Investigation of an eco-friendly aerogel as a substrate for the immobilization of MoS2 nanoflowers for removal of mercury species from aqueous solutions

Synthesis and characterization of green rust-deposited MoS2 composites for adsorptive removal of EDTA-chelated Ni(II) in wastewater

Ethylenediamminetetraacetatonickel(II) (EDTA-Ni(II)) has emerged as a significant soil and groundwater contaminant due to the increasing agricultural and industrial activities, posing environmental challenges. This study focuses on addressing the reactivity of green rust (GR), which can be hindered by oxidation with oxygen, limiting its effectiveness in remediation processes. To overcome this limitation and enhance the adsorptive capacities, the combination of sulfate green rust (SO4-GR) with various Fe(II)/Fe(III) ratios with a high-surface-area adsorbent, MoS2, resulting in the formation of binary composites of green rust-deposited MoS2 (MSGs) were explored. The aim was to improve the removal efficiency of EDTA-Ni(II) from contaminated wastewater. To characterize the MSGs, a comprehensive analysis using XRD, SEM, TEM, FTIR, and X-ray absorption spectroscopy was performed. The surface areas of the MSGs were smaller than that of MoS2 but larger than that of the SO4-GRs, indicating a promising composite material. XANES spectra analysis revealed that both MSGs and SO4-GRs exhibited a mixture of ferrous and ferric ions, as evident from their spectral positioning between FeO and Fe2O3. The optimal pH for efficient removal of EDTA-Ni(II) was 3, which resulted in removal efficiencies of 45.6%, 47.3%, 46.0%, and 46.2% for MSG 1, MSG 2, MSG 3, and MSG 4 after 24 h, respectively. Reducing the initial concentration of EDTA-Ni(II) to 50 mg Ni(II)/L effectively doubled the removal efficiency. Notably, as EDTA-Ni(II) was removed, an increased leaching of iron was observed, leading to a total iron concentration exceeding 40 mg/L for the composites with higher Fe(II)/Fe(III) ratios. These findings underscore the potential of MSG as a promising material for degrading EDTA-Ni(II) in contaminated wastewater, offering a viable solution to mitigate the environmental impact of this emerging contaminant. This study contributes to the understanding of green rust reactivity and provides valuable insights for developing effective strategies to address the challenges associated with EDTA-Ni(II) contamination.

Guided Synthesis of a Mo/Zn Dual Single-Atom Nanozyme with Synergistic Effect and Peroxidase-like Activity

We present a facile route towards a dual single-atom nanozyme composed of Zn and Mo, which utilizes the non-covalent nano-assembly of polyoxometalates, supramolecular coordination complexes as the metal-atom precursor, and a macroscopic amphiphilic aerogel as the supporting substrate. The dual single-atoms of Zn and Mo have a high content (1.5 and 7.3 wt%, respectively) and exhibit a synergistic effect and a peroxidase-like activity. The Zn/Mo site was identified as the main active center by X-ray absorption fine structure spectroscopy and density functional theory calculation. The detection of versatile analytes, including intracellular H₂ O₂ , glucose in serum, cholesterol, and ascorbic acid in commercial beverages was achieved. The nanozyme has an outstanding stability and maintained its performance after one year's storage. This study develops a new peroxidase-like nanozyme and provides a robust synthetic strategy for single-atom catalysts by utilizing an aerogel as a facile substrate that is capable of stabilizing various metal atoms.

