Physicochemical and catalytic properties of grafted vanadium species on different mesoporous silicas

Textural and morphology changes of mesoporous SBA-15 silica due to introduction of guest phase

The research focuses on study of guest phase effect on the surface area and pore volume of SBA-15 with the emphasis on elucidation of reasons for these changes. The changes of surface area and pore volume are evident from evaluated N2 adsorption isotherms of VOx-SBA-15 even for samples with relative low content of supported guest phase, which is “atomically” spread on the surface in the form of anchored monomeric vanadyl species. These species cannot block the pore with diameter of 10 nm, nevertheless the presence of such phase causes decrease in adsorbed nitrogen during physisorption. Comparison of guest phase amount with differences in adsorbed amount of nitrogen led to conclusion that each vanadyl complex prevents adsorption of about one or two N2 molecules in the layer and influences two adsorption layers. Significant pore blocking occurs in the VOx-SBA-15 materials only in the case of presence bulk oxide-like nanospecies. Re-structuralization of silica mimicking phase separation phenomena relying on spinodal decomposition of a system was observed by SEM/TEM analysis and adsorption isotherms inspection for materials with high vanadium content.

Reutilization of Cr-Y zeolite obtained by biosorption in the catalytic oxidation of volatile organic compounds

This work aims at the reutilization of a Cr-loaded NaY zeolite obtained by biorecovery of chromium from water as catalyst in the oxidation of volatile organic compounds (VOC). Cr-NaY catalysts were obtained after biosorption of Cr(VI) using a bacterium, Arthrobacter viscosus, supported on the zeolite. The biosorption experiments were conducted at different pH values in the range 1-4. The catalysts were characterized by several techniques, namely ICP-AES, SEM-EDS, XRD, XPS, Raman, H(2)-TPR and N(2) adsorption. The zeolite obtained at pH 4 has the highest content of chromium, 0.9%, and was selected as the best catalyst for the oxidation of different VOC, namely ethyl acetate, ethanol and toluene. For all VOC tested, the catalyst with chromium showed higher activity and selectivity to CO(2), in comparison with the starting zeolite NaY. The presence of chromium shifted also the reaction pathways. In terms of selectivity to CO(2), the following sequence was observed: ethyl acetate>toluene>ethanol.