Free-standing red phosphorous/silver sponge monolith as an efficient and easily recyclable macroscale photocatalyst for organic pollutant degradation under visible light irradiation

Fe3+/Mn2+ (Oxy)Hydroxide Nanoparticles Loaded onto Muscovite/Zeolite Composites (Powder, Pellets and Monoliths): Phosphate Carriers from Urban Wastewater to Soil

The development of an efficient adsorbent is required in tertiary wastewater treatment stages to reduce the phosphate-phosphorous content within regulatory levels (1 mg L^-1 total phosphorous). In this study, a natural muscovite was used for the preparation of muscovite/zeolite composites and the incorporation of Fe³⁺/Mn²⁺ (oxy)hydroxide nanoparticles for the recovery of phosphate from synthetic wastewater. The raw muscovite MC and the obtained muscovite/sodalite composite LMC were used in the powder form for the phosphate adsorption in batch mode. A muscovite/analcime composite was obtained in the pellets PLMCT₃ and monolith SLMCT₂ forms for the evaluation in fixed-bed mode for continuous operation. The effect of pH, equilibrium and kinetic parameters on phosphate adsorption and its further reuse in sorption-desorption cycles were determined. The characterization of the adsorbents determined the Fe³⁺ and Mn²⁺ incorporation into the muscovite/zeolite composite's structure followed the occupancy of the extra-framework octahedral and in the framework tetrahedral sites, precipitation and inner sphere complexation. The adsorbents used in this study (MC, LMC, PLMCT₃ and SLMCT₂) were effective for the phosphate recovery without pH adjustment requirements for real treated wastewater. Physical (e.g., electrostatic attraction) and chemical (complexation reactions) adsorption occurred between the protonated Fe³⁺/Mn²⁺ (oxy)hydroxy groups and phosphate anions. Higher ratios of adsorption capacities were obtained by powder materials (MC and LMC) than the pellets and monoliths forms (PLMCT₃ and SLMCT₂). The equilibrium adsorption of phosphate was reached within 30 min for powder forms (MC and LMC) and 150 min for pellets and monoliths forms (PLMCT₃ and SLMCT₂); because the phosphate adsorption was governed by the diffusion through the internal pores. The adsorbents used in this study can be applied for phosphate recovery from wastewater treatment plants in batch or fixed-bed mode with limited reusability. However, they have the edge of environmentally friendly final disposal being promissory materials for soil amendment applications.

Controllable synthesis of a sponge-like Z-scheme N,S-CQDs/Bi2MoO6@TiO2 film with enhanced photocatalytic and antimicrobial activity under visible/NIR light irradiation

Multifunctional photocatalytic surfaces for pollutant degradation and antimicrobial application are often in high demand, however they confront many challenges in charge transfer and light capture ability. In this work, a sponge-like N,S-CQDs/Bi₂MoO₆@TiO₂ film was constructed via hydrothermal technique aiming to solve above problems. As a result, the ternary film showed enhanced photocatalytic efficiency under visible and near-infrared (NIR) light, in which 85.8% and 44.6% of ciprofloxacin (CIP) were degraded after 240 min irradiation with visible and NIR light, respectively. Moreover, the composite film effectively realized photocatalytic sterilization of gram-positive B. subtilis and gram-negative E. coli under visible light irradiation. The bacterial colony decreased significantly from 7.56-log to 1-log cfu/mL after adding the ternary film within 1.5 h. The enhanced photocatalytic efficiency was closely related to both introduction of surface-functional N,S-CQDs and the construction of N,S-CQDs/Bi₂MoO₆@TiO₂ Z-scheme system, in which the transfer efficiency of photoinduced carriers and the light absorption property were significantly improved. We consider that the N,S-CQDs/Bi₂MoO₆@TiO₂ film is promising for the degradation of refractory pollutants and antimicrobial application under visible/NIR light irradiation. The relatively convenient recycling property and excellent photocatalytic performance of the N,S-CQDs/Bi₂MoO₆@TiO₂ film are beneficial for industrial applications.