Aptamer-functionalized and silver-coated polydopamine-copper hybrid nanoflower adsorbent embedded with magnetic nanoparticles for efficient mercury removal

Mercury (Hg) emissions are increasing annually owing to rapid global industrialization. Hg poisoning can severely affect the human body owing to its persistence and bioaccumulation. In this study, hybrid nanoflowers (NFs) were synthesized by promoting the formation of primary copper-phosphate crystals coordinated with polydopamine (PDA) and Fe₃O₄ magnetic nanoparticles (MNPs), followed by coating with silver nanoparticles on the surface of the NFs (Ag-MNP-PDA-Cu NFs). The results suggest that the hierarchical structure of the NFs enabled a large surface area with nanosized pores, which were exploited for Hg adsorption. The adsorbed Hg ions could be further eliminated from the solution based on the magnetic characteristics of the NFs. Additionally, hybrid NFs functionalized with Hg²⁺-binding aptamers (Apt-Ag-MNP-PDA-Cu NFs) were prepared based on the silver-sulfur interactions between the Ag-MNP-PDA-Cu NFs and thiol-modified aptamers. The performance of both adsorbents demonstrated that the immobilization of Hg²⁺-binding aptamers significantly improved the elimination of Hg from solution. The Hg²⁺ adsorption isotherm of the Apt-Ag-MNP-PDA-Cu NFs followed the Dubinin-Radushkevich model, with a maximum adsorption capacity of 1073.19 mg/g. The Apt-Ag-MNP-PDA-Cu NFs adsorbed greater amounts of Hg²⁺ than the non-functionalized NFs at the same concentrations, which confirmed that the functionalization of Hg²⁺-binding aptamers on the NFs improved the Hg²⁺ removal performance. The results suggest that Apt-Ag-MNP-PDA-Cu NFs could serve as an efficient Hg-removing adsorbent, possibly by providing binding sites for the formation of T-Hg²⁺-T complexes.

Composite Zn(II) Ferrocyanide/Polyethylenimine Cryogels for Point-of-Use Selective Removal of Cs-137 Radionuclides

The feasibility of several approaches to the fabrication of monolith composite cryogels containing transition-metal ferrocyanides for Cs⁺ ion uptake has been evaluated. Although in the series of investigated metal ion precursors (Cu(II), Zn(II), Ni(II), and Co(II)), in situ formation of the sorption active phase in polyethyleneimine (PEI) cryogel was feasible only in the case of Zn(II) ferrocyanide, this approach has shown significant advantages over the immobilization of ex situ synthesized ferrocyanide nanoparticles. Nanoparticles of the mixed ferrocyanide Zn_1.85K_0.33[Fe(CN)₆] formed in situ had an average size of 516 ± 146 nm and were homogeneously distributed in the monolith located at the polymer surface rather than embedded in the matrix. The Young modulus of the PEI cryogel increased after modification from 25 to 57 kPa, but composites maintained high permeability to the flow. Sorption of Cs⁺ ions has been investigated at superficial velocity up to 8 m/h. Steep breakthrough profiles and uptake efficiency of >99.5% until breakthrough point confirmed that a supermacroporous structure of the monolith composite assured good mass transfer, so that intraparticle diffusion was not the limiting stage of sorption kinetics. Application of the rate-constant distribution model (RCD model) to analyze the breakthrough curves of Cs⁺ sorption allowed the identification of two types of sorption sites with a difference in sorption rate constants of ~1 log unit. Most likely, sorption on “fast” sorption sites was governed by ion exchange between Cs⁺ ions in solution and K⁺ ions in the ferrocyanide lattice. Cs-137 radionuclide removal was investigated using the monolith composite columns of various geometries at superficial velocity up to the 6.6 m/h; specific gamma activity was reduced from 265 kBq/L to the background level, showing high potential of these materials for POU application.

A critical review on the applications and potential risks of emerging MoS2 nanomaterials

Molybdenum disulfide (MoS₂) nanomaterials have been widely used in various fields such as energy store and transformation, environment protection, and biomedicine due to their unique physicochemical properties. Unfortunately, such large-scale production and use of MoS₂ nanomaterials would inevitably release into the environmental system and then potentially increase the risks of wildlife/ecosystem and human beings as well. In this review, we first introduce the physicochemichemical properties, synthetic methods and environmental behaviors of MoS₂ nanomaterials and their typical functionalized materials, then summarize their environmental and biomedical applications, next assess their potential health risks, covering in vivo and in vitro studies, along with the underlying toxicological mechanisms, and last point out some special phenomena about the balance between applications and potential risks. This review aims to provide guidance for harm predication induced by MoS₂ nanomaterials and to suggest prevention measures based on the recent research progress of MoS₂' applications and exerting toxicological data.

