nanostructures is significantly increased, SERS biosensors based on these nanostructures can be used to detect very low concentrations of materials. In this study, first, the organoacid L-Lysine was detected up to a concentration of 10^-12 M, by using a biosensor based on Al, Cu, ITO, and Si substrates. Then, by comparing the results obtained from different substrates, the silicon substrate as the most successful substrate with the best results was used in the SERS biosensor to detect the organoacids, L-Tryptophan, Sebacic acid, and Glutaric acid up to a concentration of 10^-12 M. SEM imaging was used to characterize silver dendritic nanostructures on solid substrates. The successful performance of the SERS biosensor based on silver dendrites in this study promises to be effective in diagnostic applications such as cancer diagnosis (the limit of single molecular detection).

Ag fractal structures in electroless metal deposition systems with and without magnetic field

Metal electrodeposition systems display tree-like structures with extensive ramification and a fractal character. Electrolysis is not a necessary route for the growth of such dendritic metal deposits. We can grow beautiful ramification patterns via a simple redox reaction. We present here a study of silver (Ag) deposits from the reduction of Ag⁺ in (AgNO₃) solution by metallic copper. The experiments are carried out in discotic geometry, in a Petri dish hosting a thin AgNO₃ solution film. A variety of deposited structures and patterns is obtained at different Ag⁺ concentrations, yet with essentially the same fractal dimension averaged at 1.64, typical of diffusion-limited aggregation (DLA). A linear magnetic field of low induction (0.50-1.0 T) applied across the medium causes a notable transformation in the morphology of the deposits. In both the field off and the field on cases, the effect of vertical (hence 3D) heaving seems to be dominant, perhaps explaining the nearly constant fractal dimension.

Role of oxygen in wetting of copper nanoparticles on silicon surfaces at elevated temperature

Copper nanoparticles have been deposited on silicon surfaces by a simple galvanic displacement reaction, and rapid thermal annealing has been performed under various atmospheric conditions. In spite of the general tendency of the agglomeration of nanoparticles to lower the surface energy at elevated temperatures, our plan-view and cross-sectional transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDX) and X-ray diffraction (XRD) analysis shows that the thermal oxidation of the copper nanoparticles and formation of cupric oxide (CuO) on silicon surfaces leads to wetting rather than agglomeration. In contrast, agglomeration has been observed when copper nanoparticles were annealed in a nitrogen environment. The lattice transformation from cubic Cu to monoclinic CuO, and hence the change in surface energy of the particles, assists the wetting process. The occurrence of wetting during the oxidation step implies a strong interaction between the oxidized film and the silicon surface.

High Surface-Enhanced Raman Scattering (SERS) Amplification Factor Obtained with Silver Printed Circuit Boards and the Influence of Phenolic Resins for the Characterization of the Pesticide Thiram

In this work, low-cost substrates with rough silver surfaces were prepared from commercial copper foil-covered phenolic board (CPB) and an aqueous solution of AgNO3, and were used for surface-enhanced Raman scattering (SERS) and surface-enhanced resonance Raman scattering (SERRS) measurements. A maximum SERS amplification factor of 1.2 × 10(7) was obtained for Rhodamine 6G (R6G), and use of the CPB resulted in a detection limit for Thiram pesticide of 0.5 µmol L(-1) The minimum detection level was limited by residual traces of phenolic groups that originated from the substrate resin, which became solubilized in the aqueous Ag(+) solution. It was found that the bands corresponding to the impurities had less influence in the Thiram analysis, which could be explained by the high affinity of sulfur for Ag surfaces. The influence of impurities in the SERS analyses therefore depended on the linkage between the rough silver surface and the analyte. The findings demonstrated the ease and effectiveness of using CPB to prepare a nanostructured surface for SERS.

Simple electrochemical synthesis of an Au–Ag–Cu trimetallic nanodendrite and its use as a SERS substrate

An Au–Ag–Cu trimetallic nanodendrite was constructed by simple electrochemical methods and was evaluated as a surface enhanced Raman scattering (SERS) substrate.

Surface enhanced Raman scattering of dendritic Ag nanostructures grown with anodic aluminium oxide

Ag dendrites grown simultaneously with anodic aluminium oxide showing long-term stability for reuse even after one year and a simulated Ag dendrite both demonstrating surface enhanced Raman scattering.

Improved galvanic replacement growth of Ag microstructures on Cu micro-grid for enhanced SERS detection of organic molecules

Galvanic growth of Ag nano/micro-structures on Cu micro-grid was systematically studied for surface-enhanced Raman scattering (SERS) applications. Detailed characterizations via FE-SEM and HR-TEM showed that processing parameters, (reaction time, Ag(+) concentration, and PVP addition) all substantially affect thermodynamics/kinetics of the replacement reaction to yield substrates of significantly different microstructures/homogeneities and thus varied SERS performances (sensitivity, enhancement factor, and reproducibility) of the Ag substrates in the detection of R6G analyte. PVP as an additive was shown to notably alter nucleation/growth behaviors of the Ag crystals and promote the deposition of dense and uniform Ag films of nearly monodisperse polyhedrons/nanoplates through suppressing dendrites crystallization. Under optimized synthesis (50mM of Ag(+), 30s of reaction, and 700 wt.% of PVP), Ag substrates exhibiting a high Raman signal enhancement factor of ~1.1 × 10(6) and a low relative standard deviation of ~0.13 in the repeated detection of 10 μM R6G were obtained. The facile deposition and excellent performance reported in this work may allow the Ag microstructures to find wider SERS applications. Moreover, growth mechanisms of the different Ag nano/micro-structures were discussed based on extensive FE-SEM and HR-TEM analysis.