Red Phosphorus: An Up-and-Coming Photocatalyst on the Horizon for Sustainable Energy Development and Environmental Remediation

Photocatalysis is a perennial solution that promises to resolve deep-rooted challenges related to environmental pollution and energy deficit through harvesting the inexhaustible and renewable solar energy. To date, a cornucopia of photocatalytic materials has been investigated with the research wave presently steered by the development of novel, affordable, and effective metal-free semiconductors with fascinating physicochemical and semiconducting characteristics. Coincidentally, the recently emerged red phosphorus (RP) semiconductor finds itself fitting perfectly into this category ascribed to its earth abundant, low-cost, and metal-free nature. More notably, the renowned red allotrope of the phosphorus family is spectacularly bestowed with strengthened optical absorption features, propitious electronic band configuration, and ease of functionalization and modification as well as high stability. Comprehensively detailing RP's roles and implications in photocatalysis, this review article will first include information on different RP allotropes and their chemical structures, followed by the meticulous scrutiny of their physicochemical and semiconducting properties such as electronic band structure, optical absorption features, and charge carrier dynamics. Besides that, state-of-the-art synthesis strategies for developing various RP allotropes and RP-based photocatalytic systems will also be outlined. In addition, modification or functionalization of RP with other semiconductors for promoting effective photocatalytic applications will be discussed to assess its versatility and feasibility as a high-performing photocatalytic system. Lastly, the challenges facing RP photocatalysts and future research directions will be included to propel the feasible development of RP-based systems with considerably augmented photocatalytic efficiency. This review article aspires to facilitate the rational development of multifunctional RP-based photocatalytic systems by widening the cognizance of rational engineering as well as to fine-tune the electronic, optical, and charge carrier properties of RP.

Elemental red phosphorus-based photocatalysts for environmental remediation: A review

The low-cost and environmentally benign elemental red phosphorus (RP) is a new class of photocatalysts with tunable bandgaps (ca. 1.5-2.4 eV) and has a strong visible-light response. It has been considered as a promising metal-free photocatalyst for solving the energy crisis and environmental problems. Unfortunately, due to the low-charge carrier mobility, and serve charge trapping effects, its photocatalytic activity is still restricted in comparison with the traditional compound photocatalysts. Considerable efforts, such as morphology modification, cocatalysts addition, heterostructure construction, charge trapping mitigation, have been conducted to improve the photocatalytic activity of the RP photocatalysts. In this review, the physical and chemical properties and the synthetic strategies of the RP photocatalysts were summarized along with the application in environmental remediation accompanied by the photocatalytic reaction mechanism. Finally, an overview and outlook on the problems and future avenues in designing and constructing advanced RP photocatalysts were also proposed.

Visible light activation of persulfate by magnetic hydrochar for bacterial inactivation: Efficiency, recyclability and mechanisms

The development of "green" water disinfection technology utilizing solar energy is highly desired but remains challenging. In this study, sulfate radical (•SO₄^-)-mediated bacterial inactivation was first attempted by using Fe₃O₄-based magnetic hydrochar (MHC) as a recyclable catalyst for persulfate (PS) activation under visible light (VL) irradiation. Complete treatment of 8.0 log E. coli cells was reached within 40 min in VL/PS/MHC system, compared with that of only 2.0 log-reduction was obtained in the PS/MHC system under the same conditions. The system was applicable in wide range of pH (3.0-9.0), and increasing dissolved O₂ could further promote the efficiency. A three-route mechanism was proposed, in which the PS activation by ≡Fe(II) of Fe₃O₄ and photo-generated electron captured by PS were the major processes. The bacterial cell lesion process was found to be triggered directly via •SO₄^-, which caused the damage of outer membrane, followed by up-regulation of intracellular ROSs and destroy of chromosomal DNA, finally leading to irreversible cell death. Moreover, the VL/PS/MHC system is also effective to inactivate versatile pathogenic bacteria including P. aeruginosa and S. aureus. As a proof-of-concept, our study provides meaningful information to advance the areas of "green" water disinfection technology which can be realized by recyclable photocatalytic systems using solar energy.

Facile self-assembly synthesis of γ-Fe2O3 /graphene oxide for enhanced photo-Fenton reaction

A novel self-assembly method was developed to prepare a γ-Fe₂O₃/graphene oxide (GO) heterogeneous catalyst that showed excellent synergy between photocatalysis and Fenton-like reactions. The γ-Fe₂O₃/GO catalyst prepared on the iron plates demonstrated efficient and reproducible catalytic activities for water treatment. It takes only 80 min to degrade 50 mg L^-1 methylene (MB) completely, which is the main non-biodegradable dye in wastewater from the textile industry. The heterogeneous catalyst is stable over a wide range of pH (from 2.0 to 10.2) for MB degradation, and can be easily extracted from solution and repeatedly used with little loss of catalytic activity. The high activity and stability of the catalyst system can be attributed to charge separation between γ-Fe₂O₃ and GO, which could accelerate Fenton-like process and photocatalysis. In addition, the dominant reactive oxidant species responsible for the MB degradation, including the hydroxyl radicals (•OH) and holes (h⁺), were trapped on the surface of the γ-Fe₂O₃/GO composite, as proved by a free-radical quenching experiment. The γ-Fe₂O₃/GO heterogeneous catalyst could potentially provide a solution for removal of non-biodegradable dyes from wastewater in the textile industry.