Rational Design of Polyamine-Based Cryogels for Metal Ion Sorption

Here we report the method of fabrication of supermacroporous monolith sorbents (cryogels) via covalent cross-linking of polyallylamine (PAA) with diglycidyl ether of 1,4-butandiol. Using comparative analysis of the permeability and sorption performance of the obtained PAA cryogels and earlier developed polyethyleneimine (PEI) cryogels, we have demonstrated the advantages and disadvantages of these polymers as sorbents of heavy metal ions (Cu(II), Zn(II), Cd(II), and Ni(II)) in fixed-bed applications and as supermacroporous matrices for the fabrication of composite cryogels containing copper ferrocyanide (CuFCN) for cesium ion sorption. Applying the rate constant distribution (RCD) model to the kinetic curves of Cu(II) ion sorption on PAA and PEI cryogels, we have elucidated the difference in sorption/desorption rates and affinity constants of these materials and showed that physical sorption contributed to the Cu(II) uptake by PAA, but not to that by PEI cryogels. It was shown that PAA cryogels had significantly higher selectivity for Cu(II) sorption in the presence of Zn(II) and Cd(II) ions in comparison with that of PEI cryogels, while irreversible sorption of Co(II) ions by PEI can be used for the separation of Ni(II) and Co(II) ions. Using IR and Mössbauer spectroscopy, we have demonstrated that strong complexation of Cu(II) ions with PEI significantly affects the in situ formation of Cu(II) ferrocyanide nanosorbents leading to their inefficiency for Cs⁺ ions selective uptake, whereas PAA cryogel was applicable for the fabrication of efficient monolith composites via the in situ formation of CuFCN or loading of ex situ formed CuFCN colloids.

Point-of-care assay for drunken driving with Pd@Pt core-shell nanoparticles-decorated ploy(vinyl alcohol) aerogel assisted by portable pressure meter

Alcohol abuse causes health problems and security accidents. A reliable and sensitive detection system for alcohol has been an instinctive demand in law enforcement and forensic. More efforts are demanded in developing new sensing strategy preferably with portable and non-invasive traits for the pushforward of point-of-care (POC) device popularization.

Methods: We developed a POC diagnosis system for alcohol assay with the aid of alcohol oxidase (AOX) pre-joining in the system as well as Pd@Pt core-shell nanoparticles (abbreviated to Pd@Pt) that were decorated on ploy(vinyl alcohol) aerogel with amphiphilicity. Biological samples like saliva and whole blood can be absorbed by the aerogel in a quick process, in which the analyte would go through a transformation from alcohol, H₂O₂, to a final production of O₂, causing an analyte dose-dependent signal change in the commercial portable pressure meter. The cascade reactions are readily catalyzed by AOX and Pd@Pt, of which the latter one possesses excellent peroxidase-like activity.

Results: Our design has smartness embodied in the aerogel circumvents the interference from methanol which is more ready to be catalyzed by AOX. Under the optimal conditions, the limit of detection for alcohol was 0.50 mM in saliva, and is able to distinguish the driving under the influence (DUI) (1.74 mM in saliva) and driving while impaired (DWI) (6.95 mM in saliva) in the national standard of China.

Conclusion: Our proof-of-concept study provides the possibility for the establishment of POC device for alcohol and other target detection, not only owing to the sensing qualification but also thanks to the architecture of such sensor that has great flexibility by replacing the AOX with glucose oxidase (GOX), thenceforth realizing the accurate detection of glucose in 0.5% whole blood sample. With the advantages of easy accessibility and anti-interference ability, our sensor exhibits great potential for quantitative diagnostics in biological system.