Tilt boundary induced heteroepitaxy in chemically grown dendritic silver nanostructures on germanium and their optical properties

Dentritic silver nanostructures prepared by a galvanic displacement reaction on germanium substrates show a new type of heteroepitaxy where significantly large lattice mismatch is accommodated by the formation of low-energy asymmetric tilt boundaries.

Controlled synthesis of homogeneous Ag nanosheet-assembled film for effective SERS substrate

Homogeneous Ag nanosheet-assembled film was successfully fabricated by using Cu plate through a simple modified solution method, where weak reductive Cu2O layer and complexing agent citrate ions were both introduced into the reaction system to control the reaction process. Meanwhile, citrate ions were used as morphology-controlled reagent to lead Ag units to grow in the form of nanosheet. The growth process exhibited that Ag nanosheet-assembled film formed slowly with reaction proceeding. Additionally, the pack density of nanosheets in the final product was found to be adjusted by the concentrations of Ag(+) ions in precursor solution. Using Rhodamine 6G (R6G) as probing molecules, the surface-enhanced Raman scattering (SERS) experiments showed that the Ag film assembled by nanosheets with high pack density exhibited excellent detecting performance, which could be used as effective SERS substrate for ultrasensitive detecting. Besides, a novel quintuplet SERS substrate could be synthesized in one batch by our method, which showed good reproducibility and a linear dependence between analyte concentrations and intensities, revealing the advantage of this method for easily scale-up production.

Surface-enhanced Raman scattering imaging of a single molecule on urchin-like silver nanowires

Urchin-like silver nanowires are prepared by reacting AgNO(3)(aq) with copper metal in the presence of cetyltrimethylammonium chloride and HNO(3)(aq) on a screen-printed carbon electrode at room temperature. The diameters of the nanowires are about 100 nm, and their lengths are up to 10 μm. Using Raman spectroscopy, the detection limit of Rhodamine 6G (R6G) on the urchin-like silver nanowire substrate can be as low as 10(-16) M, while the analytical enhancement factor is about 10(13). Raman mapping images confirm that a single R6G molecule on the substrate can be detected.

Silver nanoplates prepared by modified galvanic displacement for surface-enhanced Raman spectroscopy

Silver nanoplates were prepared by modified galvanic displacement on commercial copper foil. SEM, TEM, UV-vis and XPS were employed to analyze those closely packed silver nanoplates. This type of surface-enhanced Raman spectroscopy substrates showed strong surface plasmon absorption and reliable surface-enhanced Raman activity.

Fabrication and evolution of multilayer silver nanofilms for surface-enhanced Raman scattering sensing of arsenate

Surface-enhanced Raman scattering (SERS) has recently been investigated extensively for chemical and biomolecular sensing. Multilayer silver (Ag) nanofilms deposited on glass slides by a simple electroless deposition process have been fabricated as active substrates (Ag/GL substrates) for arsenate SERS sensing. The nanostructures and layer characteristics of the multilayer Ag films could be tuned by varying the concentrations of reactants (AgNO3/BuNH2) and reaction time. A Ag nanoparticles (AgNPs) double-layer was formed by directly reducing Ag+ ions on the glass surfaces, while a top layer (3rd-layer) of Ag dendrites was deposited on the double-layer by self-assembling AgNPs or AgNPs aggregates which had already formed in the suspension. The SERS spectra of arsenate showed that characteristic SERS bands of arsenate appear at approximately 780 and 420 cm-1, and the former possesses higher SERS intensity. By comparing the peak heights of the approximately 780 cm-1 band of the SERS spectra, the optimal Ag/GL substrate has been obtained for the most sensitive SERS sensing of arsenate. Using this optimal substrate, the limit of detection (LOD) of arsenate was determined to be approximately 5 μg·l-1.

Field-assisted synthesis of SERS-active silver nanoparticles using conducting polymers

A gradient of novel silver nanostructures with widely varying sizes and morphologies is fabricated on a single conducting polyaniline-graphite (P-G) membrane with the assistance of an external electric field. It is believed that the formation of such a silver gradient is a synergetic consequence of the generation of a silver ion concentration gradient along with an electrokinetic flow of silver ions in the field-assisted model, which greatly influences the nucleation and growth mechanism of Ag particles on the P-G membrane. The produced silver dendrites, flowers and microspheres, with sharp edges, intersections and bifurcations, all present strong surface enhanced Raman spectroscopy (SERS) responses toward an organic target molecule, mercaptobenzoic acid (MBA). This facile field-assisted synthesis of Ag nanoparticles via chemical reduction presents an alternative approach to nanomaterial fabrication, which can yield a wide range of unique structures with enhanced optical properties that were previously inaccessible by other synthetic routes.

Silver microflowers and large spherical particles: Controlled preparation and their wetting properties

In this article, we report a simple wet-chemical method to prepare silver microflowers and large spherical particles. The formation of the two different microstructures of silver is based on the reduction of AgNO(3) by para-phenylenediamine in aqueous medium at room temperature. The controlling of the silver microstructures can be achieved only by adjusting the concentration of the reactants. It is found that the two different silver microstructures display opposite wetting properties. Large spherical silver particles exhibit superhydrophilic properties with a contact angle (CA) of close to 0 degrees, microflower-like silver particles exhibit highly hydrophobic properties with CA about 132 degrees. X-ray diffraction (XRD), X-ray photoelectron spectra (XPS) and UV-vis spectra are used to characterize the chemical structure of the obtained products.